Are older drivers’ driving patterns during an on-road driving task representative of their real-world driving patterns?

Abstract

Objective: The current study investigated whether older drivers’ driving patterns during a customized on-road driving task were representative of their real-world driving patterns.

Methods: Two hundred and eight participants (male: 68.80%; mean age?=?81.52 years, SD?=?3.37 years, range?=?76.00–96.00 years) completed a customized on-road driving task that commenced from their home and was conducted in their own vehicle. Participants’ real-world driving patterns for the preceding 4-month period were also collected via an in-car recording device (ICRD) that was installed in each participant’s vehicle.

Results: During the 4-month period prior to completing the on-road driving task, participants’ median real-world driving trip distance was 2.66?km (interquartile range [IQR]?=?1.14–5.79?km) and their median on-road driving task trip distance was 4.41?km (IQR?=?2.83–6.35?km). Most participants’ on-road driving task trip distances were classified as representative of their real-world driving trip distances (95.2%, n?=?198).

Conclusions: These findings suggest that most older drivers were able to devise a driving route that was representative of their real-world driving trip distance. Future research will examine whether additional aspects of the on-road driving task (e.g., average speed, proportion of trips in different speed zones) are representative of participants’ real-world driving patterns.     

某电子垃圾拆解园周边农田土壤中多环芳烃的污染特征及风险评估

研究了某电子垃圾拆解园周边151个农田土壤样品中16种多环芳烃(PAHs)的污染特征和环境风险。结果表明,125个表层土壤样品中PAHs总质量浓度在149.0~2.0×104μg/kg,均值为1 805.5μg/kg,随着剖面土壤深度增加,PAHs含量总体呈递减趋势。通过来源解析,电子拆解园周围土壤中PAHs污染主要由废弃的电子电器元件的粗放燃烧和汽车尾气排放共同引起。土壤风险评估表明,7种类二噁英毒性PAHs的毒性当量(TEQPAH)在6.000×10-5~0.689pg TEQ/g,平均值为0.015pg TEQ/g;苯并(a)芘、二苯并(a,h)蒽、苯并(a)蒽、苯并(b)荧蒽、茚并(1,2,3-cd)芘致癌风险率超出百万分之一的样本比例分别为20.53%、6.62%、1.99%、2.65%、2.65%,其中采样点1、68两个点位表层土壤的苯并(b)荧蒽致癌风险率超过了万分之一。     

高压实新疆阿尔泰膨润土微观结构随吸力变化特征

采用压汞法(MIP)和扫描电镜(SEM)法,在自由和侧限状态下,试验研究了高压实新疆阿尔泰膨润土在不同吸力条件下的微观结构变化特征。吸力的控制采用了气相法和渗析(液相)法。研究结果表明:(1)低吸力范围内,自由膨胀和侧限条件下的高压实膨润土土水特征存在明显差异;(2)膨润土在自由和侧限状态下的水化过程中呈现出了截然不同的微结构变化特征。自由膨胀条件下,土的吸水膨胀量主要来自土中大孔隙的逐渐膨胀。侧限状态下,随着控制吸力的降低,膨润土的大孔隙逐渐被压缩,较小孔隙的数量不断增加,土中孔隙分布变得更加均匀。     

道路车辆电气及电子设备在振动试验中的应力循环和试验设计原则

本文试从振动试验的特点和受试样品承受振动激励的应力循环切入分析,为把握试验方案的拟订提供支持。同时也简要介绍了应力循环的计算方法,供试验人员参考使用。     

A LARGE ELECTRONIC WEIGHING LYSIMETER SYSTEM: DESIGN AND INSTALLATION1

ABSTRACT: To measure crop evapotranspiration, a large double tank, electronic weighting lysimeter system was designed and installed at the Shahid Bahonar University farm, Kerman, Iran. The system was installed in a 50 m² underground building. It includes two tanks of 3.00 m in diameter and 1.75 m deep. The weighing mechanism for each tank is a set of three compression strain gage load cells, which are fixed on 1.20 m height column above the floor. According to the specification of the load cells, the maximum possible weighing error may be about 0.01 percent of total mass, which is equivalent to 0.28 mm of water, but the measured error was equal to 1 kg mass, which is equivalent to 0.14 mm of water. The load cell data from each tank and the on‐site environmental data (temperature, humidity, and wind velocity and direction) are automatically recorded and saved in a personal computer hard disk for further use and analysis.     

