响应面法优化克浅十油田废水的混凝沉淀工艺

以克浅十污水处理站原水为研究对象,采用混凝沉淀工艺,探讨优选出的复配混凝剂投加量、助凝剂投加量及静置时间对原水中浊度和总铁去除效果的影响.应用Box-Behnken中心组合实验和响应面分析法,建立混凝剂对处理原水的二次多项式数学模型,确定了混凝沉淀去除原水浊度和总铁的优化工艺参数分别为:复配混凝剂投加量为152.15 mg/L、143.84 mg/L,助凝剂投加量为4.14 mg/L、4.32 mg/L,静置时间为11.77 min、11.22 min.在此工艺条件下回归方程得到的浊度和总铁的去除率预测值与实验值接近,且拟合性良好,误差介于3％～5％之间.通过均值内插法,对比浊度和总铁的多元二次回归方程,推导得出的2组最佳工艺条件均能满足浊度和总铁的去除要求.     

Behavior of bensulfuron-methyl in an agricultural alkaline soil

A field experiment to determine the available bensulfuron-methyl (BSM) in the upper soil layer was conducted in an agricultural area in the South of Spain. To facilitate herbicide analysis, two application rates were employed, 200 g ha^?1 and 5 kg ha^?1. Samples of upper soil and soil solution were collected. Soil solution was sampled by means of metallic samplers, placed at a depth of 35 cm. In the plots receiving the lower dose ceramic suction, porous cups were also installed. Results from soil solution samples showed that the maximum BSM concentration was found after 8-10 days for the high irrigation supply (945 mm) and after 18-25 days for the lower irrigation regime (405 mm). The mathematical model FOCUSPELMO 1.1.1 was applied to interpret the data obtained in the field experiments. In general, there was a reasonable agreement between experimental and simulated data for soil samples, although the model did not acceptably predict herbicide concentrations in water soil samples. Ceramic cups sampled a higher soil water volume and more frequently than did the metallic samplers. However some variable results were attributed to preferential flow.     

Comparison of surface emissions and subsurface distribution of cis- and trans-1,3-dichloropropne and chloropicrin in sandy field beds covered with four different plastic films

The purpose of this study was to conduct a field study at a Florida field site on surface emissions and subsurface distribution of cis-and trans-1,3-dichloropropene (1,3-D) and chloropicrin (CP) in raised beds injected with Telone C35 with four replications. A total of 16 beds were applied with Telone C35 by chisel injection and covered with four different plastic films, 4 beds for each film. Each bed was installed with five 20-cm long soil pore air probes and a surface air collection pan at arbitrarily locations along the length of each bed for sampling soil pore air and surface air, respectively, for analysis of the three biologically active compounds, cis- and trans-1,3-D and CP. We found that average concentrations of the three compounds at 20-cm depth among the beds covered with four different plastic films generally were not statistically different. Among the four beds covered with the same plastic film, average concentrations of the three compounds were statistically different only in the four metallic PE covered beds at 5 and 24 hours after injection. Volatilization rates of the three compounds among the beds covered with four different plastic films, with the exception of CP at 48 hours after injection, were not statistically different. It appeared that initial upward diffusion and volatilization flux were influenced by solar radiation. Initial subsurface concentrations of the three compounds and volatilization flux, especially cis-1,3-D, were greater in the beds on the east side of the field than that in the beds on the west side of the field. Whether or not difference in initial subsurface concentrations of the compounds between east side beds and west side beds may influence fumigant efficacy remains to be determined.     

光磁耦合废水处理工艺条件的优化研究

以Fe3O4/TiO2作为磁性光催化剂,采用光磁耦合技术处理模拟印染废水。利用统计学方法对光磁耦合废水处理的影响因素进行了探讨和分析,考察了磁场强度、磁性光催化剂投加量、pH值和光照时间对光磁耦合废水处理的影响。通过Design-Expert 7.0.0软件分析得到最佳工艺条件:磁场强度73.95 mT,磁性光催化剂投加量1.13 g/L,模拟废水pH值13,光照时间120 min。在最佳工艺条件下进行实验,脱色率为88.60%。     

