Conversion regular patterns of acetic acid, propionic acid and butyric acid in UASB reactor

On the basis of continuous tests and batch tests, conversion regular patterns of acetate, propionate and butyrate in activated sludge at different heights of the UASB reactor were conducted. Results indicated that the conversion capacity of the microbe is decided by the substrate characteristic when sole VFA is used as the only substrate. But when mixed substrates are used, the conversion regulations would have changed accordingly.Relationships of different substrates vary according to their locations. In the whole reactor, propionate‘s conversion is restrained by acetate and butyrate of high concentration. On the top and at the bottom of the reactor, conversion of acetate, but butyrate, is restrained by propionate. And in the midst, acetate‘s conversion is accelerated by propionate while that of butyrate is restrained. It is proved, based on the analysis of specific conversion rate, that the space distribution of the microbe is the main factor that affects substrates‘ conversion. The ethanol-type fermentation of the acidogenicophase is the optimal acid-type fermentation for the two-phase anaerobic process.     

Experimental study on Cr(Ⅵ) reduction by Pseudomonas aeruginosa

Investigation on Cr(Ⅵ) reduction was conducted using Pseudomonas aeruginosa. The study demonstrated that the Cr(Ⅵ) can be effectively reduced to Cr(Ⅲ) by Pseudomonas aeruginosa. The effects of the factors affecting Cr(Ⅵ) reduction rate including carbon source type, pH, initial Cr(Ⅵ) concentration and amount of cells inoculum were thoroughly studied. Malate was found to yield maximum biotransformation, followed by succinate and glucose, with the reduction rate of 60.86%, 43.76% and 28.86% respectively. The optimum pH for Cr(Ⅵ) reduction was 7.0, with reduction efficiency of 61.71% being achieved. With the increase of initial Cr(Ⅵ) concentration, the rate of Cr(Ⅵ) reduction decreased. The reduction was inhibited strongly when the initial Cr(Ⅵ) concentration increased to 157 mg/L. As the amount of cells inoculum increased, the rate of Cr(Ⅵ) reduction also increased. The mechanism of Cr(Ⅵ) reduction and final products were also analysed. The results suggested that the soluble enzymes appear to be responsible for Cr(Ⅵ) reduction by Pseudomonas aeruginosa, and the reduced Cr(Ⅲ) was not precipitated in the form of Cr(OH)3.     

典型耐候钢在江津大气环境中暴晒1 a的腐蚀行为

目的 研究3种典型耐候钢在江津大气环境中暴晒1 a的初期腐蚀行为。方法 采用户外大气挂片、腐蚀质量损失、SEM、XRD、电化学等方法,研究Q355NH、Q460FRW、Q690的腐蚀速率、锈层形貌、锈层物相和锈层电阻,并与Q345碳钢进行对比。结果 耐候钢和碳钢在大气暴晒初期的腐蚀规律是一致的,Q355NH、Q460FRW、Q690和Q345碳钢的腐蚀速率分别为0.050 9、0.053 6、0.047 8、0.055 mm/a,Q690的腐蚀速率最小,约为碳钢的87%。耐候钢和碳钢的锈层都主要由α-FeOOH、γ-FeOOH和Fe₂O₃组成,耐候钢的锈层更致密,裂纹更少。Q355NH、Q460FRW、Q690的锈层电阻值分别为821.3、1 005、1 080?·cm²,碳钢为101.68?·cm²,耐候钢的锈层电阻值约为碳钢的10倍。Cr和Cu元素在耐候钢的锈层中富集明显。结论 耐候钢的腐蚀速率低于碳钢,3种耐候钢的耐蚀性顺序为Q690>Q355NH>Q460FRW。Cr和Cu元素在...     

汽车环境风洞地面区域流场数值仿真

目的 探究汽车环境风洞地面区域流场规律,获取风洞边界层抽吸装置的最佳抽吸率和底盘测功机对风洞地面区域边界层厚度、风速、总压和静压的影响规律,并比较MRF法和旋转壁面法对底盘测功机转毂转动模拟的精度。方法 运用计算流体动力学方法对汽车环境风洞流场进行数值仿真计算。结果 边界层抽吸装置对应于喷口风速120 km/h时的最佳抽吸率为0.048。底盘测功机区域总压呈现下降趋势。相比于存在底盘测功机,汽车环境风洞无底盘测功机时,底盘测功机区域内相同位置的边界层厚度会增加1.28～12.22 mm。在前转毂的前侧、上侧、后侧和后转毂的上侧和后侧会有一个高风速区域,区域内风速比设定风速高1%～4%,与无底盘测功机相比,区域内静压值低0.32～46.02 Pa。在前后转毂前侧和后侧与地面相连接的凹部会有一个低风速区域,区域内风速比设定风速低1%～5%,与无底盘测功机相比,区域内静压值高0.08～49.34 Pa。底盘测功机转毂的转动会使附近区域的地面边界层厚度变大。在前转毂前侧,采用旋转壁面法进行模拟比MRF法地面边界层厚度增加近8 mm,而在其他位置,2种模拟方法对边界层厚度的模拟差别在1.5 mm...     

