沉积物中多环芳烃和有机氯农药定量分析的质量保证和质量控制

以美国ＥＰＡ为方法为基础,进行了沉积物中多环芳烃和有机氯农药分析的质量保证和质量控制实验,采用回收率指示物控制回收率,用内标法定量。结果表明多环芳烃的指示物回收率为５０．６７－９７．３３％,目标化合物的回收率为５８．６７－９６．３３％,方法检测限为３．３０－９．２６μｇ．ｋｇ＾－１。     

不同改良剂对重金属污染农田水稻产量和重金属吸收的影响

探讨了石灰、过磷酸钙和有机物等改良剂的应用对水稻(oryzasativa)产量和重金属吸收的影响。实验共四种处理:T1,对照;T2,石灰(0.25kg·m-2);T3,石灰 过磷酸钙(0.40kg·m-2);T4,石灰 过磷酸钙 有机物(0.90kg·m-2)。叶面喷施的处理方法研究不多,因此结合在水稻的孕穗期喷施KH2PO4(0.3%)溶液研究喷施途径的处理效果。结果显示,T3处理即石灰 过磷酸钙(0.40kg·m-2),对于降低水稻体内的重金属含量效果最好,与对照相比,米中的Pb、Zn和Cd分别下降了61.8%、14.1%和45.1%,同时也使水稻茎叶中的Pb和Zn分别比对照下降8.1%和4.3%。另外,在水稻的叶面喷施KH2PO4溶液将水稻的产量从0.61kg·m-2提高到0.68kg·m-2,并且这种喷施措施也能有效地降低水稻中的重金属含量。     

四川省卧龙地区土壤中二噁英类化合物和多氯萘的海拔梯度分布及对牦牛的毒性风险评价

初步研究了四川省卧龙地区5个不同海拔高度的表层土壤和2个牦牛样品中二噁英/呋喃(PCDD/Fs)、共平面多氯联苯(co-PCBs)和多氯萘(PCNs)的分布特征、来源、毒性当量以及生态风险状况.土壤样品中总2,3,7,8-PCDD/Fs的含量范围为2.48-4.30 pg·g-1dw,平均3.50 pg·g-1dw,最高含量在海拔3927 m的塘房.co-PCBs的总含量平均为9.14 pg·g-1dw,最高值在海拔4487 m的垭口.总2,3,7,8-PC-DD/Fs和总co-PCBs含量随海拔高度的变化表现出正相关关系.不同海拔高度土壤中的PCDD/Fs和co-PCBs异构体的分布相似,表明具有相同的来源.总PCNs与海拔梯度呈负相关关系,最高含量出现在海拔3345 m的贝母坪,平均21.4 pg·g-1dw,主要以3.氯为主.土壤中PcDD/Fs毒性当量浓度范围为0.29-0.43pg TEQ·g-1dw.牦牛肉和牦牛组织中PcDD,/Fs总浓度分别为27.5和23.6 pg·g-1脂肪,毒性当量浓度为4.04和4.07 pg TEQ·g-1脂肪.结果表明,牦牛中的PCDD/Fg,co-PcBs和PCNs不大可能对卧龙地区人群导致严重的负面效应.     

多溴联苯醚、六溴环十二烷和四溴双酚A在环境中污染现状的研究进展

作为最主要的三大传统溴系阻燃剂(BFRs),多溴联苯醚(PBDEs)、六溴环十二烷(HBCD)、四溴双酚A(TBBPA)具有半挥发性、环境持久性和远距离传输性,目前在全球各种环境介质、生物体内广泛存在.毒理学研究表明,PBDEs、HBCD、TBBPA均具有明显的生物毒性和致癌性,对生态环境和人体健康存在潜在危害.本文简...     

C/N比和曝气量影响MBR同步硝化反硝化的研究

通过连续运行MBR研究了C/N比和曝气量对同步硝化反硝化的影响,结果表明,在环境温度13～23℃,MLSS为6.0～6.8 g/L,进水NH⁺₄-N浓度50 mg/L,曝气量0.5 m³/h,HRT为6 h实验条件下,总氮去除率随着进水C/N比的增加而增加,在C/N比为6∶1～8∶1时,TN去除率达到79%～89%,低的C/N比抑制反硝化,过高的C/N比增加了碳源补加的成本。改变反应曝气量,当C/N比为6∶1,曝气量为0.4 m³/h时,TN的去除率达到了最大值85%。曝气量过高或过低,TN去除率均下降。并对在不同曝气量下MBR 内的DO 值分布进行了初步研究。     

