稻田CO2通量对光强和温度变化的响应特征

采用涡度相关法对我国亚热带稻田生态系统CO2通量进行了连续监测,并对CO2通量随光强和温度变化的响应特征进行了分析.结果表明,白天稻田生态系统CO2通量对光强的响应过程可以用直角双曲线方程进行描述.随光强的增加,CO2通量(绝对值)呈增加趋势,当光强大于1 000μmol/(m2·s)时,CO2通量变化比较稳定.早、晚稻间以及不同生育期水稻的光量子利用效率和最大光合速率存在一定的差异.晚稻的光量子利用效率(0.046 5～0.099 9 μmol/μmol)高于早稻(0.0176～0.0541μmol/μmol),并以水稻生长旺盛期的光量子利用效率和最大光合速率最高.夜间稻田生态系统呼吸速率随土壤温度的升高呈指数增加,5 cm土层温度可以作为反映稻田呼吸速率变化的温度指标.早稻生长季生态系统呼吸对温度的变化明显较晚稻生长季更为敏感.     

Evaluation of mercury speciation and removal through air pollution control devices of a 190 MW boiler

Air pollution control devices (APCDs) are installed at coal-fired power plants for air pollutant regulation. Selective catalytic reduction (SCR) and wet flue gas desulfurization (FGD) systems have the co-benefits of air pollutant and mercury removal. Configuration and operational conditions of APCDs and mercury speciation a ect mercury removal e ciently at coal-fired utilities. The Ontario Hydro Method (OHM) recommended by the U.S. Environmental Protection Agency (EPA) was used to determine mercury speciation simultaneously at five sampling locations through SCR-ESP-FGD at a 190 MW unit. Chlorine in coal had been suggested as a factor a ecting the mercury speciation in flue gas; and low-chlorine coal was purported to produce less oxidized mercury (Hg2+) and more elemental mercury (Hg0) at the SCR inlet compared to higher chlorine coal. SCR could oxidize elemental mercury into oxidized mercury when SCR was in service, and oxidation e ciency reached 71.0%. Therefore, oxidized mercury removal e ciency was enhanced through a wet FGD system. In the non-ozone season, about 89.5%–96.8% of oxidized mercury was controlled, but only 54.9%–68.8% of the total mercury was captured through wet FGD. Oxidized mercury removal e ciency was 95.9%–98.0%, and there was a big di erence in the total mercury removal e ciencies from 78.0% to 90.2% in the ozone season. Mercury mass balance was evaluated to validate reliability of OHM testing data, and the ratio of mercury input in the coal to mercury output at the stack was from 0.84 to 1.08.     

基于不同土壤数据单元法的DNDC模型对太湖地区水稻土CH4排放模拟研究

利用农业土壤痕量气体排放模型DNDC(DeNitrification-DeComposition),以整个太湖地区37个县234万hm2水稻土为例,分析了3种不同土壤数据单元法对CH4排放模拟的影响.其中,1∶5万图斑单元法土壤属性来自1∶5万土壤数据库,图斑为最小模拟单元;1∶5万"县级"单元法土壤属性也取自1∶5万土壤数据库,"县"为最小模拟单元;1∶1 400万"县级"单元法土壤属性取自国内同类研究使用最多的1∶1 400万土壤图和《中国土种志》,"县"为最小模拟单元.结果表明,虽然1∶5万图斑单元法大多数县的CH4排放量都在1∶5万"县级"单元法最大与最小值范围之间,但整个地区总排放量(以C计,下同)相差达到1 680 Gg;而1∶1 400万"县级"单元法CH4排放量与1∶5万图斑单元法相比,尽管整个地区总排放量只相差180 Gg,但各"县级"单元之间的估算差异却很大,这一方面说明了土壤数据的详细程度是保证地球生物化学模型模拟精度的重要因子,另一方面也说明在区域CH4排放量估算模拟中使用更详细的土壤资料是非常必要的.     

电磁混响室的理论设计与场均匀性仿真

总结了混响室腔室和搅拌器的设计准则,并依此完成了最低可用频率为400MHz的混响室腔室和搅拌器的设计。利用FEKO软件对混响室建模,进行场均匀性仿真,计算工作区8个位置的电场,得到场标准偏差。仿真结果表明,设计的混响室性能完全符合标准IEC61000-4-21的规定,电场均匀性小于3dB。     

Modeling Flow,Nutrient, and Sediment Delivery from a Large International Watershed Using a Field‐Scale SWAT Model

A large international watershed, the St. Clair‐Detroit River System, containing both extensive urban and agricultural areas, was modeled using the Soil and Water Assessment Tool (SWAT) model. The watershed, located in southeastern Michigan, United States, and southwestern Ontario, Canada, encompasses the St. Clair, Clinton, Detroit (DT), Sydenham (SY), Upper, and Lower Thames subwatersheds. The SWAT input data and model resolution (i.e., hydrologic response units, HRUs), were established to mimic farm boundaries, the first time this has been done for a watershed of this size. The model was calibrated (2007–2015) and validated (2001–2006) with a mix of manual and automatic methods at six locations for flow and water quality at various time scales. The model was evaluated using Nash–Sutcliffe efficiency and percent bias and was used to explore major water quality issues. We showed the importance of allowing key parameters to vary among subwatersheds to improve goodness of fit, and the resulting parameters were consistent with subwatershed characteristics. Agricultural sources in the Thames and SY subwatersheds and point sources from DT subwatershed were major contributors of phosphorus. Spatial distribution of phosphorus yields at HRU and subbasin levels identified locations for potential management targeting for both point and nonpoint sources and revealed that in some subwatersheds nonpoint sources are dominated by urban sources.     

