A method to estimate the impact of clear-cutting on nutrient concentrations in boreal headwater streams

Large-scale forestry operations, like clear-cutting, may impair surface water quality if not done with environmental considerations in mind. Catchment and country level estimates of nutrient loads from forestry are generally based on specific export values, i.e., changes in annual exports due to the implemented forestry operations expressed in kg ha⁻¹. We introduce here a specific concentration approach as a method to estimate the impact of clear-cutting on nutrient concentrations and export in headwater streams. This new method is potentially a more dynamic and flexible tool to estimate nutrient loads caused by forestry, because variation in annual runoff can be taken into account in load assessments. We combined water quality data from eight boreal headwater catchment pairs located in Finland and Sweden, where the effect of clear-cutting on stream water quality has been studied experimentally. Statistically significant specific concentration values could be produced for total nitrogen, nitrate, ammonium, and phosphate. The significant increases in the concentrations of these nutrients occurred between 2 and 6 years after clear-cutting. Significant specific concentration values could not be produced for total phosphorus and total organic carbon with the whole dataset, although in some single studies significant increases in their concentrations after clear-cutting were observed. The presented method enables taking into account variation in runoff, temporal dynamics of effects, and the proportional size of the treated area in load calculations. The number of existing studies considering large site-specific variation in responses to clear-cutting is small, and therefore further empirical studies are needed to improve predictive capabilities of the specific concentration values.     

An Avoidable Tragedy at the Sea Cliff (Rincon) Oil Field

Three men were killed and four others were injured during a well drill operation on Hobson Well C-10A in the Sea Cliff Oil Field (also known as Rincon Oil Field), in Ventura County, California, United States, on August 10, 1994, as a result of errors made by the work supervisors at the site. The oil field was under management by Vintage Petroleum, Ltd., which was sued for negligence by the families of the deceased and injured. The coroner's autopsy examination concluded that the cause of the deaths was due to the inhalation of the toxic gas carbon monoxide (CO). This gas was assumed to have been released from the firing of high-energy guns (HEGs) using carbon-rich explosive pentaerythritol tetranitrate (PETN) in an oxygen-depleted environment, during a fracking operation by Schlumberger Corporation on Well C-10A. The author of this article was appointed as an expert witness by Schlumberger to evaluate if the coroner's conclusion was correct. A series of chemical analytical analyses were conducted on the vapor phase of samples, in addition to dissolved components in water from Well C-10A and two adjacent wells. Stable isotope analyses were also conducted on hydrogen (H₂), methane (CH₄), nitrogen (N₂), CO, and water (H₂O) 3 weeks after the accident, as well as on four additional occasions from September to December 1994. Control test analyses were performed on the products from HEG firings, using the same explosives as those used in the perforation of Well C-10A in control chambers at a Schlumberger facility in Houston, Texas. The conclusion reached was that the dominant products of PETN detonations are H₂, CH₄, CO, and N₂. However, the isotope ratios (D/H and ¹³C/¹²C) of methane in the control experiments were different in Well C-10A, following the detonation on August 10, 1994, than those resulting from controlled PETN explosions. The conclusion reached in this study was that the fracking of the well at a depth of around 2,150 ft had increased the permeability of the sediment layers in the Padres Zone at that depth to allow the rapid release of a large quantity of natural gas, primarily CH₄, which supersaturated the water in the well. This event caused the formation of a large bubble, which ballooned out of the well to the surface, displacing air in the location where the men were working, and thus causing asphyxiation, which resulted in the death of the three men. The judge accepted this interpretation.     

隔膜压滤机滤室最优空腔厚度

利用UG软件对隔膜压滤机滤室内流体进行三维建模,导入Gambit中进行网格划分及边界条件的设定,结合Fluent选用RNG k-ε湍流模型,采用多孔介质模型模拟隔膜压滤机滤室内固-液两相流分离,得到不同空腔厚度下滤室内流体的体积分数轮廓图、压强云图,得出滤饼含水率与空腔厚度大小的关系。实验结果表明,模拟和实验结果具有较好的一致性。在压滤机滤室空腔厚度为12 mm时,滤饼含水率为48%,每天污泥处理量为102 t,隔膜压滤机工作效率最高。     

以聚己内酯作为生物反硝化固体碳源的研究

为解决水体因低碳氮比而导致脱氮效率差的问题,将颗粒聚己内酯(PCL)重新塑形为阶梯环状,研究其作为反硝化过程的生物膜载体与固相碳源的反硝化性能。结果表明,在静态实验中,平均反硝化速率为8.57 mg NO3-N/(L·h);反硝化过程为零级反应。连续填充床实验中,超过90%的硝酸盐可被去除,出水NO2-N质量浓度低于0.20 mg/L;出水NH3-N质量浓度略有上升;出水溶解性有机碳(DOC)先上升后降低至1 mg/L左右。电子扫描显微镜扫描显示,PCL阶梯环反应表面空隙率较高,表面生物膜以杆菌为主,反应后被明显腐蚀;液相色谱检测显示PCL阶梯环分子量反应前后略有下降,其结构未受到破坏;表明该材料适合作为反硝化反应的碳源的同时,又可以作为载体供微生物附着生长。     

