垃圾渗滤液处理工艺改进的研究

针对武进夹山垃圾填埋场渗滤液处理工艺设计及运行过程中存在的问题 ,提出了厌氧与SBR 混凝法相结合的渗滤液处理工艺改进方案。研究表明 :SBR及混凝处理的CODCr最大降解率分别达 4 2 5 %、6 3 0 % ,SBR法正交试验得出的最佳工艺条件是 :曝气时间 30h ,闲置时间 6h ,污泥浓度 5 0mg L ;化学混凝对SBR法处理的出水有较好处理效果 ,其最佳进水pH值应控制在 9 0左右。最后 ,结合填埋场现有的处理工艺及运行现状 ,对处理工艺改进方案进行了讨论。     

Toward a green economy: The nexus between economic and environmental factors in MENA countries,ARDL bounds approach

With the transition of the global economy toward a green economy, it is important to analyze the elements that can either support or impede this transformation. Therefore, in this study, we aimed to evaluate the potential of the green economy in the Middle East and North Africa (MENA) countries by analyzing the correlation between economic and environmental factors. The objective of this study is to explore the potential of the green economy in MENA countries by analyzing key factors such as access to clean fuel, GDP, and CO₂ emissions. The study aims to distinguish between long- and short-term effects, assess the presence of a long-run relationship or co-integration between the parameter estimates, and evaluate the progress of MENA countries toward a green economy based on the impact of economic, and environmental factors. Using quarterly and seasonally adjusted data from 2000 to 2018, the auto-regressive distributed lag (ARDL) technique was employed to examine the co-integration of the factors in the long and short terms. Multiple cointegration techniques were also used to determine the feasibility of a green economy by analyzing the relationship between access to clean fuel for technology and cooking, GDP, and CO₂ emissions. The study's findings indicate a clear long- and short-term relationship between the analyzed factors, as confirmed by the error correction model (ECM) which suggests that the variables are cointegrated and potentially relevant. Additionally, the result of the autoregressive distributed lag bound test shows that the green economy variables, GDP, CO₂ emissions, and access to clean fuel, are cointegrated in the long-term.     

Toxic substances: Measures and measurements†

The formulation of a sound policy for environmental protection and toxic substances control requires knowledge of the presence and concentration of environmental contaminants. For this reason monitoring programs have been set up in the Netherlands for water, drinking water, and air pollution. The Netherlands system for air pollution, monitoring of the substances SO2, NOχ, CO, O₃ is now fully automated. Some examples will be given to show the acquisition and management and interpretation of air pollution measurements.

Various smaller projects, supported by the Department of Health and Environmental Protection include measurement of indoor air‐contaminants, contaminants in soil and hazardous waste sites, and contaminants in biotic samples such as for instance PCB's in eels and seals and mussels. Moreover a Coordinating Committee regularly collects measurements from various sources in the Netherlands regarding pesticide residues and contaminants in food.

For cost‐effective monitoring the accuracy of the measurements must be chosen with regard to the biological effect concentration of the pollutant. The necessity of proper control measurements to establish background levels and the necessity of ring‐tests to increase interlaboratory reproducibility is discussed. In cost‐effective monitoring the minimum number of measurements, which are necessary to check the effect of environmental protection measures, must be defined through proper sampling.     

3种克藻物质对蛋白核小球藻（Chlorella pyrenoidose）的组合抑制效应

通过世界经合组织推荐的藻类生长抑制实验方法,对气相色谱一质谱联机鉴定出的3种克藻物质进行对蛋白核小球藻的克藻效应的组合实验,得出棕榈酸＋琥珀酸、棕榈酸＋琥珀酸＋乙酸丁酯,这两种组合对蛋白核小球藻的克藻效应为协同作用;棕榈酸＋乙酸丁酯、琥珀酸＋乙酸丁酯组合出现拮抗作用。光学显微镜照片显示,克藻物质组合作用后,蛋白核小球藻...     

Performance on a Work-Simulating Firefighter Test Versus Approved Laboratory Tests for Firefighters and Applicants

Aim. Firefighters must meet minimum physical demands. The Norwegian Labour Inspection Authority (NLIA) has approved a standardised treadmill walking test and 3 simple strength tests for smoke divers. The results of the Trondheim test were compared with those of the NLIA tests taking into account possible effects of age, experience level and gender. Methods. Four groups of participants took part in the tests: 19 young experienced firefighters, 24 senior male firefighters and inexperienced applicants, 12 male and 8 female. Results. Oxygen uptake (V_O2) at exhaustion rose linearly by the duration of the treadmill test. Time spent on the Trondheim test was closely related to performance time and peak V_O2 on the treadmill test. Senior experienced firefighters did not perform better than equally fit young applicants. However, female applicants performed poorer on the Trondheim test than on the treadmill test. Performance on the Trondheim test was not closely related to muscle strength beyond a minimum. Conclusion. Firefighters completing the Trondheim test in under 19 min fit the requirements of the NLIA treadmill test. The Trondheim test can be used as an alternative to the NLIA tests for testing aerobic fitness but not for muscular strength. Women’s result of the Trondheim test were poorer than the results of the NLIA treadmill test, probably because of their lower body mass.     

