含油废水处理技术

概述了含油废水的来源、特点、分类及危害,介绍了含油废水的处理方法的原理、优势及存在的问题,同时简述了各种处理方法的最新研究成果,最后提出了含油废水发展趋势。     

冶金高含盐废水处理工艺实践应用

某黄金冶炼厂根据云南当地的实际情况,在废水处理工程中采用太阳能预热-刮板式薄膜蒸法工艺处理黄金深加工过程中产生的高含盐废水,处理效果好,出水稳定,是一种非常有效的处理工艺。氯化物及重金属到达GB5749—2006生活饮用水卫生标准。     

含固率和接种比对叶菜类蔬菜垃圾厌氧消化的影响

通过叶菜类蔬菜垃圾中温批式厌氧消化实验,比较了含固率(3%、5%、7%)和接种比(1.5、2.5、3.5)对产甲烷效果的联合影响.结果表明,在研究实验参数范围内,含固率越低、接种比越高,越有利于缩短产甲烷反应迟滞期,平均日产甲烷速率越快.经过52d的培养,在含固率为3%、接种比为3.5的工况中,平均日产甲烷速率最快,达到9.5mL/(gVS·d),日最大产甲烷速率最快,达到49.8mL/(gVS·d),最早进入快速产甲烷期.当接种比为3.5时,随着含固率的升高,产甲烷速率下降,迟滞期延长,但单位底物累计产甲烷量增大,含固率7%时单位底物累计净产甲烷量为481mL/gVS.而当接种比为1.5时,含固率为5%和7%的工况均无法启动甲烷化反应,含固率为3%的工况的产气迟滞期达15d.挥发性有机酸的累积抑制甲烷化反应的启动,迟滞期随着液相中有机酸浓度的增加而延长,当有机酸浓度低于1260mg/L,甲烷化反应没有明显的迟滞期.     

Electro-Fenton法处理印染废水应用研究进展

Electro-Fenton法是利用电解的方法产生Fe2+和H2O2,新生的Fe2+和H2O2作用产生·OH。作为一种新兴的废水处理技术,在处理难降解有机废水方面,国内外已开展了广泛的研究,对于处理高浓度难降解有机废水效果良好。阐述了Electro-Fenton法的发展、分类、反应机理及其在印染废水处理中的应用研究现状,并指出Electro-Fenton法存在的主要问题和今后的发展方向。     

生物法处理海上油田含聚生产污水研究报告

应用"倍加清"特种微生物技术,结合"气浮+生化+固液分离"的处理工艺,以中海油绥中SZ36-1陆上终端含聚污水为水质样本,研究生物法处理海上油田含聚生产污水的效果。结果表明,该工艺处理后出水可达"1.5.2"的水质标准,远优于"10.10.3"的注入水质指标要求,并确定了相关技术参数。该技术具备处理效果好、适应来水水质范围大、环境友好等优势。但由于空间重量的限制,尚不适用于海上油田平台的生产水处理工艺。     

磁絮凝处理染整废水的中试研究

针对染整废水进行磁絮凝的中试研究,将磁粉加载于混凝澄清池,该技术是在接触絮凝加速澄清技术基础上提出的一种应用絮凝形态学理论的新型高效固液分离技术。中试试验经过半年的调试和运行,浊度等水质数据明显优于普通的砂滤出水水质。处理后的出水水质为pH=6~9,COD≤200 mg/L,浊度≤10NTU,色度≤200倍。     

碱改性脱水污泥对水中镉的吸附效能研究

城市市政污水处理厂产生的剩余污泥是一种良好的重金属生物吸附剂制备原料。以北京某市政污水处理厂产生的脱水剩余污泥为原料,采用碱改性处理方法,制备得到碱改性脱水污泥生物吸附剂,通过其对水中镉的等温吸附实验,考察其重金属吸附效能。研究结果表明:碱改性脱水污泥对水中镉的等温吸附曲线符合Langmuir等温吸附模型。碱改性处理后,脱水污泥对水中镉的最大饱和吸附容量提高了2.8倍,达0.966 mmol/g,显著高于同类型脱水污泥生物吸附剂。碱改性脱水污泥对水中镉的最大饱和吸附容量与改性过程中所使用的Na OH浓度之间的线性相关性较差,呈现一定的波动变化趋势。     

