城市污水厌氧氨氧化工艺的菌群分析与效能评估

厌氧氨氧化（Anammox）是一种高效低耗的新型生物脱氮技术,在城市污水处理中具有广阔的应用前景.在城市污水脱氮系统中,厌氧氨氧化菌（AnAOB）是否存在、丰度如何及Anammox脱氮效能如何,是进行Anammox评估的重要指标.本研究重点介绍了在生物脱氮系统中进行AnAOB菌种测定和菌群结构分析的分子生物学技术及Anammox脱氮贡献率的计算方法 .结果发现,对于AnAOB的菌种测定和菌群结构分析,可采用实时荧光定量聚合酶链锁反应（qPCR）、16S rRNA高通量测序和宏基因组测序等分子生物学技术;Anammox脱氮贡献率可通过物料衡算法和¹⁵N同位素示踪法计算.同时,对这些评估方法存在的一些局限性也进行了阐述.总体而言,如何科学、有效、全面地评估Anammox在生物脱氮系统中发挥的作用仍是一个需要长期探究的课题.但随着相关研究的不断深入,检测手段和分析方法也会得到不断优化,这将为Anammox工艺的理论研究及工程应用提供重要支持.     

Mechanical properties of Municipal Solid Waste by SDMT

In the paper the results of a geotechnical investigation carried on Municipal Solid Waste (MSW) materials retrieved from the “Cozzo Vuturo” landfill in the Enna area (Sicily, Italy) are reported and analyzed. Mechanical properties were determined both by in situ and laboratory large-scale one dimensional compression tests.While among in situ tests, Dilatomer Marchetti Tests (DMT) is used widely in measuring soil properties, the adoption of the DMT for the measurements of MSW properties has not often been documented in literature. To validate its applicability for the estimation of MSW properties, a comparison between the seismic dilatometer (SDMT) results and the waste properties evaluated by laboratory tests was carried out.Parameters for “fresh” and “degraded waste” have been evaluated. These preliminary results seems to be promising as concerns the assessment of the friction angle of waste and the evaluation of the S-wave in terms of shear wave velocity. Further studies are certainly required to obtain more representative values of the elastic parameters according to the SDMT measurements.     

工业发展与环境污染关系的区域差异分析--基于江苏省的实证研究

利用格兰杰因果关系检验（Granger causality tests）方法分析了江苏省处在不同发展阶段的三大区域的工业经济增长和环境污染之间双向作用关系。研究结果表明：经济发展水平越高,工业经济增长对环境污染的影响越明显,并且持续时间长,在某种程度上环境污染已经成为受工业经济增长影响的内生变量;江苏省三大区域环境污染都不是工业经济增长的原因,环境污染的加重并不能带来工业经济的增长,因此,在实践中靠牺牲环境来换取经济增长的理念是不可取的,＂先污染后治理＂的发展思路是不可行的。     

聚氨酯型固沙剂改性土室内试验研究

对自主研发的PUA、PUB和PUC 3种聚氨酯型固沙剂改性土的强度、抗冲刷性、抗风蚀性等性能进行了室内试验研究,并结合聚氨酯分子结构和功能对固沙剂改良原理进行了分析。试验结果表明:3种聚氨酯型固沙剂改性土的无侧限抗压强度、内聚力得到了提高,抗冲刷和抗风蚀性能得到了明显增强;3种固沙剂改性土的无侧限抗压强度和内聚力均随着固沙剂浓度的增加而增大;PUA、PUB和PUC浓度为3g/cm3的改性土试样的冲刷率分别只有4.4%、14.7%和0.6%,而参照样高达79.5%;PUA、PUB和PUC浓度达到1g/cm3以上的改性土风蚀后表面保持完整,没有风蚀破坏痕迹。因此,聚氨酯型固沙剂可以很好地增强土体粘聚力、促进表层固化、减少水土流失,可用于坡面防护、水土保持、防尘固沙、沙漠化治理等领域。     

WAVE INDUCED FLOW AND TRANSPORT IN SEDIMENT BEDS1

ABSTRACT: The fate of contaminants in large water bodies is highly influenced by the transfer of flow and solutes across the water sediment interface. In this paper, an analytical model is presented where flow in both sediment bed and open channel is coupled at the interface through a boundary layer occupying the upper part of the sediment bed. The presence of this layer allows not only the capture of the inertia effects through a drag term in the generalized Darcy's equation, but also the specification of different soil parameters for the two porous zones. The flow is advective and driven by wave action along the water surface. The resulting system is solved for the pressure and flux in each sediment layer. The generated transport velocity fields are linked to a random walk simulation that is used to examine the trajectories of solute particles. Comparison of these trajectories against experimental tracer tests suggests a pattern very similar to the one attributed to the presence of surface mounds. The results clearly show the significance of the boundary layer and the drag term for soil with high permeability and the impact of both the thickness of the boundary layer and the length of the gravity wave relative to the depth of the water channel on the transport and exchange across the interface. The paper also examines the sensitivity of the mass exchange to the permeability of the two porous zones.     

