多壁碳纳米管序列修饰聚氯乙烯超滤膜的制备及性能研究

采用硫酸、硝酸混酸改性多壁碳纳米管(MWCNTs),通过化学水热法在改性的MWCNTs表面负载纳米Fe_3O_4,将负载Fe_3O_4的MWCNTs(MWCNTs/Fe_3O_4)与PVC在无磁场、有磁场作用下共混制膜,获得MWCNTs无序排列、有序排列修饰的PVC超滤膜,同时,制备了纯PVC膜以作比较.对共混膜有序修饰机制及断面形态进行了分析,对相关性能参数如接触角、膜的溶胀、膜孔隙率、膜平均孔径、纯水通量、截留性能及吸附性能等进行了研究.研究结果表明:MWCNTs/Fe_3O_4的加入使膜的亲水性、纯水通量、截留性能等有了显著提高,MWCNTs有序排列修饰使膜在表皮层形成了更加致密,更为狭长的微孔结构,具有了更优异的导流网络通道,在长时间运行条件下仍能保持良好的过滤负荷,提高了膜的性能.     

纳滤去除水中的内分泌干扰物

采用陶氏DOW FILMTEC NF270芳香聚酰胺类复合纳滤膜处理水中内分泌干扰物——17α-乙炔雌二醇（EE2）,实验中分别考察了原液浓度、操作压力、pH值、Ca²⁺浓度及腐殖酸共存等不同条件下对EE2截留效果的影响。结果表明,NF270对于去除水中的EE2具有很好的效果,截留率可达到97.6%,而且,实验发现,原液浓度对EE2的截留效果影响较小;当操作压力为0.6 MPa时,膜对EE2的截留效果最好;而随着pH值和Ca²⁺浓度的增加,膜对EE2的截留率均呈上升趋势;而当腐殖酸存在时膜对EE2的截留率有明显提高,但同时也造成膜污染加剧和膜通量下降,特别是在EE2、腐殖酸和Ca²⁺共存时,膜污染更加严重。     

酒石酸钾钠（PST）对纳滤处理重金属废水的强化效果

以酒石酸钾钠（PsT）为络合剂,分别选取cd、zn、As和Ph4种金属废水,探索络合纳滤工艺对金属离子去除率和膜通量的强化效果,测定纳滤膜表面接触角以表征膜通量变化规律,并研究了压力、金属浓度和溶液pH参数对络合纳滤过程的影响。结果表明,PsT对4种金属去除的强化效果存在相似规律,分别有一个最佳PsT添加浓度。随PsT浓度的增加,金属离子去除率先增大后减小,而膜通量一直增大。研究发现,纳滤膜表面接触角与膜通量呈稳定的反比例关系,与金属离子种类和PsT添加量无关。随着操作压力的增大,膜通量线性增加,去除率基本不变;金属离子浓度的增加对膜通量影响不大,金属去除率略有上升;pH在4～5之间变化时,As去除中膜通量和去除率均有所升高,而cd、zn和Ph3种溶液处理效果基本不受pH影响。     

混凝-纳滤集成工艺深度处理脱墨废水简

采用混凝-纳滤工艺对脱墨废水生化出水进行深度处理。实验结果表明,当聚合氯化铝的投加量为100 mg/L时,废水中污染物的综合去除性能最佳,其中浊度去除率达91%,色度去除率达74%。采用4种相同材质、不同切割分子量的纳滤膜进一步深度处理后,出水达到《再生水质标准（SL368-2006）》中锅炉用水控制指标的要求。     

DOM对纳滤膜去除磺胺甲恶唑效果影响研究

试验研究几种不同可溶性有机物(DOM)对纳滤膜(NF)去除抗生素磺胺甲恶唑(SMZ)的影响效果.试验所用DOM选定腐殖酸(HA)、单宁酸(TA)和海藻酸钠(SA).结果显示3种DOM对SMZ去除率和通量影响迥异,并与DOM的亲疏水性有密切的关系.为更好了解DOM对NF去除SMZ的影响机理,试验对臭氧化HA也进行了研究.臭氧化HA相对于臭氧前HA亲水性显著提高,对SMZ去除率的影响相应提高.结果表明在有多种DOM共同存在的天然原水中,SMZ的去除机理十分复杂,DOM的本身物理化学性质对于目标物的去除效果十分重要.     

