纳米铁强化的混凝-沉淀-过滤工艺对典型印染废水中有机物去除

以东江流域某典型印染企业尾水为研究对象,将混凝剂与少量的纳米铁进行复合投加,再结合多介质过滤器对印染尾水进行深度处理实验研究.结果表明,新型混凝剂HPAC-9对极性有机物具有较强的去除能力,但对非极性或弱极性有机物去除效果不很理想.通过将纳米铁与HPAC-9复合投加并结合多介质过滤工艺,对印染企业尾水中的有机污染物进行...     

Modelling spills of water-reactive chemicals

This paper describes part of a programme of work undertaken at the Health and Safety Laboratory (HSL) to investigate the behaviour of selected water-reactive chemicals. Following an accidental release, such substances react exothermically with any water present, generating acidic vapours. The STAWaRS (Source Term Assessment of Water Reactive Substances) software was developed for the Health and Safety Executive (HSE) by ESR Technology to model this complex process. The aims of the study described here were to provide experimental validation of the heats of hydrolysis used within STAWaRS, and to perform sensitivity studies on selected STAWaRS input parameters.The heat of hydrolysis of acetyl chloride was measured and showed good correlation with the value used within STAWaRS. Some of the variables that influence the severity of acetyl chloride spills are examined, with reference to predictions made by the STAWaRS model. The heats of hydrolysis of titanium tetrachloride previously measured at HSL are also discussed, and the effect of adopting these experimentally derived values for modelling spills is shown for a hypothetical land use planning case. This study demonstrates the importance of using experimentally validated values for STAWaRS input parameters.     

一起有机硅工厂燃爆事故的应急监测案例分析

本文介绍了绍兴市袍江工业区2.20浙江恒业成有机硅有限公司燃爆事故的应急监测,在监测过程中确立了气、水等环境介质作为监测对象,确定含硅有机物和氯化氢作为主要监测因子,并根据实际情况合理地选择了监测方法,以为事故的应急处理提供借鉴。     

Chloride Released from Three Permeable Pavement Surfaces after Winter Salt Application

Few studies exist on how chloride from chloride‐based deicers is transported in infiltration‐based stormwater control measures. In 2009, the U.S. Environmental Protection Agency (USEPA) constructed a 0.4 ha parking lot in Edison, New Jersey, that was surfaced with permeable interlocking concrete pavers (PICP), pervious concrete (PC), and porous asphalt (PA). Each surface type has four equally sized, lined sections that direct all infiltrate to separate 5.7 m³ collection tanks. The USEPA acute criterion for aquatic life (860 mg/l) was exceeded in events immediately following a snow event. Concentrations of the infiltrate exceeded the detection limit (5 mg/l) year round but did not exceed the USEPA chronic toxicity (230 mg/l) after April. The chloride concentration decreased with cumulative rainfall since previous snow event, and a power regression described this relationship. In the power regression, the coefficient (b) described the initial concentration following a snow event, and the exponent (m) described the rate in which chloride was flushed through the system with infiltrating water. PC had the largest coefficient (5,664) and largest absolute exponent (?0.92), followed closely by PICP (b = 4,943 and m = ?0.87), and distantly by PA (b = 2,907 and m = ?0.67). The differences in release rate were proportional to the measured surface infiltration rates of 4,000; 2,400; and 200 cm/h for PC, PICP, and PA, respectively. These results will assist those who manage or regulate stormwater where receiving waters are chloride impaired.     

氯化橡胶的清洁生产

通过氯化橡胶的清洁生产审计，改进氯化工序的设备结构及尾气吸收工艺，提高氯气利用率，并把工艺气变成可利用的工业产品，取得显著的环境效益和经济效益。     

聚硅氯化铝混凝剂中Al(Ⅲ)水解聚合历程及铝硅作用特性研究

采用共聚与复合两种制备工艺，制备出了系列具有不同碱化度和不同Ａｌ／Ｓｉ摩尔比的聚硅氯化铝混凝剂，分析研究了ＰＡＳＣ中Ａｌ（Ⅲ）的水解－聚合历程以及聚硅酸与铝水解聚合产物的相互作用，探讨了ＰＡＳＣ溶液的酸解聚。     

聚合氯化铝与有机高分子复合絮凝剂的形态分布研究——AlFerron和~(27)AlNMR相结合

主要研究了Ａｌ－Ｆｅｒｒｏｎ逐时络合比色法和＾２７Ａｌ－ＮＭＲ法应用于聚合铝与有机高分子复合絮凝剂形态分布的测定，结果表明，两种方法分别测定的Ａｌｂ和Ａｌ１３的结果具有一定的相关性；聚合铝与有机高分子复合后其形态分布发生了一定的变化，Ａｌｂ（或Ａｌ１３）的含量有所降低，但仍是优势形态，Ａｌａ（或Ａｌ单）的含量基本保持不变。     

煤矸石制取聚羟基氯化铝的研究

介绍了用煤矸石制取聚羟基氯化铝的方法,研究了酸浸、调整盐基度等过程的最佳工艺过程。     

氯化钠抑制下乙酸厌氧降解的动力学模型

作者利用五个实验室规模的完全混合反应器进行较长时间的半连续培养,研究在氯化钠抑制下乙酸盐的厌氧降解。结果表明,在不同条件下运行的反应器内,存在优势菌群的显著差异,因此在不同条件下运行的反应器对抑制有不同的响应。作者引入抑制因子的概念,建立了在氯化钠抑制下乙酸厌氧降解的动力学模型。同时指出反应器运行条件与菌群组成的联系以及菌群组成的差别对反应器运行状况的影响,在废水生物处理的动力学模型研究中应给予足够的重视。     

二氧化钛脱除高温烟气中的氯化氢

HCl是城市垃圾焚烧产生的主要气体污染物之一。将一种新型脱氯剂TiO2引入到垃圾焚烧系统中,并与其他脱氯剂的性能进行比较。研究了不同脱氯剂使用量、不同反应温度和不同HCl气体浓度对TiO2、CaO和CaTiO3脱氯效果的影响。结果显示,TiO2能在高温(800~1 000℃)、高HCl浓度(1 303.6~1 629.5 mg/m3)下获得较好的脱氯效果。与传统的脱氯剂CaO相比,TiO2更适合于高温烟气脱氯,其在1 000℃时的氯容(36.3 mg HCl/g TiO2)几乎是相同情况下的CaO氯容(9.3 mg HCl/g CaO)的4倍。而CaTiO3的脱氯效果不但受到自身分解效率的影响,还受到TiO2和CaO脱氯效果的影响,其脱氯效果较差。