首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   4570篇
  免费   469篇
  国内免费   1922篇
安全科学   266篇
废物处理   250篇
环保管理   604篇
综合类   4190篇
基础理论   303篇
污染及防治   1282篇
评价与监测   58篇
社会与环境   8篇
  2024年   54篇
  2023年   141篇
  2022年   207篇
  2021年   235篇
  2020年   220篇
  2019年   240篇
  2018年   152篇
  2017年   188篇
  2016年   236篇
  2015年   308篇
  2014年   546篇
  2013年   345篇
  2012年   390篇
  2011年   384篇
  2010年   345篇
  2009年   376篇
  2008年   390篇
  2007年   289篇
  2006年   322篇
  2005年   238篇
  2004年   215篇
  2003年   191篇
  2002年   118篇
  2001年   103篇
  2000年   97篇
  1999年   86篇
  1998年   75篇
  1997年   63篇
  1996年   91篇
  1995年   61篇
  1994年   48篇
  1993年   63篇
  1992年   42篇
  1991年   43篇
  1990年   32篇
  1989年   24篇
  1987年   1篇
  1986年   1篇
  1979年   1篇
排序方式: 共有6961条查询结果,搜索用时 734 毫秒
281.
反硝化反应受到抑制导致硝化反应消耗的碱度未能得到平衡,偏低的PH使微生物的代谢速度减慢。因而生化系统的处理能力降低,同时较高的亚硝酸盐氮、硝酸盐氮含量使二沉池极易发生污泥上浮。通过增加有机负荷来降低溶解氧确实可以抑制硝化反应。让问题得到缓解,但通过污泥龄来控制硝化程度,确保比较彻底的反硝化、氮最大程度的得以脱除,使生化系统形成良性循环,这才是根本的解决措施。  相似文献   
282.
概述了含油废水的来源、特点、分类及危害,介绍了含油废水的处理方法的原理、优势及存在的问题,同时简述了各种处理方法的最新研究成果,最后提出了含油废水发展趋势。  相似文献   
283.
以武汉市五座污水处理厂剩余污泥经Ⅰ、Ⅱ、Ⅲ三种污泥调理方法调理及脱水的污泥深度脱水滤液为研究对象,分析测定了水样的常规水质指标。结果表明,配方Ⅰ所得脱水滤液pH为12.8左右,呈强碱性,配方Ⅱ、Ⅲ所得脱水滤液pH=3.0~6.2,呈酸性。污泥深度脱水滤液的水质随脱水污泥的来源、污泥调理方法不同而异,稳定、氧化程度高的污泥其深度脱水滤液水质较好。经调理后的深度脱水滤液ρ(COD)为180~1200 mg/L,为中低浓度有机废水;BOD5/COD=0.49~0.66,可生化性良好;氨氮浓度为20~200 mg/L,差异较大,但普遍较高,C/N在2.2~13.4,属低C/N比废水;TP在0.4~5.5 mg/L,C∶N∶P对微生物生长来说并不协调。污泥调理剂中的破胞试剂对污泥脱水滤液水质影响较大,配方Ⅱ、Ⅲ调理剂中含破胞试剂,调理后的污泥深度脱水滤液COD和氨氮值较大。最后,建议对氨氮负荷过高而不适合回流的深度脱水滤液采用高效的生物脱氮工艺进行处理。  相似文献   
284.
应用"倍加清"特种微生物技术,结合"气浮+生化+固液分离"的处理工艺,以中海油绥中SZ36-1陆上终端含聚污水为水质样本,研究生物法处理海上油田含聚生产污水的效果。结果表明,该工艺处理后出水可达"1.5.2"的水质标准,远优于"10.10.3"的注入水质指标要求,并确定了相关技术参数。该技术具备处理效果好、适应来水水质范围大、环境友好等优势。但由于空间重量的限制,尚不适用于海上油田平台的生产水处理工艺。  相似文献   
285.
市政污水处理厂产生的脱水剩余污泥中含有大量的细菌胞外聚合物、胞内聚合物等大分子有机物,是一种良好的生物吸附剂制备原料。以脱水污泥为原料,采用碱提取的方法,对污泥中胞外聚合物与胞内聚合物进行提取,提取得到聚合物吸附剂,分析了聚合物吸附剂中聚合物浓度、核酸浓度随提取剂中NaOH浓度的变化,考察了聚合物吸附剂对水中镉的等温吸附性能。研究结果表明,当NaOH浓度小于0.5 mol/L时,随着提取剂NaOH浓度的升高,得到的提取液中聚合物浓度、核酸浓度逐渐升高。最佳的提取剂中NaOH浓度为0.3 mol/L,该条件下能够充分实现污泥中聚合物的提取。当NaOH浓度高于0.5 mol/L,聚合物中核酸存在一定程度的分解。聚合物吸附剂对水中Cd2+的吸附符合Langmuir模型,NaOH浓度为0.3 mol/L条件下提取得到的聚合物吸附剂的镉饱和吸附容量最大,达1.022 mmol/g。  相似文献   
286.