膜表面光接枝改性的研究现状及展望

本文介绍了利用紫外光将单体接枝到聚合物表面的技术原理与条件 ,并介绍了分离膜表面进行光接枝聚合的研究进展及发展趋势     

Effects of ion concentration and natural organic matter on arsenic(V) removal by nanofiltration under different transmembrane pressures

The removal of As(V) from synthetic water was studied using four different nanofiltration (NF) membranes (ESNA-1-K1, NF270, ESNA-1-LF, and HODRA-CORE). The influences of ion concentration, transmembrane pressure (TMP), and the presence of natural organic matter (humic acid, HA) on the arsenic removal efficiency and permeate flux were investigated. The arsenic rejection of ESNA- 1-LF was higher than those of the other membranes in all experiments (> 94%), and the HODRA-CORE membrane gave the lowest removal of arsenic (< 47%). An increase in the ion concentration in the feed solution and addition of HA decreased the arsenic rejection of the HODRA-CORE membrane. However, both increasing of the ion concentration and addition of HA made the rejection increased for the other membranes (ESNA-1-K1, NF270, and ESNA-1-LF). With increasing TMP, for all four NF membranes, increases in both arsenic rejection and permeate flux were observed. The permeate fluxes of the four NF membranes decreased to some extent after addition of HA to the solutions for operating time of 6 hr.     

Mechanism of combination membrane and electro-winning process on treatment and remediation of Cu^2＋ polluted water body

Mechanism of treatment and remediation of synthetic Cu2+ polluted water body by membrane and electro-winning combination process was investigated. The influences of electrolysis voltage, pH, and electrolysis time on the metal recovery efficiencies were studied. Relationship between trans-membrane pressure drop ( P), additions ratio, initial Cu2+ concentration on operating efficiency, stability of membrane and the possibility of water reuse were also investigated. The morphology of membrane and electrodes were observed using scanning electron microscopy (SEM), the composition of surface deposits was ascertained using combined energy dispersive X-ray spectroscopy (EDX) and atomic absorption spectrophotometer. The results showed that using low pressure reverse osmosis (LPRO), Cu2+ concentration could increase from 20 to 100 mg/L or even higher in concentrated solutions and permeate water conductivity could be less than 20 μS/cm. The addition of sodium dodecy/sulfate sodium dodecyl sulfate improved Cu2+ removal efficiency, while EDTA had little side influence. In electro-reduction process, using plante electrode cell, Cu2+ concentration could be further reduced to 5 mg/L, and the average current efficiency ranged from 9% to 40%. Using 3D electrolysis treatment, Cu2+ concentration could be reduced to 0.5 mg/L with a current efficiency range 60%–70%.     

脂肪族及杂环分子结构和纳滤膜特性对截留率的影响规律

选择20种脂肪族及杂环化合物作为模型污染物,分别测定了三种不同纳滤膜对脂肪族及杂环化合物的截留率.结果表明,脂肪族及杂环化合物的截留率受到分子的分枝结构、环状结构、酸性和膜特性的影响:对于同分异构体,分枝结构愈多,截留率愈高;环状有机物与分子量相近的直链有机物相比,截留率明显偏高;脂肪酸的截留率高于绝大多数醇类、醚类和酮类等不离解的化合物;孔径小、荷电量大的纳滤膜截留率更高.通过基于遗传算法结合偏最小二乘回归法(GA-PLS)建立了纳滤膜对脂肪族及杂环化合物截留率的定量构效关系模型,通过分析回归方程,可以看出膜与脂肪族及杂环化合物之间的电性作用并不是影响截留率的主要因素,而分子形状和大小对截留率的影响很显著.     

混凝-纳滤集成工艺深度处理脱墨废水

采用混凝-纳滤工艺对脱墨废水生化出水进行深度处理。实验结果表明,当聚合氯化铝的投加量为100mg／L时,废水中污染物的综合去除性能最佳,其中浊度去除率达91％,色度去除率达74％。采用4种相同材质、不同切割分子量的纳滤膜进一步深度处理后,出水达到《再生水质标准（SL368—2006）》中锅炉用水控制指标的要求。