ICP-AES法测定农田土壤中重金属含量

土壤样品经预处理后,采用微波溶样消解法提取农田土壤中的有效态铜、锌元素,通电感耦合等离子体原子发射光谱法(ICP-AES),在最佳测定条件下利用标准曲线法,完成对土壤中有效态铜、锌元素的测定.测定方法操作简便、线性范围大,结果精密度高、准确度好,可以满足农田土壤样品中有效铜、锌元素的测定需要.     

Efficient dechlorination of chlorinated solvent pollutants under UV irradiation by using the synthesized TiO2 nano-sheets in aqueous phase

Titanium dioxide(TiO2), which is the widely used photo-catalyst, has been synthesized by simple hydrothermal solution containing tetrabutyl titanate and hydrofluoric acid. The synthesized product has been applied to photo-degradation in aqueous phase of chlorinated solvents, namely tetrachloroethene(PCE), trichloroethene(TCE) and 1,1,1-trichloroethane(TCA). The photo-degradation results revealed that the degradation of these harmful chemicals was better in UV/synthesized TiO2 system compared to UV/commercial P25 system and UV only system. The photo-catalytic efficiency of the synthesized TiO2 was 1.4, 1.8 and 3.0 folds higher compared to the commercial P25 for TCA, TCE and PCE degradation, respectively. Moreover, using nitrobenzene(NB) as a probe of hydroxyl radical(.OH), the degradation rate was better over UV/synthesized TiO2, suggesting the high concentration of.OH generated in UV/synthesized TiO2system. In addition,.OH concentration was confirmed by the strong peak displayed in EPR analysis over UV/synthesized TiO2system. The characterization result using XRD and TEM showed that the synthesized TiO2 was in anatase form and consisted of well-defined sheet-shaped structures having a rectangular outline with a thickness of 4 nm, side length of 50 nm and width of 33 nm and a surface 90.3 m2/g. XPS analysis revealed that ≡Ti-F bond was formed on the surface of the synthesized TiO2. The above results on both photocatalytic activity and the surface analysis demonstrated the good applicability of the synthesized TiO2 nano-sheets for the remediation of chlorinated solvent contaminated groundwater.     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.     

微波消解-火焰原子吸收分光光度法测定固体废物中的钡

采用微波消解法对固体废物浸出液样品进行前处理,采用乙炔-空气火焰原子吸收法测定钡的含量,检出限为2．04mg／L,加标回收率为94．5％,精密度为4．85％-6．81％。     

石墨烯基磁性复合材料吸附水中亚甲基蓝的研究

建立了一种超声辅助共沉淀法制备磁性Fe3O4/氧化石墨烯(Fe3O4/GO)纳米粒子.透射电镜和磁滞回线研究表明,该复合物具有小的颗粒尺寸和超顺磁性.该磁性纳米材料可以吸附废水中的染料亚甲基蓝,实验研究了溶液pH值、吸附剂的用量、时间和温度对亚甲基蓝去除率的影响.结果表明,pH值在6~9范围内,Fe3O4/GO都能高效地吸附亚甲基蓝.反应过程在前25 min反应速率很快,到180 min内达到吸附平衡.该磁性纳米材料对亚甲基蓝的吸附符合Langmuir吸附等温模型和准二级动力学方程,吸附过程是一个自发和吸热过程.该吸附材料对亚甲基蓝吸附容量高,在313 K时Fe3O4/GO的饱和吸附量为196.5 mg·g-1.另外,可以方便地通过外部磁场分离回收吸附剂,利用过氧化氢可以再生重复使用,是一种优良的吸附染料废水的材料.     