Effect of a high strength chemical industry wastewater on microbial community dynamics and mesophilic methane generation

A high strength chemical industry wastewater was assessed for its impact on anaerobic microbial com- munity dynamics and consequently mesophilic methane generation. Cumulative methane production was 251 mL/g total chemical oxygen demand removed at standard temperature and pressure at the end of 30 days experimental period with a highest recorded methane percentage of 80.6% of total biogas volume. Volatile fatty acids （VFAs） analysis revealed that acetic acid was the major intermediate VFAs produced with propionic acid accumulating over the experimental period. Quantitative analysis of microbial communities in the test and control groups with quantitative real time polymerase chain reaction highlighted that in the test group, Eubacteria （96.3%） was dominant in comparison with methanogens （3.7%）. The latter were dominated by Methanomicrobiales and Methanobacteriales while in test groups increased over the experimental period, reaching a maximum on day 30. Denaturing gradient gel electrophoresis profile was performed, targeting the 16S rRNA gene of Eubacteria and Archaea, with the DNA samples extracted at 3 different time points from the test groups. A phylogenetic tree was constructed for the sequences using the neighborhood joining method. The analysis revealed that the presence of organisms resembling Syntrophomonadaceae could have contributed to increased production of acetic and propionic acid intermediates while decrease of organisms resembling Pelotomaculum sp. could have most likely contributed to accumulation of propionic acid. This study suggested that the degradation of organic components within the high strength industrial wastewater is closely linked with the activity of certain niche microbial communities within eubacteria and methanogens.     

Nitrogen mass balance in a constructed wetland treating piggery wastewater effluent

The nitrogen changes and the nitrogen mass balance in a free water surface flow constructed wetland （CW） using the four-year monitoring data from 2008 to 2012 were estimated. The CW was composed of six cells in series that include the first settling basin （Cell 1）, aeration pond （Cell 2）, deep marsh （Cell 3）, shallow marsh （Cell 4）, deep marsh （Cell 5） and final settling basin （Cell 6）. Analysis revealed that the NH4＋-N concentration decreased because of ammonification which was then followed by nitrification. The NO4＋-N and NO4＋-N were also further reduced by means of microbial activities and plant uptake during photosynthesis. The average nitrogen concentration at the influent was 37,819 kg/year and approximately 45% of that amount exited the CW in the effluent. The denitrification amounted to 34% of the net nitrogen input, whereas the accretion of sediment was only 7%. The biomass uptake of plants was able to retain only 1% of total nitrogen load. In order to improve the nutrient removal by plant uptake, plant coverage in four cells （i.e., Cells 1, 3, 4 and 5） could be increased.     

铁碳微电解法预处理聚氯乙烯(PVC)离心母液废水

采用铁碳微电解法对聚氯乙烯(PVC)离心母液废水进行预处理。分别考察反应时间、铁粉投加量、Fe/C(质量比)、pH值及曝气速率对母液废水中的COD和聚乙烯醇(PVA)去除率的影响,并在此基础上通过正交实验确定了废水COD的最佳处理条件。结果表明,最佳处理条件为:反应时间为4 h、铁粉投加量为30 g/L、Fe/C为1:2、pH值为2、曝气速率为0.8 L/min。在该条件下,废水中COD、PVA和TOC的平均去除率分别为(67%±2)%、(98%±1)%和(55%±3)%,废水的BOD/COD值从0.3提高到0.5,可生化性得到了显著提高。同时,废水中的NH3-N、浊度也在很大程度上得到了去除,出水中总铁含量也很低。