VALIDATION OF THE SWAT MODEL ON A LARGE RWER BASIN WITH POINT AND NONPOINT SOURCES1

ABSTRACT: The State of Texas has initiated the development of a Total Maximum Daily Load program in the Bosque River Watershed, where point and nonpoint sources of pollution are a concern. Soil Water Assessment Tool (SWAT) was validated for flow, sediment, and nutrients in the watershed to evaluate alternative management scenarios and estimate their effects in controlling pollution. This paper discusses the calibration and validation at two locations, Hico and Valley Mills, along the North Bosque River. Calibration for flow was performed from 1960 through 1998. Sediment and nutrient calibration was done from 1993 through 1997 at Hico and from 1996 through 1997 at Valley Mills. Model validation was performed for 1998. Time series plots and statistical measures were used to verify model predictions. Predicted values generally matched well with the observed values during calibration and validation (R²≥ 0.6 and Nash‐Suttcliffe Efficiency ≥ 0.5, in most instances) except for some underprediction of nitrogen during calibration at both locations and sediment and organic nutrients during validation at Valley Mills. This study showed that SWAT was able to predict flow, sediment, and nutrients successfully and can be used to study the effects of alternative management scenarios.     

黄河下游泥沙灾害与减灾对策(Ⅰ)——泥沙灾害分类与侵蚀型泥沙灾害

从泥沙研究的角度概述了与河流泥沙有关的灾害及其分类，将黄河下游的泥沙灾害分成侵蚀型泥沙灾害与堆积型泥沙灾害两种情况，讨论了侵蚀型泥沙灾害，包括滩岸坍塌、河道整治工程出险，初步提出了侵蚀型泥沙灾害的减灾方略。     

APPLICATION OF A SEDIMENT ROUTING MODEL TO A MIDDLE EUROPEAN WATERSHED1

ABSTRACT: A simulation model that computes sediment yield due to sheet and rill erosion at the outlet of a large watershed requires daily precipitation and the soil, topographic, and vegetative characteristics of the watershed. An important problem, particularly in a large watershed, is the transport of sediment produced in the sub-watersheds to the outlet of the whole watershed. This problem is approached mathematically by a sediment routing model that is used as a component of the total model.     

COALBED METHANE PRODUCT WATER CHEMISTRY IN THREE WYOMING WATERSHEDS1

ABSTRACT: The Powder River Basin in Wyoming has become one of the most active areas of coalbed methane (CBM) development in the western United States. Extraction of methane from coalbeds requires pumping of aquifer water, which is called product water. Two to ten extraction wells are manifolded into one discharge point and product water is released into nearby unlined holding ponds. The objective of this study was to evaluate the chemistry, salinity, and sodicity of CBM product water at discharge points and associated holding ponds as a function of watershed. The product water samples from the discharge points and associated holding ponds were collected from the Cheyenne River (CHR), Belle Fourche River (BFR), and Little Powder River (LPR) watersheds during the summers of 1999 and 2000. These samples were analyzed for pH, electrical conductivity (EC), total dissolved solids (TDS), alkalinity, sodium (Na), calcium (Ca), magnesium (Mg), potassium (K), sulfate (SO₄^2‐), and chloride (C^1‐). From the chemical data, practical sodium adsorption ratio (SARp) and true sodium adsorption ratio (SARt) were calculated for the CBM discharge water and pond water. The pH, EC, TDS, alkalinity, Na, Ca, Mg, K, SARp, and SARt of CBM discharge water increased significantly moving north from the CHR watershed to the LPR watershed. CBM discharge water in associated holding ponds showed significant increases in EC, TDS, alkalinity, Na, K, SARp, and SARt moving north from the CHR to the LPR watershed. Within watersheds, the only significant change was an increase in pH from 7.21 to 8.26 between discharge points and holding ponds in the LPR watershed. However, the LPR and BFR exhibited larger changes in mean chemistry values in pH, salinity (EC, TDS), and sodicity (SAR) between CBM product water discharges and associated holding ponds than the CHR watershed. For instance, the mean EC and TDS of CBM product water in LPR increased from 1.93 to 2.09 dS/m, and froml,232 to 1,336 mg/L, respectively, between discharge and pond waters. The CHR exhibited no change in EC, TDS, Na, or SAR between discharge water and pond water. Also, while not statistically significant, mean alkalinity of CBM product water in BFR and LPR watersheds decreased from 9.81 to 8.01 meq/L and from 19.87 to 18.14 meq/L, respectively, between discharge and pond waters. The results of this study suggest that release of CBM product water onto the rangelands of BFR and LPR watersheds may precipitate calcium carbonate (CaCO₃) in soils, which in turn may decrease infiltration and increase runoff and erosion. Thus, use of CBM product water for irrigation in LPR and BFR watersheds may require careful planning based on water pH, EC, alkalinity, Na, and SAR, as well as local soil physical and chemical properties.     