改性活性碳纤维电芬顿降解苯酚废水性能研究

采用微波改性、硝酸改性、磷酸改性及氨水改性等方法改性活性碳纤维(ACF-0),依次标记为ACF-1、ACF-2、ACF-3和ACF-4.以改性前后的活性碳纤维为阴极,电芬顿催化处理苯酚模拟废水,考察不同的改性方法对H2O2生成量、COD去除率、苯酚去除率及其中间产物的影响.结果表明,微波改性活性碳纤维的吸附性能及电催化活性最优,相比未改性活性碳纤维,经微波或酸碱改性后的活性碳纤维反应体系中,H2O2生成量均有所增加.苯酚在各电芬顿催化体系中的去除率大小依次是:ACF-1>ACF-3>ACF-4>ACF-2>ACF-0;COD去除率大小依次是:ACF-1>ACF-4>ACF-3>ACF-2>ACF-0,说明微波及酸碱改性有利于提高活性碳纤维的催化性能.此外,苯酚降解中间产物的生成也会受到改性方法的影响.     

微波及其组合工艺强化污泥厌氧消化研究

为提高剩余污泥的厌氧消化效能和脱水性能,考察了微波及其组合污泥预处理工艺的强化污泥厌氧消化效果,同时考察了预处理-厌氧消化过程的污泥理化特征及其脱水性能.结果表明,微波及其组合工艺可以强化污泥厌氧消化产甲烷,其中微波-过氧化氢-碱(0.2)的强化效果最为显著,不仅30 d累计产甲烷量比对照组增加了13.34%,而且产甲烷速率也得到了提升.与单独微波处理相比,过氧化氢、碱的投加显著提高了溶解性COD的释放量,这表明微波、过氧化氢、碱之间的协同作用能有效破碎污泥,进而强化厌氧消化效果;微波-酸预处理后的污泥具有良好的脱水性能,毛细吸水时间(CST)只有9.85 s,污泥脱水性能的改善与其表面电性、粒径分布的变化密切相关;不同预处理条件下的污泥经过厌氧消化后,污泥脱水性能较为接近.     

双组分VOCs的催化氧化及动力学分析

考察了微波加热与管式炉加热下挥发性有机化合物(VOCs)甲苯与氯苯的催化氧化性能,并对双组分VOCs的反应动力学进行了分析.结果表明,VOCs的竞争吸附使得双组分中甲苯和氯苯的转化率比单组分降低3%~12%;微波的"热点效应"与"非热效应"使得VOCs转化效率明显优于管式炉加热,尤其是氯苯的转化率提高了31%~38%;微波加热降低了氧化反应温度和处理能耗.动力学分析表明,微波加热下甲苯和氯苯的反应活化能比管式炉加热下减少了2146 J·mol-1和1450J·mol-1,微波加热下氯苯的化学反应速率常数是管式炉加热的35倍,甲苯的反应速率常数提高了6倍.     

微波消解ICP-AES法测定土壤中的金属元素研究

采用硝酸-盐酸-氢氟酸-双氧水作溶剂,通过微波消解技术、电感耦合等离子发射光谱法测定土壤中的锑、砷、铍、镉、铬、铜、铅、镍、硒、银、铊、锌,优化了微波消解仪和等离子发射光谱仪的工作参数,研究了共存离子的干扰和消除方法。优化后的微波消解酸体系及用量比例为HNO3∶HCl∶HF∶H2O2=5∶2∶3∶1,方法线性良好,各元素的检出限在0.000 2 mg/L~0.010 1 mg/L之间,土壤样品测定的标准偏差在0.001~0.051之间,加标回收率在85.5%~108.5%之间。该方法检出限低、精密度高、准确度好,测定结果令人满意。     

微波消解-石墨炉原子吸收光谱法测定土壤中镉

近年来,土壤中的镉污染事件频发,对土壤中镉测定的研究也越来越受到关注,本文以磷酸二氢铵-硝酸镁体系为基体改进剂,通过微波消解-石墨炉原子吸收光谱法分析测定土壤中镉,结果表明,该方法镉的检出限为1.96×10-13g。加标回收率为95.9%¹01.4%,相对标准偏差为0.57%,标样的测定结果在不确定度范围内。该方法具有快速、准确、灵敏度高的优点,能满足日常环境监测。