密封充氢环境条件下固态电化学氢气传感器效应试验研究

目的研究密闭充氢环境下固态电化学氢气传感器效应。方法设计能模拟低氧、低氢和压力变化的密闭充氢环境,并在此环境中进行一系列氢气传感器效应试验,分析、评定试验数据。结果得到了不同环境下氢气、氧气浓度随时间变化的规律,提出固态电化学氢气传感器的有效工作环境,并预测了其在不同贮存环境下的工作寿命。结论密闭充氢环境内压力和温度的变化对固态电化学氢气传感器影响较大,湿度影响较小,注气检定合格的氢气传感器,在密封容器内扩散式检定,不合格率高,检定数据误差大于±5%FS。     

Effects of typical additives on the thermal stability of ammonium peroxydisulfate

Ammonium peroxydisulfate (APS), one of the most widely used inorganic peroxides in the process industries, is a thermally unstable peroxide and potent oxidizer due to the presence of peroxy bond in the molecule and is incompatible with most substances. To investigate the effect of typical additives on the thermal decomposition of APS, in this paper, diamine phosphate (DAP), monoamine phosphate (MAP), and aluminum hydroxide (AH) were selected as additives; pure APS and samples with 10 wt% and 20 wt% of additives were first tested by differential scanning calorimetry (DSC). The experiments and analysis showed that the samples with 10 wt% of additive had better thermal stability than those with 20 wt% of additive. After screening, the three groups of 10 wt% AH, 10 wt% MAP, and 20 wt% MAP additive conditions could be considered to have a better thermal stability effect on the thermal decomposition of APS. Four groups of samples were, in turn, tested by Phi-Tec II. The adiabatic results showed two discontinuous exothermic processes; 10 wt% AH promoted the weak exothermic effect in the first stage. In contrast, the three groups of additives in the main exothermic stage showed different degrees of inhibition, and the inhibiting effect was ranked as 10 wt% AH, 10 wt% MAP, and 20 wt% MAP in order. Finally, the self-accelerated decomposition temperature (SADT) was calculated under the 25 kg standard package. The adiabatic results, including SADT, were combined to render feasible recommendations for the use of additives, which provides references for the packaging and transportation of additives and their applications.     

氧化硫硫杆菌固定化菌球制备及其耦合填料去除H2S

以海藻酸钠(SA)为包埋载体,对氧化硫硫杆菌(Acidithiobacillus thiooxidans)进行固定化制备菌球,优化菌球制备条件,在生物滤塔内验证其对H₂S的去除能力.以前期驯化获得的富含硫系恶臭降解微生物菌群的污泥为菌源进行生物滤塔填料筛选,耦合A.thiooxidans菌球和填料进行生物除臭.结果表明,优选的固定化条件为:SA浓度3.0%､吸附剂CNT､A.thiooxidans菌悬液与混合液比例20%､CaCl₂浓度4.0%､改性剂己二胺溶液,获得的菌球机械强度､传质性能､硫氧化能力最好.将A.thiooxidans菌球填装于生物滤塔,H₂S最大去除率和去除能力为70%和1.06g H₂S/m³·h.以混合挂膜方式进行填料挂膜后,在聚氨酯泡沫､活性碳布和陶粒中优选出最佳填料活性碳布,获得H₂S最大去除率和去除能力为88%和0.84g H₂S/m³·h.以混合填装方式将A.thiooxidans菌球与活性碳布填装于生物滤塔,获得H₂S最大去除率和去除能力为86%和1.00g H₂S/m³·h.     

丁二烯过氧化物的生成、危害及安全性研究

综述了国内外丁二烯过氧化物研究进展，主要包括丁二烯过氧化物的危害性、成因、危险评价和热稳定性，并对今后的研究方向进行了展望。     

Preparation, characterization and application of CuCrO2/ZnO photocatalysts for the reduction of Cr(VI)

The delafossite CuCrO₂ elaborated by sol-gel from 40 nm diameter colloid is optically active in the visible region. It is characterized physically and photoelectrochemically. The microstructure is fairly homogenous with a mean crystallite size of ca. 2 μm. The optical gap (1.30 eV), determined from the diffuse reflectance, is well suited to the sunlight spectrum. The Mott Schottky plot is characteristic of P-type conductivity with a flat band potential of -0.26 V_SCE. As application, the photoreduction of chromate is successfully achieved in air-equilibrated suspension CuCrO₂/ZnO (1/1). CuCrO₂ is photoactivated by visible light and the electrons in the conduction band (-1.34 V_SCE) are injected to ZnO. In the presence of salicylic acid, a conversion of Cr(VI) to Cr(III) of 57% is obtained under optimal conditions (pH 3 at 25℃, 5×10^-4 mol/L) because of the HCrO₄^- dark adsorption onto ZnO (4HCrO₄^- + 3C₇H₆O₃ + 18O₂ + 16H⁺ → 4Cr³⁺ + 21CO₂ + 19H₂O, ΔG⁰ = -557 kcal/mol). Prolonged illumination is accompanied by a deceleration in the photoactivity owing to the competitive water reduction, an issue of energetic concern. The hetero-system exhibits self sensitization for hydrogen production with an evolution rate of 149 μmol/(hr·g).     

