旋转切向流聚丙烯管式膜微滤能耗分析

设计了一种新型旋转切向流聚丙烯管式膜器,实验研究了聚丙烯PA管式膜器的能耗通过建立的旋转切向流强化微滤实验装置系统,测定了聚丙烯PA管式膜器在旋转切向流和轴向流下的膜通量与能量有效利用率.实验结果表明,旋转切向流管式膜微滤比一般轴向流膜微滤的有效利用率要高得多,是一种非常有效的强化膜分离技术在实验条件下,直线切向流膜微滤和圆弧切向流膜微滤的稳态能量有效利用率比轴向流稳态能量有效利用率分别高11.185倍和14.591倍.     

洪水泥石流等自然灾害对旅游景区的破坏作用研究

通过泥石流灾害模拟模型与灾害损失率计算方法了解旅游景区的损失状况,研究自然灾害对旅游景区的破坏作用。旅游景区洪灾模拟模型由分流模型与汇流模型构成,根据泥石流多相流成分中固液两相分离原则构建泥石流分流模型;引用DEM数据得到泥石流流域栅格的汇流方向,根据经验模型计算汇流用时,采用八方向方法获取河道信息,基于这些数据构建泥石流模拟的汇流模型,采用ArcGis软件实时呈现该模型的泥石流灾害模拟效果;结合ArcGis软件显示的灾情数据,采用洪灾损失率计算方法获取旅游景区自然灾害损失率。实验结果表明,该模型计算旅游景区建筑损失率误差均小于5%,在有效模拟泥石流灾害的同时,可准确描述自然灾害对旅游景区的破坏作用。     

Recovery of Ni(II) from real electroplating wastewater using fixed-bed resin adsorption and subsequent electrodeposition

Resin adsorption and subsequent electrodeposition were used for nickel recovery. Treated wastewater can meet the Electroplating Pollutant Discharge Standard. The spent resin is completely regenerated by 3 BV of 4% HCl solution. 95.6% of nickel in concentrated eluent was recovered by electrodeposition. Effective recovery of high-value heavy metals from electroplating wastewater is of great significance, but recovering nickel ions from real electroplating wastewater as nickel sheet has not been reported. In this study, the pilot-scale fixed-bed resin adsorption was conducted to recover Ni(II) ions from real nickel plating wastewater, and then the concentrated Ni(II) ions in the regenerated solution were reduced to nickel sheet via electrodeposition. A commercial cation-exchange resin was selected and the optimal resin adsorption and regeneration conditions were investigated. The resin exhibited an adsorption capacity of 63 mg/g for Ni(II) ions, and the average amount of treated water was 84.6 bed volumes (BV) in the pilot-scale experiments. After the adsorption by two ion-exchange resin columns in series and one chelating resin column, the concentrations of Ni(II) in the treated wastewater were below 0.1 mg/L. After the regeneration of the spent resin using 3 BV of 4% (w/w) HCl solution, 1.5 BV of concentrated neutral nickel solution (>30 g/L) was obtained and used in the subsequent electrodeposition process. Using the aeration method, alkali and water required in resin activation process were greatly reduced to 2 BV and 3 BV, respectively. Under the optimal electrodeposition conditions, 95.6% of Ni(II) in desorption eluent could be recovered as the elemental nickel on the cathode. The total treatment cost for the resin adsorption and regeneration as well as the electrodeposition was calculated.     

The deflectors influence on flow complexity,bed morphology,sediment transport and water quality of urban lotic waters - A laboratory study

In this laboratory study different combinations of bed (sand, pebble gravel [gravel], and a mix of sand and gravel) and flow (typical and overtopping) were experimented with to investigate the impact of porous deflectors in flow diversity, water quality, and fish performance in prismatic open channels. Deflectors changed the gradually varied flow to a rapidly varied flow, as a sudden change in the water depth was observed at the deflectors, and this change was large for smooth beds. With the presence of gravel, the scouring near the downstream deflector was almost twice that of the sand bed, and with the scouring at its own upstream deflector, irrespective of whether the flow was typical or overtopping. This behavior was a result of sand mobilization due to shear stress and sand mobilization aided gravel transport. The mixed bed showed less gravel movement compared to the gravel-only bed. The percentage of sediment washed out was minor for all bed scenarios, indicating that sediment transport was local. Relative to the sand bed without deflectors (representing a typical urban canal), deflectors resulted in reduced and improved water quality (in terms of sediment load) for sand, and mixed bed, respectively. The fishes found refuge and were comfortable in the pool areas created by deflectors unlike in channels without deflectors where they showed exhaustion.     

