基于PPI的河段水体潜在污染研究

提出了一种预报河段水体潜在污染的方法——河段潜在污染指数法(riversection potential pollution index,R-PPI),并在北京市山区3个典型小流域进行应用.河流水体污染是我国目前最为突出的水环境问题,在治理工作开展前需要确定重点污染河段、区域和污染源,而基于河流水质监测的水质评价方法难以确定重点污染源.因此引入了潜在非点源污染指数(potential non-point pollution index,PNPI)法,进行了土地利用类型扩展、土地利用分类比对和土壤渗透性分级3个方面改进,得到潜在污染指数(potential pollution index,PPI),并在此基础上建立了河段潜在污染指数法.通过在3个小流域的应用研究可知,该方法具有所需监测资料少、操作简单、便于确定重点污染源、综合性强等特点,可为流域污染治理提供科学指导.     

河流水污染损失补偿模型研究

我国水污染问题的突出表现之一是省际间、地区间水污染纠纷接连不断, 严重影响经济发展和社会稳定。在流域不同主体之间建立水污染补偿机制,可以把水污染造成的环境外部损失内部化,从而促使污染者在治污成本和经济补偿之间进行权衡,促进水污染治理措施的有效执行和水污染纠纷的解决。在水污染经济损失评估的基础上,以河流为研究对象,采用水环境数学模型的方法描述了污染物排放的空间影响关系,进而把超量排放的环境影响与经济影响联系起来,对模型的基本特征、处理方法和应用范围进行了讨论,并且以太湖流域范围内的京杭运河为例进行实证研究,得到了河流水污染损失补偿的数学模型。     

碳源变化对降解2,4-D的好氧颗粒污泥性能及形态的影响

在长期运行的序批式生物反应器(SBR)中,考察了以葡萄糖和2,4-二氯苯氧乙酸(2,4-D)为混合碳源培养的好氧颗粒污泥在转换为2,4-D唯一碳源废水后,其形态、结构及对目标污染物去除功能的变化.结果表明,基质转换为2,4-D单一碳源后,好氧颗粒污泥仍保持了对目标污染物高效的去除能力.当进水2,4-D浓度为361～564mg/L,其去除率为99.2%～100%,COD平均去除率达到85.6%.混合碳源向2,4-D单一碳源转换对原好氧颗粒结构产生一定破坏作用,使其发生部分解体,粒径由513μm下降到302μm.但好氧颗粒污泥良好的耐负荷冲击使其保持了颗粒主体,通过一段时间适应调整后能够重新聚集生长,最终获得能够利用2,4-D为唯一碳源生长并具有良好沉降性(SVI20～40mL/g)的好氧颗粒污泥,粒径为489μm.扫描电子显微镜(SEM)观察结果表明,混合碳源转向单一碳源使好氧颗粒生物相丰富度降低.     

西北干旱区中小城市水价探析

为了促进西北干旱区中小城市的快速、稳定的发展,解决该地区中小城市的水资源短缺问题,以水价作为出发点,充分利用水价格的经济杠杆作用,制定出该地区中小城市的水价。以西北干旱区中具有代表性的城市石河子为例,通过实地调研,得到石河子居民、居民生活用水情况、现行水价、居民家庭节水情况、居民的心理承受水价以及平时生活的节水意识等情况,通过分析,得出居民的心理承受偏低,现行水价仍有一定的上调空间,调价范围为1.58~2.31元/m3,最高可调至4.11元/m3。结合石河子的水价,为西北干旱区的中小城镇的水价改革、提高水资源的利用率等提出一些切实可行的建议。     

低温A/O-MBR工艺启动试验研究

研究了A/O-MBR工艺低温(水温在5~12℃)启动效能,结果表明,低温下A/O-MBR工艺启动迅速,活性污泥的培养驯化时间较短。启动过程中根据出水水质情况,逐渐提高负荷,运行34 d,系统对COD的去除率能达到90%以上,系统对氨氮的去除率能达到96%以上,至稳定运行后氨氮的负荷平均可达到0.419kg/(m3.d),反硝化效果系统去除率基本能稳定在60%左右。     

硫酸系统水平衡分析计算和生产实践

在硫酸系统中,通过水平衡分析计算烟气带入净化工序的SO2体积分数和含水量,确定净化工序的能力,控制干燥塔进口烟气温度,使干吸工序生产出合格产品;通过计算,烟气带入净化工序的水量小于产品带出的水量,制酸净化污水经过污水处理工序处理后返回到净化工序重复使用,实现净化污水零排放,消除对环境的污染.     