220kV拟建输变电工程环境影响评价分析

随着电网规模的不断扩大,220 k V电压等级的输变电网络将越来越多地介入人们的日常生活,如何对民众关心的220 k V输变电工程进行客观的环境影响评价分析成为越来越重要的实际问题。以某拟建220 k V输变电工程环境影响评价为例,介绍了评价因子尤其是电磁环境的现状监测、类比监测及模式预测综合分析,深入分析了该拟建输变电工程环境影响评价全过程,对输变电工程环境影响评价工作具有一定的指导意义。     

内循环厌氧反应器多相流流场的三维数值分析简

利用数值模拟的方法,引入欧拉双流体多相流模型及标准k-ε紊流模型,模拟计算内循环厌氧反应器的三相流三维流场,并通过改变污泥颗粒密度及进水流量,针对固相流速及固含率的变化情况,分析条件的改变对流场的影响。研究结果表明,应用数值模拟方法可以获得内循环厌氧反应器内的流场特征;污泥颗粒密度及进水流量的改变对于反应器内污泥颗粒的流速及分布的均匀性有较为明显的影响。模拟结果对反应器的应用及优化设计具有一定的参考价值。     

电解液对直流电场处理石油污染土壤的影响

直流电场处理石油污染土壤技术是一种发展中的土壤修复技术,有诸多优点。在该修复过程中,电解液的成分、电解液p H值控制对通过土壤的电流、土壤含水率、土壤含油率产生了影响。直流电场处理中通过土壤的电流与电解液成分、电解液p H值、土壤电导率和土壤湿度等因素密切相关。采用直流电场处理石油污染土壤效果明显,最低石油去除率达到73.6%。当电解液为0.1 mol/L的Na2CO3时,通过调节p H值,可使通过土壤的电流达到1.6 A、土壤电导率达到0.9S/m。处理后阴极、阳极和中间3个位置的土壤含油率分别从0.4672%降到0.0696%、0.0684%、0.0625%,石油去除率达到了85.1%。     

中亚热带红壤区不同土地利用土壤田间持水量估测

田间持水量是衡量土壤保水性的重要指标,也是进行农田灌溉、作物水管理和水文模型的重要参数,但其测定繁琐而耗时,迫切需要一种简捷精确的估测方法。采集了50个来自稻田和旱地的1 m深原状土壤剖面样,然后基于土壤基本理化性质,利用多元逐步回归方法对土壤田间持水量进行模型预测。结果显示:(1)对于稻田土壤,田间持水量主要受容重和有机碳影响,而对于旱地则主要受土壤质地影响;(2)构建的田间持水量传递函数,对于稻田土壤预测精确度较高,调整的确定系数达到0.79,对于旱地则相对较弱。研究表明土地利用方式对田间持水量精确估测影响较大,利用土壤传递函数法对田间持水量的快速获取有一定参考价值。     

长期施肥对红壤性水稻土磷素积累与形态分异的影响

通过红壤性水稻土19a肥料长期定位试验,结果表明,不施磷处理的土壤磷素处于耗竭状态,耕层土壤全磷含量持续下降,但耕层以下土层的全磷尚未耗损;连年施磷的土壤耕层全磷含量提高,提高的幅度呈现明显量级关系。在本试验条件下,土壤中各组分无机磷含量以Fe-P和O-P为主体,各占土壤无机磷总量的44.63％和31.27％;其次是A1-P和Ca     

不同施肥方式下紫色水稻土土壤肥力变化规律研究

通过连续 12 a田间小区定位试验 ,研究了在不同施肥方式下 ,连年稻 -麦轮作的滇中地区紫色冲积性潴育型水稻土土壤肥力及产量变化的规律。结果表明 :厩肥 (O)处理与厩肥配合氮磷处理 (ONP)12 a后土壤肥力明显高于对照和单施化肥的 NP、NK、PK、NPK等 4处理 ,土壤有机质含量增加 8.4 g/kg以上 ,速效氮、速效磷、速效钾含量增加 14.6 %以上 ,土壤容重下降 0 .16以上 ;单施化肥的处理 ,土壤肥力的变化与对照无显著差异。