Influence of disability type on upper-limb motor skills

This study was carried out in order to determine the effect of physical disability (paraplegia) and sensory disability (deafness) on motor skills of the upper limbs. Studies were distinguished by two parameters: the nature of the control curve (sine or random) and the magnitude of the isometric force exerted on the lever (10?N, 20?N, 40?N, 80?N). A comparison of the quality of manual force control in a visual detection task among groups of people with sensory disability (deaf), people with physical disability (paraplegic) and people without disability showed differences among those groups. Values of force above 20?N create conditions of lower quality of control and of direction of force exertion outside the body. At the same time, the study proved that people with some types of disability can perform certain work tasks as effectively as people without disability.     

流动注射在线UV消解测定环境水体中的总氮研究

采用San++流动分析仪在线UV消解测定环境水体中的总氮,样品浓度在0.00~5.0 mg/L与峰高有良好的线性关系(r=0.999 6)。进行了标准样品考核和实际水样的流动注射法和国标方法的比对分析。实验结果表明:采用流动注射在线消解测定水中TN,其标样测定值均在保证值范围内,相对标准偏差小于3%;两种方法测定实际水样的结果无显著性差异且具有很好的一致性,加标回收实验的回收率在90.0%~97.7%之间,能满足地表水及排放废水中TN监测要求。     

The Precision of Precipitation Chemistry Measurements in the Canadian Air and Precipitation Monitoring Network (CAPMoN)

Precision estimates are presented for precipitation chemistry and depth measurements made by the Canadian Air and Precipitation Monitoring Network (CAPMoN). The estimates were made for daily measurements of ion concentration and precipitation depth as well as for weekly, 28-day, seasonal and annual precipitation-weighted mean concentrations and depths. The data on which the estimates are based were collected from collocated samplers at five CAPMoN sites during the period 1985 to 1993. The data pairs from the collocated samplers were used to calculate the between-instrument error defined as 1/2 times the difference between the paired sample concentrations (or depths). For all of the ion concentrations and depths, the between-sampler errors were found not to be normally distributed, but the normality of the distributions improved with the length of the (volume-weighting) time period considered. A set of quantitative measures of overall network precision were derived in absolute (mg L^-1) and relative (%) units. These included the Modified Median Absolute Deviation (M.MAD), the P90% probability values and the Coefficient of Variation (CoV). The latter, defined as the percent ratio of the M.MAD to the median concentration (or depth), represents the relative precision at the center of the error and concentration (and depth) distributions. Based on the CoV values, the relative precision of the CAPMoN measurements was very high (better than 4%) for SO ₄ ^2- , NO ₃ ^- , pH, H⁺, NH ₄ ⁺ , sample depth and standard gauge depth, and not as high (between 10 and <35%) for Cl^-, Na⁺, Ca²⁺, Mg²⁺, and K⁺. The ions with the lowest median concentrations had the poorest relative precision since so many of the concentrations were at or near the analytical detection limit. Except for the sample and standard gauge depths, both the absolute and relative precision improved with the length of the precipitation-weighting period. Detailed statistical testing established that the precision of the daily measurements is dependent on a number of factors, the most dominant being sample depth and concentration, i.e., the absolute precision improves with increasing sample depth and decreasing concentration. The strength of these relationships diminished with the length of the precipitation-weighting period being considered. Laboratory-related sources of imprecision were found to account for less than 4% of the overall daily measurement imprecision for most species, while field-related sources of imprecision accounted for the balance. Specialized plots are shown which allow data users to estimate the absolute and relative precision at any concentration and depth value.     

染料中间体废水的逆流漂洗法处理

将逆流漂洗工艺应用于4－乙酰基－2－氨基苯甲醚生产上，可使生产过程中产生的硫酸浓度为2％的硝化废水，浓缩成浓度为30％－40％的浓废酸，可供化肥厂综合利用生产硫铵肥料，从而实现生产废水零排放。实验室和生产规模试验均表明，采用该工艺后，产品的平均得率提高4．1％，产品质量的所有指标达到且超过企业标准（Q／320221NCB02－91）。     

亚铁－过氧化氢氧化法处理染料中间体H酸生产废液的研究

Ｈ酸生产过程中排出的废液中含有大量萘的衍生物,对生物具有毒性,是目前最难处理的废水之一。本研究采用亚铁－过氧化氢氧化法对该废液进行处理,以改善它的可生化性能,降低水中有机物的溶解性,提高混凝处理效率。结果表明,最佳pH值为2～4,亚铁的适宜投加量为200mg/L,当H₂O₂投加量为30g/L时,COD去除率为50％,废水已具有可生化性。经亚铁－过氧化氢氧化处理（H₂O₂的投加量为3g/L）后的废液,再用FeCl₃进行两级混凝处理（FeCl₃的量分别为15和5g/L）,COD的去除率达90％,H酸氧化过程中,HO先和萘环上的钝化基团发生置换反应,使萘环活化,进一步氧化,萘环裂解,最终转化为无机物。研究结果对提高该种废水生物处理效率有实用意义。     

