铁屑去除酸法地浸采铀地下水中硝酸盐的试验研究

在酸法地浸采铀过程中,硝酸及硝酸盐的广泛使用使硝酸盐在地下不断累积并扩散到地下水中,这给矿区地下水造成了一定程度的污染.本试验以铁屑为还原剂,对该地下水中NO3--N的去除进行了批试验和动态试验研究.试验结果表明,铁屑可有效去除地下水中的NO3--N,其去除率随pH值的降低而逐渐升高;溶液中共存的Ca2 、Mg2 对NO3--N的去除影响不大,而SO42-、HCO3-的存在可明显降低NO3--N去除率;铁屑最佳投加量为120 g/L,铁炭最佳体积比为1∶1;二级柱可以明显提高柱子的稳定运行时间,在55 h内NO3--N去除率可保持在93%以上,去除效果较好.     

水源更换对给水管网水质的影响研究

为了研究水源更换对给水管网水质的影响,对北方A市水源更换过程中管网水质理化指标进行了监测分析.通过33 h的监测发现,由于水源水质不同造成管网水质化学不稳定,管网水水质部分指标发生了明显的下降,pH从7.54降到7.18,碱度从188　mg·L^-1降到117 　mg·L^-1,氯化物从310 　mg·L^-1降到132 　mg·L^-1（以Cl^-计）,电导率从0.176　S·m^-1降到0.087 　S·m^-1,钙离子和镁离子略有下降分别为15 　mg·L^-1和11 　mg·L^-1,这些都是由于滦河水质与黄河水质不同造成的;余氯在换水过程中发生了较复杂的变化,主要是由于水源更换造成耗氯量增加以及夜间用水量少造成管网水输配时间长引起的;pH、碱度、余氯的变化使得管网水中铁的含量增加,最高达到0.4 　mg·L^-1,超出饮用水标准规定的0.3 　mg·L^-1.通过分析水源更换过程中水质的变化,提出了控制管网水质稳定的方法主要有提高pH、增加碱度、投加缓蚀剂和严格保证出厂水及管网水水质指标特别是余氯等.     

铁矿石对脱除烧结废气中NOx的催化效应

向混合料中加添加剂能够在烧结过程中脱除烧结废气中的NO。实验研究了铁矿石对NO脱除反应的催化效应。在900℃下,分别以5种不同铁矿石作为填料层,用2种标准气体和压缩空气配制的混合气体模拟烧结废气。试验结果表明,铁矿石种类对铁矿石的催化能力有重要影响。D型铁矿的催化能力最强而且不会发生弱化,NO转化率接近100%;其它几种铁矿石的催化能力较差,随着反应时间的延长有明显的弱化现象,但很快即基本趋于稳定状态,NO转化率达到了60%~70%。     

某市给水管网中铁释放现象影响因素与控制对策分析

针对某市管网水中铁浓度的变化规律进行了系统的研究,确定了管垢向管网水中释放出的铁是管网水中铁超标的主要原因.研究中发现铸铁管和镀锌钢管中管垢的主要化学组分为铁.在给水管网中,管网水的溶解氧和余氯浓度低时,对应的管网水中铁释放现象严重,其原因是还原条件使管垢表面的致密钝化层被破坏,造成二价铁的大量释放.根据试验结果提出了给水管网中铁释放和“红水”现象的控制对策.     

石英砂负载氧化铁的表征及其除锑吸附性能研究

通过SEM/EDAX以及Nova-1000表面分析仪对石英砂负载的氧化铁颗粒进行了表征,发现负载氧化铁的粒径为200 nm左右,其表面孔径及孔隙率分别为2×10-9～9×10-9m及0.11%,负载氧化铁的石英砂的比表面积为原砂的5倍.考察了石英砂负载氧化铁(IOCS)在不同的实验条件下(吸附时间,pH值,温度等)对水溶液中锑的去除效果,在pH为3～9范围内,其去除率均超过了98%.吸附动力学及吸附等温线实验数据分别符合二级反应动力学模型及Langmuir等温吸附模型.热动力学实验结果进一步表明:IOCS吸附锑的过程是自发的、吸热的化学吸附反应.     

