308 nm光作用下α-Fe2O3表面HNO3的光解

采用紫外可见光谱(UV-Vis)、傅立叶变换红外光谱(FTIR)及离子色谱(IC)技术对HNO3在α-Fe2O3表面暗反应和308nm下光解反应进行了研究.考察了时间、HNO3浓度、相对湿度(RH)等条件对反应的影响.结果表明,随着HNO3浓度、光照时间的增加,HNO3在气相与α-Fe2O3表面光解产物浓度均呈指数增加;HNO3在α-Fe2O3表面光解产生的NO2、NO分别为气相产生的3.27及3.87倍,而无论气相还是表面光解的NO2浓度均约为NO的2倍.随着RH的增加,HNO3光解产生的HONO的浓度随之呈指数增大,其产率从RH 20%时的0.023增加到90%时的0.087.α-Fe2O3的表面效应在HNO3的表面光解反应中起主导作用.     

V_2O_5-TiO_2离子存储电极薄膜的溶胶-凝胶法制备与性能研究

利用无机溶胶-凝胶技术制备了V2O5-（TiO2）x离子存储电极薄膜。采用X射线衍射（XRD）、原子力显微镜（AFM）、Raman光谱、循环伏安法（CV）和紫外-可见光透射光谱分别研究了复合薄膜的微观结构、化学计量、锂离子注入性能以及光学性能。结果表明复合薄膜具有V2O5的层状结构,其c轴方向的结构取向性有所降低;颗粒尺寸和表面粗糙度显著减小;同时TiO2的复合导致薄膜中V2O5的化学计量发生偏移,氧空位数量增多。当x=0.2时,薄膜具有相对较高的离子存储容量及循环稳定性,并且在离子注入/脱出状态均获得相当高的可见光透过性。     

Effect of housing geometry on the performance of Chemcatcher passive sampler for the monitoring of hydrophobic organic pollutants in water

Passive sampling of pollutants in water has been gaining acceptance for environmental monitoring. Previously, an integrative passive sampler (the Chemcatcher) was developed and calibrated for the measurement of time weighted average concentrations of hydrophobic pollutants in water. Effects of physicochemical properties and environmental variables (water temperature and turbulence) on kinetic and thermodynamic parameters characterising the exchange of analytes between the sampler and water have been published. In this study, the effect of modification in sampler housing geometry on these calibration parameters was studied. The results obtained for polycyclic aromatic hydrocarbons show that reducing the depth of the cavity in the sampler body geometry increased the exchange kinetics by approximately twofold, whilst having no effect on the correlation between the uptake and offload kinetics of analytes. The use of performance reference compounds thus avoids the need for extensive re-calibration when the sampler body geometry is modified.     

Dioxins,chlorophenols and other chlorinated organic pollutants in colloidal and water fractions of groundwater from a contaminated sawmill site

BACKGROUND, AIM, AND SCOPE: The distribution of chlorinated organic contaminants in groundwater and the importance of colloids were studied in groundwater from a sawmill site contaminated by chlorophenol preservatives. MATERIALS AND METHODS: The groundwater was fractionated into three different size ranges: (1) >0.7 mum, (2) 0.4-0.7 mum and (3) 0.2-0.4 mum and the filtered water phase. The concentrations of chlorophenols (CP), chlorinated phenoxy phenols (PCPP), chlorinated diphenyl ethers (PCDE), chlorinated dibenzofurans (PCDF) and chlorinated dibenzo-p-dioxins (PCDD) were determined in each fraction. The colloids were characterised regarding the chemical composition using X-ray photoelectron spectroscopy (XPS). RESULTS: Chlorophenols were mostly found in the water fraction and PCDD/Fs were found almost exclusively in the particulate fractions. For example, the filtered water phase contained 2,100 mug l(-1) and 0.72 ng l(-1) for CPs and PCDD/Fs, respectively, and the particulate fractions contained 27 mug l(-1) and 32 ng l(-1) for CPs and PCDD/Fs, respectively. XPS evaluation of the particulate phases showed no correlation between the surface chemistry of the particle properties and the distribution of chlorinated compounds. DISCUSSION: The results suggest that groundwater transport of CPs, PCPPs, PCDEs and PCDD/Fs may occur from contaminated sawmill sites and that the colloid-facilitated transport, especially of PCDD/Fs, is substantial. The results correlated well with previous studies of compounds sorbed to dissolved organic carbon, which indicate that dissolved and colloidal organic carbon facilitated the transport of PCDEs, PCDFs and PCDDs particularly. CONCLUSIONS: Several classes of chlorinated compounds were readily detected in the groundwater samples. Due to the differences in their physicochemical properties, CPs, PCPPs, PCDEs and PCDD/Fs vary in their partitioning between colloidal fractions and the filtered groundwater. The proportion of the bound fraction increased with an increasing hydrophobicity of the chlorinated compounds. The groundwater transport of colloid-associated pollutants from the site may be significant. RECOMMENDATIONS AND PERSPECTIVES: The results imply that colloidal particles <0.7 mum are freely mobile in groundwater from this site. The groundwater transport of colloid-associated pollutants may be significant. However, the extent of the problem is not yet known and, thus, further research is needed to evaluate the impact of colloidal transport of hydrophobic organic contaminants. In Sweden alone, 400 to 500 sawmill sites are estimated to be contaminated with PCDD/Fs as a result of the former use of CP-based wood preservatives. The widespread use of CP mixtures for a variety of applications, including wood preservation, indicates that potential colloidal transport will be an issue of concern in many countries.     