加速量热仪在物质热稳定性研究中的应用

加速量热仪（ARC）是一种基于绝热原理设计的热分析仪器,与其它热分析仪器相比,加速量热仪可以测量克量级的固体或高闪点液体样品,具有测试样品最大,敏感度高等特点,并能够实时记录样品放热反应过程中的温度和压力变化,以过氧化氢叔丁基为例说明加速量热仪测试结果在研究物质质变热稳定性方面的应用,得到了过氧化氢叔丁基放热分解反应的温度－时间和压力－时间关系曲线以及升温速度和压力随温度变化的曲线,通过计算和分析得到了反应系统升压速率随压力的变化曲线,计算出了过氧化氢叔丁基分解反应的动力学参数表观活化能Ea和指前因子A。     

区域电网火电厂对水环境影响评价指标研究

区域电网内所有火电厂对区域水环境影响评价指标是进行区域火电厂规划环评的基础.通过对区域电网内火电厂对区域水环境影响的共性研究,提出了区域电网内火电厂取水影响、排水影响和水污染物影响3项评价指标;在此基础上利用和积法计算各指标的权重,依据权重求得区域水环境综合影响评价指标.评价指标在华东电网火电厂区域水环境影响评价中进行了应用,结果表明,华东电网火电厂对区域水环境的影响程度由大到小依次为黄浦江、太湖、巢湖、淮河、长江和钱塘江.      

序批式反应器处理精对苯二甲酸废水

采用序批式反应器（SBR）处理模拟精对苯二甲酸（PTA）废水,考察了曝气量、沉降时间、进水方式等对对苯二甲酸（TA）生物降解效果的影响。实验结果表明,对于TA质量浓度小于1500mg／L的废水,采用完全曝气SBR运行4h,TA和COD的去除率均能达到95％以上,TA平均去除速率随TA浓度的增加而增大。TA质量浓度为1500mg／L时,曝气量、沉降时间和进水方式是影响其降解效果的主要因素。采用SBR处理高浓度PTA废水可克服污泥膨胀和抗冲击负荷能力弱的问题,且系统的稳定性和PTA废水的处理效果较好。     

膨胀颗粒污泥床反应器在低温低浓度下的动力学研究

在考虑膨胀颗粒污泥床(EGSB)反应器的反应动力学、水力动力学和热动力学特点的基础上,建立了EGSB反应器在低浓度下的基质降解动力学模型,求出EGSB反应器在进水COD450m g/L、35,15℃(与35℃同样的液体上升流速)和15℃(提高液体上升流速至最佳)3种运行条件时的速率常数分别为3.91×102,1.07×102,2.54×102d-1。用A rrhenius方程分析了温度对速率常数的影响,计算出EGSB反应器在提高液体上升流速前后的活化能分别为4.897×104J/m o l和1.197×104J/m o。l低温使速率常数明显降低,但液体上升流速的提高却能显著提高速率常数,降低活化能。     

常温SBR厌氧-好氧反应器的短程硝化

短程硝化-反硝化是污水节能脱氮新技术之一,其关键在于实现短程硝化,而水温是控制短程硝化的主要因素。在生活污水氨氮浓度小于100mg/L的水质条件下,采用SBR厌氧-好氧反应器进行了常温短程硝化试验研究。研究结果表明,水温14．5℃～16．5℃的条件下,在好氧段可以实现短程硝化,亚硝化率达到了94．9%。亚硝化的程度还与曝气时间的长短有关,曝气时间短时,可以将氨氧化控制在亚硝化阶段,积累大量的亚硝酸盐,但是氨转化率比较低;曝气时间延长,氨氮去除率增加,同时部分亚硝酸氮会被进一步氧化成硝酸氮。该研究结果打破了只有在中高温条件下才能实现短程硝化的普遍看法,从而为在常温下实现短程硝化提供了新的依据。     

A remote sensing system of vehicle emissions based on tunable diode laser technology

As being an effective real-time method of monitoring vehicle emissions on-road, a remote sensing system based on the tunable diode laser （TDL） technology was presented, and the key technologies were discussed. A field test in Guangzhou（Guangdong, China） was performed and was found that the factors, such as slope, instantaneous speed and acceleration, had significant influence on the detectable rate of the system. Based on the results, the proposal choice of testing site was presented.