基于缺陷重构的类芬顿光催化剂在降解染料废水中的应用

近年来,通过缺陷调控提高催化剂催化性能引起了广泛关注,而缺陷重构过程对光催化-类芬顿耦合反应的影响仍鲜有研究.本文将含铁多酸分子强耦合到富含氧空位缺陷的二氧化钛(TiO_2)光催化剂(P25)表面,考察了缺陷形成和二次重构过程对光催化-类芬顿协同催化降解有机染料活性的影响.结果表明,单氰胺复合后二次煅烧有利于H2气氛处理生成的氧空位进行空间分布重构,重构后的缺陷更为有利于TiO_2表面的光生电荷向含铁多酸分子界面转移.借助TiO_2光催化剂光生电荷分离能力的提升和类芬顿试剂活性位点的增强,缺陷重构的类芬顿光催化剂在降解亚甲基蓝染料的反应中催化活性提高了13倍.     

Preparation, characterization and performance of an electrospun carbon nanofiber mat applied in hexavalent chromium removal from aqueous solution

Hexavalent chromium, Cr(VI), a highly toxic oxyanion known as a carcinogen and mutagen,is an issue of concern due to its adverse impact on human health. Therefore, development of effective technologies and/or materials for Cr(VI) removal from water has been of great interest for researchers. In this study, an electrospun carbon nanofiber(CNF) mat was prepared via electrospinning polyacrylonitrile(PAN), followed by thermal pre-oxidation and carbonization. Scanning electron microscopy(SEM) observation showed that the fiber diameter of the CNF with carbonization temperature of 950°C(CNF_(950)) was about 266 nm.Potentiometric titration analysis demonstrated that the point of zero charge p H(pHpzc) of CNF_(950) was around 7.93. CNF_(950) demonstrated high adsorption capacity and fast adsorption kinetics for Cr(VI) at pH 3. Langmuir isotherm calculations showed that the maximum adsorption capacity of Cr(VI) on CNF_(950) was 118.8 mg/g at pH 2. The adsorption isotherm of Cr(VI) on CNF_(950) was well described by the Redlich–Peterson model, revealing that Cr(VI)adsorption was the result of a combination of monolayer and multilayer adsorption,depending on the initial Cr(VI) concentration. Solution pH greatly affected Cr(VI) adsorption onto CNF_(950) due to the electrostatic interaction, and the adsorption capacity was relatively high when pH was below 3. X-ray photoelectron spectroscopy(XPS) analysis revealed that the removal of Cr(VI) might be the result of a combination of redox reaction and electrostatic adsorption. The adsorption-saturated CNF_(950) could be regenerated by NaOH solution. This study extends the potential applicability of electrospun CNF mats for Cr(VI)-contaminated water purification.     

ATR-FTIR and XPS study on the structure of complexes formed upon the adsorption of simple organic acids on aluminum hydroxide

Information on the binding of organic ligands to metal （hydr）oxide surfaces is useful for understanding the adsorption behaviour of natural organic matter on metal （hydr）oxide. In this study, benzoate and salicylate were employed as the model organic ligands and aluminum hydroxide as the metal hydroxide. The attenuated total reflectance Fourier transform infrared （ATR-FTIR） spectra revealed that the ligands benzoate and salicylate do coordinate directly with the surface of hydrous aluminum hydroxide, thereby forming innersphere surface complexes. It is concluded that when the initial pH is acidic or neutral, monodentate and bridging complexes are to be formed between benzoate and aluminum hydroxide while bridging complexes predominate when the initial pH is alkalic. Monodentate and bridging complexes can be formed at pH 5 while precipitate and bridging complexes are formed at pH 7 when salicylate anions are adsorbed on aluminum hydroxide. The X-ray photoelectron （XP） spectra demonstrated the variation of C 1 s binding energy in the salicyate and phenolic groups before and after adsorption. It implied that the benzoate ligands are adsorbed through the complexation between carboxylate moieties and the aluminum hydroxide surface, while both carboxylate group and phenolic group are involved in the complexation reaction when salicylate is adsorbed onto aluminum hydroxide. The information offered by the XPS confirmed the findings obtained with ATR-FTIR.     

磁性竹基炭对Pb2+、Cd2+与Cu2+的吸附机理研究

采用微波辐照技术,以枯竹子为碳源制备了磁性竹基炭(BBMC),并将其用于对重金属离子Pb2+、Cd2+与Cu2+的吸附去除.同时,分析了吸附时间、pH值、离子强度及初始金属离子浓度等条件对吸附的影响,讨论了BBMC对3种金属离子的吸附特性与吸附机理.结果表明,金属离子在BBMC上的吸附符合Langmuir等温模式和准二级动力学吸附方程;吸附的机理可归结为金属阳离子与BBMC上的H+之间的离子交换作用,且吸附能力可能与金属离子半径有关,呈现出Pb2+Cd2+Cu2+的趋势,重金属离子Pb2+、Cd2+与Cu2+的最大平衡吸附量分别为16.2、14.0和9.5 mg·g-1.     

