Monitoring atmospheric metal pollution: a review of the use of mosses as indicators

This article reviews the literatureon the use of mosses for monitoring atmospheric metalpollution. It discusses the nature of mosses, themechanisms for moss uptake of metals from the air andwet precipitation, the various forms in which mossesare used for this purpose, and cases in which mosseshave been used for monitoring local hot spots ofpollution, and regional patterns of metal pollution.Also highlighted are the questions of uptake of metalsfrom the substrates, interspecies differences, and acomparison of the effectiveness of mosses with otherindicator materials, among other issues.     

Synergistic effect of F and triggered oxygen vacancies over F-TiO2 on enhancing NO ozonation

Oxidation-absorption technology is a key step for NO_x removal from low-temperature gas. Under the condition of low O₃ concentration (O₃/NO molar ratio = 0.6), F-TiO₂ (F-TiO₂), which is cheap and environmentally friendly, has been prepared as ozonation catalysts for NO oxidation. Catalytic activity tests performed at 120°C showed that the NO oxidation efficiency of F-TiO₂ samples was higher than that of TiO₂ (about 43.7%), and the NO oxidation efficiency of F-TiO₂-0.15 was the highest, which was 65.3%. Combined with physicochemical characteristics of catalysts and the analysis of active species, it was found that there was a synergistic effect between F sites and oxygen vacancies on F-TiO₂, which could accelerate the transformation of monomolecular O₃ into multi-molecule singlet oxygen (¹O₂), thus promoting the selective oxidation of NO to NO₂. The oxidation reaction of NO on F-TiO₂-0.15 follows the Eley-Rideal mechanism, that is, gaseous NO reacts with adsorbed O₃ and finally form NO₂.     

蔬菜样品的H_2SO_4-H_2O_2快速消化方法

本文报道了使用硫酸 -过氧化氢对蔬菜样品进行快速消化的方法。其消化时间比常规消化方法大为缩短。重金属元素镉、铬、铜、镍、锌含量测定的结果 ,与用常规消化方法 (硝酸 -高氯酸 )相吻合。     

印刷线路板厂含铜污泥固化处理工艺研究

研究采用水泥作固化基材固化处理某印刷线路板厂酸性废水用石灰混凝所产生的含铜、锡、金的污泥 ,对固化块在不同 pH的水中重金属Cu2 +的浸出实验结果表明 :水泥固化处理该混凝污泥效果良好 ,控制合适的条件 ,可得到混合性能好、初凝时间适当、抗压强度较好的固化块。Cu2 +的浸出率低于允许浸出浓度。混凝过程中加入硫脲硅酸钠等助剂 ,可提高固化效果。研究还对几种不同配比的固化块抗压强度进行了探讨。     

金属板料成形摩擦机理研究

对不锈钢板料和碳钢在金属塑性成形时 (高接触压力 )的摩擦机理进行了实验研究 ,分析了压力对滑动阻力和摩擦系数的影响 ,得出了随压力增大摩擦系数逐渐变小的结论 ,从而为应用有限元法进行板料成形过程中塑性变形的计算机模拟提供真实的边界条件打下了基础。     

南昌市环境空气质量分析和控制

利用多年的环境监测数据,分析南昌市环境空气中主要污染物尘类、二氧化硫和氮氧化物产生的原因,并提出有效控制上述污染物的具体措施。     

厦门湾海域表层沉积物重金属和多环芳烃污染特征及生态风险评价

研究了厦门湾海域表层沉积物中Cu,Pb,Zn,Cr,Cd,Hg和As和16种多环芳烃的分布、来源及潜在的生态风险.结果表明:(1)Cu,Pb和As平均含量均介于效应浓度区间低值(ERL)和效应浓度区间中值(ERM)之间,而大多数站位Zn,Cr,Cd和Hg平均含量则低于ERL值;(2)沉积物多环芳烃(PAHs)以石油或油料燃烧来源为主,PAHs的总量远低于ERL值(4000μg·kg~(-1));(3)重金属与低环PAHs相关性显著,易发生交互作用;(4)利用沉积物平均效应区间中值商法(mERM-Q)进行沉积物生态风险评价发现,筼笃湖表层沉积物对海洋底栖生物可能存在较强的生物毒性风险.     

矸石基X型分子筛对水中Co2+、Cu2+、Cd2+和Cr3+的去除

以煤矸石为原料,采用碱熔后水热合成法制备X型分子筛并进行XRD、SEM、BET和Zeta电位分析。研究其对水中Co2+、Cu2+、Cd2+和Cr3+4种离子的吸附性能,包括吸附等温线、吸附动力学以及初始金属离子浓度、pH值对吸附性能的影响。所合成的矸石基X型分子筛的BET比表面积为676.02 m2/g,微孔孔容为0.263 cm3/g。吸附实验表明,矸石基X型分子筛能有效去除上述4种离子,同时实现煤矸石的资源化和金属离子的去除。4种离子的平衡吸附量均随初始浓度的增大而增大,相同条件下平衡吸附量的大小顺序为Cd2+>Cr3+>Cu2+>Co2+。准二级动力学模型能很好地描述4种离子的吸附动力行为。Langmuir模型对Co2+、Cu2+和Cd2+吸附的拟合较Freundlich模型高,说明其主要表现为物理吸附过程。4种离子的吸附速率均由液膜扩散和颗粒内扩散共同控制。     

Heavy Metal Contents of the Karasu Creek Sediments, Nigde, Turkey

Heavy metal contamination in sediments of the Karasu spring was investigated in the presented study. In this respect, sediment samples were collected from contaminant sites along the spring starting from the spring water manifestation site, base of the Akkaya dam to the dam exit site. Heavy metal concentrations were determined by X-ray Fluorescence Spectrometer. Cobalt, copper, arsenic, tin, nickel, zinc, cadmium, lead, aluminum, iron, titan, chromium and manganese contents of the Karasu creek sediments are found as 18.30–69.00, 12.40–595.0 5.50–345.3, 5.80–15.1, 10.9–64.1, 28.90–103,300, 4.1–356.2, 7.70–37,840, 13,460–109,400, 11,740–62,900, 22.18–59.04, 41.70–369 and 12.09–3,480 mg/kg, respectively. Results indicate the presence of a contamination in the Karasu creek. All the metal concentrations were found to be exceeding their acceptable limit values. Eutrophication is developed in the Karasu creek and the Akkaya dam. It is thought that heavy metal accumulation in the creek is originated from discharge from mine quarries, industrial and domestic wastes. Protection zones should be defined and all necessary measures must be taken along the Karasu creek.     

Optical and Chemical Methods of Metal Ash Analysis and Tin Recovery

‘Metal ash’ presents a waste disposal problem in most of the developing countries as the industries employ obsolete technologies. In this paper we describe analysis of tin ash, zinc ash and aluminium ash by means of optical methods, such as X-ray diffraction (XRD), inductively coupled plasma mass spectrometry (ICP-MS), electron probe micro analysis (EPMA), scanning electron microscopy (SEM) and chemical methods. The results of tin ash obtained by XRD method matched well with the cassiterite, a naturally occurring mineral of tin. ICP-MS studies reveal the presence of a large number of tracer metals, which may cause pollution by tertiary dispersion and this aspect is discussed. Conversely, the data generated by chemical methods are limited. However, the methods are simple and cost-effective. Then, they can easily be adopted by low-budget industries. Simple and cost-effective process to recover tin from tin ash is described. It is based on heating tin ash with sodium cyanide to about 900°C to separate tin component from the metal ash. The process recovers good quality tin and offers a very high yield. The process can be scaled up to small pilot plant.