腈纶污水的分质处理

介绍某公司腈纶污水的水质特点，处理工艺、主要设备及构筑物设计参数。该污水预处理装置运行以来，处理效果良好，符合后续生化处理的进水要求。     

ORBAL氧化沟在炼油污水处理上的应用

总结了石炼污水处理场采用ORBAL氧化沟做为二级生化处理设施的成功经验，并对ORBAL氧化沟和周边进水，周边出水二沉池的运行机理进行了说明。     

难降解有机废水处理新技术

介绍了光氧化法、超临界氧化和低温等离子体化学三种废水处理新技术的原理,国内外研究的现状和未来的发展前景,分析了这些新技术在优化污染物废水处理方面得到工业应用所必须解决的主要技术问题.     

GdFeO3上CO氧化的Redox机理动力学

ＧｄＦｅＯ３用柠檬酸络合制备。用ＸＲＤ测定ＧｄＦｅＯ３为钙钛矿结构。用ＣＯ还原脉冲及用Ｏ２再氧化脉冲证实在ＧｄＦｅＯ３上ＣＯ氧化为Ｒｅｄｏｘ机理。用外循环流动无梯度反应顺研究了ＣＯ氧化稳态动力学。用正交设计法估计动力学方程中的参数。还原催化剂再氧化为控制步骤。     

高压脉冲电凝聚技术处理活性染料废水试验研究

难生物降解有机废水是废水处理的难点。阐述了高压脉冲电凝聚技术处理高浓度、难生物降解有机废水的最新机理。采用高压脉冲电凝聚技术处理活性染料（活性红）生产废水．研究了影响高压脉冲电凝聚技术处理活性染料废水效果的操作条件及影响因素．结果表明，在最佳处理工艺条件下。CODCr浓度12628mg／L的生产废水经处理后CODCr去除率为65％左右。再经后续混凝沉淀，最终出水CODCr可降低到1000mg／L以下。     

Comparison of UV-based advanced oxidation processes for the removal of different fractions of NOM from drinking water

This study examined the effectiveness for degradation of hydrophobic (HPO), transphilic (TPI) and hydrophilic (HPI) fractions of natural organic matter (NOM) during UV/H₂O₂, UV/TiO₂ and UV/K₂S₂O₈ (UV/PS) advanced oxidation processes (AOPs). The changing characteristics of NOM were evaluated by dissolved organic carbon (DOC), the specific UV absorbance (SUVA), trihalomethanes formation potential (THMFP), organic halogen adsorbable on activated carbon formation potential (AOXFP) and parallel factor analysis of excitation–emission matrices (PARAFAC-EEMs). In the three UV-based AOPs, HPI fraction with low molecular weight and aromaticity was more likely to degradate than HPO and TPI, and the removal efficiency of SUVA for HPO was much higher than TPI and HPI fraction. In terms of the specific THMFP of HPO, TPI and HPI, a reduction was achieved in the UV/H₂O₂ process, and the higest removal rate even reached to 83%. UV/TiO₂ and UV/PS processes can only decrease the specific THMFP of HPI. The specific AOXFP of HPO, TPI and HPI fractions were all able to be degraded by the three UV-based AOPs, and HPO content is more susceptible to decompose than TPI and HPI content. UV/H₂O₂ was found to be the most effective treatment for the removal of THMFP and AOXFP under given conditions. C1 (microbial or marine derived humic-like substances), C2 (terrestrially derived humic-like substances) and C3 (tryptophan-like proteins) fluorescent components of HPO fraction were fairly labile across the UV-based AOPs treatment. C3 of each fraction of NOM was the most resistant to degrade upon the UV-based AOPs. Results from this study may provide the prediction about the consequence of UV-based AOPs for the degradation of different fractions of NOM with varied characteristics.     

Catalytic oxidation effect of MnSO4 on As(III) by air in alkaline solution

The catalytic oxidation effect of MnSO₄ on As(III) by air in an alkaline solution was investigated. According to the X-ray diffraction (XRD), scanning electron microscope-energy dispersive spectrometer (SEM-EDS) and X-ray photoelectron spectroscopy (XPS) analysis results of the product, it was shown that the introduction of MnSO₄ in the form of solution would generate Na_0.55Mn₂O₄·1.5H₂O with strong catalytic oxidation ability in the aerobic alkaline solution, whereas the catalytic effect of the other product MnOOH is not satisfactory. Under the optimal reaction conditions of temperature 90°C, As/Mn molar ratio 12.74:1, air flow rate 1.0 L/min, and stirring speed 300 r/min, As(III) can be completely oxidized after 2 hr reaction. The excellent catalytic oxidation ability of MnSO₄ on As(III) was mainly attributed to the indirect oxidation of As(III) by the product Na_0.55Mn₂O₄·1.5H₂O. This study shows a convenient and efficient process for the oxidation of As(III) in alkali solutions, which has potential application value for the pre-oxidation of arsenic-containing solution or the detoxification of As(III).     

皮革和毛皮加工废水处理技术

采用混凝沉淀-酸化水解-悬挂链曝气-生物接触氧化组合工艺处理皮革和毛皮加工生产废水。实验结果表明;进水COD为2400mg/L,处理后出水COD≤100mg/L,去除率≥95.8%。各项水质指标均稳定地达到了GB8978-96污水综合排放一级标准。     

Promotional effect of cobalt doping on catalytic performance of cryptomelane-type manganese oxide in toluene oxidation

The cryptomelane-type manganese oxide (OMS-2)-supported Co (xCo/OMS-2; x = 5, 10, and 15 wt.%) catalysts were prepared via a pre-incorporation route. The as-prepared materials were used as catalysts for catalytic oxidation of toluene (2000 ppmV). Physical and chemical properties of the catalysts were measured using the X-ray diffraction (XRD), Fourier transform infrared spectroscopic (FT-IR), scanning electron microscopic (SEM), X-ray photoelectron spectroscopy (XPS), and hydrogen temperature-programmed reduction (H₂-TPR) techniques. Among all of the catalysts, 10Co/OMS-2 performed the best, with the T_90%, specific reaction rate at 245°C, and turnover frequency at 245°C (TOF_Co) being 245°C, 1.23 × 10⁻³ mol_toluene/(g_cat·sec), and 11.58 × 10⁻³ sec⁻¹ for toluene oxidation at a space velocity of 60,000 mL/(g·hr), respectively. The excellent catalytic performance of 10Co/OMS-2 were due to more oxygen vacancies, enhanced redox ability and oxygen mobility, and strong synergistic effect between Co species and OMS-2 support. Moreover, in the presence of poisoning gases CO₂, SO₂ or NH₃, the activity of 10Co/OMS-2 decreased for the carbonate, sulfate and ammonia species covered the active sites and oxygen vacancies, respectively. After the activation treatment, the catalytic activity was partly recovered. The good low-temperature reducibility of 10Co/OMS-2 could also facilitate the redox process accompanied by the consecutive electron transfer between the adsorbed O₂ and the cobalt or manganese ions. In the oxidation process of toluene, the benzoic and aldehydic intermediates were first generated, which were further oxidized to the benzoate intermediate that were eventually converted into H₂O and CO₂.     

接触氧化-电解工艺处理印染废水

主要介绍了采用生物接触氧化 电解工艺处理印染废水的设计及运行情况。处理系统运行结果表明 :当进水CODCr、BOD5和色度分别为 764 5mg L、2 63 7mg L和 42 0倍时 ,系统出水CODCr、BOD5和色度分别为 160 5mg L、48 9mg L和 12倍 ,去除率分别为 79%、81 5 %和 97 1%。该工艺运行稳定 ,操作控制方便