SBR工艺设计经验探讨

提出了SBR工艺中,反应池容积、反应时间以及需氧量的计算方法和设计经验。同时,在研读和对比国内外相关资料的基础上,探讨了SBR工艺发生污泥膨胀的可能性和原因,介绍了控制方法与措施。     

新生产空调客车内挥发性有机物浓度水平和来源分析

选取某厂家新生产的、下线时间不超过28d的53座新空调客车,在车辆处于静止状态下采用二次热解析-毛细管气相色谱/质谱联用法测量新空调车内挥发性有机物的分布特征和浓度水平.根据NIST02标准谱图进行匹配检索,结合色谱保留时间定性,共定性检出33种挥发性有机物,包括烷烃(15种、45.4%)、芳香类化合物(9种、27.3%)、醇(4种、12.1%),酮(3种、9.1%)、酯(2种、6.1%),且大多集中在C6～C10的范围内.新车内浓度最高的前5种挥发性有机物分别为癸烷(8.01 mg/m3)、3-甲基己烷(7.10mg/m3)、庚烷(5.10mg/m3)、异庚烷(4.20 ms/m3)和1-甲基,3-乙基苯(3,56 mg/3),总挥发性有机物TV012,52.5mR/m3.烷烃主要来源于空调车内部保温材料如聚氨酯(PU)发泡海绵或者聚乙烯(PE)发泡材料的释放,而车内检出的芳香族化合物主要来自汽车内饰用胶粘剂、密封胶等的释放.     

城镇面貌三年大变样环保行动成效显著

自实施城镇面貌三年大变样环保行动计划以来,我省城市空气质量持续改善,2008年,全省设区城市空气质量二级以上天数平均达到324天,比2007年增加11天。今年128月,设区城市空气二级以上天数平均达到232天,比去年同期增加8天,全省“蓝天”（空气二级及二级以上）数平均每月达29天。     

复合混凝剂用于夏季太湖水混凝脱浊研究

用特征粘度系列化的聚二甲基二烯丙基氯化铵(PDM)与聚合氯化铝(PAC)复合得到稳定的复合混凝剂,用于夏季高藻太湖水强化混凝脱浊处理.通过混凝烧杯实验.考察了无机/有机复合比例、PDM特征粘度对脱浊效果及絮团沉淀性能的影响.结果表明,对浊度为30-33 NTU,温度为28～30℃,藻含量为2.6×107个儿的太湖水,在与某市水厂混凝强度相近的搅拌强度下.当达到该水厂2NTU沉淀池出水的余浊标准时,PAC需7.00 mg/L的投加量.质量复合比例为5:1、10:1、20:1的PAC(以Al2O3计)/PDM复合混凝剂所需PAC投加量随PDM特征粘度0.52、1.53、2.46 dL/g的增加分别为3.00-2.83 ms/L、3.50-3.49ms/L、5.37-4.67 mg/L,相对于PAC减少投加量57.14%-59.57%、50%-50.14%、23.29%-33.29%;作为深度处理的技术准备.当沉淀出水浊度要求提高至1NTU的情况下,复合药剂依然可发挥好的作用,PAC需10 mg/L的投加量,PAC(以Al2O3计)与PDM质量复合配比为20:1、10:1、5:1的复合混凝剂需8.33-3.91 mg/L的投加量,能比PAC减少投加量16.7%～60.9%.可见,PDM明显提高了PAC的混凝脱浊效果与沉淀性能,且PAC/PDM质量复合配比越低,PDM特征粘度越高,脱浊效果与沉淀性能越好.     

Development and application of a two-dimensional water quality model for the Daqinghe River Mouth of the Dianchi Lake

Water quality models are important tools to support the optimization of aquatic ecosystem rehabilitation programs and assess their efficiency. Basing on the flow conditions of the Daqinghe River Mouth of the Dianchi Lake, China, two-dimensional water quality model was developed in the research. The hydrodynamics module was numerically solved by the alternating direction iteration (ADI) method. The parameters of the water quality module were obtained through the in situ experiments and the lab analyses that were conducted from 2006 to 2007. The model was calibrated and verified by the observation data in 2007. Among the four modelled key variables that were water level, CODcr, NH3-N and PO4-P, the minimum value of the coefficient of determination (CoD) was 0.69, which mean the model performed reasonably well. The developed model was then applied to simulate the water quality changes at the downstream cross-section assuming that the designed restoration programs were implemented. According to the simulated results, the restoration programs could cut down the loads of CODcr and PO4-P about 15%, however, they would have very little effect on the NH3-N removal. Besides, the water quality at the outlet cross-section would be still in class V (3838-02), indicating more measures should be taken to further reduce the loads. The study demonstrated the capability of water quality models to support aquatic ecosystem restorations.     

