循环流化床锅炉床温控制方法

就目前电厂循环流化床锅炉运行中存在的床温波动问题，讨论了导致床温波动的因素，并针对性地提出了控制床温的一些措施。     

DENSITY CURRENT INTRUSIONS IN AN ICE-COVERED URBAN LAKE1

ABSTRACT: Evidence is presented that snowmelt runoff from an urban watershed can produce density current intrusions (underflows) in a lake. Several episodes of density current intrusions are documented. Water temperatures and salinities measured near the bottom of a 10 m deep Minneapolis lake during the late winter warming periods in 1989, 1990, 1991, and 1995 show significant rapid changes which are correlated with observed higher air temperatures and snowmelt runoff. The snowmelt runoff entering this particular lake (Ryan Lake) has increased electrical conductivity, salinity, and density. The source of the salinity is the salt spread on urban streets in the winter. Heating of littoral waters in spring may also contribute to the occurrence of the sinking flows, but is clearly not the only cause.     

平衡调温调湿方式中变流量冷冻水系统设计

通过对变流量冷冻水系统的分析指出，在运用平衡调温调湿方式的空调系统中，应用变流量冷冻水系统可以较大地节约能源和投资；并提出了实现这种应用的方法。     

pH和温度对2,2’,4,4’-四溴联苯醚在土壤中吸附和解吸行为的影响研究

研究了pH和温度对2,2’,4,4’-四溴联苯醚(BDE-47)在土壤中的吸附和解吸行为的影响。结果表明,pH和温度都可以影响BDE-47在受试土壤中的吸附和解吸行为。pH升高或降低均会使土壤对BDE-47的吸附能力提高,且在碱性环境中提高的程度更大;酸性或碱性条件下BDE-47在土壤中的解吸滞后性显著增强。温度降低后,土壤对BDE-47的吸附能力提高,5℃时的单点分配系数(Kd,表征土壤对BDE-47的吸附能力)是25℃时的1.03~1.67倍;温度由25℃降低到5℃后,BDE-47在土壤中的解吸滞后性增强。     

Impact of continental margins in the Mediterranean Sea: Hints from the surface colour and temperature historical record

The surface colour and temperature fields of the Mediterranean Sea, as appearing in time series, of basin-wide images available in the CZCS (1979–1985) and AVHRR (1982–1991) historical archives, differentiate between basin interior and continental margins affected by coastal patterns, river plumes, and mesoscale features. The original data were processed to apply calibration factors, to correct for atmospheric contamination, and to estimate chlorophyll-like pigment concentration and surface temperature. Composites were derived, as monthly and annual means, using a fixed equal-area projection with a 1-km² pixel grid. Enhanced pigment values and lower temperatures along the northern coastal areas (i.e. the Ligurian, Provençal and Balearic basins, as well as the Adriatic, and Aegean Seas) have been associated with the impact of runoff from continental margins (i.e. both a direct impact due to the sediment load and one induced on the planktonic flora by the associated nutrient load) and with vertical mixing due to the prevailing winds (i.e. the Mistral in the northwest, the Bora in the Adriatic, the Etesians in the Aegean). The pattern of increasing pigments and decreasing temperatures in seen to develop in the monthly images from the coastal zone towards the open sea from summer to winter, and then back from winter to summer. The southern coastal areas show different values, namely lower pigments and higher temperatures (except in areas where the data are altered by signal contamination). It is suggested that differences in geomorphology and meteorology of the basin margins have an impact on both water biogeochemistry and dynamics, influencing the biooptical and thermal properties of the various sub-basins, and of the entire Mediterranean region.     

Effects of ecological factors on the diurnal activity rhythm of Yakutian black-capped marmots (Marmota camtschatica bungei) in the arctic

It is established that the activity of marmots (the genusMarmota) on the surface is timed to the daylight period. In the Arctic, under conditions of continuous illumination (the polar day), the diurnal rhythm of black-capped marmotsMarmota camtschatica bungei on the surface has a “daylight” pattern. The main external regulator of the diurnal rhythm is the altitude of the sun above the horizon. In the cold period, however, the effect of air temperature on animal activity becomes stronger.     

