分光光度法测定雨水中微量过氧化氢的研究

本文提出了以钛（ＩＶ） 过氧化氢 ２ （３，５ 二溴 ２ 吡啶偶氮） ５ 二乙氨基苯酚（３，５ ｄｉＢｒ ＰＡＤＡＰ）三元配合物体系光度测定雨水中微量过氧化氢的方法，该方法简便，灵敏度和选择性较高，所得结果令人满意     

Preparation of rare-earth metal complex oxide catalysts for catalytic wet air oxidation

Catalytic wet air oxidation (CWAO) is one of the most promising technologies for pollution abatement. Developing catalysts with high activity and stability is crucial for the application of the CWAO process. The Mn/Ce complex oxide catalysts for CWAO of high concentration phenol-containing wastewater were prepared by coprecipitation. The catalyst preparation conditions were optimized by using an orthogonal layout method and single-factor experimental analysis. The Mn/Ce serial catalysts were characterized by Brunauer-Emmett-Teller (BET) analysis and the metal cation leaching was measured by inductively coupled plasma torch-atomic emission spectrometry (ICP-AES). The results show that the catalysts have high catalytic activities even at a low temperature (80°C) and low oxygen partial pressure (0.5 MPa) in a batch reactor. The metallic ion leaching is comparatively low (Mn<6.577 mg/L and Ce<0.6910 mg/L, respectively) in the CWAO process. The phenol, COD_Cr, and TOC removal efficiencies in the solution exceed 98.5% using the optimal catalyst (named CSP). The new catalyst would have a promising application in CWAO treatment of high concentration organic wastewater. Translated from Techniques and Equipment for Environmental Pollution Control, 2005, 6(2): 40–44 [译自: 环境污染治理技术与设备]     

多环芳烃的几种理化参数与LC_(50)的相关性研究

对多环芳烃(PAHS)4种理化参数(K;W、Sw。X Vv。)与 LCO的相关关系进行了研究,建立了 4种一元线性回归方程。结果表明,4种参数的相关系数分别为:0.刀66、08083、09488、0.9570,经r检验,后两种属高度显著相关.用所建立的一元线性回归方程对7种PAHS的LC。进行估算,估算值与实测值相比,平均相对误差分别为58.84％、32.23％、1761％、198％,用l和V＊.H对LClj进行估算的估算精度也较高。经比较,提出用(。估算P＊比对麦穗鱼＊CO的新方法。     

Occurrence and congeners specific of poiychlorinated biphenyls in agricultural soils from Southern Jiangsu, China

A total of 198 agricultural soil samples were collected from Zhangjiagang and Changshu in Southern Jiangsu for analysis of 13 polychlorinated biphenyls (PCBs) in order to assess the levels of pollution, sources, area distribution, and potential risk for the environment. All methods were rigorously tested and an adequate quality control was ensured. Only one site had no PCBs residues, and the highest total PCBs concentration in the surface soils was 32.83 ng/g. The average concentration in all the soil samples was 4.13 ng/g, signaling low-level pollution. Tetra-, penta-, and hexa-chlorinated biphenyls were dominant species in soil samples, accounting for more than 75% ofΣPCBs in the soil samples. PCB118 was the most abundant congener in all the samples. The PCB118 was about 20% ofΣPCBs. The soil organic matter content showed only a weak correlation with the levels of all PCB congeners, in which a better correlation was noted for the more volatile lighter PCB congeners than for the heavier homologues. To a certain extent, the sources and land use seemed to influence the levels of PCBs.     

Quantitative structure - activity study on the reductivedehalogenation potency of the halogenated aromatics

Ｑｕａｎｔｉｔａｔｉｖｅｓｔｒｕｃｔｕｒｅ－ａｃｔｉｖｉｔｙｓｔｕｄｙｏｎｔｈｅｒｅｄｕｃｔｉｖｅｄｅｈａｌｏｇｅｎａｔｉｏｎｐｏｔｅｎｃｙｏｆｔｈｅｈａｌｏｇｅｎａｔｅｄａｒｏｍａｔｉｃｓＨｕａｎｇＱｉｎｇｇｕｏ；ＷａｎｇＬｉａｎｓｈｅｎｇ；Ｈａｎ...     

金属铁还原降解2,4-二硝基甲苯的实验研究

研究了金属铁对2,4-二硝基甲苯(2,4-DNT)的还原降解情况.实验结果表明,2,4-DNT的还原降解与溶液初始pH值、初始浓度和溶解氧等因素有关.氯离子能消除金属铁的钝化现象.金属铁表面附载的铜对2,4-DNT的还原降解具有催化作用.     

MBBR处理低浓度污水的工程应用

用 2座体积 12 0m3的移动床生物膜反应器处理抚顺乙烯有限公司厂区的低浓度 (CODCr6 0～ 80mg L)生活污水 ,停留时间 2 4h ,出水通过高效纤维球过滤罐 ,CODCr降至 2 0mg L ,BOD5降至 5mg L ,SS降至 5mg L ,氨氮降至 1mg L ,达到了循环冷却水的回用标准。进水浓度过低 ,对MBBR挂膜不利 ,工程中采用外加营养物质的措施后 ,3d内反应器成功挂膜启动。     

乙酸型顶极群落的内平衡与反馈调节机制研究

通过产酸脱硫反应器处理高浓度硫酸盐有机废水的连续流试验，从“动态”角度考察COD／SO4^2-比改变引起的pH值、氧化还原电位（ORP）、碱度（ALK）和末端产物（VFAs）等的变动及生态因子的叠加效应引发的优势种群变迁，分析了乙酸型顶极群落的稳定性及其发生定向性生态演替的规律，进而阐明了乙酸型顶极群落抵抗环境压力的内平衡与反馈调节机制，并指出乙酸型代谢和乙酸型顶极群落是产酸脱硫生态系统的典型特征。     

A/O和A2/O法除磷脱氮工艺影响因素及除磷动力学的研究

重点介绍A/O除磷工艺和A~2/O除磷脱氮工艺,以及影响除磷脱氮工艺因素和除磷动力学的研究。工艺研究采用了动态与静态实验方法,采用色质联机研究了有毒有机物的降解情况。试验结果表明,A/O、A~2/O工艺的BOD_5去除率近于二级污水处理厂,A~2/O法TP去除率近于三级污水处理厂,且去除难降解有毒有机物的效率高于传统的活性污泥法。动力学公式的修正使之更适于低碳源的情况。八种影响因素的研究为工艺的设计与运行提供了依据。     

ASM1中废水和污泥组分浓度的测定方法研究

对呼吸计量法应用于校准ASM1作了简明的阐述。在呼吸速率与模型组分关系的基础上,介绍了ASM1中废水与污泥各组分浓度的测定方法,并指出模型组分细化的意义。