城市市政污水处理厂产生的剩余污泥是一种良好的重金属生物吸附剂制备原料。以北京某市政污水处理厂产生的脱水剩余污泥为原料,采用碱改性处理方法,制备得到碱改性脱水污泥生物吸附剂,通过其对水中镉的等温吸附实验,考察其重金属吸附效能。研究结果表明:碱改性脱水污泥对水中镉的等温吸附曲线符合Langmuir等温吸附模型。碱改性处理后,脱水污泥对水中镉的最大饱和吸附容量提高了2.8倍,达0.966 mmol/g,显著高于同类型脱水污泥生物吸附剂。碱改性脱水污泥对水中镉的最大饱和吸附容量与改性过程中所使用的Na OH浓度之间的线性相关性较差,呈现一定的波动变化趋势。  相似文献   
287.
Arsenic in the environment is attracting increasing attention due to its chronic health effects. Although arsenite(As(III)) is generally more mobile and more toxic than arsenate(As(V)), reducing As(V) to As(III) may still be a means for decontamination, because As(III) can be removed from solution by precipitation with sulfide or by adsorption or complexation with other metal sulfides. The performance of As(V) bio-reduction under autohydrogenotrophic conditions was investigated with batch experiments. The results showed that As(V) reduction was a biochemical process while both acclimated sludge and hydrogen were essential. Most of the reduced arsenic remained in a soluble form, although 20% was removed with no addition of sulfate, while 82% was removed when sulfate was reduced to sulfide. The results demonstrated that the reduced arsenic was re-sequestered in the precipitates, probably as arsenic sulfides. Kinetic analysis showed that pseudo first-order kinetics described the bio-reduction process better than pseudo second-order. In particular, the influences of pH and temperature on As(V) reduction by acclimated sludge under autohydrogenotrophic conditions and total soluble As removal were examined. The reduction process was highly sensitive to both pH and temperature, with the optimum ranges of pH 6.5–7.0 and 30–40°C respectively. Furthermore, Arrhenius modeling results for the temperature effect indicated that the As(V) reduction trend was systematic. Total soluble As removal was consistent with the trend of As(V) reduction.  相似文献   
288.
A novel method based on the selective pressure of particle size (particle-size cultivation method, PSCM) was developed for the cultivation and operation of aerobic granular sludge in a continuous-flow reactor, and compared with the conventional method based on the selective pressure of settling velocity (settling-velocity cultivation method, SVCM). Results indicated that aerobic granules could be cultivated in continuous operation mode by this developed method within 14 days. Although in the granulation process, under particle-size selective pressure, mixed liquor suspended solids (MLSS) in the reactor fluctuated greatly and filamentous bacteria dominated the sludge system during the initial operation days, no obvious difference in profile was found between the aerobic granules cultivated by PSCM and SVCM. Moreover, aerobic granules cultivated by PSCM presented larger diameter, lower water content and higher specific rates of nitrification, denitrifieation and phosphorus removal, but lower settling velocity. Under long term operation of more than 30 days, aerobic granules in the continuous-flow reactor could remain stable and obtain good chemical oxygen demand (COD), NH4^+-N, total nitrogen (TN) and total phosphorus (TP) removal. The results indicate that PSCM was dependent on the cultivation and maintenance of the stability of aerobic granules in continuous-flow bioreactors.  相似文献   
289.
在A/A/O普通活性污泥工艺中引入非寡毛类微型后生动物考察其生长条件和对剩余污泥的减量效果及对系统处理效果的影响。结果表明,当进水负荷小于0.5 mg(/mg MLSS·d)时,非寡毛类微型后生动物可大量生长;当内回流比升高、外回流比降低时,更有利于虫体的繁殖。经过适时的运行工艺调整可使生化系统虫体密度和稳定性提高,污泥减量效果可达到40%以上。非寡毛类后生动物的活动与摄食作用提高了系统污泥的沉降性能,并对系统出水COD、NH3-N、TN、TP、SS没有影响。。  相似文献   
290.
针对UASB耐冲击能力低的问题,采用短暂冲击负荷的方法进行52 d中试研究,并考察接种絮状污泥的UASB对以污冷凝水为主要成分的酒精废水的处理效果,结果表明,UASB呈现较强耐冲击负荷能力;第49天产气速率最高,可达3.03 L/(L·d),反应器内形成了粒径0.5~1.5 mm的颗粒,电镜扫描的颗粒污泥结构致密,由多个杆状细菌形成网状结构。在夏季无保温措施、负荷冲击条件下培养颗粒污泥是可行的。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号