光离子化检测器便携式气相色谱仪快速测定水中苯系物

本文研究了使用光离子化检测器便携式气相色谱仪，在环境温度下手工摇荡的快速顶空法测定水中苯系物（苯、甲苯、乙苯、邻、间、对位的二甲苯及异丙苯）的分析方法。方法的线性范围为０～１８０μｇ／Ｌ，相关系数均在０．９９６以上，方法的变异系数分别为１．０～１４％（１０μｇ／Ｌ），２．９～７．８％（３０μｇ／Ｌ），方法的最低检测限达０．５～１．５μｇ／Ｌ。     

污染源废气中氟的监测方法研究

本文叙述了有组织废气中氟化物的测定方法。该法用碱性滤膜捕集氟化物，使现场操作大为简化，并使精密度和准确度都比溶液吸收法有较大改善。本文给出了方法的研究结果，最后给出方法的操作程序     

气相色谱法测定废水中的茚及芳烃混合物

本文采用气相色谱法，选择中等极性的Ｔｒｉｃｒｅｓｙｌｐｈｏｓｐｈａｔｅ与高沸点的非极性ＡｐｉｅｚｏｎＬ配成混合固定液，测定工业废水中的茚及芳烃混合物。该方法灵敏度高，再现性好，简便快速，适合测定化工、制漆、制茚树脂生产所排放的废水，同时也能检出受苯系物及高沸点的不饱合物萘等多组分污染的水体     

饮用水反硝化脱氮方法研究

为去除饮用水中的硝酸盐氮(NO3ˉ-N)，采用上流式厌氧污泥床(UASB)反应器和固定化微生物进行异养反硝化；自制固定化反硝化菌涂层电极和生物电化学脱氮装置，并用于自养反硝化。试验结果表明。若以甲醇为碳源。当碳氮比(C／N)≥1．o时，室温下经UASB处理4h，NO3ˉ-N去除率为97．7％；若以乙酸为碳源。当C／N≥1．0时，30C下经固定化微生物处理6h，N03ˉ-N去除率为98．6％；在无外加碳源的条件下处理东湖现场水样，30C下经60h后。N03ˉ-N去除率达93．5％。生物电化学脱氮装置可迅速建立自养反硝化菌所需的厌氧环境，水样在室温下经72h处理，脱氮率达96．3％。     

低床层烟炱吸附法脱硫试验及机理探讨

研究了以锅炉烟气沉降物为吸附剂的烟炱吸附法脱除SO2的工艺条件，结果表明该法较适宜的工艺条件为SO2浓度小于2400mg/L,烟气流速小于36m/h，烟气温度低于100℃，此时脱硫效率可达30％以上。初步探讨了烟炱吸附法脱硫的作用机理。     

过滤捕集法处理含DEP雾废气的研究

为了探讨玻璃纤维过滤器处理含DEP雾废气的效率问题,在实验室进行了DEP雾去除实验。考查了不同气体入口浓度、过滤流速下玻璃纤维过滤捕集装置对含DEP雾废气的净化能力,结果表明:利用玻璃纤维过滤器去除DEP雾,在DEP雾粒径主要分布为0.48～3.4μm之间,DEP雾浓度小于220 mg/m3,过滤流速小于10 cm/s情况下,玻璃纤维过滤器对DEP雾的去除率大于99%,最大气体流量下的压力降小于1610Pa;同时对含油(酸)雾废气除雾效果好,特别是对于粒径特别细微的油(酸)雾,捕集效率也很高,还可回收利用,不会产生二次污染。     

小型炭素焙烧炉沥青烟气净化技术初探

阐述了颗粒层吸附技术在小型炭素焙烧沥青烟气净化中的应用。     

现代电化学技术与环境保护

介绍了电化学技术在清洁工艺的开发、清洁产品的制备、废水与废气的处理、被污染土壤的修复和环境污染物监测方面的应用情况。电化学技术具有能量利用率高、经济实用以及污染物产生量少或污染物去除率高等特点，在环境保护领域具有广阔的应用前景。     

黄磷尾气现场脱硫试验

黄磷尾气的主要成分是CO，其中含硫杂质主要以硫化氢的形式存在。测定了黄磷尾气中硫化氢、氧气的含量，分别采用吸收、吸附工艺及其组合工艺对黄磷尾气进行了现场脱硫试验，得出了最佳的黄磷尾气净化脱硫工艺，即吸收、活性炭变温吸附。出口气中H2s的质量浓度为1—5mg/m^3，净化效率达到99．7％。     

Drying of granulated wood ash by flue gas from saw dust and natural gas combustion

At the district heating plant of Kalmar, Sweden an on-line unit for production of granulated wood ash for nutrient recycling on forest soils is being applied. Currently, the granules are dried by hot air from an oil-fired burner. The objective of this work was to investigate how drying by flue gas affects the hardening of granules, or impacts their chemical composition and properties. Ninety-six granule samples were treated by flue gas from natural gas combustion in a laboratory pilot scale flue gas generator. CO₂, CO, O₂, C₃H₈ and NO concentrations were varied during the experiment. Additionally, some samples were treated by flue gas from combustion of sawdust at the heating plant in Kalmar. Drying by flue gases did not affect the chemical composition of granules, but minor effects were seen in their mineralogy. The carbonate content was slightly higher in granules treated with flue gas from natural gas combustion compared to the granules dried by hot air only, when measured by wet chemical methods. Results from XRD analysis imply that the calcite content is higher and the portlandite and arcanite content slightly less in granules treated with flue gas from sawdust combustion compared to the granules dried by hot air only. The results from this investigation showed no negative effects on ash granule composition or physical structure by the use of a flue as a drying medium.