福州市城市化进程与大气污染关系研究

以福州市为研究区域,选取福州市1996—2012年的时间序列数据,将大气污染物浓度作为被解释变量,城市化水平作为解释变量,分别设定二次曲线模型和三次曲线模型,通过比较PM10、SO2、NO2浓度与城市化水平的二次曲线和三次曲线模型的回归拟合效果,得出福州市大气污染与城市化水平之间的演化规律。结果表明,1996—2012年,福州市城市化水平平稳上升,城市的大气污染程度与城市化水平之间的关系并不完全符合"倒U型"的环境库兹涅茨曲线,不同的污染物类型具有不同的演化规律。PM10、SO2与城市化水平呈"倒N型"的曲线关系;NO2与城市化水平之间呈现"倒U型"曲线关系。由于研究的时间序列较短,因而研究结果可能只是真实曲线的一部分,福州市的大气污染与城市化水平之间的关系还有待进一步研究。     

Adsorption of chlorpyrifos,penconazole and metalaxyl from aqueous solution by modified clays

Sorption of three pesticides (chlorpyrifos, metalaxyl and penconazole) has been measured on a commercial clay montmorillonite and on the same mineral modified with either of two cationic-surfactant micelles. Both micelle–clay complexes, commercial names Cloisite 20A and Cloisite 30B, showed a good capacity to sorb all three pesticides from water, whereas their sorption on the natural montmorillonite was not described by an isotherm. Modelling sorption on both micelle–clay complexes showed that the Freundlich sorption constant (K _F) was higher for chlorpyrifos on Cloisite 20A (K _F = 7.76) than on Cloisite 30B (K _F = 5.91), whereas the sorption of metalaxyl was stronger on Cloisite 30B (K _F = 1.07) than on Cloisite 20A (K _F = 0.57). Moreover the micelle–clay complex Cloisite 20A also showed a good affinity for penconazole, the maximum quantity adsorbed (q _m) of 6.33 mg g^?1 being 45% more than that on Cloisite 30B. Single-batch adsorption of each pesticide onto both micelle–clay complexes was studied using the Freundlich isotherm for chlorpyrifos and metalaxyl and the Langmuir isotherm for penconazole. The Cloisite 20A micelle–clay complex was predicted to require 23% less adsorbent to treat certain volumes of wastewater containing 30 mg L^?1 chlorpyrifos, 43% more to treat metalaxyl similarly and 57% less to treat penconazole compared with Cloisite 30B.     

Subcellular distribution and toxicity of cadmium in Potamogeton crispus L

The submerged macrophyte Potamogeton crispus L. was subjected to varying doses of cadmium (0, 20, 40, 60 and 80 μM) for 7 d, and the plants were analyzed for subcellular distribution of Cd, accumulation of mineral nutrients, photosynthesis, oxidative stress, protein content, and ultrastructural distribution of calcium (Ca). Leaf fractionation by differential centrifugation indicated that 48-69% of Cd was accumulated in the cell wall. At all doses of Cd, the levels of Ca and B rose and the level of Mn fell; the levels of Fe, Mg, Zn, Cu, Mo, and P rose initially only to decline later. Exposure to Cd caused oxidative stress as evident by increased content of malondialdehyde and decreased contents of chlorophyll and protein. Photosynthetic efficiency, as indicated by the quenching of chlorophyll a fluorescence (Fv/Fm, Fo and Fm), decreased significantly, the extent of decrease being directly proportional to the concentration of Cd. Increased amounts of precipitates of calcium were noticed in the treated plants, located either outside the cell membrane or in chloroplasts, mitochondria, the nucleus, and the cytoplasm whereas control plants showed small deposits of the precipitates around surface of the vacuole membrane and in the intercellular space but rarely in the cytoplasm. Photosynthetic efficiency and oxidative stress could be used as indicators of physiological end-points in determining the extent of Cd phytotoxicity.     

Stand-alone wind power system with battery/supercapacitor hybrid energy storage

This paper presents a stand-alone wind power system with battery/supercapacitor hybrid energy storage. A stand-alone wind power system mainly consists of a wind turbine, a permanent magnet synchronous generator, hybrid energy storage devices based on a vanadium redox flow battery and a supercapacitor, an AC/DC converter, two bidirectional DC/DC converters, a DC/AC converter and a variable load. Several control strategies for the stand-alone wind power system are involved such as a maximum power point tracking (MPPT) control, a vanadium redox flow battery charge/discharge control and a supercapacitor charge/discharge control. The proposed MPPT control combines a sliding mode control with an extreme search control to capture maximum wind energy. This strategy avoids the necessity of measuring wind velocity, obtaining models or parameters of the wind turbine and calculating the differentials of the power generated from the wind power system and from the speed of the generator. The battery charge/discharge control maintains a constant DC bus voltage. When the battery charging/discharging current reaches the setting threshold, the charge/discharge control of the supercapacitor is triggered to limit the charging/discharging current of the battery. The simulation results show that the proposed method can rapidly respond to variations in wind velocity and load power.     

基于正交实验的面粉爆炸特性研究

为探究面粉爆炸实验中粉尘质量浓度、点火能量、点火延迟时间对面粉爆炸的影响,采用正交实验法并利用20 L球形爆炸测试装置比较研究了粉尘质量浓度、点火延迟时间以及点火能对面粉爆炸的影响程度.结果表明:对最大爆炸压力影响最为显著的因素是点火延迟时间,对最大爆炸指数影响最为显著的因素是粉尘质量浓度;在实验浓度范围内,存在最佳实...     

