二氧化碳捕集技术的最新研究进展

较全面地剖析和解读了目前二氧化碳(CO2)捕集技术现状,通过燃烧后、燃烧前、氧燃烧等各种二氧化碳捕集技术的对比,提出各种捕集方法的适用范围和优、缺点,同时介绍了二氧化碳捕集技术的最新进展和发展方向。     

壳寡／聚糖系列衍生物对铅离子的吸附研究

比较了9种壳寡/聚糖系列衍生物作为吸附剂对同一浓度铅离子的吸附,结果为交联香草醛壳聚糖（CTSV-G）〉香草醛壳聚糖（CTSV）〉羧甲基壳聚糖（CM-CTS）〉巯基化壳寡糖（O-CTS-SH）〉壳寡糖（O-CTS）〉香草醛壳寡糖（O-CTSV）〉壳聚糖（CTS）〉壳寡糖硫酸酯（O-CTSS）〉羧甲基壳寡糖（CM-O-CTS）;比较了同一吸附剂对不同浓度的铅离子的吸附率,其吸附率随着溶液浓度的升高而降低。研究了各吸附剂在铅、镉、铬金属离子竞争中对铅吸附的影响,结果表明各吸附剂对镉和铅离子的吸附效果最好,可达80%,对铬离子吸附较少,在40%左右。     

二价铜离子与抗坏血酸共存下的杀菌效果及其机理

考察了二价铜离子与抗坏血酸的组合对大肠杆菌的杀菌效果。实验证明:高浓度的铜离子与抗坏血酸的组合有非常好的杀菌效果,不论是酸性还是中性条件下都能在0.5 h杀灭所有的大肠杆菌;低浓度的铜离子与抗坏血酸的组合也有不错的杀菌效果,且随着pH值的升高,杀菌效果增强,pH=4的条件下24 h后杀灭大肠杆菌,pH=7的条件下0.5 h便能杀灭所有杆菌。实验运用ESR检测羟基自由基,并结合杀菌实验结果推断二价铜离子与抗坏血酸反生了类Fenton反应。     

Effect of ionic strength on adsorption of As（Ⅲ） and As（Ⅴ） on variable charge soils

The study was to investigate the adsorption behavior of arsenite (As(Ⅲ)) and arsenate (As(Ⅴ)) on two variable charge soils, i.e., Haplic Acrisol and Rhodic Ferralsol at different ionic strengths and pH with batch methods. Results indicated that the amount of As(Ⅲ) adsorbed by these two soils increased with increasing solution pH, whereas it decreased with increasing ionic strength under the acidic condition. This suggested that As(Ⅲ) was mainly adsorbed on soil positive charge sites through electrostatic attraction under the acidic condition. Moreover, intersects of As(Ⅴ) adsorption-pH curves at different ionic strengths (a characteristic pH) are obtained for both soils. It was noted that above this pH, the adsorption of As(Ⅴ) was increased with increasing ionic strength, whereas below it the reverse trend was true. Precisely the intersect pH was 3.6 for Haplic Acrisol and 4.5 for Rhodic Ferralsol, which was near the values of PZSE (soil point of zero salt effect) of these soils. The effects of ionic strength and pH on arsenate adsorption by these soils were interpreted by the adsorption model. The results of zeta potential suggested that the potential in adsorption plane becomes less negative with increasing ionic strength above soil PZSE and decreases with increasing ionic strength below soil PZSE. These results further supported the hypothesis of the adsorption model that the potential in the adsorption plane changes with ionic strength with an opposite trend to surface charge of the soils. Therefore, the change of the potential in the adsorption plane was mainly responsible for the change of arsenate adsorption induced by ionic strength on variable charge soils.     

Photocatalytic degradation of methyl orange over ITO/CdS/ZnO interface composite films

ITO/CdS/ZnO interface composite films were successfully prepared by subsequent electrodeposition of CdS and ZnO onto indium tin oxide (ITO) glass substrates. The obtained ITO/CdS/ZnO composite films were characterized with X-ray diffraction (XRD), scanning electron microscopy (SEM), and UV-Vis spectroscopy. The photocatalytic activity of ITO/CdS/ZnO composite films were investigated using methyl orange (MO) as a model organic compound under UV light irradiation. The influence of operating parameters on MO degradation including initial concentration of MO, pH value of solution, and inorganic anion species over the composite films were examined. A blue shift of absorption threshold was observed for the ITO/CdS/ZnO film in comparison with ITO/ZnO film. ITO/CdS/ZnO composite films prepared under specific conditions showed a higher photocatalytic activity than that of ITO/ZnO films. It was also found that the photocatalytic degradation of MO on the composite filing followed pseudo-first order kinetics.     