EFFECTS OF TOPOGRAPHY AND SOIL PROPERTIES ON RECHARGE AT TWO SITES IN AN AGRICULTURAL FIELD1

ABSTRACT: Field experiments were conducted from 1992 to 1995 to estimate ground water recharge rates at two sites located within a 2.7‐hectare agricultural field. The field lies in a sand plain setting in central Minnesota and is cropped continuously in field corn. The sites are located at a topographically high (upland) site and a topographically low (lowland) site in an effort to quantify the effects of depression focusing of recharge. Three site‐specific methods were used to estimate recharge rates: well hydrograph analysis, chlorofluorocarbon age dating, and an unsaturated zone water balance. All three recharge methods indicated that recharge rates at the lowland site (annual average of all methods of 29 cm) exceeded those at the upland site (annual average of 18 cm). On an annual basis, estimates by the individual methods ranged from 12 to 44 percent of precipitation at the upland site and from 21 to 83 percent at the lowland site. The difference in recharge rates between the sites is primarily attributed to depression focusing of surface water runon at the lowland site. However, two other factors were also important: the presence of thin lamellae at the upland site, and coarser textured soils below a depth of 1.5 m at the lowland site.     

Swelling related to ettringite crystal formation in chromite ore processing residue

Several million tons of Chromite Ore Processing Residue (COPR) were deposited at two sites in New Jersey and Maryland, USA, and over time they exhibited extensive heaving phenomena. Ettringite, a needle-shaped mineral and an expansive mineral commonly recognized in the literature concerning cement- and soil, has been identified extensively in numerous COPR samples collected from these sites. It was therefore believed that ettringite formation and its crystal growth are strongly associated with COPR heaving. We investigated the correlation between ettringite and the heaving phenomena in COPR materials that contained no initial ettringite. Two identical COPR samples were exposed to a 4% w/w sulfate solution (25°C, 50°C) in a confined swell test apparatus. Both swell test samples were analyzed by means of X-ray powder diffraction. The peak intensities of newly formed ettringite were more pronounced in the sample tested at 50°C, and swell development was only observed in this sample. Scanning electron microscopy analyses revealed well-crystallized ettringite needles exceeding 40 μm in length for this sample, while ettringite crystals less than 15 μm in length formed in the sample tested at 25°C. Therefore, the results suggest that the quantity of ettringite and the extent of crystallization play a key role in the heave of COPR.     

The use of physiological characteristics for comparison of organic compounds phytotoxicity

The influence of intact (FLT) and photomodified (phFLT) fluoranthene (0.05, 0.5 and 5 μmol l⁻¹) and herbicide Basagran (5, 20, 35 and 50 nmol l⁻¹) on the germination, growth of seedlings and photosynthetic processes in pea plants (Pisum sativum L., cv. Garde) was investigated. The germination was significantly inhibited already by the lowest concentration (0.05 μmol l⁻¹) of FLT and phFLT, while Basagran caused inhibition only in higher concentrations (35 and 50 nmol l⁻¹). The growth of roots was significantly inhibited by higher concentration 5 μmol l⁻¹ of both FLT and phFLT and the shoot of seedlings was significantly influenced only by photomodified form. The length of root and shoot was inhibited already by concentration 5 nmol l⁻¹ of Basagran. Organic compounds applied on chloroplasts suspension influenced primary photochemical processes of photosynthesis. In chlorophyll fluorescence parameters, the significant increase of F₀ values and the decrease of F_V/F_M and Φ_II values by application of FLT (0.5 and 5 μmol l⁻¹) and phFLT (0.05, 0.5 and 5 μmol l⁻¹) was recorded. The maximum capacity of PSII (F_V/F_M) was influenced by the highest (50 nmol l⁻¹) and the effective quantum yield of PSII (Φ_II) already by the lowest (5 nmol l⁻¹) concentration of Basagran. Hill reaction activity decreased and was significantly inhibited by higher concentration (0.5 and 5 μmol l⁻¹) of FLT and phFLT and already by the lowest concentration (5 nmol l⁻¹) of Basagran.     

粘性泥石流运动模型的实验研究

粘性泥石流运动模型的研究因受实验条件的限制,还很不完善。国内外学者应用较多的５种模型都有一定的适用性,但也都存在不同的缺陷。本文应用粘性泥石流土样中的细颗粒和粗颗粒进行流变实验,不仅得到了粗颗粒在浆体中的沉降特性和泥石流体的流变特性,还研究了粘性泥石流运动模型及其参数。所提模型能很好地反映泥石流体的流变特性,较现有的５种模型能更好地描述粘性泥石流。     

基于Arrhenius模型和Peck模型的分段非线性加速模型

目的 解决Arrhenius模型无法估计湿度应力敏感产品和Peck模型试验时间较长的问题。方法 考虑温度应力和湿度应力对产品贮存寿命的综合影响,在产品激活能不变的假设下,将Arrhenius模型对产品激活能的估计和Peck模型对湿度应力参数的估计相结合,建立Arrhenius&Peck分段非线性加速寿命估计模型。基于此模型,在双应力恒加试验条件下,得到产品的寿命估计方程。结果 以弹上电子产品的恒定应力加速贮存试验为例,进行仿真分析,得到产品寿命的估计,并对比产品实际寿命。Arrhenius&Peck模型的寿命误差和失效率误差均控制在5%以内,准确度高于Arrhenius模型和Peck模型。结论 构建的Arrhenius&Peck分段非线性加速寿命模型可以充分利用温度和湿度条件下的试验数据,对温湿敏感产品的寿命估计有较好的应用效果,为导弹产品的寿命估计提供一种可选方法。