Composting of waste algae: A review

Although composting has been successfully used at pilot scale to manage waste algae removed from eutrophied water environments and the compost product applied as a fertiliser, clear guidelines are not available for full scale algae composting. The review reports on the application of composting to stabilize waste algae, which to date has mainly been macro-algae, and identifies the peculiarities of algae as a composting feedstock, these being: relatively low carbon to nitrogen (C/N) ratio, which can result in nitrogen loss as NH₃ and even N₂O; high moisture content and low porosity, which together make aeration challenging; potentially high salinity, which can have adverse consequence for composting; and potentially have high metals and toxin content, which can affect application of the product as a fertiliser. To overcome the challenges that these peculiarities impose co-compost materials can be employed.     

用于石油污染土壤降解的高效降解菌的筛选及其降解条件优化

经过富集、分离优选出高效石油降解菌L-1,根据形态观察和生理生化特征初步鉴定为琼氏不动杆菌;采用单因素花盆实验模拟微生物原位修复并对其降解条件进行优化。结果表明,将高效石油降解菌应用于修复石油污染土壤,适宜接种量、表面活性剂浓度、CNP比、翻耕频率分别为15%、0.1%、100∶10∶1和1 d 1次;在该降解条件下修复28 d,可达到16.80%的石油降解率,远远高于土著微生物6.92%的降解率。     

毛木耳产漆酶发酵条件的研究

以毛木耳为产酶菌,以CMC为唯一碳源,探讨了不同培养条件对毛木耳产漆酶的影响。结果表明,在最适温度为27℃、pH值为6．0、接种量为10％、装液量为90mL／250mL、摇床转速为180rpm、培养天数为6d时,产酶活力最大。以各个因子的最佳梯度做优化培养,发酵液中的漆酶活力高达70．76IU／mL。     

Modeled Summer Background Concentration of Nutrients and Suspended Sediment in the Mid‐Continent (USA) Great Rivers1

Angradi, Ted R., David W. Bolgrien, Matt A. Starry, and Brian H. Hill, 2012. Modeled Summer Background Concentration of Nutrients and Suspended Sediment in the Mid‐Continent (USA) Great Rivers. Journal of the American Water Resources Association (JAWRA) 48(5): 1054‐1070. DOI: 10.1111/j.1752‐1688.2012.00669.x Abstract: We used regression models to predict summer background concentration of total nitrogen (N), total phosphorus (P), and total suspended solids (TSS), in the mid‐continent great rivers: the Upper Mississippi, the Lower Missouri, and the Ohio. From multiple linear regressions of water quality indicators with land use and other stressor variables, we determined the concentration of the indicators when the predictor variables were all set to zero — the y‐intercept. Except for total P on the Upper Mississippi River, we could predict background concentration using regression models. Predicted background concentration of total N was about the same on the Upper Mississippi and Lower Missouri Rivers (430 μg l^?1), which was lower than percentile‐based values, but was similar to concentrations derived from the response of sestonic chlorophyll a to great river total N concentration. Background concentration of total P on the Lower Missouri (65 μg l^?1) was also lower than published and percentile‐based concentrations. Background TSS concentration was higher on the Lower Missouri (40 mg l^?1) than the other rivers. Background TSS concentration on the Upper Mississippi (16 mg l^?1) was below a threshold (30 mg l^?1) designed to protect aquatic vegetation. Our model‐predicted concentrations for the great rivers are an attempt to estimate background concentrations for water quality indicators independent from thresholds based on percentiles or derived from stressor‐response relationships.     

常温低基质厌氧氨氧化反应器启动及其稳定性

以上向流生物滤池为反应器,以实验室内氧化沟回流污泥为接种污泥,采用先培育好氧生物膜,后转为厌氧环境培育厌氧氨氧化生物膜的方式,成功实现了常温低基质浓度下厌氧氨氧化反应器的启动。控制反应器进水pH为7.50～7.80,NH4+-N为30～40 mg/L,NO2--N为35～50 mg/L,温度为20～25℃。224 d以后,反应器启动成功。在稳定运行阶段,出水亚硝氮和氨氮的平均浓度分别为1.4 mg/L和4.6 mg/L,平均去除率分别为95.3%和90.1%,去除比例为1～1.8∶1,主要集中在1.4～1.5∶1,亚硝氮和氨氮去除的容积负荷分别为104.2 mg/(L.d)和146.0 mg/(L.d)。     

不同来源高浓度有机废水的集中处理

按照水质情况,将多种来源于不同工业生产过程中的高浓度有机废水划分为高悬浮固体乳化液废水、难生化高浓度有机废水、高悬浮固体不含油有机废水、含铬有机废水和杂质含量较少的乳化液废水5类,分别采用酸化破乳/Fen-ton氧化/混凝/絮凝、Fenton氧化/混凝/絮凝、混凝/絮凝、还原/混凝/絮凝、震动膜过滤技术作为生化预处理技术,并通过小试和中试验证了各技术的效果。实验结果表明,按照上述分类结果,采用不同预处理技术可以得到良好的效果,废水水质明显改善,满足继续生化处理的基本条件。各预处理生产装置处理效果稳定,同时生化系统已经稳定运行120天以上,COD去除率超过90%,出水经过低剂量的Fenton试剂处理后可达到《污水排入城镇下水道水质标准》(CJ343-2012)。     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

地震滑坡地形剖面线多重分形特征及其在稳定性判别中的应用

"5.12"汶川地震诱发了大量的滑坡和不稳定斜坡体,这些滑坡和不稳定斜坡体的稳定性影响到灾区社会经济发展和灾后重建。地震滑坡的不同稳定性状态孕育了滑坡地形剖面线的演化特征,并且地震滑坡地形剖面线直接地反映了在地震力作用下坡体的演变过程和演化机制。根据实测的汶川地震诱发的滑坡地形剖面线特征,研究了相对稳定滑坡、蠕滑阶段滑坡和不稳定斜坡的地形剖面线的分布特征,以及地震滑坡不同稳定状态下的地形剖面线的多重分形维数演化特征。研究结果表明相对稳定滑坡的多重分形维数演化特征的具有明显的有序性,处于蠕滑状态的滑坡和不稳定斜坡的多重分形维数演化出现明显的特征性拐点。     

Developing Mechanism of Rubber-tea-chicken Agro-forestry Model in Tropical Area of China

As a typical tropical agro-forestry ecosystem in Wenchang,Hainan Province,China,rational mechanisms of the rubber-tea-chicken eco-agricultural model were studied with the Solow technological level index,stability indicator,harmonizing coefficient,grey correlation coefficient and production dominance.This study focused on rational hierarchical structure,the limiting factors and optimal strategies of the model development based on model structure,resource conditions and external market demands.Results showed that rational mechanism of the rubber-tea-chicken ecosystem model mainly included technological contributions,leverage function of dominance component(livestock husbandry),stability of the model structure and harmony of its components,the model dominant product’s market demand and government’s supporting policies.The contributions of fund,technology,information and talent resources played an important role in improving sustainability and productivity of the agro-forestry model.     

有机酸性腐蚀品生产危险性分析

目前我国化工生产中涉及大量有机酸性腐蚀品,通过对某市化工行业调查及分析,发现有机酸性腐蚀品生产普遍,而且生产原料易燃易爆,生产过程存在火灾爆炸危险,结合具体生产工艺,采用预先危险性分析法和作业条件的危险性评价法分析生产过程危险性,从而揭示并概括有机酸性腐蚀品生产危险性.为更好地促进我国安全生产,在此基础上探讨了一些针对性的安全措施.