四川某中小城镇污水处理厂进水水质统计分析

生活污水水质对处理工艺的选择、设计参数的选取以及稳定运行十分重要。运用SPSS软件,对四川某中小城镇污水处理厂为期一年的进水指标(水量、COD、氨氮、总磷、pH、SS)进行方差和相关性分析。方差分析结果显示进水量、氨氮和SS在月份和季节之间存在显著性差异,而总磷和pH仅在月份之间存在显著差异,COD在季度和月份之间无显著性差异;指标相关性分析表明,进水量和氨氮之间呈负相关,氨氮和总磷、COD和总磷之间呈正相关,且相关性显著。在此分析的基础上对污水处理厂设计、工艺选择及运行管理提出了一些建议。     

Effects of Cu（Ⅱ） and humic acid on atrazine photodegradation

This work was designed to explore the characteristics of photodegradation of herbicides in the copper-polluted water body. The results showed that Cu(II) alone could induce a photo Fenton-like reaction to enhance the degradation of atrazine, in which hydroxyl radical ( OH) was a main active species. Humic acids restrained atrazine degradation, nevertheless, when introducing Cu(II), the photodegradation was accelerated, in which singlet oxygen (1O2) replaced OH acting as the prevailing species. A feasible mechanism for the photochemical process was also proposed, which is helpful for better understanding the environmental photochemistry of atrazine in the copper-polluted water.     

Chemical cleaning of fouled PVC membrane during ultrafiltration of algal-rich water

Cleaning of hollow-fibre polyvinyl chloride (PVC) membrane with di erent chemical reagents after ultrafiltration of algal-rich water was investigated. Among the tested cleaning reagents (NaOH, HCl, EDTA, and NaClO), 100 mg/L NaClO exhibited the best performance (88.4% 1.1%) in removing the irreversible fouling resistance. This might be attributed to the fact that NaClO could eliminate almost all the major foulants such as carbohydrate-like and protein-like materials on the membrane surface, as confirmed by Fourier transform infrared spectroscopy analysis. However, negligible irreversible resistance (1.5% 1.0%) was obtained when the membrane was cleaning by 500 mg/L NaOH for 1.0 hr, although the NaOH solution could also desorb a portion of the major foulants from the fouled PVC membrane. Scanning electronic microscopy and atomic force microscopy analyses demonstrated that 500 mg/L NaOH could change the structure of the residual foulants on the membrane, making them more tightly attached to the membrane surface. This phenomenon might be responsible for the negligible membrane permeability restoration after NaOH cleaning. On the other hand, the microscopic analyses reflected that NaClO could e ectively remove the foulants accumulated on the membrane surface.     

Efficacy of natural biocide on control of microbial induced corrosion in oil pipelines mediated by Desulfovibrio vulgaris and Desulfovibrio gigas

We compared the efficacy of a natural biocide with four chemical tetrakishydroxymethyl phosphonium sulfonate, benzyl trimethyl ammonium chloride, and formaldehyde, glutaraldehyde, to control microbial induced corrosion in oil pipelines. The efficacy of biocides were monitored against Desulfovibrio vulgaris and Desulfovibrio gigas in experimental pipes by measuring cell counts, H2S production, Fe(II) production, production of extracellular polymeric substances and structure of biofilm. The treatment with cow urine had minimum planktonic cell counts of 3 102 CFU/mL as well as biofilm cell counts of 9 101 CFU/mL as compared with tetrakishydroxyl methyl phosphonium sulfonate, benzyl trimethyl ammonium chloride, formaldehyde and glutaraldehyde. Sulfide production was the lowest with cow urine (0.08 mmol/L), followed by tetrakishydroxymethyl phosphonium sulfonate 0.72 mmol/L. On day 90 of treatment, Fe(II) production was also found to be the lowest with cow urine. The scanning electron microscopic studies indicated that the biofilm bacteria were killed by cow urine. These results demonstrate the cow urine mediated control of microbially induced corrosion, and this is indicative of its potential as a viable substitute of toxic biocides. To the best of our knowledge, this seems to be the first report which screens possible biocidal activity by cow urine as compared to the most common biocides which oil industry is currently using.