圆板型多孔α-Al2O3陶瓷膜支撑体的制备与表征

以α-Al2O3为骨料,羧甲基纤维素作为成孔剂,高岭土、TiO2作为高温粘结剂和烧结助剂,采用干压成型工艺和固态粒子烧结法制备出了圆板型多孔α-Al2O3陶瓷膜支撑体(=50 mm,厚度为2 mm)。研究了成孔剂用量、高温粘结剂和烧结助剂的用量、烧结温度因素对支撑体性能的影响。结果表明,制得的支撑体孔隙率在34%以上,孔径在2.23～6.75μm,耐酸碱度在98%以上,机械强度高。     

饮用水除砷材料吸附特性及影响因素分析

采用活性氧化铝、零价铁粉和载铁沸石作为吸附剂,通过静态吸附实验,研究3种饮用水除砷材料的吸附特性及影响因素。结果表明,在pH值为6.5,砷浓度为1 mg/L,投加量为2 g/L,25℃恒温的条件下,活性氧化铝、零价铁粉和载铁沸石分别在90 min、150 min和90 min达到吸附平衡状态,均较好符合langmuir等温吸附模型,对砷的最大吸附容量依次为7.3、3.3和3.9 mg/g。pH值和竞争性阴离子对砷的去除均有显著影响。降低溶液pH值能明显提高3种材料的除砷效率;水中磷酸根离子的存在,能够明显降低活性氧化铝和零价铁粉的除砷效率;水中硅酸根离子的存在,能够明显降低零价铁粉和载铁沸石的除砷效率。     

铝灰酸溶法制备聚合氯化铝

以铝灰为原料采用酸溶法制备了聚合氯化铝（PAC）,并通过正交实验优化了PAC制备的最佳工艺参数,并考察了自制PAC对废水COD的去除效果。制备PAC的最佳工艺条件为：m（铝灰）∶V（HCl）∶V（H₂O）=10∶20∶40,反应温度85℃,反应时间2.5h,搅拌转速80r/min,熟化时间30h,熟化温度60℃。采用生石灰可高效、经济地调节产品的盐基度,且产品在处理印染废水时COD去除率达64.7%,高于市售同类产品。     

活性氧化铝去除地下水中微量砷的实验

研究了活性氧化铝对地下水中低浓度砷的吸附效果。结果表明,活性氧化铝对砷的吸附作用与溶液的pH值有关,pH值在5～6之间对砷的吸附率最高,最大活性氧化铝砷吸附量为75mg/g。活性氧化铝不仅对砷有吸附作用,对氟化物也有较强的吸附作用。     

活性氧化铝对水中磷的去除与回收研究

使用活性氧化铝作为吸附剂研究其对磷的吸附特性,并对不同提取剂对磷的回收效果进行了讨论.结果表明,活性氧化铝对使用蒸馏水、自来水及洱海入湖河流罗时江水配制的磷溶液有不同的磷吸附效果,其对3种不同磷溶液的吸附等温线模型均符合Langmuir模型,经计算得到理论最大吸附量分别为20.88、32.15和29.85 mg·g-1.通过吸附试验表明,电解质的存在对吸附效果有促进作用.pH值越低,活性氧化铝表面的Zeta电位越高,越有利于磷吸附.对比使用4种不同提取剂的试验结果表明,使用0.1 mol·L-1NaOH基本可以完全提取活性氧化铝吸附的磷.     

Decomposition of hexachlorobenzene over Al2O3 supported metal oxide catalysts

Decomposition of hexachlorobenzene (HCB) was investigated over several metal oxides (i.e., MgO, CaO, BaO, La₂O₃, CeO₂, MnO₂, Fe₂O₃, and Co₃O₄) supported on Al₂O₃, which was achieved in closed system at a temperature of 300°C. Catalysts were prepared by incipient wetness impregnation with different metal oxides loading and impregnating solvents. The decomposition efficiency of different catalysts for this reaction depends on the nature of the metal oxide used, and Al₂O₃ supported La₂O₃ was found to be the most active one. Pentachlorobenzene (PeCB), and all tetrachlorobenzene (TeCB), trichlorobenzene (TrCB), and dichlorobenzene (DCB) isomers were detected after the decomposition reaction, indicating that the decomposition was mainly a dechlorination process. The detection of all lower chlorinated benzenes suggested the complexity of decomposition and the presence of more than one dechlorination pathway.     

