大型空间环境模拟器真空系统配置技术研究

分别对国内外大型空间环境模拟器的真空系统配置进行了介绍,并对真空系统各个子系统的配置与技术特点进行了分析,重点针对大型空间环境模拟器真空系统中所需的真空抽气策略进行了研究,为后续超大型环境试验设备的研制和试验测试提供了参考。     

提升汇流环湿热环境适应性方法研究

目的提高汇流环在湿热环境下的适应能力。方法实物解剖,观察汇流环绝缘材料损坏情况、碳粉堆积情况,在不同温度、湿度下测试绝缘材料绝缘度、抗电强度,碳粉堆积和导电情况,比对不同绝缘材料性能,并找出最适合的绝缘材料,比对滚动汇流环、碳刷组件、刷丝组件,找到解决碳粉堆积的方法。结果汇流环受湿热影响会从接缝处和电缆连接处进入湿气,温度、湿度的上升会使得原绝缘材料性能下降,长时间使用汇流环,碳粉会在汇流环内堆积并受到湿热的影响而导电,局部密封汇流环可以减少湿气进入。PPO材料性能优异,可以替换原绝缘材料从而减少湿热的影响,使用刷丝组件替代碳刷可以避免碳粉的产生。结论综合运用局部密封、绝缘材料改进、碳刷组件改进三种措施,可以有效提高汇流环在湿热环境下的适应能力。     

一种模拟动力学边界条件的环境振动试验方法研究

目的提高环境振动试验的可靠性。方法以某典型钛合金蜂窝夹芯壁板试验件为例,提出一种模拟试验件动力学边界条件的试验方法,在试验件周围引入弹性连接件,再通过刚性转接工装与振动台台面连接,以试验件在试验安装状态下的共振频率及振型节线位置为优化目标,以弹性连接件的外形尺寸及厚度为优化变量,对弹性连接件进行优化设计,从而模拟试验件真实的动力学边界条件。结果弹性连接件的优化设计使得试验件在试验安装状态下前两阶共振频率与试验要求相差小于8%,而且振型节线位置与试验要求基本重合,达到了模拟试验件真实动力学边界条件的设计目标。结论对于壁板类试验件,在传统刚性夹具的基础上引入弹性连接件的试验方法,可以较好地模拟试验件真实动力学边界条件,提高环境振动试验的可靠性,并且这种方法对试验费用及试验周期影响较小,具有良好的工程应用前景。     

环境升温过程对常温固化环氧树脂热力学性能的影响

目的提高常温固化环氧树脂体系的高温使用性能。方法采用常温固化剂T31、中温固化剂IPDA以及高温固化剂DDM作为混合固化剂,对E-44型和AG-80型混合环氧树脂体系进行常温固化反应,并分析环境升温过程对固化物热力学性能的影响。通过DMA分析、热变形测量、固化度测试,分别评价室温固化环氧树脂在环境升温过程前后的玻璃化转变温度、热变形量及体系内部的固化反应程度变化,并通过吸水率测试和弯曲强度测试对玻璃纤维布增强常温固化环氧树脂基复合材料的耐湿热性能以及高温条件下的力学性能进行分析。结果环氧树脂常温固化物的tg为85.21℃,经1.5℃/min的平均升温速率加热至90℃之后,该环境升温过程使固化物的固化度增大至92%以上,tg增长为132.06℃的同时热变形温度增大。其复合材料耐湿热性能提高,且100℃时弯曲强度的保持率为65%,对于加热至120℃的环境升温过程,固化物的固化度接近96%,tg增长为144.45℃的同时热变形温度进一步提高,其复合材料耐湿热性能改善程度更加明显,且130℃时弯曲强度保持率仍接近60%。结论常温、中温、高温混合固化剂的合理复配有助于环氧树脂体系在环境升温变化的诱导条件下发生梯度式固化反应,使体系内部的交联固化程度迅速升至较高水平,可以有效提高其玻璃化转变温度,显著改善常温固化环氧树脂体系在高温条件下的热力学性能。     

Monitoring Air Quality in Mountains: Designing an Effective Network

A quantitatively robust yet parsimonious air-quality monitoring network in mountainous regions requires special attention to relevant spatial and temporal scales of measurement and inference. The design of monitoring networks should focus on the objectives required by public agencies, namely: 1) determine if some threshold has been exceeded (e.g., for regulatory purposes), and 2) identify spatial patterns and temporal trends (e.g., to protect natural resources). A short-term, multi-scale assessment to quantify spatial variability in air quality is a valuable asset in designing a network, in conjunction with an evaluation of existing data and simulation-model output. A recent assessment in Washington state (USA) quantified spatial variability in tropospheric ozone distribution ranging from a single watershed to the western third of the state. Spatial and temporal coherence in ozone exposure modified by predictable elevational relationships ( 1.3 ppbv ozone per 100 m elevation gain) extends from urban areas to the crest of the Cascade Range. This suggests that a sparse network of permanent analyzers is sufficient at all spatial scales, with the option of periodic intensive measurements to validate network design. It is imperative that agencies cooperate in the design of monitoring networks in mountainous regions to optimize data collection and financial efficiencies.     

