流化床中污泥干燥特性

以湿污泥为原料在气固流动流化床干燥器内进行了污泥干燥特性的实验研究,考察流化风速、送风温度、联合干燥热量配比的变化对干燥强度、干燥热效率及平均传热系数的影响。实验结果表明,流化床污泥干燥最佳流化风速为1.48 m/s左右;随着流化风温的升高,干燥强度和干燥热效率逐渐增大,但增幅减小;单独的加热管干燥和流化风干燥的干燥热效率均较低,分别为33%和45%左右。在相同总输入热量下,随着内置加热管输入热量的比重越来越大,干燥热效率、干燥强度和平均传热系数均先增大后减小。     

基于LabVIEW设计的热延伸试验机

根据GB/T 5013.1和GB/T 2951.12的要求,对电线电缆的绝缘和护套需要进行热延伸试验。为了提高检测数据的准确性和可靠性,利用LabVIEW设计了热延伸试验机,不仅实现了数据采集、计算、存储及监控,还可以查看历史记录、实时报警等功能。该试验机控制界面设计友好,在线参数设定方便、扩展性强等优点,具有较高的实用价值。     

Status and Environmental Impact of Emissions from Thermal Power Plants in India

The main emissions from coal combustion at thermal power plants are carbon dioxide (CO₂), nitrogen oxides, sulfur oxides, chlorofluorocarbons (CFCs), and airborne inorganic particles such as fly ash and soot; CO₂, methane, and CFCs are greenhouse gases. These emissions are considered to be partially responsible for harmful global climate change. This review summarizes the status of thermal power plants in India and their various types of emissions that directly or indirectly produce harmful effects on the environment and human health. Moreover, it focuses on various types of preventive measures used to avoid/minimize emissions.     

热解吸对污染土壤中不同形态汞的去除作用

选取贵州省万山矿区的汞污染土壤样品进行不同形态汞的热解吸去除行为研究。研究了热解吸过程中∑Hg的去除效果及动力学,以及温度和时间对污染土壤中不同形态汞的去除作用。结果表明,热解吸修复技术可有效去除土壤中的汞,土壤中∑Hg的热解吸过程符合二级动力学方程。固定热解吸时间在10 min时,随着热解吸温度的升高,土壤中水溶态汞、盐酸溶态汞和碱溶态汞含量呈现先下降后上升再下降的趋势,王水溶汞和盐酸溶态汞始终呈现下降趋势,说明不同形态的汞之间发生了转化。热解吸温度为250℃时,随着热解吸时间的增加,环境风险大的水溶态汞、盐酸溶态汞、碱溶态汞和硝酸溶态汞的去除率大幅增加,土壤的有机质损失较少,说明在低温下,延长热解吸时间,对生物毒性强的形态汞有良好的修复效果,且此温度下处理后的土壤更容易恢复农田耕作。     

反渗透与低温多效法海水淡化工艺在电站应用中的比较

海水淡化是淡水资源紧缺的沿海电厂向海洋获取新鲜淡水的主要方式,目前主要有反渗透膜法和低温多效热法等技术路线。对上述两种技术从工艺、技术经济性等方面进行综合比较,分析各自的优势及存在的不足。最后根据舟山地域特点及地区海水淡化规划,推荐适合舟山电厂的海水淡化技术。     

Heat transfer of vapor chamber with different types of microchannels

Two 40-mm × 35-mm × 1.525-mm micro vapor chambers were fabricated by inductively coupled plasma etching on silicon substrates and tested in this study. One vapor chamber exhibited convergent microchannels, whose widest and narrowest width were 0.3 mm and 0.1 mm, respectively, and the other exhibited discontinuous microchannels having width of 0.3 mm. Those micro vapor chambers that were filled with deionized water in a filling ratio of approximately 48% were tested with various titled angles and input powers. The results showed that the thermal performance of the vapor chamber having discontinuous microchannels was inferior because the spacing between microchannelend and the micropostin both condensing and evaporating sections was too far to return the condensed fluid from condensing section to the evaporating section of the vapor chamber. On the contrary, the convergent microchannel in the other vapor chamber enhanced capillary force, so that the condensed liquid could be successfully forced from the condensing section to the evaporating section even with top heating mode (–90°). The thermal resistance of the vapor chamber having convergent micro channels with top heating mode was 2.08°C/W at 22 W, while the thermal resistance of the vapor chamber with horizontal heating mode was 1.46°C/W at 28 W.     

固体吸附/热脱附-气相色谱法测定环境空气中苯系物的不确定度评定

建立固体吸附/热脱附-气相色谱法测定环境空气中苯系物的不确定度评定方法,分析测定过程中不确定度的来源,进行各不确定度分量的评估,并给出合成相对标准不确定度和扩展不确定度。     

直接进样-热脱附-GC-MS快速测定大气细颗粒物中有机示踪物

建立了直接进样-热脱附-GC-MS快速测定细颗粒物中甾烷类和藿烷类有机示踪物的方法。经实验条件优化,13种目标化合物的线性回归方程的相关系数均在0.990以上,空白加标回收率为81.4%~102.3%,实际样品加标回收率为79.1%~112.9%,相对标准偏差小于13.2%。当采样体积为24 m~3时,各目标化合物的检出限为0.008~0.084 ng/m~3,方法灵敏度高。利用该方法测定了北京城区采暖季和非采暖季PM2.5实际样品,结果表明:各目标物均有检出,且采暖季的甾烷类和藿烷类化合物的总量均明显高于非采暖季。该方法无需复杂的前处理和有机溶剂,操作简便快捷,在颗粒物中非极性化合物的快速检测方面具有很大的应用价值。     

型煤燃烧特性初探

本文使用热重分析仪对型煤的燃烧特性进行了初步探讨。煤灯样品在升温过程中,发生两次快速失重,对应的温度分别为Ｔ１和Ｔ２。由于制备型煤时,添加了无机粘结剂和无机固硫剂等无机物,导致制备型煤用的混合料的Ｔ１比原煤降低,而刷烈燃烧温度Ｔ２却比原煤升高。     

医用电气设备电源变压器的过载试验

采用电阻法测量医用电气设备电源变压器过载试验时的绕组温升,试验电流和试验时间的选取与熔断器、过流释放器、热断路器等保护装置有关。