北京2010年10月一次典型灰霾过程光学特性分析

利用探空资料、NECP再分析资料、AERONET气溶胶反演资料等分析了北京地区一次典型灰霾天气过程的成因及气溶胶光学特性参数变化情况.结果表明:此次灰霾期间,稳定的环流形势、湿润的环境及逆温结构的存在是灰霾得以持续和发展的重要原因.灰霾期间AOD、PM2.5浓度逐渐增大,能见度逐渐降低,这可能与局地气溶胶的累积和相对湿度的增大有关,使气溶胶粒子的消光性增强.气溶胶的体积谱表现为双峰型结构,细粒子体积浓度峰值远大于粗粒子浓度峰值,且细粒子浓度峰值逐日增大,Angstrom波长指数在1.2~1.4之间,两参数均可表明此次灰霾过程的污染粒子以气溶胶细粒子为主;灰霾期间SSA逐日增大,表明气溶胶粒子的散射性逐渐增强,SSA随波长的变化主要呈现两种变化趋势,这与当日主控粒子的尺度有关.因气溶胶的作用,使到达地面的辐射通量减小.这些光学特性参量的变化为了解北京地区灰霾期间气溶胶特性及其气候效应提供了参考.     

太湖中颗粒有机碳对水体固有光学特性的影响

利用2011年5期太湖现场测量数据和室内分析数据,通过建立ρ(POC)(POC为颗粒有机碳)与a_p(λ)(颗粒物吸收系数)、b_bp(510)(总颗粒物的后向散射系数)的相关关系,评价了POC对水体固有光学特性的影响. 结果表明,太湖水体ρ(POC)时空变化显著,各期样品平均值在1 558.06~5 281.09 mg/m3之间变化. ρ(POC)与a_p(λ)具有较好的相关关系,特别是在浮游植物色素强烈吸收的波段(605~700 nm),各期数据的相关系数均在0.9以上;但ρ(POC)与b_bp(510)的相关性较差(R2=0.04, P=0.02). 进一步分析ρ(POC)对颗粒物的色素部分和非色素部分的影响发现,ρ(POC)与色素颗粒物吸收系数〔a_ph(665)〕的相关性很好(R2=0.82),而与非色素颗粒物吸收系数相关性较差. ρ(NPOC)(NPOC为非有机碳颗粒物)与b_bp(510)的相关性较好(R2>0.60),说明太湖水体POC对浮游植物色素的吸光特性有重要影响,而NPOC影响了水体的后向散射特性.      

新型锌／铜／铝类水滑石的合成及对模拟印染废水吸附性能的研究

采用低饱和共沉淀法制得锌／铜／铝类水滑石化合物（Zn5CuAl2（OH）16CO3·xH2O）,在450℃焙烧得焙烧物,通过XRD ,FT－IR ,SEM和TG－DSC等手段对样品的结构、形貌和热稳定性进行了分析。将其焙烧物用于吸附模拟印染废水中的阴离子染料活性艳橙,结果表明,pH值在2～9,经吸附90 min ,其对印染废水的吸附性能最佳,染料去除率达96％以上。     

形变马氏体对奥氏体不锈钢封头性能的影响

奥氏体不锈钢因其优异的性能,被广泛应用于石油化工特种设备领域。本文针对常见的形变马氏体致奥氏体不锈钢封头泄露这一失效现象,阐述形变马氏体的产生机理、影响因素以及其对封头性能的影响,并提出相应的预防措施,旨在为不锈钢封头的制造和安全稳定运行提供参考,以减少失效事故的发生。     

山西夏季气溶胶空间分布飞机观测研究

以搭载了多种气溶胶观测仪器的飞机为观测平台,在2013年夏季首次对山西中部地区霾日及晴空大气气溶胶空间分布特性进行了观测,得到气溶胶粒子数浓度和尺度的垂直分布廓线以及不同高度气溶胶粒子谱分布特征.研究发现,山西夏季非降水天气条件下气溶胶粒子以核模态和积聚模态的细粒子为主,粗粒子很少.霾日气溶胶数浓度是晴空的2~3倍,主要是核模态的小粒子;气溶胶粒子数浓度随着高度逐渐减小,低空存在气溶胶累积区,逆温层的存在是导致气溶胶累积区形成的主要原因;气溶胶粒子尺度随高度增加,大粒子主要分布在2500m以上的高空;不同高度上的气溶胶粒子谱均呈双峰或三峰分布,谱型基本一致,从近地面到5000m高空,气溶胶粒子谱随高度的增加略有展宽.观测区域气团后向轨迹模拟结果显示,4000m以上高空气溶胶粒子主要是从中国西北地区远距离输送而来,3000m以下气溶胶粒子则主要来源于近地面排放.     