基于过程改变法的铁厂节水调控优化研究

将过程改变法应用到铁厂用水系统改造中,对其用水网络进行调优,实现废水排放量最小化。在厂区用水情况调查基础上,确定用水系统范围及限制杂质;并计算所确定用水系统的最小新鲜水用量和最小废水排放量;最后对其用水网络进行优化设计。改造后的铁厂用水网络新鲜水用量节约57.7%,废水排放量减少75.9%。     

含有机物铁泥的超临界水氧化法资源化

氨基染料生产过程中产生大量含有机物的铁泥,对环境造成严重污染并造成资源的极大浪费.利用超临界水氧化法对含有机物铁泥进行资源化处理研究,并对产物进行了X射线衍射分析(XRD)、色差实验与电子探针分析.研究结果显示,用超临界水氧化法处理铁泥可以将铁泥中所含的有机物完全氧化,真正实现环境友好;超临界水首先将铁泥氧化成α-Fe2O3与γ-Fe2O3,再经过800℃煅烧后可以作为氧化铁红颜料使用;超临界反应压力对样品的晶型与颜色影响不大.     

纳米级铁粉脱氯降解四氯化碳

四氯化碳的生产和使用,给人类带来了较大危害.为此,采用纳米铁粉这一新方法对其进行脱氯处理.试验以纳米级铁粉对四氯化碳的脱氯率为考察指标,选用L25(56)正交试验方案,考察了降解介质的初始pH值、纳米铁粉的质量、降解温度、摇床转速和脱氯时间5个影响因素.结果表明,pH值这一因素有极显著影响;在得出的纳米铁粉对四氯化碳脱氯的最佳工艺条件下,获得了99.5%的脱氯率,为有机氯化物脱氯开辟了一条新途径.     

Investigation on Fe, Mn, Zn, Cu, Pb and Cd fractions in the natural surface coating samples and surficial sediments in the Songhua River, China

Natural surface coating samples （NSCSs） from the surface of shingles and surficial sediments （SSs） in the Songhua River, China were employed to investigate the relationship between NSCSs and SSs in fractions of heavy metals （Fe, Mn, Zn, Cu, Pb, and Cd） using the modified sequential extraction procedure （MSEP）. The results show that the differences between NSCSs and SSs in Fe fi＇actions were insignificant and Fe was dominantly present as residual phase （76.22% for NSCSs and 80.88% for SSs） and Fe-oxides phase （20.33% for NSCSs and 16.15% for SSs）. Significant variation of Mn distribution patterns between NSCSs and SSs was observed with Mn in NSCSs mainly present in Mn-oxides phase （48.27%） and that in SSs present as residual phase （45.44%）. Zn, Cu, Pb and Cd were found dominantly in residual fractions （〉48%）, and next in solid oxides/hydroxides for Zn, Pb and Cd and in easily oxidizable solids/compounds form for Cu, respectively. The heavy metal distribution patterns implied that Fe/Mn oxides both in NSCSs and SSs were more important sinks for binding and adsorption of Zn, Pb and Cd than organic matter （OM）, and inversely, higher affinity of Cu to OM than Fe/Mn oxides in NSCSs and SSs was obtained. Meanwhile, it was found that the distributions of heavy metals in NSCSs and SSs were similar to each other and the pseudo-total concentrations of Zn, Cu, Pb and Cd in NSCSs were greater than those in SSs, highlighting the more importance for NSCSs than SSs in controlling behaviours of heavy metals in aquatic environments.     

Selective extraction and separation of Fe, Mn oxides and organic materials in river surficial sediments

In order to investigate the adsorption mechanism of trace metals to surficial sediments （SSs）, a selective extraction procedure was improved in the present work. The selective extraction procedure has been proved to selectively remove and separate Fe, Mn oxides and organic materials （OMs） in the non-residual fraction from the SSs collected in Songhua River, China. After screening different kinds of conventional extractants of Fe and Mn oxides and OMs used for separation of heavy metals in the soils and sediments, NH2OH .HCl （0.1 mol/L） ＋ HNO3 （0.1 mol/L）, （NH4）2C2O4 （0.2 mol/L） ＋ H2C2O4 （pH 3.0）, and 30% of H2O2 were respectively applied to selectively extract Mn oxides, Fe/Mn oxides and OMs. After the extraction treatments, the target components were removed with extraction efficiencies between 86.09%--3.36% for the hydroxylamine hydrochloride treatment, 80.63%- 101.09% for the oxalate solution extraction, and 94.76%-102.83% for the hydrogen peroxide digestion, respectively. The results indicate that this selective extraction technology was effective for the extraction and separation ofFe, Mn oxides and OMs in the SSs, and important for further mechanism study of trace metal adsorption onto SSs.