综合拉底、扩漏和出矿全过程的底部结构安全性颗粒流模拟技术研究

为探明自然崩落法从拉底崩落至出矿全过程中底部结构节理连续扩展过程与破坏过程规律，采用PFC2D软件，结合RocLab软件反演节理岩体参数，建立229 m×129 m的岩体扩大模型，对拉底崩落至出矿过程进行连续综合计算。研究结果表明:模拟结果及破坏现象与现场监测结果相近，建模与细观参数反演方法适用于该类岩体工程研究；裂纹扩展贯通导致岩体失稳破坏，破坏过程与裂纹扩展具有相对应的阶段特征，裂纹扩展分为崩落前稳定扩展期，崩落与聚矿槽开挖过程加速扩展期和后续持续扩展期；结构破坏分为蕴育过程，扰动失稳过程和宏观破坏过程；较大范围的宏观破坏主要在出矿阶段。该模拟方法与结果可为底部结构维护以及节理岩体长期稳定性研究提供参考。     

Dynamic pressure induced by a methane–air explosion in a coal mine

The hazardous effect of dynamic pressure and strong gas flows induced by a methane–air mixture explosion in underground coal mines is studied. The dynamic pressure effect of a methane–air explosion was analyzed by numerical simulation, in a duct and tunnel. Compared to the overpressure generated by an explosion that can act on a body, the dynamic pressure caused by the high-speed flow of the gaseous combustion products can cause serious damage as well. At the structural opening of a coal mine, the destruction caused by the dynamic pressure induced by a methane–air explosion is more serious than the overpressure. For a tube or tunnel partially filled by a methane–air mixture, the dynamic pressure is lower than the overpressure in the region occupied by the flammable mixture. Beyond the premixed region, the dynamic pressure is of the same order of magnitude as the overpressure.     

粉末活性污泥处理含铀废水的特性

以生活污水处理厂剩余活性污泥为原料,制备粉末活性污泥(PAS)作为生物吸附剂,考察p H值,PAS投加量,U(Ⅵ)初始浓度和吸附时间对PAS吸附U(Ⅵ)的影响,探讨了PAS吸附U(Ⅵ)的作用机理。实验结果表明,在U(Ⅵ)初始浓度为10 mg/L时,其最佳吸附p H值为3,去除率97.77%,吸附平衡时间120 min;吸附过程较好地拟合了准二级动力学模型(R2≈1)和Freundlich等温模型(R2≈1);X射线能谱和离子交换实验分析表明,离子交换为其主要吸附方式,参与交换的主要离子为Ca2+;红外光谱分析表明,PAS吸附U(Ⅵ)后自身结构未发生改变。以0.1 mol/L的HCl溶液作为解吸液,初次解吸率达92.83%,循环利用3次仍具有较好的吸附效果。     

双风机并联机站局阻特性研究

为探究双风机并联机站局部阻力特性、完善机站局部阻力及其系数的计算公式,以实际矿井通风机站为工程背景,在分析机站流场能量损失机理的基础上,采用物理模型实验和数值计算相结合的方法,分析了机站入口分流、出口汇流的断面速度不均匀程度与机站阻力损失的关系,同时对不同宽高比的矩形断面进行多工况模拟。结果表明:断面速度不均匀性越大,速度分布重组造成的阻力损失越大;确定了机站局阻计算所需参数的合理测定位置,得出机站局阻系数计算时的综合影响系数Kc随风机工况增大而增大、随断面宽高比A增大而减小,并呈现较好的线性关系。研究结果可为多级机站通风系统通风阻力特性分析以及工程优化设计提供参考。     

基于CFD-DEM的旋风除尘器内气固流动特性研究

为了研究旋风除尘器内气固流动特性,采用CFD-DEM耦合算法研究不同入口气体速度下旋风除尘器内颗粒流态、静压、径向速度及轴向速度分布特征。结果表明:煤屑颗粒在离心力和径向曳力的作用下以螺旋颗粒条带靠近除尘器的壁面稳定向下移动,随着入口风速的增加煤屑颗粒条带变宽,条带与除尘器的第1次接触的拐点上移,螺距减小;除尘器内部压力轴向变化较小,径向变化较大,随着入口气体速度增加,除尘器壁面附近高压区范围和压力也随之增加,除尘器上方和下方的负压区变宽并朝轴向方向延伸;随入口气体速度增加,除尘器内径向速度和轴向速度逐渐增加,煤屑颗粒在除尘器中部聚集较多,煤屑停留时间变长,入口气体速度为15 m/s时,煤屑颗粒在除尘器内停留时间最长。     

基于热湿交换理论的巷道风流温、湿度影响因素研究

为了研究巷道风流参数的影响因素、预测风流温湿度的变化规律,结合热湿交换理论,建立了风流与围岩壁面之间热湿交换的数学模型,以及贴体坐标系下围岩内部温度场的导热微分方程;利用数值方法,将围岩内部的导热问题与影响风流参数变化的热湿交换问题耦合起来,并以大柳塔煤矿52505综采工作面为例进行计算,得到了与实测参数较为一致的模拟结果,验证了该数值方法的有效性。研究结果表明:风流温度受原始岩温、入风流温度、局部热源强度等因素的影响,风流相对湿度与入风流温、湿度以及井下湿源的数量和强度有关;巷道壁温作为将围岩温度场与风流参数之间关联起来的主要因素,对模拟结果影响较大,其数值取决于壁面与风流之间热湿交换以及围岩原始岩温。