土壤溶液性质对Zn的形态变化及其微生物毒性的影响

采集了我国具有代表性的12种不同性质土壤,利用基础诱导硝化(SIN)方法测定了不同土壤中锌的微生物毒性阈值,同时利用850离子色谱仪与WHAM6.0模型,测定了溶液不同阴离子组成及自由Zn2+含量,建立了基于不同土壤性质与溶液离子的土壤中Zn毒性预测模型.结果表明,基于SIN测定的不同土壤Zn微生物毒性阈值在不同土壤间有显著差异,其中EC50从196mg/kg至1310mg/kg;EC10值从48mg/kg增加至682mg/kg,不同土壤EC50与EC10的最大值与最小值的比例分别达到了6.68及14.3倍,表明土壤性质对Zn的微生物毒性有非常显著的影响;基于SIN的Zn的毒性阈值ECx(x=10,50)与溶液自由Zn2+浓度的负对数p(Zn2+)间呈正相关关系,表明随着土壤溶液中自由Zn2+值的升高,Zn的毒性逐渐增加.土壤pH值、OC、CEC、F-、Cl-、Ca2+及Mg2+与Zn的毒性阈值ECx(x=10,50)及p(Zn2+)呈正相关关系,其中土壤pH值为最重要的影响因子,偏相关系数均达到极显著水平(P<0.01),其次为OC、CEC及F-,ECx与溶液中NO3-, SO42-呈负相关关系.基于不同主控因子的土壤中Zn毒性阈值(ECx)及P(Zn2+)的预测模型表明,pH值、OC、CEC、F- 四个变量因子分别解释了log(EC50)、log(EC10)及p(Zn2+)预测模型变异的89.9%、81.2%和92.3%.     

The importance of different forms of Pb on diminishing biological activities in a calcareous soil

In this experimental study, we evaluated the effect of different lead (Pb) fractions on biological properties in soil spiked with 0, 600, 1200 and 1800 mg kg^?1 Pb, during a 90-day incubation period at 25?28°C. Different Pb fractions were measured by sequential extraction at days 1 and 90 after soil treatment. Diethylenetriaminepentaacetic acid (DTPA)-extractable Pb and soil biological properties at days 1, 5, 15, 45 and 90 were measured. The concentration of Pb in soluble and exchangeable fractions was very high at day 1, but it showed remarkable transfer into carbonate and residual fractions by day 90. Substrate-induced respiration, basal respiration, acid and alkaline phosphatases, microbial populations (bacterial, fungal and actinomycetes) and biomass carbon decreased significantly with soil contamination compared with the control. With Pb ageing, these biological properties increased. Metabolic quotient (qCO₂) increased significantly compared with the control with increasing Pb concentration. The toxicity of various forms of Pb for the biological status of the soil was in the following order: KNO₃ extractable>NaOH extractable>EDTA extractable>HNO ₃ extractable>total content Pb. Thus, the bioavailable fractions are better indicators of Pb pollution in soils.     

Thermal cracking of waste printed wiring boards for mechanical recycling by using residual steam preprocessing

Mechanical waste-processing methods, which combine crushing and separation processes for the recovery of valuable materials, have been widely applied in waste printed wiring board (PWB) treatment. However, both the high impact toughness and the tensile and flexural strengths of whole PWB with a laminated structure result in great energy consumption and severe abrasion of the cutters during multi-level crushing. In addition, the high temperatures occurring in continual crushing probably cause the decomposition of the polymer matrix. A thermal-crack method using residual steam as the heating medium has been developed to pre-treat waste PWBs. This treatment reduces the mechanical strength in order to improve the recovery rate of valuable materials in subsequent mechanical recycling. The changes of the PWBs’ macro-mechanical properties were studied to evaluate thermal expansion impacts associated with changes in temperature, and the dynamic dislocation micro-structures were observed to identify the fracture mechanism. The results showed that thermal cracking with steam at the temperature of 500 K can effectively attenuate the mechanical properties of waste PWBs, by reducing the impact, tensile and flexural strengths respectively, by 59.2%, 49.3% and 51.4%, compared to untreated PWB. Thermal expansion can also facilitate the separation of copper from glass fiber by reducing peel resistance by 95.4% at 500 K. It was revealed that the flexural fracture was a transverse cracking caused by concentrated stress when the heating temperature was less than 500 K, and shifted to a vertical cracking after exceeding 500 K.     

海藻酸钠/锆@钙水凝胶的制备及其对磷的吸附研究

利用简便的方法制备了一种新型的海藻酸钠/锆@钙(SA/Zr@Ca)水凝胶材料,采用SEM、XRD对该材料进行了表征,并通过拟合吸附等温模型及吸附动力学模型,结合XPS和Zeta电位分析,研究了该材料对磷酸盐吸附的性能和机理.结果表明,该材料为非晶态的无定型材料.在溶液初始pH为2～7时,SA/Zr@Ca对磷酸盐(以PO...     

Biochemical properties of beryllium potentially relevant to its carcinogenicity†

The carcinogenicity of beryllium to several animal species is well established and evidence exists which strongly suggests that this is the case in human exposure. In this review several biochemical properties of the metallocarcinogen are considered including, the causation of cell transformation, and infidelity of DNA synthesis, inhibition of cell division and enzyme induction, and interference with regulatory mechanisms controlling gene expression. These effects are discussed in relation to beryllium chemistry, cellular accumulation mechanisms and distribution to subcellular organdies and molecular targets. It is suggested that the ultimate location and interactions of the metal ion in cell nuclei and its selective inhibition of certain protein phosphorylation reactions in particular are the biochemical effects potentially most relevant to induction of beryllium carcinogenesis.