薄膜扩散梯度技术在重金属生物有效态监测中的应用

重金属生物有效性是评估重金属元素迁移性、生物可利用性和生态影响的关键参数。薄膜扩散梯度技术(DGT)是一种原位被动采样技术,因其具有原位富集性、形态选择性,可提供被监测物质在监测时间段内的平均浓度等优点,可作为生物对重金属摄取的模拟替代物对环境介质中重金属的生物可利用度进行预测,已被广泛应用于环境介质中重金属生物有效性的测定。研究主要介绍了DGT技术的原理、组成和特点,评述了其近年来在水体、土壤、沉积物中重金属生物有效态应用方面的新进展,提出了DGT技术未来要提高抗生物污染能力及寻找可与DGT技术联用的相关技术的观点。     

Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

水体中常见无机阳离子对TiO2薄膜光催化还原Cr（Ⅵ）的影响

选择了6种水体中常见的阳离子（Na^＋、Mg^2＋、Ca^2＋、Al^3＋、Cu^2＋、Ni^2＋）,分别考查了其对TiO2薄膜光催化还原Cr（Ⅵ）的影响;从光吸收、无机离子本身的性质对光生电子的捕获及传递等讨论了上述离子影响TiO2薄膜光催化还原Cr（Ⅵ）的反应速率的原因。结果表明：由于其不能捕获光生电子,Na^＋、Mg^2＋、Ca^2＋本身对TiO2薄膜光催化还原Cr（Ⅵ）的反应速率影响不大;Al^3＋吸引电子能力较强,成为光生电子和Cr（Ⅵ）之间的桥梁,促进了Cr（Ⅵ）的还原;浓度为1 mmmol/L时,Cu^2＋显著地促进了Cr（Ⅵ）的光催化还原,其主要原因是Cu^2＋捕获光生电子的能力很强,起到了催化剂的作用,而浓度大于10 mmol/L时,Cu^2＋形成单质Cu以及对紫外光的吸收都使促进作用降低;Ni^2＋未充满的d轨道具有获得并传递光生电子的能力,也促进了Cr（Ⅵ）的还原;在浓度同为1mmol/L时,对Cr（Ⅵ）光催化还原的促进作用依次为：Cu^2＋〉Al^3＋〉Ni^2＋〉Na^＋、Ca^2＋、Mg^2＋。     

Effect of lipids on sorption/desorption hysteresis in natural organic matter

The chemical composition and physical conformation of natural organic matter (NOM) play a major role in regulating its capacity to retain hydrophobic organic compounds. Naphthalene and phenanthrene were used to study the correlations between sorption/desorption isotherm nonlinearity and compositional data obtained from quantitative ¹³C solid-state DPMAS NMR spectroscopy for soil and peat organic matter with or without lipids. Sorption experiments were conducted using a batch equilibration method. Desorption experiments were carried out immediately following the sorption experiments by three successive decant-refill cycles. Hysteresis was observed in all samples. Nonlinear sorption behavior was increased by removal of lipids from the NOM. The hysteresis index, obtained from the ratio of the Freundlich exponents (N values) for the desorption and sorption isotherms, was lower in the lipid-extracted NOM samples than in the same samples without lipid extraction. The relationship between the extent of hysteresis and the characteristics of the ¹³C DPMAS NMR spectra indicates that altering NOM composition through lipid extraction not only increased the proportion of aromatic-C content, but also increased sorption/desorption hysteresis. Our data also suggest that the hysteresis index is negatively related to aromaticity.     

Potential concerns related to using octadecyltrichlorosilane (OTS) in rendering soils and porous ceramics hydrophobic

The treatment of hydrophilic porous ceramics to render them hydrophobic and wetting to non-aqueous phase liquids (NAPLs) is frequently needed in multiphase flow experiments to control the flow or to measure the pressure of the NAPL. In addition, research dealing with soil wettability implies a need for hydrophobic or NAPL-wet soils. The traditional procedure, which has been widely used in literature, to render hydrophilic porous ceramics and soils hydrophobic is achieved by placing the hydrophilic solid in a 5% (by volume) octadecyltrichlorosilane (OTS) solution in ethanol followed by rinsing in ethanol. This research assesses the use of this procedure as it was found that this treatment procedure resulted in excess OTS on the surface of treated hydrophobic solids which can dissolve in an organic phase and in turn alter the wettability condition of adjacent hydrophilic soils. A modified procedure, which results in hydrophobic solids free of excess OTS, is presented.     

Modeling urban films using a dynamic multimedia fugacity model

A thin film coats impervious urban surfaces that can act as a source or sink of organic pollutants to the greater environment. We review recent developments in the understanding of film and film-associated pollutant behavior and incorporate them into an unsteady-state version of the fugacity based Multimedia Urban Model (MUM), focusing on detailed considerations of surface film dynamics. The model is used to explore the conditions under which these atmospherically-derived films act as a temporary source of chemicals to the air and/or storm water. Assuming film growth of 2.1 nm d⁻¹ (Wu et al., 2008a), PCB congeners 28 and 180 reach air-film equilibrium within hours and days, respectively. The model results suggest that the film acts as a temporary sink of chemicals from air during dry and cool weather, as a source to air in warmer weather, and as a source to storm water and soil during rain events. Using the downtown area of the City of Toronto Canada, as a case study, the model estimates that nearly 1 g d⁻¹ of ∑₅PCBs are transferred from air to film to storm water.