循环流化床干法脱硫除尘一体化工艺去除汞探讨研究

目前,由于人类污染源每年向大气排汞量日益增长,使国际上对汞排放的控制研究成为热点,本文通过理论计算及工程实例说明了循环流化床干法烟气脱硫除尘一体化工艺系统可以有效地控制燃煤电厂汞的排放。     

太湖山地强降雨事件中不同水体的氮磷负荷分析

夏季暴雨洪水是太湖山区氮磷营养盐流失的主要载体,对强降雨事件中的不同水体农业养分负荷的观测和分析,将有助于更准确地评估农业非点源污染。在台风“麦莎”期间,选择典型山区流域对台风降雨径流过程进行观测。结果表明太湖山地短时强降水事件中,地下径流约占总径流的51％,而对无机氮径流负荷的贡献在80％以上;可溶性总磷在河道径流中的浓度低于在地下水和地表径流中的浓度,显示可溶性磷在汇流过程中被截留,说明可溶性磷的迁移具有流域尺度的迟滞特征。     

钙镁磷肥生产富氧空气助燃节能可行性分析

介绍了钙镁磷肥传统生产方法,分析了钙镁磷肥高炉富氧空气助燃的可行性,认为该方法可行。     

吡草醚水解动力学的研究

研究了吡草醚在不同pH和温度条件下的降解动力学情况,以及在三种生态水样和土悬液中的水解情况。结果表明,吡草醚在酸性水环境中比较稳定,在中性和碱性环境中易降解;水解反应速率随反应温度的升高而增大;吡草醚在三种生态水中的降解速率较快,降解半衰期分别为：水库水4．56d,河水3．96d,池塘水1．35d;吡草醚在土悬液中降解较快,这与其碱性条件和含量较高的可溶性碳有关。     

新标准下垃圾焚烧飞灰化学稳定技术的比选和研究

研究了新的生活垃圾填埋场污染控制标准(GB168892008)实施后,飞灰要进入生活垃圾卫生填埋场时传统的重金属稳定方法可行性,并在此基础上提出了新的复合药剂稳定法.研究结果表明,已经报道的化学药剂稳定法均有必要重新检验其对重金属的稳定效果是否满足新的填埋标准的要求.绿矾与TMT-18配合使用、绿矾用量为25%（质量分数）以下、TMT-18的用量为8‰左右时完全可以使飞灰中所有重金属浸出浓度满足新的填埋标准要求,是处理二噁英含量不高于3 ng·g-1(以TEQ计)飞灰的一种经济处理技术.对二噁英含量高于3 ng·g-1 (TEQ)的飞灰,采用绿矾辅助水热处理的方法可以稳定包括Pb、Cd在内的所有重金属和降解二噁英使之符合新填埋标准对飞灰填埋的要求.     

A methodology for assessment of long-term exposure to whole-body vibrations in vehicle drivers to propose preventive safety measures

Introduction: The appearance of musculoskeletal disorders (MDs) in professional drivers due to exposition to whole-body vibration (WBV) makes it relevant to assess this exposure. The European Directive 2002/44/EC has two methods to evaluate exposure to WBV (defined in ISO2631-1:2008). These methods evaluate the exposure associated with an 8-hour working day; however, MDs due to WBV could also be caused by accumulated exposure to vibrations over long term, and hence, the methods defined in the European directive may be limited in their ability to ensure the safety of workers exposed to WBV throughout their years of employment. Method: A detailed comparison and discussion of methods defined in the European Directive and the ISO2631-5:2018 was used as a starting point of the main results of this paper. On this basis, a new methodology for the management and organization of preventive measures is proposed to consider the assessment of ISO2631-5:2018 standard and the full working life of workers. Experimental data to assess exposure to WBV in heavy equipment vehicle (HEV) drivers under different road surface conditions and range of velocities were considered to illustrate the process of the proposed methodology. Results: The methods defined in the standards provide different assessments leading to a different possible consideration of safe operations when the risks associated with them may actually be high. The proposed methodology can be used with the aim of ensuring safety of workers throughout their working lives and providing an easy implementation of the calculations of ISO2631-5:2018 standard. Conclusions: A procedure to assess the health risk probability to which the HEV worker is exposed in terms of the exposure years and a different range of operational vehicle speeds is proposed and exemplified with a study case. Practical applications: This study provides a practical tool for the management of WBV exposure related to work-tasks in HEV drivers. Safety managers should consider the global exposition to WBV throughout their working life, and this research provides an easy tool to accomplish it.     

宿迁市区负氧离子浓度变化与气象要素相关分析

对宿迁市区负氧离子浓度变化与气象要素的相关关系进行了分析。试验分析表明：宿迁市区年平均负氧离子浓度为1031个／cm^3,达到保健浓度水平,对人体健康有利;其中6月至次年1月高于保健浓度标准,2—5月负氧离子浓度在允许浓度范围,且远高于临界浓度。其中夏季负氧离子浓度最高,平均为1257个／cm^3,高于保健浓度标准,对人体健康有利;秋冬分别为965,1080个／cm^3,接近保健浓度水平,对人体健康有利;春季最小为823个／cm^3,对人体健康较有利。一天中负氧离子浓度凌晨最大,中午前后最小。负氧离子浓度变化与相关气象要素关系密切：月平均浓度与月平均相对湿度和降水量呈正相关;日平均浓度与日照时数呈负相关,与最小相对湿度、平均温度距平呈正相关;有雷电日和有降水日的负氧离子浓度比无雷电和无降水日明显偏高;逐时浓度与温度呈明显的负相关。     

超声辐照去除焦化废水中的氨氮

采用超声辐照去除焦化废水中的氨氮,在废水初始pH为8～9、氨氮初始质量浓度为121mg／L、饱和气体同时曝气同时超声的作用方式下对氨氮去除效果最佳。通过测定自由基清除剂对氨氮去除过程的影响和氨氮的转化形态,提出了超声去除氨氮的作用机理可能是溶液中的氨分子进入空化泡内进行高温热解反应最终转化成氮气和氢气的过程。     

用溴化容量法测定间甲酚的含量

探讨了间甲酚含量的容量分析方法。通过试验确定了利用溴化容量法测定间甲酚含量的最佳分析条件：反应温度为18～30℃、溴化反应时间为8～10min、溴化反应的酸度为1．0～1．5mol／L、溴过量50％～100％。此法简便快速,精密度好,准确度高,对高浓度和低浓度的试样均能获得满意的结果,检出下限为0.5％(5mg／L)。     

芳香烃清洁硝化催化剂

综述了国内外有关芳香烃硝化过程中替代硫酸的催化剂的研究进展;介绍了沸石类催化剂、粘土类催化剂、离子交换树脂催化剂、固载化液体酸催化剂、金属氧化物及金属盐催化剂、杂多酸催化剂以及固体超强酸催化剂的合成及催化效率与优缺点.