用梯度氧化铝膜净化空气

研究了孔径沿径向由大到小自然过渡的梯度氧化铝陶瓷膜管对空气的过滤净化。梯度氧化铝膜管控制层平均孔径为 0 2 μm ,对于空气中粒径大于或等于 0 2 2 μm的颗粒 ,膜管的截留率达到 10 0 % ;细菌的总滤除率为 99 99%。提高操作压力和错流线速度都有利于提高膜的过滤通量。空气净化过程中截留在空气中的微粒沉积于梯度氧化铝膜的管内壁 ,防止膜管的深层堵塞 ,使用过程通量下降缓慢 ,一次性使用寿命为 4年 ,易于清洗 ,清洗后过滤通量和过滤效率仍达 10 0 %     

非均相催化氧化处理焦化废水

研究了非均相催化氧化处理焦化废水的效果。实验得出处理焦化废水的最佳条件：采用经质量浓度为80g／L的硝酸铜溶液浸渍后的γ—Al2O,为催化剂,废水pH为3,催化剂体积分数为40％,H2O2体积分数为4％,反应时间3h以上。原水经处理后COD由4540mg／L降至600mg／L以下,氨氮质量浓度由552mg／L降至160mg／L以下。     

Simultaneous determination of fenitrothion and aminocarb in blueberry foliage and fruits: Application to the analysis of residues in field samples

Abstract

Samples of blueberry foliage and fruits were collected from spray blocks in Ontario after aerial application of fenitrothion and aminocarb at dosage rates of 210 g active ingredient (AI)/ha and 70 g AI/ha respectively. Residues were extracted from the samples by homogenizing with ethyl acetate, cleaned up by microcolumn chromatography using alumina as adsorbent, and analyzed by GLC‐AFID with a glass column packed with 1.5% OV‐17 and 1.95% OV‐210 on 80–100 mesh Chromosorb W‐HP. Average recoveries for fenitrothion and aminocarb from foliage at three fortification levels (1.0, 0.10 and 0.01 ppm) were respectively 99 and 96%. The corresponding values for the fruits were 99 and 95%. Foliage samples collected 1 h post‐spray contained on average 1.13 ppm of fe‐nitrothion and 1.14 ppm of aminocarb. However, residue levels reached below the detection limit (<0.01 ppm) in foliage collected 15 d after treatment. In addition, the fruit samples collected after 15 d post‐spray contained extremely low levels (0.03 ppm for fenitrothion and 0.02 ppm for aminocarb) of residues, and were barely above the detection limit.     

硅铝比和NiO对ZSM-5协同低温等离子体降解甲苯的影响

研究了不同硅铝比的ZSM-5与Ni/ZSM-5分子筛协同低温等离子体技术对甲苯降解性能的影响.以Ni O(Nickel Oxide)为活性组分,采用浸渍法对ZSM-5分子筛进行改性,利用氮气吸附脱附(BET)、X射线衍射仪(XRD)、X射线光电子能谱分析(XPS)、H_2程序升温还原(H_2-TPR)、NH_3程序升温脱附(NH_3-TPD)、Toluene程序升温脱附(Toluene-TPD)等技术表征样品的物理化学性质.考察了硅铝比对ZSM-5与Ni/ZSM-5分子筛体系中甲苯的吸附性能,研究了不同放电电压下硅铝比对甲苯降解率、碳平衡及二氧化碳选择性的影响,并采用气相色谱-质谱联用仪(GC-MS)分析了催化剂表面的有机产物.结果表明:硅铝比不但影响分子筛本身的物理化学特性(比表面积、氧化还原性能、表面酸性、疏水性等),还会影响Ni的负载形态和方式,更高的硅铝比与Ni O的负载能促进甲苯深度氧化,减少副产物,提高碳平衡和二氧化碳选择性.