ROLE OF EROSION PROCESSES IN TRANSFER OF RADIONUCLIDES: RESULTS OF FIELD EXPERIMENTS1

ABSTRACT: An experimental one-year fieldwork has been conducted in the vicinity of the Chernobyl NPP, within an agricultural watershed, to study the transfer of radionuclides brought into the environment by the disaster of 1986. Presented are results of observation of the washout of ¹³⁷Cs from the runoff plot both in natural conditions and under artificial rainfalls. Beside traditional hydro-logical methods, new techniques were used allowing to consider microtopographical peculiarities of the runoff plot and their role in the redistribution of radionuclides. The estimate of the annual mass balance for the soil and the radionuclides within the runoff plot has shown that, regardless of significant areal variation of their concentration, the ¹³⁷Cs washout with the solid runoff resulted from artificial rainfalls amounts to some 1 percent of its reserves in the uppermost 5 cm of the topsoil. The same parameter for the natural runoff is lower by an order of magnitude. Both these factors of self-purification are about two times less than natural radioactive decay of ¹³⁷Cs.     

EROSION ON LOGGING ROADS IN REDWOOD CREEK,NORTHWESTERN CALIFORNIA1

Road-related erosion was estimated by measuring 100 randomly located plots on a 180 km road network in the middle reach of R'dwood Creek in northwestern California. The estimated erosion ratn of 177 m³ km^-1 was contrasted with two earlier studies in nearby parts of the same watershed. A sizable proportion of the great reduction in erosion from that reported in the earlier studies is attributed to changes in forest practice rules. Those changes have resulted in better placement and sizing of culverts and, especially, to less reliance on culverts to handle runoff from logging roads.     

“R1-R4” AND “BOISED” SEDIMENT PREDICTION MODEL TESTS USING FOREST ROADS IN GRANITICS1

ABSTRACT: Erosion and sedimentation data from research watersheds in the Silver Creek Study Area in central Idaho were used to test the prediction of logging road erosion using the R1-R4 sediment yield model, and sediment delivery using the “BOISED” sediment yield prediction model. Three small watersheds were instrumented and monitored such that erosion from newly constructed roads and sediment delivery to the mouths of the watersheds could be measured for four years following road construction. The errors for annual surface erosion predictions for the two standard road tests ranged from +31.2 t/ha/yr (+15 percent) to -30.3 t/ha/yr (-63 percent) with an average of zero t/ha/yr and a standard deviation of the differences of 18.7 t/ha/yr. The annual prediction errors for the three watershed scale tests had a greater range from -40.8 t/ha/yr (-70 percent) to +65.3 t/ha/yr (+38 percent) with a mean of -1.9 t/ha/yr and a standard deviation of the differences of 25.2 t/ha/yr. Sediment yields predicted by BOISED (watershed scale tests) were consistently greater (average of 2.5 times) than measured sediment yields. Hillslope sediment delivery coefficients in BOISED appear to be overly conservative to account for average site conditions and road locations, and thus over-predict sediment delivery. Mass erosion predictions from BOISED appear to predict volume well (465 tonnes actual versus 710 tonnes predicted, or a 35 percent difference) over 15 to 20 years, however mass wasting is more episodic than the model predicts.     

Conservation strategies for effective land management of protected areas using an erosion prediction information system (EPIS)

This research demonstrates the predictive modeling capabilities of a geographic information system (GIS)-based soil erosion potential model to assess the effects of implementing land use change within a tropical watershed. The Revised Universal Soil Loss Equation (RUSLE) was integrated with a GIS to produce an Erosion Prediction Information System (EPIS) and modified to reflect conditions found in the mountainous tropics. Research was conducted in the Zenzontia subcatchment of the Río Ayuquíla, located within the Sierra de Manantlán Biosphere Reserve (SMBR), México. Expanding agricultural activities within this area will accentuate the already high rate of soil erosion and resultant sediment loading occurring in the Río Ayuquíla. Two land-use change scenarios are modeled with the EPIS: (1) implementation of soil conservation practices in erosion prone locations; and (2) selection of sites for agricultural expansion which minimize potential soil loss. Confronted with limited financial resources and the necessity for expedient action, managers of the SMBR can draw upon the predictive capacity of the EPIS to facilitate rapid and informed land-use planning decisions.