改性SCAC催化臭氧氧化去除布洛芬效能与反应活性位点研究

采用不同的表面改性方法(去矿化处理、氧化改性、碱改性和还原改性)对污泥基活性炭(SCAC)进行处理,分别获得了表面金属含量低、碱位低、碱性官能团含量高及Lewis碱含量高的4种改性SCAC(SCAC-D、SCAC-S、SCAC-OH和SCAC-N),对比考察了改性前后SCAC催化臭氧氧化去除布洛芬(IBP)的效能,并探讨了SCAC催化臭氧氧化反应的主要活性位点。结果表明,5种SCAC催化活性顺序为:SCAC-N>SCAC-OH>SCAC>SCAC-S>SCAC-D;金属组分减少会直接影响SCAC的催化活性,碱位减少对其催化活性的影响相对较弱,说明SCAC表面较为丰富的金属组分是其催化臭氧氧化反应的主要活性位点;增加SCAC表面碱位(Lewis碱和碱性官能团),减少表面酸性官能团有助于提高其催化活性。     

快腐剂对畜禽粪便堆肥过程中腐熟度的影响

以牛粪、菌糠和鸡粪等为材料按照两种比例调配为混合基质,在添加或不添加快腐剂的条件下在发酵桶中进行为期38 d的堆肥发酵实验,通过对发酵产物的温度、p H值、总有机碳、C/N、硝铵态氮含量和种子发芽指数等指标变化的研究,揭示了快腐剂对发酵过程的影响。结果表明,虽然快腐剂对有机物料的温度、C/N比无显著的影响,但可以促进铵态氮向硝态氮的转化,在16 d时使发酵产物NH+4-N/NO-3-N比值降为0.15,达到腐熟标准(0.16);提升种子发芽指数,在腐解29 d时使种子发芽指数达到82.76%,达到完全腐熟指标(0.8),比不添加快腐剂的处理提前了4 d左右。快腐剂的作用效果受腐解物料配比的影响。     

活性炭涂层电极电容去离子的性能

采用活性炭涂层电极构建电容去离子吸附装置,以氯化钠模拟含盐原水,研究电压、流量、进水浓度等操作参数对活性炭涂层电极脱盐效率和能耗的影响。实验结果表明,去除率和比吸附量随着电压的增大而增加,且比能耗随之增大。流速越小,出水的浓度越低,当对出水的浓度要求较高时,宜采用小流速。当进水浓度低于活性炭涂层电极的饱和吸附量时,比吸附量随着进水浓度呈线性增加;当达到饱和吸附量时,比吸附量不会随进水浓度的增大而发生改变;比能耗随着进水浓度的增加而降低。     

PW_(12)/g-C_3N_4光催化降解甲基橙

采用浸渍法制备了磷钨酸(PW12)/g-C3N4复合光催化剂,并将其用于溶液中甲基橙的光催化降解,运用IR技术对使用前后的光催化剂进行了表征。表征结果显示,PW12和g-C3N4的结构未在浸渍负载中发生改变,且PW12和g-C3N4结合牢固。实验结果表明:最佳的PW12负载量(光催化剂中PW12的质量分数)为50%;光催化降解甲基橙的优化反应条件为初始甲基橙质量浓度5 mg/L、光催化剂加入量0.6 g/L、初始溶液p H=7;在优化条件下,分别采用紫外光、模拟太阳光、可见光照射120 min后,甲基橙的降解率分别为96.59%,82.23%,42.78%;该光催化剂固载良好,使用中不易发生溶脱,稳定性好,可重复使用。     

煤气脱硫废料综合利用新工艺

针对煤气脱硫废料（简称废料）的成分（硫、碳、萘及少量其他有机物）,提出了一种处理废料的新工艺,先用乙酸乙酯提取废料中的萘和少量其他有机物,再用复合溶剂B加热溶解废料,热过滤得碳粉,最后将溶液冷却结晶分离出硫。实验结果表明：在乙酸乙酯与废料的质量比（R1）为3.75,提取温度为60℃,提取时间为4h的条件下,萘回收率为98%,纯度大于等于70%,在复合溶剂B与提取剩余物的质量比（R2）为2.69,过滤温度为100℃的条件下,硫回收率接近100%,纯度大于等于99%,碳回收率和纯度为100%。     

纳米晶粒TiO2多孔微球的制备及其光催化性能的研究进展

介绍了纳米晶粒TiO2多孔微球的主要制备方法、主要参量及表征、光催化性能研究进展,指出了纳米晶粒TiO2多孔微球制备过程的技术关键与基本参量的功能。针对目前存在的问题,提出了今后的主要研究方向,并展望了纳米晶粒TiO2多孔微球在水处理领域的应用前景。