青岛海洋环境碳纤维复合材料与低合金钢电偶腐蚀研究

目的 探究碳纤维复合材料在舰船应用时与金属材料的电偶腐蚀问题。方法 针对一种典型舰船用碳纤维增强乙烯基树脂复合材料,在青岛海洋大气环境下开展0.5、1、1.5、2 a期的自然曝晒试验,进而采用电化学分析手段考察其与低合金钢的电偶腐蚀效应,结合老化机制探究碳纤维复合材料的老化行为对其与钢电偶腐蚀的影响。结果及结论 在青岛大气环境曝晒不同周期的复合材料试样,开路电位与低合金钢相差较大,存在较高的电偶腐蚀倾向。随曝晒时间的延长,复合材料表面微裂纹不断产生、扩展,导致电化学反应活性点增多,两者电偶电流密度随之增大。在青岛海洋大气环境下暴露2 a后,碳纤维增强乙烯基树脂复合材料与低合金钢的电偶电流为0.356 9 μA/cm²,两者的电偶腐蚀敏感性达到B级。     

不同温湿度条件下微米硼的氧化过程研究

目的 探究不同温湿度条件下微米硼的氧化层结构特征。方法 利用高温水浴浸泡处理去除原料微米硼的表面氧化层,然后在恒温恒湿条件下对微米硼进行加速氧化,利用扫描电子显微镜、透射电子显微镜和X射线光电子能谱对加速氧化后硼颗粒的氧化层厚度及组成进行分析,总结表面氧化层结构及成分组成变化规律,揭示温湿度条件下微米硼的氧化机制。结果 微米硼经高温水浴浸泡处理后,表面氧化层去除率达到50%。随着加速氧化时间的延长,硼颗粒氧化层的厚度逐渐增大,由内向外硼颗粒表面可以用B-BxOy-B2O3三层结构来表示,BxOy总是伴随着B2O3同时出现的,且随着氧化反应的进行,颗粒表面BxOy的含量将超过B的含量。结论 不同温湿度条件下微米硼的氧化机制为O2向B颗粒内部单向扩散的反应机制,B先与O2反应,形成低氧化物BxOy,BxOy进而与O2反应生成B2O3。随着氧化层厚度的增加,O2向B颗粒内部扩散的阻力增大,氧化反应速率随之降低。相比湿度的影响,温度的升高可显著加快硼表面氧化层的形成;温度一定时,湿度的增加可促进硼氧化层的形成。     

电子产品野外环境下温循加速载荷谱编制方法

目的 将电子产品在野外环境下日变化波动与季节差异明显的温度载荷编制成温循载荷谱和转换为加速载荷谱。方法 通过四点雨流计数法提取原谱中的载荷循环信息,对提取的循环信息进行分布拟合、相关性检验等统计分析,进而构建循环均值与范围值的联合概率密度函数,再运用概率密度法,编制出8×8二维环境载荷谱。在二维载荷谱基础上,编制出温循载荷谱,使用针对电子部件参数修正的加速方程转化为加速载荷谱。结果 利用野外作业现场1个作业周期内的气温纪录,提供了一套编制温循载荷谱和转换加速载荷谱的合理化流程和解决方案。结论 该制谱方法可以利用原始环境谱中绝大部分有效信息,较好地还原电子部件野外作业阶段经历的温度变化过程,为电子产品的加速寿命试验和使用寿命预测奠定基础。     

Comprehensive temperature monitoring in an in-vessel forced-aeration static-bed composting process

Comprehensive temperature monitoring was done in an in-vessel forced-aeration static-bed composting process using sewage sludge. The three layers that divided the compost pile horizontally showed different temperature distributions. The temperature of the top layer appeared not to be influenced by the ambient temperature. The temperature of the center area of the top layer was taken to be the representative temperature for evaluating composting start-up performance. The temperature of the bottom layer was strongly influenced by the ambient temperature, and the temperature of the center area of the bottom layer was taken to be the representative temperature for pathogen control as it was the minimum temperature in the reactor. Composting start-up performance was influenced by several factors when the ambient temperature was either below or above 20°C. When the ambient temperature was below 20°C, the time taken to reach 65°C (T ₆₅) was influenced by the temperature of inflowing air, but when the temperature was higher than 20°C, it was influenced by the ratio of sewage sludge to seed compost (F/S). T ₆₅ was least when F/S was 1–2. Received: January 9, 2001 / Accepted: October 10, 2001