磁性多孔陶粒生物膜反应器处理焦化废水的试验研究

以磁性材料为原料,经过特定的工艺处理,对多孔陶瓷进行磁化改性获得磁性多孔载体,并将该载体应用于生物膜反应器中进行焦化废水处理试验。对不同类型的多孔陶粒载体进行对比试验,结果表明:磁性载体生物膜反应器对COD、NH3-N的去除率比普通活性污泥法高出25%³0%,比非载体生物膜反应器高出15%30%,比非载体生物膜反应器高出15%²0%左右。反应器的曝气量为1.5 L/h,曝气时间为10 h/d,温度为2520%左右。反应器的曝气量为1.5 L/h,曝气时间为10 h/d,温度为25³0℃。焦化废水经磁性载体生物膜反应器处理后,上清液中COD,NH3-N的去除率均在90%左右。出水浓度达到国家工业废水排放二级标准(GB18918-2002)。     

改性聚氨酯载体用于高氨氮废水处理的研究

利用聚丁二酰亚胺对聚氨酯泡沫体进行化学改性处理,研究改性载体固定化微生物处理高氨氮模拟废水的效果。结果表明:当聚氨酯单元与聚丁二酰亚胺单元摩尔比为10∶1时,对泡沫进行改性后聚氨酯泡沫载体亲水性能良好,且具有较高的微生物负载量。改性后泡沫体上具有化学活性的官能团增加,有利于通过载体结合法固定化微生物细胞;,改性后的聚氨酯泡沫体作为微生物固定化载体用于模拟废水处理时,对主要污染指标呈现良好的污染物去除效果。     

活性炭固定耐冷菌对废水中硝基苯的降解

文章研究了颗粒活性炭固定鲍曼不动杆菌对硝基苯的降解情况。考查了活性炭对硝基苯的吸附等温线,符合Freulndlich经验公式,同时探究了其最佳投加量为5 mg/mL。较单纯微生物降解来说,在温度为15℃,pH为7,摇床转速140 r/min的条件下,生物活性炭降解浓度为200 mg/L的硝基苯所用时间大大缩短,而400 mg/L的硝基苯不能直接被菌株降解,固定化后84 h可基本完全降解,并且由于微生物作用活性炭得到再生。     

印染废水处理提标小试研究

利用"水解酸化+强化好氧+深度处理"的工艺技术方案开展印染废水小试研究。在工艺前端采用混流式和升流式两级水解酸化池,后续在曝气池投加活性焦载体,提高污泥浓度,强化好氧池处理能力,最后对生化出水加药混凝,并用生物活性焦滤池进行深度处理。结果表明,该处理工艺适宜处理印染废水,处理效果达到处理提标要求。     

Alga-lysing bioreactor and dominant bacteria strain

Alga-lysing bacteria have been paid much attention to in recent years. In this study, the alga-lysing strain P05 which was isolated from an immobilizing biosystem was immobilized by coke and elastic filler, forming two biological reactors. The removal efficiencies of algae, NH4^＋-N and organic matter using the two reactors were studied. The results showed that strain P05 was an ideal algal-lysing bacteria strain because it was easy to be immobilized by coke and elastic filler which are of cheap, low biodegradability and the simple immobilization procedure. After 7 d filming, the biological film could be formed and the reactors were used to treat the eutrophic water. These two reactors were of stability and high effect with low cost and easy operation. The optimal hydraulic retention time （HRT） of each reactor was 4 h. The algae removal rates were 80.38% and 82.1% （in term of Chl-α） of coke reactor and filler reactor, respectively. And that of NH4^＋-N were 52.3% and 52.7%. The removal rates of CODMn were 39.03% and 39.64%. The strain P05 was identified as Bacillus sp. by PCR amplification of the 16S rRNA gene, BLAST analysis, and comparison with sequences in the GenBank nucleotide database.     

CMC-膨润土交联固定镰刀菌反应器对对氯苯酚废水的降解特性

采用CMC-膨润土交联方法固定镰刀菌,研究了其固定方法对4-CP废水的降解效果,考察了固定化生物反应器间歇与连续运行处理4-CP废水的降解性能.结果表明,CMC-膨润土包埋固定镰刀菌对4-CP的降解速率最大;反应器问歇运行时,4-CP的降解率随其初始浓度增加而有所下降,浓度高于50 mg·L-1的4-CP降解过程基本上...     

Removal of copper ions from aqueous solution by calcium alginate immobilized kaolin

Kaolin has been widely used as an adsorbent to remove heavy metal ions from aqueous solutions. However, the lower heavy metal adsorption capacity of kaolin limits its practical application. A novel environmental friendly material, calcium alginate immobilized kaolin (kaolin/CA), was prepared using a sol-gel method. The e ects of contact time, pH, adsorbent dose, and temperature on Cu2+ adsorption by kaolin/CA were investigated. The Langmuir isotherm was used to describe the experimental adsorption, the maximum Cu2+ adsorption capacity of the kaolin/CA reached up to 53.63 mg/g. The thermodynamic studies showed that the adsorption reaction was a spontaneous and endothermic process.     

供碳源载体及其在低碳氮比污水处理中的应用研究

为解决低C/N污水的脱氮问题,本实验自行研制开发了一种新型碳聚合物载体.对该载体进行低C/N污水的生物膜脱氮研究,考察了HRT、pH、DO、温度等因素对系统同步硝化反硝化脱氮效果的影响.结果表明:在C/N比为4、pH=8、DO=1 mg/L、HRT=6 h,T=24℃的条件下,氨氮及总氮的去除率分别可以达到90%和70...     

循环水养殖系统（RAS）生物载体上微生物群落结构变化分析

为研究循环水养殖系统(recirculating aquaculture systems,RAS)生物滤池挂膜及运行过程中生物载体上微生物群落结构的变化及其脱氮机制,采用传统微生物培养方法,对不同时期生物载体上的异养细菌、氨氧化细菌及硝化菌进行堵养计数.并通过变性梯度凝胶电泳技术,对细菌的16S rDNA V3可变区的...     

应用加载磁絮凝技术处理垃圾渗滤液试验研究

垃圾渗滤液是一种成分复杂多变的高浓度难处理有机废水。本研究采用加载磁絮凝技术对垃圾渗滤液进行预处理,并讨论了适宜的磁载体、凝聚剂和絮凝剂的加入量。