石英不同Ti-Li心电子自旋共振信号光晒退特征及其测年意义

为探讨石英不同Ti-Li心电子自旋共振（ESR）信号的光晒退特征及其测年意义,对典型花岗岩类基岩样品、河流现代表层沉积物样品及地质历史时期沉积物样品的石英Ti-Li心option A、Ti-Li心option B、Ti-Li心option C、Ti-Li心option D和Ti-Li心option E的ESR信号光晒退特征进行了系统研究。结果显示：（1）不同Ti-Li心ESR信号可在较短时间内（260 h）完全晒退,表明Ti-Li心是优良的石英ESR测年信号心;（2）石英的赋存环境对同一Ti-Li心ESR信号晒退“归零”所需的时间具有明显的影响作用。相比于基岩石英和地质历史时期沉积物石英,现代河流沉积物石英因其已经接受了一定时间的光晒退作用而具有更快的光晒退“归零”速率;（3）石英同一Ti-Li心的光敏感特性会因石英经历的地质循环过程的不同而改变,相比于基岩,沉积物因经历了更复杂的地质过程而具有了深陷阱电子,所以需要更长的光晒退归零时间;（4）同一样品的不同Ti-Li心表现出了相同的光晒退特征,说明不同类型的Ti-Li心具有相同的光敏特性;（5）Ti-Li心option B在某些自然样品中不易观察,Ti-Li心option D和Ti-Li心option E信号较为微弱,因此,Ti-Li心option A是进行沉积物石英ESR测年的最佳信号心。     

金银合金纳米颗粒的可控合成及其光催化性能

以果糖为还原剂和表面活性剂,可控合成了平均粒径小于14.6nm的金银（Au-Ag）合金纳米颗粒.基于一步法,改变合成时间（1~8min）,Au-Ag合金纳米颗粒的成分及其表面等离子共振（SPR）波长被连续调控.采用UV-Vis、EDX、ICP、XPS、TEM、HR-TEM和SAED等分析手段对Au-Ag合金纳米颗粒进行表征,发现制备的合金纳米颗粒具有均匀的成分和合金结构.由于Au、Ag两元素的协同作用,Au-Ag合金纳米颗粒在4-硝基苯酚的光催化降解反应中表现出了优异的光催化活性和稳定性.除了改变Au-Ag合金纳米颗粒的添加量,光催化反应的动力学速率常数还可通过改变合金成分来线性调节.基于可控合成,动力学速率常数甚至可通过Au-Ag合金纳米颗粒的合成时间来线性调控.上述控制动力学速率常数的方法可为其他的光催化反应提供参考.     

“玉米—牛—沼气—日光温室”循环农业模式研究

为了加快推进西北内陆灌区发展循环农业,在临泽县平川镇三二村研究和总结了绿洲玉米种子繁殖田与荒漠区日光温室间的循环农业模式。该循环模式主要包括制种玉米、牛、沼气、荒漠区日光温室4个接口,实现了＂玉米—牛—沼气—日光温室＂的循环,具有良好的经济效益、社会效益和生态效益。     

Photolysis of oxyfluorfen in aqueous methanol

Photolysis of oxyfluorfen, an herbicide of the nitrodiphenyl ether class, was studied in aqueous methanol under UV and sunlight. UV irradiation was carried out in a borosilicate glass photoreactor (containing 250 ppm oxyfluorfen in 50% aqueous methanol) equipped with a quartz filter and 125 watt mercury lamp (maximum output 254 nm) at 25 ± 1°C. Sunlight irradiation was conducted at 28 ± 1°C in borosilicate Erlenmeyer flasks containing 250 ppm oxyfluorfen in 50% aqueous methanol. The samples from both the irradiated conditions were withdrawn at a definite time interval and extracted to measure oxyfluorfen content by gas chromatography-flame ionization detector for rate study. The half-life values were 20 hours and 2.7 days under UV and sunlight exposure, respectively. Photolysis of oxyfluorfen yielded 13 photoproducts of which three were characterized by infrared spectrophotometer and ¹H NMR and ¹³C NMR spectroscopy. The rest of the photoproducts were identified by gas chromatography-mass spectrometry (GC-MS) and thin layer chromatography (TLC). An ionization potential 70 eV was used for electron impact-mass spectrometry (EI-MS) and methane was used as reagent gas for chemical ionization-mass spectrometry (CI-MS). Two of the photoproducts were also synthesized for comparison. The main phototransformation pathways of oxyfluorfen involved nitro reduction, dechlorination, and hydrolysis as well as nucleophiles displacement reaction.     

