矿用聚氨酯注浆材料阻燃及加固性能研究

为获得压缩强度和阻燃性能兼顾的聚氨酯注浆材料,通过L9(34)正交试验,研究Mg(OH)2含量、甲基膦酸二甲酯(DMMP)含量、异氰酸酯指数、辛酸亚锡含量对聚氨酯注浆材料的阻燃性能及压缩性能的影响。获得这种聚氨酯注浆材料的最佳制备条件。对比分析最佳制备条件试样及不加阻燃剂试样的热稳定性。结果表明:DMMP含量和Mg(OH)2含量对平均燃烧时间影响显著;Mg(OH)2还有补强加固作用,对压缩强度影响最为显著,其次为异氰酸酯指数。在Mg(OH)2,DMMP,辛酸亚锡质量分数分别为16%,24%和0.4%,异氰酸酯指数为1.10时,聚氨酯注浆材料兼顾阻燃性能和压缩性能,平均燃烧时间为13.9 s,压缩强度为19 MPa,其热稳定性明显优于不添加阻燃剂样品。     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

A multilevel investigation of predictors and outcomes of shared leadership

For modern organizations, shared leadership becomes increasingly important. Knowledge on shared leadership may be limited, as past research often relies on cross-sectional data or student samples, and most studies neglect the multilevel nature of shared leadership. Our research model includes transformational leadership, trust, and organizational support as predictors of shared leadership. Furthermore, we analyze the influence of shared leadership on team performance and team creativity. In total, 160 teams with 697 employees participated in our field study. Data collection took place at three time points. To test our hypotheses, we used multilevel modeling with a Bayesian estimator. We found relationships of transformational leadership and trust with shared leadership at the team level and of transformational leadership, trust, and organizational support with shared leadership at the individual level. Furthermore, shared leadership fully mediated the effect of the three input factors on team performance and team creativity. This study contributes to the understanding of the antecedents and outcomes of shared leadership. Furthermore, the dynamic development of team processes based on an input–mediator–output model is explored. On the basis of the results, organizations can increase shared leadership behavior by focusing on transformational leadership and trust building.     

On the search for mimetic patterns in environmental disclosure: an international perspective

In this paper, we assert and test the proposition that environmental disclosure (ED) is structured by institutionalised myths and that is why ED is decoupled from environmental performance and media pressures. Focusing on firms from Canada, France and Germany, findings show that ED mimetic isomorphism for different topics varies among countries and by industry sensitiveness to the environment. The results corroborate the institutional presumption that institutionalised myths vary among different contexts. Our findings also suggest that institutionalised ED structures may not reflect environmental performance, mimetic patterns being affected by environmental performance. However, the decoupling between ED mimetic isomorphism and environmental performance decrease when firms’ ED credibility is questioned by the media.     

The impact of coal and non-coal consumption on China's energy performance improvement

China is the world's largest energy consumer, and coal accounts for a higher proportion of the country's total energy consumption, yet during its 12th five-year plan (2011–2015), the coal share among total energy consumption significantly decreased. Previous studies exploring energy performance typically used energy consumption as an input, but this lacks the analytical capacity for the structure of energy consumption. Thus, this study splits energy input into two different inputs, coal consumption and non-coal energy consumption, and based on their differences with other variables, uses the hybrid dynamic data envelopment analysis model to assess the energy performance of China's provincial industrial sector during the period 2011 to 2015. We then compare coal consumption's and non-coal consumption's rooms for improvement and conclude that provinces in eastern and central China should reduce the amount of coal consumption, thereby improving energy performance. Conversely, provinces in the western region should target a balance between energy utilization efficiency and coal consumption.     

Performance-based earthquake evaluation of a full-scale petrochemical piping system

Assessment of seismic vulnerability of industrial petrochemical and oil & gas piping systems can be performed, beyond analytical tools, through experimental testing as well. Along this line, this paper describes an experimental test campaign carried out on a full-scale piping system in order to assess its seismic behaviour. In particular, a typical industrial piping system, containing several critical components, such as elbows, a bolted flange joint and a Tee joint, was tested under different levels of realistic earthquake loading. They corresponded to serviceability and ultimate limit states for support structures as suggested by modern performance-based earthquake engineering standards. The so called hybrid simulation techniques namely, pseudo-dynamic and real time testing with dynamic substructuring, were adopted to perform seismic tests. Experimental results displayed a favourable performance of the piping system and its components; they remained below their yielding, allowable stress and allowable strain limits without any leakage even at the Near Collapse Limit State condition for the support structure. Moreover, the favourable comparison between experimental and numerical results, proved the validity of the proposed hybrid techniques alternative to shaking table tests.     