高锰酸钾去除水中TCE的研究

以水中常见的氯代烃污染物三氯乙烯(TCE)为目标污染物,以自制的高锰酸钾溶液为氧化剂,探讨了不同条件下高锰酸钾对TCE的去除效果.结果表明,在30℃、高锰酸钾浓度为0.276 g.L-1的条件下,反应时间为30 min时,TCE的去除率就可达到100%.高锰酸钾对TCE的去除符合一级反应动力学方程,速率常数为0.142 9 min-1,半衰期t1/2为4.85 min.TCE的去除速率随高锰酸钾浓度的增大而增大并呈线性关系,随反应温度的升高而增大,受pH值和离子强度的影响较小.     

臭氧氧化水中2,4,6-三氯酚的反应机理研究

研究了臭氧氧化对2,4,6-三氯酚的去除效果,以及氧化过程中过氧化氢、氯离子、甲酸和乙二酸的变化情况,探讨了臭氧氧化2,4,6-三氯酚的反应机理和反应途径.实验结果表明,如果溶液中没有自由基清除剂,在臭氧投加量为24mg·L~(-1)时,0·1mmol·L~(-1)的2,4,6-三氯酚在6min内,去除率可达99%.臭氧分子氧化2,4,6-三氯酚的过程中产生过氧化氢,检测到的过氧化氢的最大摩尔浓度为初始2,4,6-三氯酚摩尔浓度的22·5%.中间产物过氧化氢随后和臭氧反应生成大量的羟基自由基,此时2,4,6-三氯酚是被臭氧和羟基自由基联合氧化,生成甲酸和乙二酸.当溶液中含有大量的自由基清除剂时,2,4,6-三氯酚首先被臭氧分子氧化成黄色的氯代对苯醌,然后氧化成甲酸和乙二酸.臭氧氧化2,4,6-三氯酚存在臭氧分子氧化以及O3/OH·联合氧化两种反应途径.     

Effects of fungicides triadimefon and propiconazole on soil bacterial communities

The impact of fungicides triadimefon and propiconazole on soil bacterial populations from a strawberry field was investigated. Two fungicides were applied to the soil at concentrations of 10 mg/kg or 100 mg/kg with soil water contents 20.2% (fresh soil water content) or 26.0% (field capacity). Changes in bacterial communities were assessed using DNA extraction, polymerase chain reaction (PCR) amplification of the 16S rDNA and denaturing gradient gel electrophoresis (DGGE). High performance liquid chromatography (HPLC) was utilized to detect the residue of fungicides in soils. The results showed that propiconazole was more persistent than triadimefon in soils, and the two soil water contents did not cause significant differences in dissipation rates between the two fungicides. A high concentration of propiconazole could inhibit the existence of soil microbes while one of triadimefon might induce the microbial population in the first stage. From unweighted pair-group method using arithmetic averages (UPGMA) dendrograms, the effect of triadimefon and propiconazole at the two applied concentrations on a soil bacterial community could be long term. After triadimefon was applied for 60 days and propiconazole for 75 days, the compositions of microbial communities were not recovered. From the viewpoint of environmental protection, it was of significant importance to pay more attention not only to the residues of pesticide but also to the change in soil microbial communities.     

第一菊酸乙酯生产废水处理

采用“Fenton反应好氧生物接触氧化”工艺处理第一菊酸乙酯生产废水,确定了处理单元的设计参数;该工艺的CODCr、硝基苯、苯胺去除率分别为94%、78%、83%,出水水质符合(GB89781996)二级排放标准,实际运行效果稳定,运行成本适中,工程造价合理。     

活化过硫酸盐氧化地下水中苯酚的动力学研究

以柠檬酸(CA)络合亚铁离子CA-Fe(II)为活化剂,活化过硫酸盐(S2O82-,PS)产生强氧化剂硫酸根自由基(SO4·-),进而催化氧化苯酚.从CA/Fe(II)物质的量比、Fe(II)浓度、过硫酸盐(PS)投加量和苯酚初始浓度4个因素来考察络合亚铁离子活化过硫酸盐氧化去除苯酚的动力学.结果表明,随着PS投加量的增加,苯酚的去除率随之提高;但随着苯酚初始浓度的增加,去除率逐渐降低;CA/Fe(II)物质的量比为1/5时,能够保持水溶液中足量的亚铁离子,有利于苯酚的氧化去除;当PS/CA/Fe(II)/苯酚物质的量比为100/10/50/1时,苯酚的去除率最高,反应15min后去除率达到98%,此时,苯酚的氧化反应速率k也达到最高值0.430min-1.活化过硫酸盐氧化去除苯酚的过程基本符合准一级动力学,在CA/Fe(II)/苯酚物质的量比为10/50/1条件下,苯酚氧化反应速率与过硫酸盐投加量呈线性正相关(R2 = 0.953).     

厌氧颗粒污泥中微生物种群变化的分子生物学解析

荧光定量-聚合酶链式反应(RTQ-PCR)与荧光原位杂交(FISH)技术对厌氧反应器内不同状态下颗粒污泥中微生物种群的数量变化与空间分布进行研究.结果发现,颗粒污泥中真细菌明显多于古细菌,但随着厌氧反应器有机负荷的提高,古细菌明显增加,其中产甲烷丝菌也明显增加;真细菌多分布生长在颗粒污泥的外层,而对环境条件敏感的古细菌多分布生长在内层,且随着反应器有机负荷的提高,这种层状分布的特点更为明显.