Analysis of pollutant levels in central Hong Kong applying neural network method with particle swarm optimization

Air pollution has emerged as an imminent issue in modernsociety. Prediction of pollutant levels is an importantresearch topic in atmospheric environment today. For fulfillingsuch prediction, the use of neural network (NN), and inparticular the multi-layer perceptrons, has presented to be acost-effective technique superior to traditional statisticalmethods. But their training, usually with back-propagation (BP)algorithm or other gradient algorithms, is often with certaindrawbacks, such as: 1) very slow convergence, and 2) easilygetting stuck in a local minimum. In this paper, a newlydeveloped method, particle swarm optimization (PSO) model, isadopted to train perceptrons, to predict pollutant levels, andas a result, a PSO-based neural network approach is presented. The approach is demonstrated to be feasible and effective bypredicting some real air-quality problems.     

Floristics, performance and prognosis of historical trees in the urban forest of Guangzhou City (China)

Outstanding historical trees embedded in cities constitute pertinent environmental assets, yet they are widely threatened in third-world cities. Inadequate understanding of this valuable natural-cum-cultural heritage hinders proper conservation. A case study of Guangzhou in south China evaluated floristic composition, age profile and biomass structure of historical trees, assessed their performance in major habitats (institutional, park and roadside), and established a prognosis for future growth and management. The 348 historical trees examined belonged to only 25 species, vis-à -vis 254 trees in the entire urban forest, dominated by five species and native members. Roadside had more trees, followed by institutional and park, with merely the most common four species shared by all habitats. The limited commonality reflected tree-performance differentiation by habitats exerting selection pressure on species. The institutional growth-regime was more conducive to nurturing high-caliber specimens, whereas park is less capable. Individual species achievement by habitats, derived from tree-count ranking and relative-abundance indices, could inform species choice and tree conservation. Few trees exceeded 300 years of age in the millennium-old city, echoing a history of intense tree—city conflicts. Potential life-span, trunk and crown diameters indicated ample opportunities for further expansion of biomass and landscape impacts, which would be straitjacketed by the tightening urban fabric.     

阿图什市空气质量变化趋势分析

分析了阿图什市“八五”至“九五”期间空气质量监测数据不同年度、不同季节及不同污染因子的动态变化趋势．结合当地能源结构、气候特征、城市环境综合发展水平，指出影响阿图什市空气质量的主要因素，为防治和减轻阿图什市的空气污染提供了科学依据。     

Distribution of airborne particles from multi-emission source

The purpose of this work was to study the distribution of airborne particles in the surroundings of an iron and steel factory in southern Finland. Several sources of particulate emissions are lying side by side, causing heavy dust loading to the environment. This complicated multi-pollutant situation was studied mainly by SEM/EDX methodology.Particles accumulated on Scots pine bark were identified andquantitatively measured according to their element content,size and shape. As a result, distribution maps of particulateelements were drawn and the amount of different particle typesalong the study lines was plotted. Particulate emissions fromthe industrial or energy production processes were not themain dust source. Most emissions were produced from theclinker crusher. Numerous stockpiles of the industrial wastesand raw materials also gave rise to particulate emissions as aresult of wind erosion. It was concluded that SEM/EDXmethodology is a useful tool for studying the distribution ofparticulate pollutants.     

Trace Metal Concentration in Roadside Surface Soil and Tree Back: A Measurement of Local Atmospheric Pollution in Abuja, Nigeria

Cadmium, copper, lead, nickel and zinc concentrations were analysed by atomic absorption spectrophotometry in surface soil and tree bark from different districts of Abuja, Nigeria, in order to determine the atmospheric trace metal input in the area.Elevated concentrations of some of the studied metals were observed in the soil and tree bark samples from the commercial/high traffic areas of the city compared to backgroundvalues. In soil samples, the average concentration of the metals were 0.6±0.4, 18.0±4.0, 281±39, 16±4 and66±23 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively, whilst the average concentrations in tree bark were 0.3±0.2, 12±4, 133±32, 13±3 and 61±10 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively. The trend in trace metal levels suggested that automobile emissions are a major source of these metals as the highest concentrations of Pb and Zn were recorded in the commercial areas of the city known for their high traffic densities. The levels of metal in the study area were relativelylow compared to levels found in some larger and older cities in various countries worldwide.