物理场水处理器的应用与分类研究

笔者在物理场水处理器的组成结均和作用原理的基础上，依据相关国家行业标准，将其分成了三大类，并对各类物理场水处理器作了简要的说明。其中，重点阐述了电子式水处理器的分类、命名、原理、组成结构及选用安装要求等。     

Present status of the recycling of waste electrical and electronic equipment in Korea

In Korea due to rapid economical growth followed by urbanisation, breakage of large traditional families into small nuclear families, continuous changes in equipment features and capabilities causes tremendous increase in sale of new electrical and electronic equipment (EEE) and decrease in sale of used EEE. Subsequently, the ever-increasing quantity of waste electrical and electronic equipment (WEEE) has become a serious social problem and threat to the environment. Therefore, the gradual increase in the generation of WEEE intensifies the interest for recycling to conserve the resources and protect the environment. In view of the above, a review has been made related to the present status of the recycling of waste electrical and electronic equipment in Korea. This paper describes the present status of generation and recycling of waste electrical and electronic equipment, namely TVs, refrigerators, washing machines, air conditioners, personal computers and mobile phones in Korea. The commercial processes and the status of developing new technologies for the recycling of metallic values from waste printed circuit boards (PCBs) is also described briefly. Since 1998, three recycling centers are in full operation to recycle WEEE such as refrigerators, washing machines and air conditioners, having the total capacity of 880,000 units/year. All waste TVs are recently recycled on commission basis by several private recycling plants. The recycling of waste personal computers and mobile phones is insignificant in comparison with the amount of estimated obsolete those. Korea has adopted and enforced the extended producer responsibility (EPR) system. Korea is making consistent efforts to improve the recycling rate to the standards indicated in the EU directives for WEEE. Especially environmentally friendly and energy-saving technologies are being developed to recycle metal values from PCBs of WEEE.     

电子产品故障物理模型研究与应用进展

提出了故障物理模型的基本概念,对几种常见的电子产品故障物理模型,包括互连热疲劳模型、互连振动疲劳模型、电迁移模型和与时间相关的介质击穿模型等进行了分析,总结提出了基于失效发生因素和失效发生过程的损伤模型建模等两种故障物理模型的建模方法。结合工程应用情况,对两种故障物理模型的应用方法——可靠性仿真分析方法和可靠性加速试验方法进行了讨论。最后对故障物理模型的研究进行了展望。     

电子垃圾重金属污染及防治对策研究

随着信息产业的飞速发展,电子产品更新换代加速,电子垃圾飞速增长,电子垃圾中的重金属对环境造成了越来越严重的污染.本文回顾了广东贵屿与浙江台州两大电子垃圾回收拆解区重金属污染的现状,分析了电子产品原材料、加工工艺和电子垃圾不当回收导致重金属污染的原因,提出了依靠政策法规引导、借鉴国外先进经验、进行电子垃圾回收处理产业化发展的相应防治对策,以期能改善电子垃圾导致的重金属污染.     

弹上电子部件加速因子估计方法研究

目的针对高可靠长寿命的弹上电子部件在实际贮存环境温度起伏变化的情况,研究基于等效温度的加速因子估计方法。方法首先剖析弹上电子部件失效机理,然后基于阿伦尼斯模型,分析加速应力与实际环境温度的对应关系,求解实际环境等效温度,进而估计加速因子,最后通过某型导弹综合控制器中的时序控制电路板,验证该方法的工程适用性。结果该方法能够真实反映环境温度情况,且与传统加权平均温度计算方法相比,加速因子估计和加速试验时间预测更准确,且随着实际环境温度起伏的增大,优势更加明显。结论该方法在实际贮存环境温度起伏变化的情况下,能够有效提高加速因子估计和加速寿命试验时间预测的准确性,为弹上电子部件加速寿命试验方案设计提供可靠依据,对其他高可靠长寿命产品的加速因子估计也具有一定的参考价值。