环境土壤标准物质的研究与制备

用高铝陶瓷球磨加工在１２０℃下烘干３０ｈ的风砂土、黑土和暗棕壤土壤样品。用Ｘ－射线荧光光谱法等分析样品中Ｃｕ,Ｆ３,Ｔｉ等元素,做均匀度检验,结果表明样品均匀。定值分析采用ＮＡ、ＩＣＰ－ＭＳ等１８种不同原理的分析技术。在１年多时间里,用Ｘ－射线荧光光谱法做稳定性实验,表明样品稳定。在ＩＢＭ计算机上处理获取的全部数据。用Ｇｒｕｂｂｓ、多重比较Ｓ法等剔除离群值,求出最佳估计值。以最佳估计值按定值原则确     

利用生活垃圾填埋场上建设飞灰固化物填埋场适宜性探讨

针对利用原有生活垃圾填埋场改扩建飞灰固化物填埋场,从勘查设计和建设角度,通过与常规生活垃圾填埋的安全和环保各相关因素对比,分析扩建前后填埋场稳定性、防渗及导排系统等勘察设计要点,研讨扩建工程新老填埋堆体基础层、防渗及导排系统等安全环保关键技术及扩建的适宜性,为扩建的可行性研究提出较为系统的技术论证思路.     

中温焙烧/钠化氧化法回收电镀污泥中的铬

采用中温焙烧/钠化氧化法从电镀污泥中回收铬.结果表明,影响铬浸出率的最主要因素为焙烧温度.电镀污泥与碳酸钠质量比、焙烧时间、水浸时间对铬浸出率的影响较接近,在水浸水固比为10.0 ; 1.0(质量比)、室温、焙烧温度为650℃、焙烧时间为2.0h、电镀污泥与碳酸钠质量比为1:1、水浸时间为60 min的最佳浸出条件下,铬浸出率为99.3%;去除氢氧化铝、氢氧化锌的最佳反应温度和pH分别为90～95℃和7.5;去除硫酸钠晶体的最佳pH为4.0,在最佳试验条件下,铬回收率为90.57%.     

Biodegradation of methyl parathion by Acinetobacter radioresistens USTB-04

Biodegradation of methyl parathion (MP),a widely used organophosphorus pesticide,was investigated using a newly isolated bacterium strain Acinetobacter radioresistens USTB-04.MP at an initial concentration of 1200 mg/L could be totally biodegraded by A.radioresistens USTB-04 as the sole carbon source less than 4 d in the presence of phosphate and urea as phosphorus and nitrogen sources,respectively.Biodegradation of MP was also achieved using cell-free extract of A.radioresistens USTB-04.MP at an initial concentration of 130 mg/L was completely biodegraded in 2 h in the presence of cell-free extract with a protein concentration of 148.0 mg/L,which was increased with the increase of pH from 5.0 to 8.0.Contrary to published reports,no intermediate or final degradation metabolites of MP could be observed.Thus we suggest that the cleavage of C--C bond on the benzene ring other than P-O bond may be the biodegradation pathway of MP by A.radioresistens USTB-04.     

Effect of Sb dopant amount on the structure and electrocatalytic capability of Ti/Sb-SnO2 electrodes in the oxidation of 4-chlorophenol

Ti/Sb-SnO_2 anodes were prepared by thermal decomposition to examine the influence',of the amount of Sb dopant on the structure and electrocatalytic capability of the electrodes in the oxidation of 4-chlorophenol.The physicochemical properties of the Sb-SnO_2 coating were markedly influenced by different amounts of Sb dopant.The electrodes,which contained 5% Sb dopant in the coating, presented a much more homogenous surface and much smaller mud-cracks,compared with Ti/Sb-SnO_2 electrodes containing 10% or 15% Sb dopant,which exibited larger mud cracks and pores on the surface.However,the main microstructure remained unchanged with the addition of the Sb dopant.No new crystal phase was observed by X-ray diffraction(XRD).The electrochemical oxidation of 4-chlorophenol on the Ti/SnO_2 electrode with 5% Sb dopant was inclined to electrochemical combustion;while for those containing more Sb dopant,intermediate species were accumulated.The electrodes with 5% Sb dopant showed the highest efficiency in the bulk electrolysis of 4-chlorophenol at a current density of 20 mA/cm~2 for 180 min;and the removal rates of 4-chlorophenol and COD were 51.0% and 48.9%,respectively.