二氧化钛复合型催化剂制备及其微波辅助催化氧化甲苯性能

实验采用溶胶凝胶法和传统浸渍法制备了TiO2-分子筛复合载体及复合载体负载过渡金属与稀土元素催化剂,通过微波辅助催化氧化甲苯的性能实验考察其催化活性.结果表明,复合TiO2明显提高了载体结构的稳定性与耐温性,并使过渡金属铜(Cu)、锰(Mn)和稀土元素铈(Ce)等活性组分在催化剂表面的分散更均匀;在复合载体吸附、吸波性能与多相活性组分催化的共同作用下,Cu-Mn-Ce/TiO2-分子筛催化剂微波辅助催化氧化甲苯的完全燃烧温度仅为175℃,此时甲苯去除率可达99％;15 h的连续性实验表明,TiO2复合型催化剂具有良好的催化活性与稳定性.由催化剂表征分析结果可知,活性组分颗粒的均匀分布与铜、锰氧化物及铜锰尖晶石固溶物等活性相的存在促进了甲苯的催化氧化,锐钛矿型TiO2较高的电子迁移速率与催化剂孔径的增大均有助于甲苯的氧化降解.     

Iron and lead ion adsorption by microbial flocculants in synthetic wastewater and their related carbonate formation

Although microbial treatments of heavy metal ions in wastewater have been studied, the removal of these metals through incorporation into carbonate minerals has rarely been reported. To investigate the removal of Fe^3＋ and Pb^2＋, two representative metals in wastewater, through the precipitation of carbonate minerals by a microbial flocculant （MBF） produced by Bacillus mucilaginosus. MBF was added to synthetic wastewater containing different Fe^3＋ and Pb^2＋ concentrations, and the extent of flocculation was analyzed. CO2 was bubbled into the mixture of MBF and Fe^3＋/Pb^2＋ to initiate the reaction. The solid substrates were analyzed via X-ray diffraction, transmission electron microscopy and energy dispersive spectroscopy. The results showed that the removal efficiency decreased and the MBF adsorption capacity for metals increased with increasing heavy metal concentration. In the system containing MBF, metals （Fe^3＋ and Pb^2＋）, and CO2, the concentrated metals adsorbed onto the MBF combined with the dissolved CO2, resulting in oversaturation of metal carbonate minerals to form iron carbonate and lead carbonates. These results may be used in designing a method in which microbes can be utilized to combine CO2 with wastewater heavy metals to form carbonates, with the aim of mitigating environmental problems.     

标准加入法测定生态水泥中的重金属

基于实验提出用标准加入法测定生态水泥中的重金属含量。包括微波辅助酸消解水泥试样,分离干扰元素,分取试液加入一定量待测元素标液,AAS测定等程序。文章选择具代表性的生态水泥,经试验确定了有关实验参数,通过建立标准曲线明确了实验条件下的线性范围、检出限。重复性试验表明各元素相对标准偏差在2.3%～9.3%之间。采用基底相似的土壤标样按标准加入法作回收试验,得到回收率在90%～96%之间。     

微波消解/ICP-AES法分析冶炼厂固废中重金属

分析固体废物中金属元素全量分析的微波消解条件,通过实验确定样品的粉碎粒度、消解功率、消解温度、消解时间等因素对样品消解效果的影响,以等离子发射光谱测定冶炼厂固体废物中24种痕量金属元素,通过测定的检出限、精密度、准确度,确立冶炼厂固体废物痕量金属全量分析检测方法准确高效。     

不同粒径医疗废物焚烧飞灰中重金属含量的试验研究

采用微波消解-原子吸收分光光度法对黄山市医疗废物焚烧飞灰中的重金属含量进行了试验研究。首先对经过预处理后的飞灰样品进行微波消解,寻找最佳消解体系;然后对不同粒径消解后的飞灰样品采用原子吸收和原子荧光法测定重金属含量。试验结果证明:微波消解的最佳酸体系为HNO3∶HF∶HClO4=10∶1∶5;在飞灰样品6个粒径范围内,Cu的含量范围为877.65~1 169.35 mg/kg,Pb的含量范围为2 292.25~3 935.45mg/kg,Zn的含量范围为2 085~14 000mg/kg,Cd的含量范围为143.2~197.7mg/kg,As的含量范围为5.5~76mg/kg,其中在粒径212~900μm范围内Zn的含量最高,在粒径74~100μm范围内As的含量最高。     

Fenton/微波深度处理增塑剂废水

探讨微波功率、活性炭投加量、pH及反应时间等因素对微波处理效果的影响;考察废水pH、Fe2+和H2O2比例、Fe2+离子浓度及处理时间等因素对Fenton处理效果的影响。分别选择最优条件进行Fenton/微波联合处理邻苯二甲酸酯废水实验,COD去除率达98.7%,出水满足国家综合排放标准中一级标准。     

微波干燥在实验室中的应用研究

本实验以环境化学实验室中常见的9种基准化合物和变色硅胶为研究对象,采用家用微波炉为干燥设备,研究微波照射下各物质的干燥时间,并与常规烘箱干燥理论时间进行对比。实验结果表明,利用微波照射法在中高火档或高火档干燥样品时,样品干燥时间较烘箱干燥可节约时间90%以上,能够极大程度的降低实验室干燥过程的能耗水平,并大幅提高实验效率。     

钒掺杂磁铁矿对亚甲基蓝的吸附性能研究

采用共沉淀硝酸盐氧化法合成了不同掺杂量的钒掺杂磁铁矿(Fe3-xVxO4, x<0.4),并运用化学分析、X射线衍射(XRD)、BET比表面积测试、傅立叶变换红外光谱(FTIR)以及N2和空气气氛下的热重-差示扫描量热分析(TG-DSC)等手段对合成的Fe3-xVxO4进行了结构表征. 结果显示,合成的Fe3-xVxO4为立方晶系尖晶石结构,钒离子主要类质同像替换八面体位上的Fe3+. 合成的Fe3-xVxO4是纳米级的磁性材料,晶粒尺寸为28～35 nm. 钒掺杂作用增加了磁铁矿的表面羟基量. 吸附实验结果表明,在中性pH下,Fe3-xVxO4对亚甲基蓝的饱和吸附量随钒掺杂量的增加明显增大,其吸附等温线符合Langmuir方程. Fe3-xVxO4对亚甲基蓝的吸附反应主要在前25 min内完成,动力学曲线符合准二级动力学方程. 此外,提高溶液的pH有利于Fe3-xVxO4对亚甲基蓝的吸附.     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

微波酸活化粉煤灰吸附酸性大红染料废水实验研究

以微波酸活化改性后的粉煤灰为吸附剂,对酸性大红染料废水进行吸附脱色处理,考察了吸附时间、pH值、吸附剂投加量等对吸附脱色效果的影响。在酸性大红染料溶液初始浓度为100 mg/L、pH=5、活化粉煤灰投加量为10 g/L吸附1 h时,活化粉煤灰对酸性大红的脱色效果较好,去除率可达96%。对实验数据进行相关数学模型拟合,结果表明微波酸活化改性后的粉煤灰吸附去除酸性大红的等温吸附平衡符合Langmuir吸附等温式,改性前后的吸附过程动力学符合准二级吸附动力学模型,线性相关系数良好。