一种新型滑动集电材料的研制及性能研究

利用粉末冶金 /挤压的方法制作了一种新型的Cu C滑动集电材料 ,并对该材料的机械物理、摩擦磨损性能进行了检测 ,结果证明该材料具有较高的抗拉强度、适中的表面硬度、较低的电阻率、优良的摩擦磨损性能 ,是一种较为优良的电力机车滑板材料。其性能测试结果和铁道部标准要求相比 ,优于铁道部标准要求。     

金属板料成形摩擦机理研究

对不锈钢板料和碳钢在金属塑性成形时 (高接触压力 )的摩擦机理进行了实验研究 ,分析了压力对滑动阻力和摩擦系数的影响 ,得出了随压力增大摩擦系数逐渐变小的结论 ,从而为应用有限元法进行板料成形过程中塑性变形的计算机模拟提供真实的边界条件打下了基础。     

黄土地基湿陷时桩的负摩阻力最大值出现深度研究

负摩阻力及中性点的定义表明,负摩阻力沿桩身(从桩顶两侧到中性点位置)的变化并不均匀,其间应存在一个最大值,最近的黄土地基浸水湿陷试验证明了这一点。本文利用该试验的资料,从理论上对桩的负摩阻力最大值出现深度进行分析研究,结果表明负摩阻力随深度的变化受到某一深度(如负摩阻力最大值处)以上土体有效重量和该深度桩周土体的有效沉降量这两个主要因素的制约,并由此推导出不同沉降性能土体湿陷时桩的负摩阻力最大值出现的深度。通过与实测资料的对比可见,本文提出的确定桩的负摩阻力最大值出现深度的理论是可信的,由此得到的计算黄土地基湿陷时桩身总的负摩阻力的方法更具合理性。     

Efficiency enhancement in solar air heaters by modification of absorber plate-a review

This paper outlines a complete review on modifications made on the absorber plate of solar air heaters in order to improve the turbulence and heat transfer rate, thereby efficiency. Corrugated sheets, fins, extended surfaces, wire mesh, porous medium, etc., are a few of the modifications used. Most of such alterations in the absorber plate resulted with an increase in efficiency but associated with drawback of increased pumping power due to raising friction factor. Pumping power is considered here as a predominant comparison parameters of various solar air heaters with different absorber plate in terms of effective efficiency.     

Autonomous emergency braking systems adapted to snowy road conditions improve drivers' perceived safety and trust

Objective: This study investigated drivers' evaluation of a conventional autonomous emergency braking (AEB) system on high and reduced tire–road friction and compared these results to those of an AEB system adaptive to the reduced tire–road friction by earlier braking. Current automated systems such as the AEB do not adapt the vehicle control strategy to the road friction; for example, on snowy roads. Because winter precipitation is associated with a 19% increase in traffic crashes and a 13% increase in injuries compared to dry conditions, the potential of conventional AEB to prevent collisions could be significantly improved by including friction in the control algorithm. Whereas adaption is not legally required for a conventional AEB system, higher automated functions will have to adapt to the current tire–road friction because human drivers will not be required to monitor the driving environment at all times. For automated driving functions to be used, high levels of perceived safety and trust of occupants have to be reached with new systems. The application case of an AEB is used to investigate drivers' evaluation depending on the road condition in order to gain knowledge for the design of future driving functions.

Methods: In a driving simulator, the conventional, nonadaptive AEB was evaluated on dry roads with high friction (μ = 1) and on snowy roads with reduced friction (μ = 0.3). In addition, an AEB system adapted to road friction was designed for this study and compared with the conventional AEB on snowy roads with reduced friction. Ninety-six drivers (48 males, 48 females) assigned to 5 age groups (20–29, 30–39, 40–49, 50–59, and 60–75 years) drove with AEB in the simulator. The drivers observed and evaluated the AEB's braking actions in response to an imminent rear-end collision at an intersection.

Results: The results show that drivers' safety and trust in the conventional AEB were significantly lower on snowy roads, and the nonadaptive autonomous braking strategy was considered less appropriate on snowy roads compared to dry roads. As expected, the adaptive AEB braking strategy was considered more appropriate for snowy roads than the nonadaptive strategy. In conditions of reduced friction, drivers' subjective safety and trust were significantly improved when driving with the adaptive AEB compared to the conventional AEB. Women felt less safe than men when AEB was braking. Differences between age groups were not of statistical significance.