带肋薄壁钢管混凝土T形柱温度场试验与数值分析

为研究高温下带肋薄壁钢管混凝土T形截面柱温度场的分布规律,采用电热炉进行了温度场试验,进而采用ABAQUS有限元软件建立模型,与试验结果比较,验证模型的可靠性,在此基础上,分析了标准火灾下构件温度分布规律,构件从受火面到构件截面中部,温度逐渐降低,混凝土温度较钢管和钢筋温度明显滞后,且四个阳角温度高于两个阴角温度。在工程常用范围内,分析了受火时间、截面尺寸和加劲肋间距对构件温度场分布的影响,结果表明:随着构件截面尺寸的增大截面温度呈明显降低趋势,随着受火时间的增加钢管温度和混凝土温度呈不同态势增长,而钢筋加劲肋间距变化对温度场影响较小。     

胶合竹材单面受火炭化及温度场试验研究

格鲁班(Glubam)胶合竹材作为一种新型建筑材料,研究其耐火性能并与木材进行比较,对胶合竹材单板及杉木单板分别进行了恒温及ISO 834标准升温条件下的单面受火试验,测得了其炭化速率及不同受火条件下试件内部的温度-时间变化曲线。结果表明,胶合竹材的炭化速率低于杉木,其炭化规律与木材相似,即在受火初期炭化层厚度增加较快,炭化速率较大,随时间延长炭化速率逐渐降低,且受火温度越高,材料的炭化速率越大,同时试验测得在标准火灾条件下,胶合竹材受火20 min的平均炭化速率为0.64 mm/min。此外,通过温度场数据的分析比较发现,胶合竹材的传热速率明显低于杉木,其具有优于杉木的隔热性能,且能够满足相关规范对建筑构件隔热性能的要求。     

磁场对航空拖缆碳钢材料腐蚀行为影响研究

目的鉴于航空拖缆海洋环境使用的实际需要以及海洋环境中磁场对腐蚀的影响,展开磁场对航空拖缆碳钢材料腐蚀行为影响的研究。方法分别运用线性极化、交流阻抗以及电化学噪声等试验方法研究施加磁场扰动下碳钢腐蚀速度变化以及腐蚀机理。结果施加磁场后,阴极氧去极化过程和中间产物的形成过程在碳钢不同腐蚀状态下分别占主导地位。当磁场强度较低时,阴极氧去极化被抑制,是腐蚀速度的控制步骤,电荷转移电阻增大,腐蚀速度减小。磁场强度逐渐增大,中间产物的形成和转化过程逐渐成为主导因素,噪声电阻增大,腐蚀速度减小。结论磁场对航空拖缆碳钢材料的腐蚀速度产生影响。     

基于数字图像相关方法的石墨高温杨氏模量测试

目的为了得到石墨在高温环境下的杨氏模量,为飞行器热防护系统和高温热结构的设计提供可靠的技术保障。方法基于数字图像相关(DIC)方法和通电电阻加热技术,建立一套测量材料在高温环境下力学性能的测试系统。利用该系统,测量高温下石墨试样的表面应变场和应力-应变曲线,计算相应温度下的杨氏模量。在1400℃实验环境下,采用基于DIC与高温引伸计的方法同时测量超高温陶瓷试件的拉伸应变数据,并进行比较验证。结果在1400℃实验环境下,采用基于DIC与高温引伸计方法测得超高温陶瓷的应变-时间曲线吻合良好,方差为1.3×10-7。1200~1900℃高温环境下,石墨的杨氏模量随温度的升高呈线性增长趋势。结论采用基于DIC方法准确有效,该方法可方便快速地实现对石墨材料在高温环境下杨氏模量的测量。另外,该方法也可应用于其他导电材料杨氏模量的测试。     

离子风和磁场作用下分布指数对线板式ESP中PM_(2.5)捕集效率的影响

为了分析分布指数对线板式静电除尘器(ESP)中PM2.5捕集性能的影响,给出了基于电磁场、流场和颗粒动力场的数学模型,数值模拟了PM2.5分级效率、综合效率分别与分布指数的变化关系,比较了有无离子风和磁场作用时PM2.5的捕集性能。结果表明:数值模型与D-A公式相比具有较高的计算精度;离子风和外加磁场均能提升PM2.5的捕集性能,且捕集效率均随着分布指数的增大而逐步降低,为进一步提升ESP捕集性能提供技术参考。