ON PRECIPITATION SENSOR NETWORK DENSITIES FOR EVALUATING WINTERTIME OROGRAPHIC CLOUD SEEDING EXPERIMENTS1

Principal component analysis is used to investigate density requirements of wintertime orographic cloud seeding experiment precipitation sensor networks. Three passes in the vicinity of Climax, Colorado are studied. The eighteen or more evenly spaced precipitation sensors of each pass are almost completely described by three principal components. These three principal components appear to represent (i) mean precipitation, (ii) slope orientation to storm systems, and (iii) elevation. Evaluation of these principal components is implemented with two distribution-free tests, a proportionality test and the runs test. The results of this study suggest that the loss of experimental information caused by low density precipitation sensor networks may be of little consequence.     

OBSERVATION WELL NETWORK DESIGN FOR PUMPING TESTS IN UNCONFINED AQUIFERS1

ABSTRACT: This paper presents a method for determining locations of observation wells to be used in conducting pumping tests in unconfined aquifers. Sensitivity coefficients, the distribution of relative errors, and the correlation coefficients between four aquifer parameters (horizontal and vertical hydraulic conductivities K_r and K_z, storage coefficient S, and specific yield S_y) are used as the criteria for the design of observation well networks and the interpretation of pumping tests. The contours of the relative errors over a vertical profile are very useful in selecting the “best” location of an observation well. Results from theoretical analyses suggest that a wide range of locations is suitable for the determination of K_r and that good locations for the determination of K_z and S may be poorly suited for the determination of S_y. Consideration must be given to the position and lengths of the pumping well screen in the selection of observation well locations. For a given location, the quality of test data can be improved by using high pumping rates and frequent sampling of drawdowns. We found that a minimum of two and preferably three observation locations are needed along a given transect. Results of the four parameters from a single well analysis may contain higher uncertainties. However, composite analyses of multiple observation wells can reduce the correlation between the four aquifer parameters, particularly between K_r and S_y, thus, improving the quality of parameter estimation. Results from two pumping tests conducted at sites located in Nebraska were examined with regard to the proposed methodology.     

军用地面装备加固液晶显示器环境适应性研究

通过对9家军用加固液晶显示器的环境适应性比对试验,归纳分析了各家产品对温度、振动、冲击、湿度、盐雾等环境的适应能力,提出改进措施建议,为产品设计人员和军方采办提供参考。     

萼花臂尾轮虫毒性试验的方法学研究

为尝试以群体取代个体作为轮虫室内毒性试验目标物的可行性,本项研究以萼花臂尾轮虫(Brachionus calyciflorus)作为实验生物开展相关实验,建立生命表并确定接种密度对于种群生长率的影响,并且用3种农药(毒死蜱、丁草胺、三唑酮)开展了轮虫毒性试验。生命表实验结果表明,轮虫的平均寿命和世代周期分别为(78.76±33.08)h和(51.56±20.55)h。接种密度实验结果表明,随着接种密度的提高,轮虫种群增长率呈下降趋势。基于接种密度实验的结果,毒性试验以35个·(100 m L)-1作为受试种群的起始密度,试验周期定为144 h。毒性试验结果显示,毒死蜱对轮虫的96 h-EC50和120 h-EC50分别为0.6066 mg·L-1和0.7323mg·L-1;丁草胺对轮虫的96 h-EC50和120 h-EC50分别为1.851 mg·L-1和3.058 mg·L-1;三唑酮对轮虫的96 h-EC50和120 h-EC50分别为12.84 mg·L-1和11.63 mg·L-1。本项研究的结果肯定了以群体取代个体作为轮虫室内毒性试验目标物的可行性。     

非耐短路变压器短路和过载保护试验的自动测试系统

针对变压器产品认证标准GB 19212.1(IEC 61558-1)中关于"短路和过载保护"的型式试验项目,研发了一套智能自动测试系统。对于两种类型的非耐短路变压器,即输入保护和输出保护类型,分别给出了系统软硬件配置和详细的测试操作流程。相比传统手动测试方式,该系统的应用可显著减少人员在线时间,同时降低人工测量环节的不确定度。