Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

利用餐饮业废油脂制造生物柴油

世界的石油产量将会逐渐减少,石化柴油燃烧后所排放的废气是造成的城市空气污染的主要原因,生物柴油是石化柴油很好的替代能源,文章介绍了国外废油脂处理利用和甸餐饮业废油脂的概况,提出了利用餐饮业废油脂制造生物柴油的方法和工艺流程,并讨论了利用餐饮业废油脂制造生物柴油的几个问题。     

船舶螺旋桨射流对湘江河床底泥扰动影响分析

船舶航行时螺旋桨产生的射流会对河道水流产生扰动,这种扰动是否能引起河床底泥的再悬浮需要更深入的论证分析。通过对比分析螺旋桨射流发展规律的研究成果,以湘江典型河段为研究对象,结合实船测量结果和此段河流地质资料,探讨了螺旋桨射流对湘江长株潭段河床底泥扰动的影响,并对此段河床底泥起动和悬浮条件进行了理论分析。结果表明:在周围环境流速较低的条件下,螺旋桨射流初始速度、河床水深及泥沙粒径是决定泥沙是否运动的主要因素。湘江长株潭河段已基本库区化,大部分河道平均水深远大于航道的标准水深2.8 m,河床泥沙平均粒径大于0.87 mm,其中细颗粒泥沙很少,由于螺旋桨射流断面平均流速小于泥沙起动流速,悬浮指标计算值远大于4,因此可以判断船舶正常航行在该段河流时底泥难以起动和再悬浮。     

连续流动注射间接测定空气中的五氧化二磷

建立连续流动注射间接测定空气中五氧化二磷的方法。空气中的五氧化二磷用过氯乙烯滤膜或滤筒采样,加入去离子水反应生成正磷酸,过滤、洗涤、定容后运用连续流动注射仪进行测定。优化了抗坏血酸浓度、硫酸浓度、钼酸盐浓度以及恒温室温度等影响显色的因素。最佳条件下,实际样品五氧化二磷加标回收率为96.0%~102%,相对标准偏差在4%以下;采样体积为300 L时,方法检出限为0.001 6 mg/m~3。t检验结果表明,所建方法与现行国标法的测定结果无显著性差异。方法分析速度快、重现性好、灵敏度高,适用于空气中五氧化二磷的测定。     

VPT511BF-SY多孔流速仪在烟气流量在线监测中的应用

针对目前国内基于单个探头的单点在线测试烟气流量与参比方法监测比对合格率不高的问题,提出一种新颖的基于平均差压皮托管法的多孔流速仪,通过对不同的安装位置及安装数量的多孔烟气流速仪的烟气在线流量监测结果与手工监测结果进行比对,验证在适当位置安装一定数量的多孔烟气流速仪可以确保与手工监测比对结果满足要求。     

流动注射分光光度法测定水中六价铬的研究

研究建立了测定水中六价铬的流动注射光度分析方法,探讨了利用抗坏血酸的还原性扣除水样中轻度色度或浊度干扰的可行性.本方法线性关系好,检出限低,精密度和准确度高,对地表水、地下水、生活污水、工业废水等实样的测定获得了令人满意的结果.与传统的二苯基碳酰二肼分光光度法相比,具有方法简单、灵敏度高、分析速度快等优点,适用于环境监测的分析工作.     

岛津TNP-4110在线分析仪的日常维护

从数据比对、硬件维护两个方面探讨岛津TNP-4110在线仪的日常维护问题。通过分析各种干扰因素来查找造成数据比对差异的原因并提出相应解决措施。在仪器日常维护上设立不同周期保养计划、共享设备维护经验,结合实践制定了合适的检修流程图。     

基于EFDC的长江常州段污水排江浓度场数值模拟

长江感潮河段水流与污染排放引起的浓度场复杂多变,基于EFDC(Environmental Fluid Dynamic Code)模型,采用正交曲线网格拟合自然河道边界,建立了长江常州段的水动力和水质模型。采用现场同步实测资料,与计算结果比对,证明该模型在水动力和水质两个方面都与实测数据吻合较好,满足了实际工程的需要;同时由于长江水流运动较快,一阶降解动力学已经满足了化学需氧量(COD)、氨氮(NH3-N)和总磷(TP)浓度计算要求,可以不考虑它们复杂的生化反应过程。     

武汉市一次污染过程的局地流场和边界层结构的数值模拟

利用2013年11月武汉市逐日空气质量资料、地面气象观测资料、NCEP/NCAR再分析资料和L波段雷达探空资料,通过WRF模式模拟空气污染生消过程中的局地气象条件变化,探讨特殊地形条件下边界层结构变化和局地环流在污染物生消过程中的作用和影响。结果表明：（1）武汉地区当背景环流场强的时候,由地形引起的局地流场对污染物扩散的影响就弱,反之当背景环流场弱的时候, 地形对流场影响明显:夜间为山风,白天为谷风。夜间山风与偏西北气流及偏东气流在武汉及周边地区辐合,形成气流汇聚带,在武汉地区形成一个反复污染带,即由地形引起的局地流场对污染物扩散的贡献就大;（2）武汉地区发生空气污染时,地面湿度较高,边界层呈上干下湿状态,其特征为暖而干且有偏东小风,这导致污染物不断堆积和重污染过程的形成。     

金属粉尘湿法处理系统的设计和除尘效果分析

为改善金属抛光操作人员的工作环境、降低抛光金属粉尘的爆炸风险,设计一种金属粉尘湿法处理系统,并通过建立多相流动数值模型,探究其内部流场特征与金属粉尘运动规律,分析金属粉尘湿法处理系统的除尘效率。研究结果表明:大粒径的金属粉尘直接重力沉降至水槽中;小粒径(PM10)的金属粉尘易随气流进入风道,进而通过水雾脱除;采用洁净进气源,可以有效降低工人操作环境的粉尘浓度;增加细水雾,可以有效提高金属粉尘湿法处理系统的除尘效率,对PM10的除尘效率从30%提升至82%。