Synthesis, characterization, and adsorption performance of Pb（Ⅱ）-imprinted polymer in nano-TiO2 matrix

Surface ion-imprinted in combination with sol-gel process was applied to synthesis a new Pb(II)-imprinted polymer for selective separation and enrichment of trace Pb(II) from aqueous solution. The prepared material was characterized by using the infrared spectra, X-ray di ractometer, and scanning electron microscopy. The batch experiments were conducted to study the optimal adsorption condition of adsorption trace Pb(II) from aqueous solutions on Pb(II)-imprinted polymer. The equilibrium was achieved in approximately 4.0 h, and the experimental kinetic data were fitted the pseudo second-order model better. The maximum adsorption capacity was 22.7 mg/g, and the Langmuir equation fitted the adsorption isotherm data. The results of selectivity experiment showed that selectively adsorbed rate of Pb(II) on Pb(II)-imprinted polymer was higher than all other studied ions. Desorption conditions of the adsorbed Pb(II) from the Pb(II)-imprinted polymer were also studied in batch experiments. The prepared Pb(II)-imprinted polymer was shown to be promising for the separation and enrichment of trace Pb(II) from water samples. The adsorption and desorption mechanisms were proposed.     

钠钙交换体对心肌保护作用的研究进展

心肌钠钙交换体是引起胞内钙超载的重要原因.简要综述了钠钙交换体的的结构特征、生理功能、病理作用以及在心肌保护方面的研究新进展.NCX反向转运的激活可能是心肌缺血预适应产生心脏保护作用的机制之一.     

风浪作用下太湖改性沉积物对藻体絮凝去除效果研究

以壳聚糖改性的太湖原位沉积物为分散介质,应用Y-型再悬浮发生装置,通过定量模拟太湖常见的中等级别风情,研究再悬浮作用下,改性沉积物对蓝藻水华的絮凝去除作用.结果表明,在黏土加入量为0.2　g·L^-1,壳聚糖分别为0.100和0.150　g·L^-1,其蓝藻的去除率分别为93.55%和99.19%;在静止30 min后,壳聚糖加入量为0.15 　g·L^-1时,水体的浊度去除率达到78.60%;静止8 h后,水体的浊度去除率达到93.88%.同时,短期内壳聚糖的加入对水体中PO^3-₄-P有一定的去除作用.初步结果表明,在中风风情下,壳聚糖的加入量为0.15　g·L^-1时,能更有效地去除蓝藻.表明利用壳聚糖改性沉积物来絮凝沉降太湖水华藻体,具有较好的应用前景.对比研究表明,引入水动力强度和水柱高度定量模拟方法,在确定壳聚糖投加量絮凝除藻中,具有明显的方法优势.     

pH和铜离子对微囊藻毒素-LR荧光免疫检测的影响与消除

研究了pH和铜离子对倏逝波全光纤免疫传感器检测微囊藻毒素-LR（MC-LR）的影响及其消除措施.研究表明,过酸或过碱条件对MC-LR免疫检测均有较强烈的影响,当pH<6或pH>8时,系统检测的信号随pH的降低或增大明显下降;而当pH在6～8之间时,检测标准曲线的IC₅₀为1.01～1.04 μg/L,检测区间在0.12～10.5 μg/L之间,较适合MC-LR的检测.低浓度铜离子对MC-LR免疫检测的影响不大,当CuSO₄浓度>5 mg/Ｌ时,系统检测荧光信号明显下降,而当CuSO₄浓度达到10 mg/Ｌ时,系统检测信号下降70％以上.在预反应混合物中添加1%的螯合剂EDTA,能有效抑制铜离子对免疫检测的影响.     

A2/O工艺中好氧污泥絮体的分形结构与理化特征分析

采用图像法和沉降柱法分别研究了A²/O工艺中好氧污泥絮体的形貌、粒度分布、低维分形维数和沉降速率、有效密度、空隙率以及质量分形维数,并尝试探讨了上述相关性质与这些污泥宏观操作性质(沉降、压缩、脱水和稳定性)相关的各种理化指标以及胞外高分子物质(EPS)的含量之间的变化关系.结果表明,污泥絮体呈现不规则的形貌,表面具有空隙.其有效密度一般随着其粒径的增加而降低,而空隙率和沉降速率却呈现与有效密度相反的变化趋势,这些均表明了污泥絮体的分形结构的存在.2次所采集的污泥絮体的中位直径分别为248.81、 332.86 μm,有效密度的平均值分别为0.004 0、 0.007 2 g·cm^-3,自由沉降速率的平均值分别为2.67、 4.79　mm·s^-1,空隙率的平均值分别为0.94、 0.89,一维分形维数分别为1.03、 1.19,二维分形维数分别为1.64、 1.84,采用基于Logan经验公式的有效密度-最大直径的双对数关系确定的质量分形维数分别为1.74、 2.29.尽管第2次所采集的污泥絮体较为密实,但其表面粗糙程度却比第1次的低.此外,研究中发现絮凝能力较高或负电荷较高的A²/O好氧污泥絮体具有高的SVI和ZSV值;分形维数较低的污泥具有高的剪切敏感性和低絮体强度,相应的污泥稳定性低;EPS总量高的污泥脱水性能差,EPS中蛋白质含量高的污泥其表面电荷也较高.