Limitations in the determination of maximum residue limits and highest residues of pesticides: Part I

The pesticide usages are controlled by comparing residue concentrations in treated commodities to legally permitted maximum levels (MRLs) determined based on supervised trials designed to reflect likely maximum residues occurring in practice following authorised use. The number of trials available may significantly affect the accuracy of estimated maximum residues. We conducted a study with synthetic lognormal distributions with mean of 1 and standard deviations of 0.8 and 1.0, which reflect the residue distributions observed in practice. The likely residues in samples were modelled by drawing random samples of size 3, 5, 10 and 25 from the synthetic populations. The results indicate that the estimations of highest residues (HR), used for calculation of short-term intake, and the MRLs, serving as legal limits, are very uncertain based on 3–5 trials indicated by the calculated HR_0.975/HR_0.025 and MRL_0.975/MRL_0.025 ratios of 12 and 9, and 13 and 10, respectively, which question the suitability of such trials for the intended purpose. As the 95% range of HR and MRL rapidly decreases with number of trials, ideally ≥15 but minimum 6–8 trials should be used for estimation of HR and MRL according to the current typical practice of Codex Alimentarius.     

Thermodynamics of interaction of lindane on silty loam and silty clay loam Indian soils

Abstract

Interaction of lindane with silty loam and silty clay loam soils was studied in batch tests at 23, 30 and 37° C. Sorption experiments were carried out at four concentrations and for varying time of contact upto 72 hours. This was followed by desorption studies. No desorption was observed. The sorption data was analysed using sorption equations and evaluating the thermodynamic parameters. The sorption was found to be predominantly entropic in nature and a combined effect of adsorption and chemisorption. The effect of organic matter and other chemical and mineralogical constituents of soils has also been discussed. The sorption with single application of lindane with the two soil types indicates that the insecticide is less likely to reach groundwater.     

MODELING FECAL COLIFORM CONTAMINATION IN THE RIO GRANDE1

This study examines sources of fecal coliform in Segment 2302 of the Rio Grande, located south of the International Falcon Reservoir in southern Texas. The watershed is unique because the contributing drainage areas lie in Texas and Mexico. Additionally, the watershed is mostly rural, with populated communities known as “colonias.” The colonias lack sewered systems and discharge sanitary water directly to the ground surface, thus posing an increased health hazard from coliform bacteria. Monitoring data confirm that Segment 2302 is not safe for contact recreation due to elevated fecal coliform levels. The goal of the study was to simulate the observed exceedences in Segment 2302 and evaluate potential strategies for their elimination. Fecal coliform contributions from ranching and colonia discharges were modeled using the Hydrologic Simulation Program‐Fortran (HSPF). Model results indicated that the regulatory 30‐day geometric mean fecal coliform concentration of 200 colony forming units (cfu) per 100 milliliters is exceeded approximately three times per year for a total of 30 days. Ongoing initiatives to improve wastewater facilities will reduce this to approximately once per year for 14 days. Best management practices will be necessary to reduce cattle access to streams and eliminate all exceedences. The developed model was limited by the relatively sparse flow and fecal coliform data.     

SUBWATERSHED SPATIAL ANALYSIS TOOL: DISCRETIZATION OF A DISTRIBUTED HYDROLOGIC MODEL BY STATISTICAL CRITERIA1

ABSTRACT: Complex hydrologic models, designed for simulating larger watersheds, require a huge amount of input data. Most of these models use spatially distributed data as inputs. Spatial data can be aggregated or disaggregated for use as input to a model, which can impact model outputs. Although, it is efficient to minimize data redundancy by aggregating the spatial data, upscaling reduces the detail/resolution of input information and increases model uncertainty. On the other hand, a large number of model inputs with high degrees of disaggregation take more computer time and space to process. Hence, a balance between striving for a maximum level of aggregation and a minimum level of information loss has to be achieved. This study presents a definition of an appropriate level of discretization, derived by establishing a relationship between a model's efficiency and the number of subwater‐sheds modeled. An entropy based statistical approach/tool called Subwatershed Spatial Analysis Tool (SUSAT) was developed to find an objective choice of an appropriate level of discretization. The new approach/tool was applied to three watersheds, each representing different hydrologic conditions, using a hydrologic model. Coefficients of efficiency and entropy estimated at different levels of discretization were used to validate the success of the new approach.     

PROBABLE MAXIMUM PRECIPITATION FOR THE LOWER RIO GRANDE1

To aid in planning and design of additional flood protection on the Lower Rio Grande, the Hydroraeteorological Branch prepared a probable maximum precipitation study for the International Boundary and Water Commission (United States and Mexico) and the Republic of Mexico. Five drainages from 2,000 to over 17,000 square miles in area between Falcon and Anzalduas Dams including Rio San Juan and Rio Alamo in Mexico are the areas of concern. The great rains of hurricane Beulah, September 19–24, 1967 verified that additional protection is needed. Procedures for estimating probable maximum precipitation (PMP) are described. A particular problem was to estimate rainfall potential for the Sierra Madre Oriental in Rio San Juan and Alamo drainages. These mountains form a north-south windward-facing slope and barrier of over 7000 feet in elevation. A detailed study was made of rains from hurricane Beulah. The storm produced the greatest known rain depths in North America for 50,000 square miles or greater, and durations longer than 48 hours.