活性炭吸附法处理冶金废水的工程设计模型

以博哈特(Bohart)和亚当斯(Adams)方程为推导依据,结合连续进水活性炭模型实验,证明了活性炭吸附法处理冶金废水的可行性,且得出了活性炭吸附高度、工作周期、污染物去除率等重要设计参数之间的关系,为活性炭的工程设计提出了一套有效的参考计算方法和设计程序。     

含铬废水的处理技术及机理简述

介绍了废水中六价铬的来源及存在形态,以及处理含铬废水的物理、物化、化学及生物等各种工艺,并对各种工艺的机理和优缺点进行分析,展望含铬废水的治理前景。     

A pilot-scale study of cryolite precipitation from high fluoride-containing wastewater in a reaction-separation integrated reactor

Fluoride removal by traditional precipitation generates huge amounts of a water-rich sludge with low quality, which has no commercial or industrial value. The present study evaluated the feasibility of recovering fluoride as low water content cryolite from industrial fluoride-containing wastewater. A novel pilot-scale reaction-separation integrated reactor was designed. The results showed that the seed retention time in the reactor was prolonged to strengthen the induced crystallization process. The particle size of cryolite increased with increasing seed retention time, which decreased the water content. The recovery rate of cryolite was above 75% under an influent fluoride concentration of 3500 mg/L, a reaction temperature of 50℃, and an influent flow of 40 L/hr. The cryolite products that precipitated from the reactor were small in volume, large in particle size, low in water content, high in crystal purity, and recyclable.     

复合膜生物反应器处理环氧氯丙烷废水

实验利用复合膜生物反应器处理以甘油为原料制备环氧氯丙烷产生的废水,考察了不同进水COD、水力停留时间以及盐度对处理能力的影响,并进行盐度冲击实验。生物处理后出水进行了深度处理的研究。结果表明:进水COD对处理能力影响较小;适当延长水力停留时间能优化出水水质;废水盐度高于22g/L时会对微生物产生抑制作用;深度处理能进一步降低出水COD;微生物通过一定时间的驯化期能适应并处理高盐度废水。     

Iron and lead ion adsorption by microbial flocculants in synthetic wastewater and their related carbonate formation

Although microbial treatments of heavy metal ions in wastewater have been studied, the removal of these metals through incorporation into carbonate minerals has rarely been reported. To investigate the removal of Fe^3＋ and Pb^2＋, two representative metals in wastewater, through the precipitation of carbonate minerals by a microbial flocculant （MBF） produced by Bacillus mucilaginosus. MBF was added to synthetic wastewater containing different Fe^3＋ and Pb^2＋ concentrations, and the extent of flocculation was analyzed. CO2 was bubbled into the mixture of MBF and Fe^3＋/Pb^2＋ to initiate the reaction. The solid substrates were analyzed via X-ray diffraction, transmission electron microscopy and energy dispersive spectroscopy. The results showed that the removal efficiency decreased and the MBF adsorption capacity for metals increased with increasing heavy metal concentration. In the system containing MBF, metals （Fe^3＋ and Pb^2＋）, and CO2, the concentrated metals adsorbed onto the MBF combined with the dissolved CO2, resulting in oversaturation of metal carbonate minerals to form iron carbonate and lead carbonates. These results may be used in designing a method in which microbes can be utilized to combine CO2 with wastewater heavy metals to form carbonates, with the aim of mitigating environmental problems.     

磁性多孔陶粒生物膜反应器处理焦化废水的试验研究

以磁性材料为原料,经过特定的工艺处理,对多孔陶瓷进行磁化改性获得磁性多孔载体,并将该载体应用于生物膜反应器中进行焦化废水处理试验。对不同类型的多孔陶粒载体进行对比试验,结果表明:磁性载体生物膜反应器对COD、NH3-N的去除率比普通活性污泥法高出25%³0%,比非载体生物膜反应器高出15%30%,比非载体生物膜反应器高出15%²0%左右。反应器的曝气量为1.5 L/h,曝气时间为10 h/d,温度为2520%左右。反应器的曝气量为1.5 L/h,曝气时间为10 h/d,温度为25³0℃。焦化废水经磁性载体生物膜反应器处理后,上清液中COD,NH3-N的去除率均在90%左右。出水浓度达到国家工业废水排放二级标准(GB18918-2002)。     