E-bikers’ braking behavior: Results from a naturalistic cycling study

Abstract

Objective: The number of e-bike users has increased significantly over the past few years and with it the associated safety concerns. Because e-bikes are faster than conventional bicycles and more prone to be in conflict with road users, e-bikers may need to perform avoidance maneuvers more frequently. Braking is the most common avoidance maneuver but is also a complex and critical task in emergency situations, because cyclists must reduce speed quickly without losing balance. The aim of this study is to understand the braking strategies of e-bikers in real-world traffic environments and to assess their road safety implications. This article investigates (1) how cyclists on e-bikes use front and rear brakes during routine cycling and (2) whether this behavior changes during unexpected conflicts with other road users.

Methods: Naturalistic data were collected from 6 regular bicycle riders who each rode e-bikes during a period of 2 weeks, for a total of 32.5?h of data. Braking events were identified and characterized through a combined analysis of brake pressure at each wheel, velocity, and longitudinal acceleration. Furthermore, the braking patterns obtained during unexpected events were compared with braking patterns during routine cycling.

Results: In the majority of braking events during routine cycling, cyclists used only one brake at a time, favoring one of the 2 brakes according to a personal pre-established pattern. However, the favored brake varied among cyclists: 66% favored the rear brake and 16% the front brake. Only 16% of the cyclists showed no clear preference, variously using rear brake, front brake, or combined braking (both brakes at the same time), suggesting that the selection of which brake to use depended on the characteristics of the specific scenario experienced by the cyclist rather than on a personal preference. In unexpected conflicts, generally requiring a larger deceleration, combined braking became more prevalent for most of the cyclists; still, when combined braking was not applied, cyclists continued to use the favored brake of routine cycling. Kinematic analysis revealed that, when larger decelerations were required, cyclists more frequently used combined braking instead of single braking.

Conclusions: The results provide new insights into the behavior of cyclists on e-bikes and may provide support in the development of safety measures including guidelines and best practices for optimal brake use. The results may also inform the design of braking systems intended to reduce the complexity of the braking operation.     

HUD状态下飞行员视觉注意资源分配机制研究

为了解决平视显示器（Head Up Display,HUD）飞行中的注意资源分配问题，基于飞行模拟器，设计双作业飞行任务开展相关研究。基于事件相关电位（Event Related Potential，ERP）技术，选取行为绩效和P300成分为评价指标，采用oddball模式，在双作业飞行任务条件下开展实验研究。结果表明:随主任务难度的增加，主、辅任务的作业绩效均显著下降，被试者对HUD上异常信息的正确操作率降低，且反应时间延长；随主任务难度的增加，由辅任务所诱发的P300的波幅显著降低。在实验结果的基础上，最终提出了HUD状态下飞行员视觉注意资源分配机制。     

飞行员人因可靠性定量预测

为有效预测飞行员的人因可靠性,以保障飞行安全,基于认知可靠性与失误分析法(CREAM)的扩展法,建立飞行员人因可靠性定量预测模型。依据飞行员的任务特点,调整认知行为及认知功能。通过优化共同绩效条件(CPC)因子水平等级,并增加新的因子,改进CPC因子依赖规则,用于修正因子的初始评估结果,解决扩展法未考虑因子间关系的问题,从而完成模型的建立。利用回看分析法验证模型的有效性,采用所建立的模型和扩展法分别对已发生的飞行案例进行预测,并与实际发生结果对比分析。结果表明,与扩展法相比,采用飞行员定量预测模型得到的预测结果与案例发生结果所反映的控制模式更为匹配。     

Driver’s mental workload prediction model based on physiological indices

Developing an early warning model to predict the driver’s mental workload (MWL) is critical and helpful, especially for new or less experienced drivers. The present study aims to investigate the correlation between new drivers’ MWL and their work performance, regarding the number of errors. Additionally, the group method of data handling is used to establish the driver’s MWL predictive model based on subjective rating (NASA task load index [NASA-TLX]) and six physiological indices. The results indicate that the NASA-TLX and the number of errors are positively correlated, and the predictive model shows the validity of the proposed model with an R² value of 0.745. The proposed model is expected to provide a reference value for the new drivers of their MWL by providing the physiological indices, and the driving lesson plans can be proposed to sustain an appropriate MWL as well as improve the driver’s work performance.