硅胶表面TEOS疏水化改性及吸附VOCs特性

以正硅酸乙酯（TEOS）为疏水改性剂,通过硅胶表面的羟基接枝反应,得到具备一定疏水性的改性硅胶;利用BET、FT-IR、XRD和TG-DTG等手段对改性硅胶的结构及稳定性进行了表征;在此基础上考察了改性硅胶对各类有机废气的吸附性能.结果表明,TEOS成功接枝在了硅胶表面,改性硅胶不仅具备一定的疏水性,而且机械强度增加到原来的66.85%,稳定性也都得到了提高; 550℃空气下焙烧后的改性硅胶仍具有疏水性且吸附容量是焙烧之前的2倍;在高湿度高浓度的废气治理中,TEOS改性硅胶表现出更高的吸附能力和优良的热再生性能.高浓度下改性硅胶的吸附容量是低浓度下的10倍且不受水汽的影响;改性硅胶循环10次的吸附/脱附几乎不变,且在一定条件下,15~30min就达到90%的脱附率.     

Factors influencing on the bioaccessibility of polybrominated diphenyl ethers in size-specific dust from air conditioner filters

Size-specific concentrations and bioaccessibility of polybrominated diphenyl ethers (PBDEs) in dust from air conditioner filters were measured, and the factors influencing the PBDE bioaccessibility were determined. Generally, the PBDE concentrations increased with decreasing dust particle size, and BDE209 (deca-BDE) was generally the predominant congener. The bioaccessibility ranged from 20.3% to 50.8% for tri- to hepta-BDEs, and from 5.1% to 13.9% for BDE209 in dust fractions of varied particle size. The bioaccessibility of most PBDE congeners decreased with increasing dust particle size. The way of being of PBDE (adsorbed to dust surface or incorporated into polymers) in dust significantly influenced the bioaccessibility. There was a significant negative correlation between the tri- to hepta-BDE bioaccessibility and organic matter (OM) contents in dust. Furthermore, tri- to hepta-BDE bioaccessibility increased with increasing polarity of OMs, while with decreasing aromaticity of OMs. The tri- to hepta-BDE bioaccessibility significantly positively correlated with the surface areas and pore volumes of dust. Using multiple linear regression analysis, it was found that the OM contents and pore volumes of dust were the most important factors to influence the tri- to hepta-BDE bioaccessibility and they could be used to estimate the bioaccessibility of tri- to hepta-BDEs according to the following equation: bioaccessibility (%) = 45.05 − 0.49 × OM% + 1.79 × pore volume. However, BDE209 bioaccessibility did not correlate to any of these factors.     

Thermodynamics of interaction of lindane on silty loam and silty clay loam Indian soils

Abstract

Interaction of lindane with silty loam and silty clay loam soils was studied in batch tests at 23, 30 and 37° C. Sorption experiments were carried out at four concentrations and for varying time of contact upto 72 hours. This was followed by desorption studies. No desorption was observed. The sorption data was analysed using sorption equations and evaluating the thermodynamic parameters. The sorption was found to be predominantly entropic in nature and a combined effect of adsorption and chemisorption. The effect of organic matter and other chemical and mineralogical constituents of soils has also been discussed. The sorption with single application of lindane with the two soil types indicates that the insecticide is less likely to reach groundwater.     

被动加标在水生生态风险评价中的应用——以多氯联苯分配系数的测定为例

准确的水生生态风险评价需要可靠的毒性数据,而其获取要求在一定时间范围内,水体中污染物的浓度保持恒定。对疏水性有机污染物进行水体生物毒性测试时,通常采用有机溶剂加标,然而该方式可能因为污染物的挥发和降解、容器壁吸附、生物摄取等问题,水体中污染物浓度持续下降,导致污染物的浓度-效应关系难以明确。近期为了克服这些问题,被动加标用于替代溶剂加标,通过污染物在加标体系中平衡分配来维持精确和恒定的水体浓度,同时还可通过测定加标聚合物中污染物的浓度来监测水体浓度。首先介绍了被动加标方法及其材料选择,讨论了该方法在生态风险评价中的主要应用,包括分配系数的测定、体外细胞测试、体内生物积累及毒性测试,以及沉积物毒性评价等。然后,以测定代表污染物多氯联苯在聚二甲基硅氧烷与水间的分配系数为例,详细说明被动加标的操作流程。最后,讨论了被动加标方法的优缺点,并对其在水生生态风险中的应用前景进行了展望。     

氯化钠/纳米疏水二氧化硅超细干粉制备及灭火性能研究

选用氯化钠为基体制备金属火灾超细干粉灭火剂。应用反溶剂法对其改性,使纳米疏水二氧化硅吸附在氯化钠晶体表面,其中分散剂为PEG-1000。结果表明,纳米疏水二氧化硅的添加有利于细化氯化钠颗粒,但过量的添加会起反作用,最佳用量为3 wt%左右,平均粒径为2.18μm。镁片灭火实验证明超细复合干粉的灭火性能明显好于传统氯化钠灭火剂(商用D类灭火剂),纳米疏水二氧化硅最佳添加量为3 wt%,此时灭火时间仅需传统灭火剂的一半。最后利用FDS5.0模拟干粉颗粒与燃烧火焰作用过程,模拟结果表明干粉覆盖对火焰具有一定的抑制效果,并分析了复合干粉灭火机理。     

