Prenatal diagnosis of neurofibromatosis type 1: From flanking rflps to intragenic microsatellite markers

Even though the neurofibromatosis type 1 (NF1) gene was cloned more than 3 years ago, the process of identifying mutations has not been fruitful, and genetic counselling is mainly based on the use of linked markers. Since 1990, we have analysed 130 NF1 families and have performed six prenatal diagnoses. In each case, genetic counselling has relied on linked markers and informativity was achieved in all of them. The use of intragenic microsatellite polymorphisms (IVS27AAAT2.1, IVS27AC28.4, IVS27AC33.1, and IVS38GT53.0) has increased the informativeness in our series of NF1 families to an average of 90 per cent, providing accurate diagnosis and confirmation of the disease status.     

加压活性炭生物膜法处理DSD有机废水

采用加压活性炭生物膜法处理以对硝基甲苯磺酸盐为主的难降解的有机废水的研究,是在活性炭生物膜法处理有机废水基础上发展起来的新技术。本实验结果表明,在加压9.8×10~4Pa(1kgt/cm~2)的条件下,COD_(Cr)去除率为62％～70％,比常压活性炭生物膜法高20％～25％;其容积负荷Nv=1.7～2.9kgCOD/m~3·d,比一般活性污泥法高3～6倍。     

活性碳纤维吸附CS2蒸气的热力学研究

通过吸附热力学研究,计算出CS_2蒸气在活性碳纤维(ACF)上的吸附热、吸附功和吸附熵.结果表明,吸附属物理吸附范畴,所用吸附剂样品表面是不均匀的.     

臭氧控制膜污染的研究进展

本文对臭氧在控制膜污染方面的研究现状进行了综述,重点放在臭氧用于膜冲洗和臭氧用于过滤液预处理这两个方面;指明了在一定的条件下,臭氧可以有效地减缓、降低膜污染;臭氧控制膜污染的作用主要通过臭氧降解造成膜污染的有机物质来实现.此外,还介绍了一些臭氧与膜联用的开发应用情况.     

无排泥条件下HRT对膜生物反应器硝化性能的影响及其生物群落结构分析

以无机氨氮废水(NH+4 N,500mg·L-1)为处理对象,在不排泥条件下逐渐缩短膜生物反应器的水力停留时间(HRT,30h～5h),连续运行260d.在反应器内的氨氮容积负荷和污泥负荷分别为1 2kg·(d·L)-1和2 13kg·kg-1·d-1时,氨氮去除率达98 2%以上.当HRT减少至7h时开始出现NH+4 N和NO-2 N的积累.尽管反应器内MLSS随着运行时间的延长在逐步上升,氨氧化菌(AOB)和亚硝酸氧化菌(NOB)的数量分别从HRT10h和15h起开始下降.16SrDNA聚合酶链式反应结合变性梯度凝胶电泳(PCR DGGE)的分析发现反应器内生物多样性随着运行时间的延长而增加,测序结果表明进行氨氧化作用的主要是亚硝化单胞菌属(Nitrosomonassp.),进行亚硝酸氧化的主要是硝化螺菌属(Nitrospirasp.).尽管反应器只进行无机氨氮配水,仍存在大量的异养菌,估计其生长是以胞外分泌产物和细胞裂解产物为基质.     

离子膜电解法降解苯胺硝基苯废水的研究

文章采用离子膜电解法对低浓度苯胺、硝基苯废水进行处理,对影响降解效果的几种因素进行了研究。实验结果表明:在常温,电压为4V,pH值为3时,电解0.5h苯胺去除率可达98.0%,硝基苯去除率为65.3%;4.5h后苯胺去除率可达99.7%,硝基苯去除率可达90.3%,TOC去除率为91.8%。同时,离子交换膜的加入还能去除废水中的盐分,为后续生化处理提供了有利条件。     

PW—W膜分离式活性污泥法处理中小规模高浓度有机废水

阐述ＰＷ－Ｗ膜分离式活性污泥法处理高浓度有机废水的原理、工艺流程及特点。处理系统集生化处理功能和固液分离于一体，对高浓度有机废水的处理取得了良好的效果，且剩余污泥量少，处理水质稳定，维护管理方便，运行费用低。     

Determination and discussion hydraulic retention time in membrane bioreactor system

Based on the microorganism kinetic model, the formula for computing hydraulic retention time in a membrane bioreactor system (MBR) is derived. With considering HRT as an evaluation index a combinational approach was used to discuss factors which have an effect on MBR. As a result, the influencing factors were listed in order from strength to weakness as: maximum specific removal rate K, saturation constant Ks, maintenance coefficient m, maximum specific growth rate ,ua and observed yield coefficient Yobs. Moreover, the formula was simplified, whose parameters were experimentally determined in petrochemical wastewater treatment. The simplified formula is θ= 1.1( 1/β -1)(Kｓ S)/KXo , for oetroehemical wastewater treatment K and Ko eaualed 0.185 and 154.2, resoectively.     

Cu／A1-Ce-PILC在丙烯选择性催化还原NO反应中的失活研究

采用聚合羟基复合阳离子合成交联黏土A1-Ce-PILC，经SO4^2-改性后，以浸渍法制备了铜基交联黏土催化剂Cu／A1-Ce-PILC，并将其应用于C3H6选择性催化还原NO的反应，350℃时NO转化率达到最大值56％，700℃时下降至22％．为探究催化剂高温失活的原因，采用XPS、TPR、TGA、Py-IR和DSC对反应前后催化剂的物化性能进行了表征．结果表明，经过H2预处理活化后活性组分Cu物种以Cu^＋形式存在，而高温反应后Cu物种除以Cu^＋和Cu^2＋ 2种形式存在外，还出现了少量CuO物种；高温反应过程中A1-Ce-PILC上结构羟基和SO4^2-流失导致催化剂表面酸性减弱；此外，还存在表面积炭覆盖了部分活性中心并堵塞了催化剂孔道的现象．这三者的共同影响促进了C3H6深度氧化，抑制了NO还原，从而导致催化剂的失活．     

Enzymatic degradation of poly([R,S] β-hydroxybutyrate)

The synthetic analogue of a bacterially produced polyester, poly(-hydroxybutyrate) (PHB) was synthesized from racemic -butyrolactone using anin situ trimethyl aluminum-water catalyst. The polymer was fractionated into samples differing in molecular weight and isotactic diad content. The latter was closely related to degree of crystallinity. The biodegradation of these fractions were examined by monitoring mass loss over time in the presence of anAlcaligenes faecalis T1 extracellular bacterial poly(-hydroxybutyrate) depolymerase. The fraction with high isotactic diad tacticity content showed little or no degradation over a 50 hour incubation period, whereas the fraction of intermediate isotactic diad content degraded in a continuous steady fashion at a rate that was less than that for bacterial PHB. The low isotactic diad fraction underwent a rapid initial degradation, followed by no further mass loss. The presence of stereoblocks in the polymer structure of the various fractions was an influence on the degree of susceptibility towards degradation and is related to sample crystallinity.