厌氧生物滴滤法脱除冷煤气中硫化氢的研究

水煤气中硫化氢在燃烧时会转变成二氧化硫,对环境产生污染。文章采用厌氧生物滴滤塔法对冷煤气进行脱硫处理。因煤气对氧的严格限制,通过设计生物滴滤塔,经挂膜驯化后在厌氧条件下对浓度在1~5 g/m3左右的硫化氢进行脱除处理,考察滴滤塔运行条件对脱除效果的影响。结果表明,生物挂膜25 d后,生物滴滤塔达到稳定,喷淋液pH值为2.23,ORP值为283 mV,溶解氧为0.4 mg/L,对溶液中硫离子氧化效率达到94%。滴滤塔在液气比0.15,空塔气速0.088 m/s,pH值5.0~7.0,填料高度为82 cm,塔温为25~30℃左右时,达到较优的运行条件,此时该滴滤塔对以CO、CO2、H2和1 940 mg/m3H2S组成的模拟水煤气的脱硫效率达91.2%。     

Fe(VI)/CaO2双氧化体系降解水环境中的DMP

研究了高铁酸盐（Fe（VI））/过氧化钙（CaO₂）联合处理对邻苯二甲酸二甲酯（DMP）的降解性能及机理,分析了共存离子的影响.基于响应面方法中的Box-Behnken实验设计进行了多因素实验,采用二次多项式和逐步回归法拟合了DMP去除率与Fe（VI）投加量、CaO₂投加量和反应时间之间的关系,对实验条件进行了优化分析.结果表明,在初始pH值为中性条件下,Fe（VI）/CaO₂可以有效去除DMP,降解过程符合准一级动力学模型.当Fe（VI）/CaO₂/DMP物质的量比为1.1/4.4/1时,模型预测DMP最大降解率为95.57%,和验证实验得出的降解率90.14%相近,表明该响应面模型具有较好的模拟和预测能力.HCO₃^-和Mg²⁺对DMP的降解有一定抑制作用.自由基清除实验结果显示,羟基自由基（HO·）和超氧自由基（O₂^-·）对DMP的降解具有重要贡献,表明Fe（VI）和CaO₂可形成类芬顿试剂协同降解污染物.DMP的主要降解途径包括酯基水解、侧链氧化和苯环的羟基化;主要降解产物为邻苯二甲酸单甲酯,2,5-二羟基苯甲酸,间苯二甲酸,草酸等.     

一种新型"Turn-on"荧光探针用于硫化氢可视化检测

硫化氢(H2S)是表征水体污染的重要参数之一,对其进行快速、有效地检测十分重要.荧光检测法由于具有不可比拟的优势得到了广泛的关注.以2-(2'-羟基苯基)苯并咪唑为荧光团,基于H2S的亲核性,设计合成了一种新型检测H2S的荧光探针.该探针与H2S作用后,荧光强度随H2S浓度的增加逐渐增强,颜色由淡黄色变成紫色,因此能够进行可视化检测,可视化检测限为3μmol·L-1.探针的最佳激发/发射波长为320/460 nm,对H2S表现出了良好的选择性和很快的响应速度(5 min),在较宽的p H(6~9)范围内,仍然表现出较好的荧光性能,荧光检测限为6μmol·L-1.该探针为H2S的检测提供了新方法.     

新型聚乙烯填料生物滴滤床净化硫化氢气体的启动研究

研究了新型高密度聚乙烯改良型拉西环填料生物滴滤床净化硫化氢气体的启动过程,重点比较了启动过程中不同的挂膜方式对启动时间及效能的影响.结果表明,采用液相连续流强化挂膜法成膜时间短,在环境温度20～28℃时7 d可以挂膜成功.在启动过程中,随着工艺参数的突然改变(GRT缩短)和入口浓度波动,液相连续流强化挂膜后反应器的硫化氢去除率更稳定.在进气浓度最高为343 mg/m³时硫化氢去除率稳定在95%以上.试验过程中还发现,将SO₄^2-浓度作为活性污泥驯化完成的监测指标、液相S^2-去除率作为挂膜完成的监测指标更合理.启动结束后,通过2种途径减去喷淋液中的碳源并未影响硫化氢的去除率,这进一步表明生物滴滤床中硫化氢的净化主要由自养菌完成.     

The influence of ClO− and acidity in the reaction between H2O2 and CuCl2

The potentially explosive reaction of hydrogen peroxide (H₂O₂) and copper chloride (CuCl₂) was investigated. Pressure tests revealed that the reaction was strongly temperature - dependent and can easily undergo runaway reaction. Nevertheless, there was only a slight pressure increase at the low temperatures studied or when using low concentrations of CuCl₂. Under the conditions generating the slight pressure increase, hypochlorite anions (ClO⁻) are generated and the acidity increases. As the reaction reaches completion, ClO⁻ disappears, and the acidity decreases. Interestingly, the addition of phosphate buffer to maintain the weakly acid conditions led to a runaway reaction, and the use of basic ClO⁻ promoted the exothermic reaction. Based on the results, acidity has a strong impact on the reaction behaviour.