基于灰建模的瓦斯含量多变量预测模型研究

研究了GM(1,N)、GM(0,N)瓦斯含量预测模型的数学原理,收集郑煤集团告成矿地质勘探期间及生产期间的瓦斯含量实测资料,获得16个可靠点,选取基岩厚度、新生界厚度、煤层厚度、煤层水分、煤层灰分、50m顶板含砂率6个因素作灰色建模预测的指标,分别建立了GM(1,6)和GM(0,6)瓦斯含量多变量预测模型。根据计算和评价结果,GM(1,6)和GM(0,6)瓦斯含量预测模型精度均能够满足工程精度的要求,说明利用灰色模型来预测瓦斯含量是可行的。由于前者精度略高于后者,故建议告成矿采用GM(1,6)模型来进行未知地区煤层瓦斯含量的预测。需要注意,由于模型没有考虑构造的影响,在实际预测时,还应根据构造对待预测区的影响关系和影响程度对模型的预测结果进行修正。     

Assisting Australian indigenous resource management and sustainable utilization of species through the use of GIS and environmental modeling techniques

Information on distribution and relative abundance of species is integral to sustainable management, especially if they are to be harvested for subsistence or commerce. In northern Australia, natural landscapes are vast, centers of population few, access is difficult, and Aboriginal resource centers and communities have limited funds and infrastructure. Consequently defining distribution and relative abundance by comprehensive ground survey is difficult and expensive. This highlights the need for simple, cheap, automated methodologies to predict the distribution of species in use, or having potential for use, in commercial enterprise. The technique applied here uses a Geographic Information System (GIS) to make predictions of probability of occurrence using an inductive modeling technique based on Bayes' theorem. The study area is in the Maningrida region, central Arnhem Land, in the Northern Territory, Australia. The species examined, Cycas arnhemica and Brachychiton diversifolius, are currently being 'wild harvested' in commercial trials, involving sale of decorative plants and use as carving wood, respectively. This study involved limited and relatively simple ground surveys requiring approximately 7 days of effort for each species. The overall model performance was evaluated using Cohen's kappa statistics. The predictive ability of the model for C. arnhemica was classified as moderate and for B. diversifolius as fair. The difference in model performance can be attributed to the pattern of distribution of these species. C. arnhemica tends to occur in a clumped distribution due to relatively short distance dispersal of its large seeds and vegetative growth from long-lived rhizomes, while B. diversifolius seeds are smaller and more widely dispersed across the landscape. The output from analysis predicts trends in species distribution that are consistent with independent on-site sampling for each species and therefore should prove useful in gauging the extent of resource availability. However, some caution needs to be applied as the models tend to over predict presence which is a function of distribution patterns and of other variables operating in the landscape such as fire histories which were not included in the model due to limited availability of data.     

Comparison of models of simazine transport and fate in the subsurface environment in a citrus farm

Contamination of groundwater by agrochemicals is now widely recognized as an extremely important environmental problem. Modern agricultural practices involve the combined use of irrigation with the application of large amounts of agrochemicals to maximize crop yield. Due to flood irrigation and natural runoff, agricultural activities might generate soil, surface water and groundwater contamination problems and leaching of pesticides. Modeling of the transport and fate of pesticides, such as simazine, may help understand the long-term potential risk to the subsurface environment. This paper illustrates a comparative study via the use of three different pesticide transport simulation models and the applicability of those models in determining the groundwater vulnerability to pesticides contamination in a citrus orchard located at the Lower Rio Grande Valley (LRGV). The three models used in the study are the pesticide root zone model-3 (PRZM-3), the pesticide analytical model (PESTAN) and integrated pesticide transport modeling (IPTM). The concentration values obtained from all three models are in agreement, and they show a decreasing trend from the surface through the vadose zone. The problem is how to use this information and, specifically, how to combine the testimony of a number of experts into a single useful judgment. With the aid of the fuzzy multiattribute decision making method, PRZM-3 is deemed as the most promising one for such precision farming applications.     

Kinetic extractions to assess mobilization of Zn, Pb, Cu, and Cd in a metal-contaminated soil: EDTA vs. citrate

Kinetic EDTA and citrate extractions were used to mimic metal mobilization in a soil contaminated by metallurgical fallout. Modeling of metal removal rates vs. time distinguished two metal pools: readily labile (QM1) and less labile (QM2). In citrate extractions, total extractability (QM1+QM2) of Zn and Cd was proportionally higher than for Pb and Cu. Proportions of Pb and Cu extracted with EDTA were three times higher than when using citrate. We observed similar QM1/QM2 ratios for Zn and Cu regardless of the extractant, suggesting comparable binding energies to soil constituents. However, for Pb and Cd, more heterogeneous binding energies were hypothesized to explain different kinetic extraction behaviors. Proportions of citrate-labile metals were found consistent with their short-term, in-situ mobility assessed in the studied soil, i.e., metal amount released in the soil solution or extracted by cultivated plants. Kinetic EDTA extractions were hypothesized to be more predictive for long-term metal migration with depth.     