Effectiveness of fluidized pellet bed for removing soluble contaminants

Fluidized pellet bed (FPB) has been successfully applied in water and wastewater treatment. However, the removal mechanism of contaminants especially the soluble ones, is still unclear. This study aimed to evaluate the e ectiveness of FPB reactor for removing soluble contaminants from synthetic wastewater. By only coagulation through jar test operation with addition of polyaluminium chloride (PACl) as primary coagulant and polyacryamide (PAM) as coagulant-aid, the removals of soluble chemical oxygen demand (COD), total phosphorus (TP), and NH4 +-N were found to be only 2.2%–7.5%, 5.7%–25.5%, and 9.9%–18.5%, respectively. However, by FPB operation under the same dosage of coagulants, these values increased to 82.7%, 37.2%, and 50%, indicating that the formation of pellets in the FPB e ectively enhanced the removal of soluble contaminants. By careful comparison of the settleablility and filterability of the pollutants after coagulation, the originally soluble contaminants could be divided into three groups, namely: (1) coagulated-andsettleable, (2) coagulated-but-nonsettleable, and (3) uncoagulable. It was found that not only the first two groups but also a large part of the third group could be e ectively removed by FPB operation. However, the mechanism for the removal of the uncoagulable pollutants by FPB operation still needs further investigation.     

二苯碳酰二肼光度法测定水中六价铬方法的改进

对比了6种酸体系对二苯碳酰二肼光度法测量六价铬的影响,得出盐酸体系步骤简化。分析速度快,易操作。线性关系、精密度、准确度能得到保证。     

水源水中典型化学品突发污染的应急处理

针对被典型化学品双酚A(BPA)与邻苯二甲酸二乙酯(DEP)污染原水的应急处理工艺进行了研究.结果表明,活性炭吸附可有效去除双酚A和DEP.拟二级动力学模型和Elovich模型较好地描述粉末活性炭对原水中BPA和DEP的吸附过程.中试条件下,50 mg/L的粉末活性炭可分别将原水中浓度约为500 μg/L的双酚A和3.3 mg/L的DEP处理达标.炭砂滤柱对2种化学品的动态吸附表明,BPA和DEP的去除率受它们初始浓度的影响较小,在滤速为5.1～15.3 m/h的范围内BPA和DEP的去除率基本不受滤速的影响.当同时采用粉末活性炭和炭砂滤柱工艺时, PAC的吸附过程是去除污染的主要阶段,炭砂滤柱可以作为粉末活性炭的有效补充保证一定的安全系数.KMnO₄和Cl₂均不能氧化DEP,3 mg/L的KMnO₄和1.5 mg/L的Cl₂可几乎完全氧化水中浓度为850　μg/L的BPA,BPA的氯化产物和KMnO₄的氧化产物及其毒性有待于进一步研究.　1.5 mg/L高锰酸钾和PAC联用对去除DEP无协同作用,对去除BPA有促进作用.     

关于环境风险评价中事故池容积的探讨

通过对建设项目环境风险评价的分析,提出事故池是环境风险评价中的一项重要防范措施,其容积既要满足事故状态下对消防水的收集又要体现经济合理性。对环境风险评价中的事故池的容积设置进行了探讨。     

颗粒物对紫外线灭活二级出水中粪大肠菌的影响

用低压紫外线照射具有相同颗粒物粒径分布的一系列水样,把实验结果带入二重动力学模型进行计算,评价自然状态下颗粒物对粪大肠菌的保护作用. 结果表明,二级出水中的大部分粪大肠菌都与颗粒物交连在一起;在颗粒物<10⁵ C·mL^-1时,颗粒物的增加会明显降低紫外线对二级出水中粪大肠菌的灭活率,但当颗粒物>10⁵ C·mL^-1时,这种影响不明显.从二重动力学模型的计算结果来看,对于不同颗粒物浓度的水样,难灭活的微生物所占的比重很小且比较稳定,大多数与颗粒物结合的粪大肠菌都较易被紫外线灭活.