水中四环素类化合物在不同光源下的光降解

研究了模拟太阳光和实际室外太阳光下四环素类化合物在水溶液中的光降解。结果表明,四环素类化合物(TCs)在模拟太阳光照射下均能发生直接光降解,且其降解速率随pH不同变化很大。四环素(TC)、土霉素(OTC)、金霉素(CTC)和多西环素(DTC)的光降解速率随溶液pH升高明显加快,而米诺环素(MTC)在水中的光降解速率随溶液pH升高略有下降。天然水体pH范围内,模拟太阳光照下四环素类化合物表观光降解速率常数在0.004～0.026 min-1范围内,降解半衰期在26～136 min范围内。在室外实际太阳光照下,四环素类化合物光降解反应速率与太阳光强成正比例关系。晴朗无云天气下,四环素类化合物降解半衰期在春冬季节较长、夏季节较短;四环素在东江实际水体中表观光降解速率很快,在冬季晴天天气下,其平均半衰期仅为8.2 min。     

仿生矿化法制备壳聚糖/纳米CdS复合粒子对猩红B光催化降解研究

用仿生矿化法制备了壳聚糖/纳米CdS复合粒子,并用于可见光光催化降解猩红B染料模拟废水,系统地研究了染料初始浓度、pH值、催化剂投加量、光照情况和催化剂重复使用等因素对猩红B的光解脱色效率的影响。结果表明,当pH=3.0,催化剂投加量为0.7 g/L的条件下,对初始溶液为20 mg/L的猩红B模拟废水,60 min之内脱色率超过96%。酸性媒介比碱性媒介更有利于猩红B染料光解脱色。实验范围内Br^-、NO^-₃和Cl^-等无机阴离子,均对降解脱色有促进作用,其中NO₃^-对脱色作用促进最显著。处理前后的UV-Vis谱图分析表明猩红B在壳聚糖/纳米CdS复合粒子可见光光解处理过程中脱色是因为染料发生氧化光降作用。催化剂重复利用5次后,处理60 min对猩红B的脱色率仍可达到80.7%。     

Photocatalytic degradation of Acid Blue 62 over CuO-SnO2 nanocomposite photocatalyst under simulated sunlight

The novel CuO-SnO2 nanocomposite oxide photocatalysts were prepared by simple co-precipitation method, and characterized by X- ray diffraction, transmission electron microscopy, N2 adsorption-desorption measurement and UV-Vis diffuse reflectance spectroscopy. The photocatalytic activities of CuO-SnO2, evaluated using the photodegradation of Acid Blue 62 as a probe reaction under the irradiation of Xenon light, were also found to be related to the calcination temperature and the molar ratio of Cu to Sn. The maximum photocatalytic activity of the CuO-SnO2 photocatalyst was observed to be calcined at 500~C for 3 h （the molar ratio of Cu to Sn was 1：1） due to the sample with good crystallization and high surface area. It also showed much higher photocatalytic activity in treatment dye wastewater under simulated sunlight irradiation compared to Degussa P25 TiO2.     

自然大气环境结构材料试验装置可行性研究

通过建立"腐蚀环境综合试验仓"、"温度、湿度、日照、淋雨综合试验仓"、"高原环境试验仓"三个大型试验仓,构建成可模拟我国不同地域大气环境,可针对大尺寸工程构件,系统开展环境适应性评价的实验装置.     

Leaching and persistence of ametryn and atrazine in red–yellow latosol

This study evaluated the mobility and persistence of atrazine and ametryn in red–yellow latosols using polyvinyl chloride columns with a diameter of 100 mm and a height of 15 cm. The assays simulated 60-mm rainfall events at 10-day intervals for 70 days. The persistence and leaching were evaluated for these two herbicides. The analytes obtained from the samples were quantified by gas chromatography using flame ionization detection. Compared with ametryn, atrazine showed a greater potential to reach depths below 15 cm over 30 days of simulated rain. Ametryn, however, showed greater persistence in soil at 70 days after application. The persistence of atrazine and ametryn in soil under sunlight was 10 and 144 days respectively. Atrazine was more susceptible to sunlight than ametryn because sunlight favored atrazine degradation in hydroxyatrazine. The results indicate that in red–yellow latosol, atrazine has a high leaching potential in short term, but that ametryn is more persistent and has a high leaching potential in long term.     

La_2O_3-TiO_2的制备及其光催化性能

采用溶胶-凝胶法制备了La2O3-Ti O2光催化剂;运用XRD,UV-Vis DRS,BET技术对光催化剂进行了表征;并以太阳光为光源,研究了不同制备条件及光反应条件下La2O3-Ti O2对罗丹明B的降解效果。实验结果表明:最佳制备条件为镧掺杂量(硝酸镧与钛酸丁酯的质量比)0.9%、焙烧温度500℃、焙烧时间2 h;该条件下制备的光催化剂为中孔结构(平均孔径3.867 nm),禁带宽度小(2.07 e V),Ti O2为锐钛矿相;在光催化剂投加量为2 g/L、溶液p H为3的最佳光反应条件下反应4 h,La2O3-Ti O2对罗丹明B的降解率达99.7%,远高于N-Ti O2的42.0%;重复使用5次的La2O3-Ti O2光催化剂仍对罗丹明B保持较高的降解率(98.5%)。