Conclusions: Drivers notice the adaptation of the autonomous braking strategy on snowy roads with reduced friction. On snowy roads, they feel safer and trust the adaptive system more than the nonadaptive automation.     

输美轮胎特保案对中国贸易的影响及对策

分析了2009年9月26日美国对中国轮胎进口实施的特别保护措施,运用国际贸易和国际经济学的相关理论,对美国轮胎特保法案进行了剖析。在目前中美轮胎贸易情况下,从宏观和微观的角度探讨了轮胎贸易顺差形成的原因,以及长期和短期内对中国经济的影响,并对中国轮胎出口贸易提出了几点政策建议。     

Evaluation of two models of a slipmeter

The aim of the study was to compare the performances of the Brungraber Mark II (BM II) and Mark III (BM III) slipmeters. Friction measurements with the two slipmeters were conducted in a laboratory using four footwear materials, four floor types, and three surface conditions. Both the coefficient of friction (COF) values obtained with the slipmeters and the force platform-based COF values were measured. The COF measured with the BM II was slightly higher than that measured with the BM III with a R² of 0.83. A comparison of the averaged normal force between the two slipmeters showed that the BM II generated a significantly higher normal force than the BM III at a low COF and the difference of the normal force between the two slipmeters decreased when the COF value was increased. The regression analysis results in this study showed that the force platform-based COF values were closer to the COF values obtained with the BM III than with the BM II. The R² values for the regression model between the COF values obtained from the slipmeter and the force platform were 0.90 and 0.79 for the BM II and BM III, respectively.     

Downward Migration of Dense Bottom Currents

The focus of this paper is on the dynamics of a dense current flowing along the continental slope, and the frictionally induced downward motion it experiences. In particular, the movement of the lateral boundaries where the isopycnals meet the bottom are considered. The current is taken to be wide compared to the Rossby radius, which is in accordance with observations and makes the dynamics quasigeostrophic. The time development of the plume thickness is studied, using three different parameterisations for the bottom friction.Independently of the choice of parameterisation, the following results are obtained: In the central part of the plume friction acts as a diffusive process to minimise the curvature of the upper surface of the plume. At the upper edge the plume quickly approaches a state with small slope, i.e. small geostrophic velocity and small frictionally induced downward flow. At the lower edge a tongue of dense water shoots out creating a widening layer. The thickness of the migrating layer is approximately equal to the boundary layer depth and its downward speed is comparable to the along-slope geostrophic velocity. The downslope end of the migrating layer may form a steep front which requires some precautions in the numerical procedure.     

基于BP神经网络的矿车运行时矿井摩擦阻力的预测*

为了快速有效地确定矿车等运输设备在巷道内运行时矿井摩擦阻力的变化情况,克服模拟软件计算量和现场实测工作量大的问题,以巷道风流速度、矿车运行速度、阻塞比、矿车长度4个矿车运行时巷道摩擦阻力的影响因素作为切入点,采用动网格技术模拟得到矿车在巷道内运行时有关矿井摩擦阻力的数据,以此为样本构建基于BP神经网络的矿井摩擦阻力预测模型,运用MATLAB软件进行网络训练,并将BP神经网络预测值与FLUENT模拟值进行对比。研究结果表明:BP神经网络结构比较简单,能以较快速度收敛,预测值与模拟值最大误差在7%以内,该神经网络模型用于求解矿车等运输设备在巷道内运行时摩擦阻力的变化情况是可行的。     

沥青涂层对桩侧摩阻力影响的试验研究

采用改进直剪仪模拟桩与土之间的滑动摩擦,研究了沥青涂层对桩侧摩阻力的影响。试验结果表明,桩侧摩阻力与土的类型、法向应力有关,随着法向应力的增长,滑动摩阻力也相应增长,且增长近似呈线性关系;在一定的法向应力下,沥青涂层对减小滑动摩阻力有一定的作用,随着法向应力的增长,沥青涂层亦会导致滑动摩阻力增加。