混凝-生物接触氧化处理合成橡胶碱洗废水

对化学合成橡胶碱洗废水进行了有机组分和可生化性分析,废水主要含有氯甲烷、六甲苯、异丁醇、甲醇等污染物质,生化降解实验中废水TOC可在6d内从60．9mg／L下降至0．0mg／L,可生化降解性好,适于生化处理。选择混凝．生物接触氧化组合工艺对废水进行处理,采用优化条件（pH=8、PAC=40mg／L、PAM=8mg／L）进行混凝,碱洗废水COD去除率为9．95％～72．94％（平均31．51％）;混凝后的碱洗废水与冲洗废水1：5混合进行接触氧化处理,在HRT为36h的情况下,COD去除率为65．6％-72．6％（平均70．4％）,出水COD为134～331mg／L,满足企业废水排放市政管网的要求;同时,实验发现COD去除率与COD容积负荷存在指数函数变化关系。     

Estimation and characterization of PCDD/Fs and dioxin-like PCBs from Chinese iron foundries

The iron foundry industry is considered to be a potential source of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). This study investigated the emission factors and total emission amounts of PCDD/Fs and dioxin-like polychlorinated biphenyls (DL-PCBs) from iron foundries in China. The concentrations and the World Health Organization toxicity equivalents (WHO-TEQs) are presented and the congener profiles are discussed in this paper.In the present work, 26 fly ash samples were collected and tested to quantify the PCDD/Fs and DL-PCBs generated by 14 plants of different scales, and five stack gas samples were collected from two (named as EFG and LFG) of those plants. The emission levels of PCDD/Fs and DL-PCBs indicated that hot-air cupolas had lower emissions than cold-air cupolas. When iron ore lump and sinter were used as raw material, the emission factors were about 250 ng TEQ t⁻¹ of product. However, if the raw material was scrap, the emission factors varied owing to the different contents of organic materials in the raw materials. It was found that the mean WHO-TEQ values of PCDD/Fs and DL-PCBs were 144 and 34.2 pg Nm⁻³ in stack gas and 20.0 and 1.58 pg g⁻¹ in fly ash. In multiple tests, it was estimated that the mean emission factors of PCDD/Fs and DL-PCBs were 365 and 10.9 ng WHO-TEQ t⁻¹ released to residue and 2719 and 555 ng TEQ t⁻¹ released to air. The total emission amounts of PCDD/Fs and DL-PCBs from Chinese iron foundries with cupola furnaces released to residue and air were 16.8 and 146 g WHO-TEQ in 2008, respectively.     

饮用水除砷技术研究进展

饮用水中的砷对人体健康危害很大。介绍了从饮用水中去除砷的各种方法,总结了目前除砷技术存在的不足,指出混凝微滤工艺具有除砷效率高、能耗低、操作简单等优点,应成为今后饮用水除砷技术的发展方向。     

Altered toxicity of organic pollutants in water originated from simultaneous exposure to UV photolysis and CdSe/ZnS quantum dots

The paper reports unforeseen results of increased toxicity of water, subsequent to interactions between CdSe/ZnS quantum dots (QDs), phenol and toluene under UV irradiation. The consistent pattern of changes in measured toxicity (TU) was observed and correlated with degradation of phenol and/or toluene. Spearman rank coefficients (SRCs) for data pairs sum-parameters vs. TU were calculated. The highest correlation between toxicity and degradation by-products was observed for hydroquinone (0.86) and catechol (0.89). The presence of QDs in tested concentration range in the absence of UV has shown low toxicity and no interactions with phenol and/or toluene. The leak of constituent core and shell metal ions was observed. The minor differences in physical characteristics of tested QDs of the same chemical composition led to rather different degradation patterns of phenol and toluene, and the amount of leak of the metal ions as well.     

Nationwide monitoring of atmospheric PCDD/Fs and dioxin-like PCBs in South Korea

Polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) and dioxin-like polychlorinated biphenyls (DL-PCBs) were measured in ambient air samples collected from different parts of South Korea in 2008, and the measured levels were used for assessing the spatial and temporal distribution of atmospheric PCDDFs and DL-PCBs in South Korea. The average concentrations of atmospheric PCDD/Fs and DL-PCBs among the 37 sites were 28 fg I-TEQ m⁻³ (ND ∼ 617) and 1 fg WHO-TEQ m⁻³ (ND ∼ 0.016). Elevated atmospheric levels of PCDD/Fs and DL-PCBs observed at residential/industrial sites and in the north-west of Korea, indicated a potential contribution and impacts of anthropogenic sources of PCDD/Fs and DL-PCBs. These levels were similar or lower than those previously reported in other ambient air surveys. Average concentrations of PCDD/Fs showed small seasonal variations (ANOVA analysis, p = 0.144). The highest concentrations of PCDD/Fs were observed during winter, followed by spring, autumn and summer. Atmospheric PCDD/Fs and DL-PCBs in South Korea rapidly decreased during the last 10 years (1998-2008), demonstrating the efficiency of stricter regulations and the application of best available technologies/best environmental practices at emission sources. Comparison of the congener profiles and principal component analysis showed that current atmospheric PCDD/Fs are mostly influenced by industrial sources and PCBs from old commercial PCB uses. Nationwide POPs monitoring will continue and allows an effective evaluation of the implementation of the Stockholm Convention on POPs.