分子连接性指数对部分有机污染物溶解度及疏水参数的预测

以化学键为基础定义了键连接性指数和分子键连接性指数，分子键连接性指数与卤代烷、环烷烃、烷基苯和含氧原子醇、酮、醚及卤代苯等有机污染物的溶解度和辛醇／水分配系数都具有良好的线性关系，使用该模型对化合物的溶解度及疏水参数的估算结果接近实验值，能很好地反映有机化合物的结构特性，可应用于不饱和碳氢体系和各类杂原子体系，且具有良好的预测能力。     

疏水性超高交联吸附树脂对氯代烃蒸气的固定床吸附特性研究

采用固定床吸附法研究了三氯乙烯（TCE）、 1,2-二氯乙烷（DCE）和三氯甲烷（TCM）共3种氯代烃类蒸气在疏水性超高交联吸附树脂LC-1上的动态吸附行为.结果表明, TCE、 DCE和TCM蒸气的初始浓度、 气体流速和吸附温度均会影响动态吸附过程,随着初始浓度、 气体流速和吸附温度的增大,穿透时间变短,传质区长度增大,其中气体流速的影响最大;采用半经验数学模型Yoon-Nelson模型对吸附穿透实验数据进行拟合,拟合相关性系数R²≥0.994.     

Removal of organic matter and disinfection by-products precursors in a hybrid process combining ozonation with ceramic membrane ultrafiltration

The performance of an integrated process including coagulation, ozonation, ceramic ultrafiltration (UF) and biologic activated carbon (BAC) filtration was investigated for the removal of organic matter and disinfection by-products (DBPs) precursors from micro-polluted surface water. A pilot scale plant with the capacity of 120 m³ per day was set up and operated for the treatment of drinking water. Ceramic membranes were used with the filtration area of 50 m² and a pore size of 60 nm. Dissolved organic matter was divided into five fractions including hydrophobic acid (HoA), base (HoB) and neutral (HoN), weakly hydrophobic acid (WHoA) and hydrophilic matter (HiM) by DAX-8 and XAD-4 resins. The experiment results showed that the removal of organic matter was significantly improved with ozonation in advance. In sum, the integrated process removed 73% of dissolved organic carbon (DOC), 87% of UV₂₅₄, 77% of trihalomethane (THMs) precursors, 76% of haloacetic acid (HAAs) precursors, 83%of trichloracetic aldehyde (CH) precursor, 77% of dichloroacetonitrile (DCAN) precursor, 51% of trichloroacetonitrile (TCAN) precursor, 96% of 1,1,1-trichloroacetone (TCP) precursor and 63% of trichloronitromethane (TCNM) precursor. Hydrophobic organic matter was converted into hydrophilic organic matter during ozonation/UF, while the organic matter with molecular weight of 1000–3000 Da was remarkably decreased and converted into lower molecular weight organic matter ranged from 200–500 Da. DOC had a close linear relationship with the formation potential of DBPs.     

有机质官能团及微孔特性对疏水性有机污染物吸附的影响机制

作为重要的地质吸附剂,土壤/沉积物中的有机质是环境中疏水性有机污染物主要的汇.由于有机质的结构异质性,疏水性有机污染物一旦进入其中,会被吸附在不同的位点上,反应活性和生态风险进而会发生变化.对疏水性有机污染物在有机质上的吸附进行研究有助于了解其在环境中的分布,传输及生物有效性.本文就疏水性有机污染物在土壤/沉积物中的有机质上吸附的国内外研究进展进行了综述,讨论了重要有机质组分(腐殖质和碳黑)的结构和吸附作用差异性,重点分析了有机质的微孔特性和官能团对吸附的影响机制.     

发酵制药废水二级出水中溶解性有机物特性分析

溶解性有机物（DOM）是发酵制药废水二级生化尾水深度处理工艺的主要去除对象,深入解析废水中DOM的特性是将其有效去除的前提和关键.本研究采集氨基酸类、头孢类、抗生素类、维生素类、阿维菌素类5种发酵制药废水二级出水,通过XAD-8树脂亲疏水性分离、凝胶色谱分子量分级、傅里叶变换红外光谱和三维荧光表征对二级出水中的DOM进行特性分析.结果表明,5种发酵制药废水二级出水的盐度和色度高,废水中有机物浓度高、波动大（48.60~245.40 mg·L^-1）.DOM大多数以疏水性组分为主,分子量分布广泛（210~10000 Da）.二级出水DOM均含有大量的不饱和双键、苯环结构,同时含有—OH、—NH₂和C=O等发色团和助色基团,造成废水色度较高.通过对发酵制药废水二级出水进行EEM-PARAFAC分析确定了4种荧光组分特征峰,包括3种腐殖质类（C1、C3、C4）和1种类蛋白类组分（C2）.发酵制药废水二级出水中DOM主要是以类腐殖质有机物为主（C1、C3）.全方面识别和解析发酵制药废水DOM的组成,可为废水深度处理工艺的优化提供指导.