Leaching behavior of heavy metals from municipal solid waste incineration bottom ash and its geochemical modeling

With the increase in the number of municipal solid waste incineration (MSWI) plants constructed in China recently, great attention has been paid to the heavy metal leaching toxicity of MSWI residues. In this study, the effects of various parameters, including extractant, leaching time, liquid-to-solid ratio, leachate pH, and heavy metal content, on the release properties of Cd, Cr, Cu, Ni, Pb, and Zn from MSWI bottom ash were investigated. Partial least-squares analysis was employed to highlight the interrelationships between the factors and response variables. Both experimental research and geochemical modeling using Visual MINTEQ software were conducted to study the pH-dependent leaching behavior of these metals in fresh and weathered bottom ash, considering precipitation/dissolution and surface complexation reactions (adsorption by hydrous ferric oxide and amorphous aluminum oxide/hydroxide). The results showed that leachate pH was the predominant factor influencing heavy metal leachability. The leaching of Cu, Pb, and Zn was mainly controlled by precipitation/dissolution reactions, whereas surface complexation had some effect on the leaching of Cr, Cd, and Ni for certain pH ranges. The modeling results aggreed well with the experimental results. Part of this work was presented at the Fourth International Conference on Combustion, Incineration/Pyrolysis and Emission Control (i-CIPEC)     

Comparison of Microscopic and Macroscopic Modeling Approaches for Subsurface Contaminant Transport

The practice of contaminant transport and remediation has shown significant progress in recent years. However, despite the significant progress made, remediation efforts are often delayed by extremely long breakthrough curve tails that render efforts to bring the level of contaminants below the regulatory standards inefficient. One hypothesis is that these long tails are due to the reservoir-like slow diffusive processes in soil micropore zones. This study compares the effects of micropores at macroscopic and microscopic levels and establishes a link between these approaches for validation and calibration purposes. The link between macroscopic and microscopic levels is established through comparisons and testing of the two models while incorporating appropriate scale and boundary effects. Despite the differences in conceptual approaches and simulation time, the two approaches rendered meaningful results. The link helps forecast the effects of micropore zone transport processes in the subsurface efficiently and thus allows development of numerical tools that could contribute towards more efficient remediation design.     

Identification of key parameters controlling dissolved oxygen migration and attenuation in fractured crystalline rocks

In the crystalline rocks of the Canadian Shield, geochemical conditions are currently reducing at depths of 500-1000 m. However, during future glacial periods, altered hydrologic conditions could potentially result in enhanced recharge of glacial melt water containing a relatively high concentration of dissolved oxygen (O2). It is therefore of interest to investigate the physical and geochemical processes, including naturally-occurring redox reactions, that may control O2 ingress. In this study, the reactive transport code MIN3P is used in combination with 2k factorial analyses to identify the most important parameters controlling oxygen migration and attenuation in fractured crystalline rocks. Scenarios considered are based on simplified conceptual models that include a single vertical fracture, or a fracture zone, contained within a rock matrix that extends from the ground surface to a depth of 500 m. Consistent with field observations, Fe(II)-bearing minerals are present in the fractures (i.e. chlorite) and the rock matrix (biotite and small quantities of pyrite). For the parameter ranges investigated, results indicate that for the single fracture case, the most influential factors controlling dissolved O2 ingress are flow velocity in the fracture, fracture aperture, and the biotite reaction rate in the rock matrix. The most important parameters for the fracture zone simulations are flow velocity in the individual fractures, pO2 in the recharge water, biotite reaction rate, and to a lesser degree the abundance and reactivity of chlorite in the fracture zone, and the fracture zone width. These parameters should therefore receive increased consideration during site characterization, and in the formulation of site-specific models intended to predict O2 behavior in crystalline rocks.     

环境污染物计算毒理学分析及环境行为模拟研究进展

根据国内外研究报道,系统地总结了计算毒理学和化合物环境行为模拟在环境科学领域的研究进展,包括二者的概念、理论、研究方法以及在环境研究中的应用;分析了计算毒理学和化合物环境行为模拟在发展中所面临的挑战,并提出对策;展望了计算毒理学和化合物环境行为模拟在环境研究中的发展前景。     

河流水生态环境质量评价方法研究与应用进展

河流生态质量的监测和评价是从河流生态系统健康状况的角度对河流质量进行的评价。河流生态健康的评价已经向多要素多指标综合、多种评价方法(预测模型法、生物完整性指数、多要素综合评价)、流域尺度方向发展。该文重点介绍了国外评价体系产生的背景和研究基础,分析了广泛应用的几类评价方法的特点、在不同国家和流域的应用情况以及各方法的应用前景,分析了国内开展河流生态质量评价研究的发展过程、阶段性研究进展和应用案例,并根据目前研究基础评述了我国评价体系现存问题及应用前景,为河流生态质量评价体系的建立及发展方向提供建议和参考。     

Perceived mastery climate,felt trust,and knowledge sharing

Interpersonal trust is associated with a range of adaptive outcomes, including knowledge sharing. However, to date, our knowledge of antecedents and consequences of employees feeling trusted by supervisors in organizations remains limited. On the basis of a multisource, multiwave field study among 956 employees from 5 Norwegian organizations, we examined the predictive roles of perceived mastery climate and employee felt trust for employees' knowledge sharing. Drawing on the achievement goal theory, we develop and test a model to demonstrate that when employees perceive a mastery climate, they are more likely to feel trusted by their supervisors at both the individual and group levels. Moreover, the relationship between employees' perceptions of a mastery climate and supervisor‐rated knowledge sharing is mediated by perceptions of being trusted by the supervisor. Theoretical contributions and practical implications of our findings are discussed.