Effect of catalyzed diesel particulate filter and its catalyst loading on emission characteristics of a non-road diesel engine

In this study, the effects of a diesel oxidation catalyst (DOC) coupled with a catalyzed diesel particulate filter (CDPF) with different catalyst loadings on the power, fuel consumption, gaseous and particulate emissions from a non-road diesel engine were investigated. Results showed that the after-treatment had a negligible effect on the power and fuel consumption. The reduction effect of the DOC on the CO and hydrocarbon (HC) increased with the engine load. Further reductions occurred coupling with the CDPF. Increasing the catalyst loading resulted in a more significant reduction in the HC emissions than CO emissions. The DOC could increase the NO₂ proportion to 37.9%, and more NO₂ was produced when coupled with the CDPF below 250°C; above 250°C, more NO₂ was consumed. The after-treatment could reduce more than 99% of the particle number (PN) and 98% of the particle mass (PM). Further reductions in the PN and PM occurred with a higher CDPF catalyst loading. The DOC had a better reduction effect on the nucleation particles than the accumulation ones, but the trend reversed with the CDPF. The DOC shifted the particle size distribution (PSD) to larger particles with an accumulation particle proportion increasing from 13% to 20%, and the geometric mean diameter (GMD) increased from 18.2 to 26.0 nm. The trend reversed with the CDPF and the accumulation particle proportion declined to less than 10%. A lower catalyst loading on the CDPF led to a higher proportion of nucleation particles and a smaller GMD.     

从水质角度论黄河干流水资源

在分析1997，1998和1999年黄河干流水质监测数据及取水口水质水量资料的基础上，结合水体用途，从水质的角度对黄河干流水资源做出相关评价，并提出了水资源功能容量和水资源功能亏缺的概念，结果表明：黄河干流取水口处水质对取水水体用途的影响显著；1999年黄河干流具备水资源功能的取水量为159．42亿m^3，不具备水资源功能的取水量为80．94亿m^3，与水资源功能容量相比，黄河干流水资源功能亏缺相对较大；且在1997－1998－1999年间，干流水资源功能亏缺存在增加的趋势。     

锰砂表面改性去除酚类化合物的研究

本文叙述了锰砂表面改性(以下简称旧锰砂)处理含酚饮用水的实验研究,陈酚率可达99％。本实验对除酚因素(温度、pH值、流速和接触时间等)进行了实验研究。当进水酚浓度≤2.0mg/l时,经旧锰砂的吸附,可使酚浓度≤0.002mg/l。     

天然水体中有机物检测方法的选择与优化

本文选取并优化了一种准确、易行、适合于天然水样中微量有机物的分析技术.天然水样品中有机物通过混合大孔径吸附树脂XAD-2与XAD-7(4:1,V/V)富集并用二氯甲烷洗脱.所有富集的有机物样品中均加入衍生化试剂N,O-双(三甲基硅基)三氟乙酰胺(缩写为BSTFA)硅烷化,最后采用气相色谱-质谱联用仪分析.为了实验的简便,我们的样品为模拟水样(4L添加定量5β-胆烷(挪威Chiron公司)的去离子水).     

云南省中小企业推广清洁生产初探

对云南清洁生产的发展概况和存在问题进行了分析,提出了从政府导向监管、企业利益和中介服务等3个方面来推广中小企业清洁生产的设想.     

The adaptive significance of male polymorphism in the acarid mite Caloglyphus berlesei

Summary Two forms of males occur in the acarid mite, Caloglyphus berlesei. One of them uses its thickened third pair of legs to kill other males; the other, without modified legs, does not attack other males. Previous studies have shown that the form of the male is environmentally determined: fighter males develop only at low population densities and their development can be suppressed by substances emanating from dense colonies. In this study, the duration of development, longevity and virility of the two male morphs were measured. The only significant difference was that fighters had a shorter development time between the two last moults. In another experiment, two groups of colonies were maintained under the same conditions but had different numbers of individuals: small colonies contained 2 fighters and 2 non-fighters, whereas large colonies contained 30 males of each type. The relative reproductive success of both morphs was estimated from numbers of matings. In small colonies, the estimated reproductive success (ERS) was significantly higher for fighters than for non-fighters, mainly because in over 50% of these colonies a single fighter male managed to kill all the rival males and monopolize the females. The opposite was true in large colonies, in which non-fighters achieved significantly higher ERS, mainly because the fighters were killed in fights more often than the non-fighters. This implies that the ratio of costs to benefits obtained by adopting the fighter-male strategy increases with the number of rival males, which may explain conditional male development in C. berlesei.     

人机工程学数据在产品设计中的应用

介绍和分析了确定产品类型、选择百分位数、产品尺寸修正量,并最终设定产品功能尺寸的思路和方法.结合实例,深入分析了人机工程学数据在产品设计中的应用方法.     

截齿截割煤体变形破坏过程数值模拟研究

采用应变软化的模型,使用连续介质快速拉格朗日分析法(FLAC,FastLagrangianAnaly-sisofContinue)进行数值模拟计算;研究截齿截割作用下煤体变形破坏过程;分析各种工况下不同参数对煤体塑性区、最大位移、最大主应力、最大剪应力的影响。研究表明:截割力与塑性区大小成正比,位移、剪应力、主应力随截割力增大而增大;截深与塑性区大小成反比;截割角度与塑性区面积关系密切,试验用煤体最佳截割角度为5°左右;截割速度增加,塑性区面积减小;通过分析截割动态过程,得到位移矢量图及剪应变等值线图,发现截割过程中煤体的破坏是拉、剪联合作用的结果,以剪破坏为主。     

关于雾灾几个相关问题的探讨

首先,基于灾害系统的理论,构建了雾灾灾害系统模式和灾害链模式,提出了以机场和高速公路为承灾体的雾灾灾害链.其次,构建了雾灾承灾体脆弱性评价体系和模型,并对中国雾灾脆弱性分省区进行了评价,结果表明雾灾脆弱性高值区是上海、北京、天津3市;次高值区是江苏、山东、海南、广东等省.最后,以2002年12月的一次大雾天气为例,运用灰色关联度方法,着重对机场客运的雾灾灾情进行了评估,以期为雾灾损失厘定和防灾减灾提供科学的依据.     

水体富营养化的渐进性和灾难性

水体富营养化是全球范围内的普遍现象,他的危害性已越来越引起全人类的关注.本文从生态学、地球化学循环和全球气候变迁的角度,结合人类的社会活动,讨论了水体富营养化发生的机制、危害,并从全球角度提出人类面对富营养化应有的态度和应采取的对策.