纳米Fe_3O_4/膨润土的制备、表征及光催化降解焦化废水

以铝柱撑膨润土负载纳米Fe_3O_4制备出性能良好的复合型催化剂。结合X射线粉末衍射(XRD)、扫描电镜(SEM)和比表面孔隙分析(BET)对催化剂的晶相、比表面积和粒度进行表征。负载的纳米Fe_3O_4粒径约为20～30nm,均匀分散到膨润土表面,未发生明显的团聚。在紫外光作用下用该催化剂对焦化厂二沉池出水进行深度处理。结果表明,在催化剂投加量为0.7 g/L,pH为2.5,温度40℃,H_2O_2初始浓度为17.6mmol/L的反应条件下,二沉池出水(化学需氧量COD=140mg/L,色度=400度)经催化氧化降解后,COD和色度可分别降低到54.44 mg/L和10度,达到国家工业再生用水水质标准GB/T 19923-2005(COD≤60 mg/L,色度≤30度)。催化剂重复使用4次时,废水COD和色度去除率保持稳定。     

高密度澄清池与V型滤池在钢铁废水处理中的应用

武钢北湖污水回用工程将由明渠收集的武钢生产废水、少量生活污水和雨污水形成的综合废水处理后回用于工业生产。该工程采用包含高密度沉淀池(the DensaDeg誖clarifier)和V型滤池(the Aquazur誖V filter)的两级混凝分离+消毒的工艺。10个月的运行表明,系统能有效去除悬浮物、铁和不溶解性油,出水浊度、铁、不溶解性油均达到甚至优于设计目标。但是,进出水总硬度变化甚微,且后混凝对出水铁含量有不利影响。此外,出水氯离子含量明显增加,将对回用系统中的金属材料有不利的影响。鉴于此,建议对高密度沉淀池的石灰软化过程、后混凝的微絮凝过滤过程中铁的行为、出水氯离子降低途径开展更深入的研究。为了进一步降低运行费用,建议对药剂投加量进行优化研究。     

脱色混凝剂(PSDC-V)的开发应用研究

采用从某钢铁厂采集来的钢渣(水渣),经过粉碎、碱浸、酸溶、聚合(加入不同的量的Fe3+和Al3+)和过滤等步骤,制得了脱色混凝剂PSDC-V系列3种;试验了活性红、阳离子蓝的模拟染料废水的脱色效果,考察了影响PSDC-V混凝及脱色效果的因素,并与PAC进行了比较。结果表明,活性红和阳离子蓝废水的最佳吸收波长分别为536 nm和440 nm,吸光度A分别为1.344和0.816;pH≥6时,PSDC-V系列混凝剂对该2种模拟染料废水均具有良好的混凝效果,在pH=8时,达到最佳脱色效果点;脱色效果先随混凝剂投加量的增加而上升,后又随着投加量的增加而减少,最佳投加量在4 mL左右。与PAC相比,PSDC-V不仅具有良好的混凝效果而且具有良好的脱色效果,制造成本低。     

厌氧氨氧化工艺脱氮及其污泥形态的研究

为研究厌氧氨氧化工艺对高浓度含氮废水的脱氮性能,在以聚乙烯海绵作为填料的上流式厌氧固定床反应器中利用人工配置高浓度含氮废水进行了实验研究.实验中通过添加充足无机碳源,实现了厌氧氨氧化反应器在总氮浓度900～1 210 mg/L长期稳定的运行,脱氮效率在80％以上,最高氮负荷为5.9 kg/m3·d.结果表明:充足的无机碳源在一定程度上可有效地降低高浓度亚硝氮对厌氧氨氧化菌的抑制作用.通过对污泥性状的研究,明确寻找出污泥上浮的原因所在.通过Stover-Kincannon模型确定系统动力学参数KB和Umax分别为30.2 g/L·d和2L2g/L·d,这将有助于对该厌氧氨氧化系统各控制条件的有效调节和准确设定,也为日后应用于实际工程中提供重要的理论依据.