Ambient Aerosol and its Carbon Content in Gainesville, a Mid-Scale City in Florida

Ambient aerosols were collected during 2000–2001 in Gainesville, Florida, using a micro-orifice uniform deposit impactor (MOUDI) to study mass size distribution and carbon composition. A bimodal mass distribution was found in every sample with major peaks for aerosols ranging from 0.32 to 0.56 μm, and 3.2 to 5.6 μm in diameter. The two distributions represent the fine mode (<2.5 μm) and the coarse mode (>2.5 μm) of particle size. Averaged over all sites and seasons, coarse particles consisted of 15% carbon while fine particles consisted of 22% carbon. Considerable variation was noted between winter and summer seasons. Smoke from fireplaces in winter appeared to be an important factor for the carbon, especially the elemental carbon contribution. In summer, organic carbon was more abundant. The maximum secondary organic carbon was also found in this season (7.0 μg m⁻³), and the concentration is between those observed in urban areas (15–20 μg m⁻³) and in rural areas (4–5 μg m⁻³). However, unlike in large cities where photochemical activity of anthropogenic emissions are determinants of carbon composition, biogenic sources were likely the key factor in Gainesville. Other critical factors that affect the distribution, shape and concentration were precipitation, brushfire and wind.     

Investigation of heavy metal contaminations in the lower Sakarya river water and sediments

In this work, water and sediment samples were collected from three different stations located along the Sakarya river between May and September 2003. Lead, copper, chromium, zinc, nickel and cadmium concentrations were determined by using solvent extraction and flame atomic absorption spectrometric method. The results show that differences based upon sampling times, regions, sediment and water samples were observed. The mean levels of copper, nickel, chromium, lead, cadmium, zinc for sediment samples are; 4.630 μg g⁻¹, 13.520 μg g⁻¹, 8.780 μg g⁻¹, 2.550 μg g⁻¹, 9.990 μg g⁻¹ and for water samples are; 0.851 μg g⁻¹, 1.050 μg g⁻¹, 0.027 μg g⁻¹, 1.786 μg g⁻¹, 0.236 μg g⁻¹, 0.173 μg g⁻¹, respectively.     

长江沉积物中痕量氯代酚类化合物的测定

本文利用同位素稀释质谱法对长江南京段沉积物中１８种氯代酚进行了分离鉴定,结果表明,沉积物中ＣＰｓ的含量以五氯苯酚为主,     

气相色谱-质谱法测定废酸油渣中的16种多环芳烃

建立了废酸油渣中16种多环芳烃超声萃取、Florisil萃取柱净化、气相色谱-质谱测定的方法.笔者对提取方式、提取剂类型和体积、提取时间和次数、净化方式等进行研究,采用无水硫酸钠分散,二氯甲烷作为提取剂超声40 min,提取液经纯水清洗、离心后取适量有机相经过3 g Florisil萃取柱净化,采用气相色谱-质谱选择离...     

混合酸消解变化对土壤和沉积物中痕量硒分析影响

基于各3种采集环境样本、国家标准物质的土壤和沉积物,以当前环境监测行业常用的3种消解方法,探讨20种混合酸系统条件在消解条件变化中对复杂样本硒元素测定的影响.确定了最佳土壤和沉积物消解的组合为王水系统(盐酸∶硝酸∶氢氟酸∶过氧化氢∶高氯酸=3∶1∶1∶1∶1),各消解法的处理结果部分(n=5):水浴法消解时间仅需0.5...     

不同点火模式下软质聚氨酯泡沫燃烧的实验研究

为研究软质聚氨酯泡沫(FPUF)的燃烧行为对火灾的影响,采用锥形量热仪(CONE)分析FPUF在强制点火和非强制点火模式下的燃烧行为、热释放速率HRR、质量损失速率MLR和燃烧效率η。研究结果表明：当外部辐射≥40 kW/m²时,FPUF在2种点火模式下燃烧的HRR和MLR均出现2个明显的峰值且η约为88%;当外部辐射<40 kW/m²时,FPUF在非强制点火模式下燃烧的HRR和MLR曲线趋于单峰形式;FPUF在强制点火模式下燃烧前期为异氰酸酯(TDI)和多元醇的混合燃烧,在非强制点火模式下为TDI的挥发。根据研究结果修正现有燃料组分的热值计算方法,获得FPUF和多元醇的热值分别为(20±2),(28±3) kJ/g。     

衡山PM_（2.5）中痕量金属元素的分析

建立了微波消解-电感耦合等离子体质谱法同时测定PM2.5中12种痕量金属元素的方法。对不同消解体系进行了讨论,确定采用HNO3＋H2O2消解体系。方法检出限在0.01～6.4 ng/m3之间,精密度为0.5%～8.9%,加标回收率在69.2%～92.6%之间。应用该方法测定了衡山PM2.5中痕量金属元素的含量,讨论了痕量元素的浓度分布特征,对各元素进行了相关性分析,并应用富集因子法对来源进行了分析。     

电感耦合等离子体原子发射光谱法(ICP-AES)测定磷生铁中的Mn、P、Si

建立了电感耦合等离子体原子发射光谱（ICP-AES）法测定磷生铁中3种元素Mn、P、Si的定量分析方法.通过试验选择257.610nm、185.942nm、212.412nm分别作为Mn、P、Si的分析谱线,无需进行光谱干扰校正.实验结果表明,各元素分析谱线线性相关系数大于0.9990.方法用于高磷铸铁标准物质分析,测定值与认定值相符,测定结果的相对标准偏差在0.21％ （Mn） ～1.8％ （P）范围.     

温州近海海域海水及滩涂沉积物中PFOS和PFOA污染特征分析

为了解温州近海海域全氟辛烷磺酸(PFOS)和全氟辛酸(PFOA)的污染状况和特征,采用固相萃取/高效液相串联质谱检测法分析了采自乐清湾、瓯江口、西湾、飞云江口及洞头半屏岛的近海海水和滩涂沉积物中PFOS和PFOA污染水平。结果显示,温州近海海水普遍存在PFOS和PFOA污染,其中,PFOS的浓度范围为<1.0～31.36 ng/L,中位浓度为2.29 ng/L;PFOA的浓度范围为<1.0～23.66 ng/L,中位浓度为5.29 ng/L。滩涂沉积物样品中PFOS和PFOA的浓度范围(干重)分别为(<1.0～11.91)×10-9(中位浓度为3.60×10-9)和(1.84～34.01)×10-9(中位浓度为6.83×10-9)。温州近海海水中PFOS和PFOA的污染水平明显高于香港沿岸、中国南海海水、韩国沿岸海水和近海珠江三角洲,与大连湾的海水相当,海岸滩涂沉积物中的PFOS和PFOA浓度远高于珠江和黄浦江沉积物中的浓度。     

四川妇女血清中多溴联苯醚的浓度水平与组成特征

用气相色谱-质谱的选择离子法测定四川省妇女血清中多溴联苯醚的质量浓度,并对其组成特征及主要来源进行了研究.在被测的11种多溴联苯醚当中,BDE-209是主要成分,质量浓度从0.12～2.38μg.L-1,中值为0.63μg.L-1,占多溴联苯醚总量的质量分数为63.57%～90.34%,其次是BDE-66、-99和-100,其它多溴联苯醚几乎没有检出,表明污染主要来自十溴联苯醚,其次是四溴和五溴联苯醚.实验结果与其它国家的数据相比,表明多溴联苯醚对普通妇女的污染在四川还处于一个较低的水平.