有机膨润土吸附苯酚的性能及其在水处理中的应用初探

分别用氯化十六烷基吡啶（CPC）和溴化十六烷基三甲铵（CTMAB）改性膨润土,试验了制备有机膨润土的适宜条件及其对吸附苯酚性能的影响。上述两种有机膨润土吸附水中苯酚很快能达到平衡。pH值为3─9时,有机膨润土处理苯酚的效果基本一致;pH>11时,有较高的去除率。CPC－膨润土或CTMAB－膨润土对苯酚的饱和吸附容量分别为103.5mg/g和75.0mg/g。有机膨润土处理苯酚的效果比原土提高8倍以上。     

Lindet ypeF(K)沸石对Zn~(2+)的吸附研究

利用粉煤灰合成Linde type F(K)沸石吸附重金属Zn2+,考察吸附剂量、pH值、反应温度对Zn 2+吸附效果影响,研究沸石吸附Zn2+的等温线与动力学,得到了相应的模型。结果表明:吸附剂量、pH值、反应温度均对Zn2+去除效果影响显著。随着吸附剂量增大,Zn 2+去除效果不断提高,饱和吸附量逐渐减小。初始pH值为3~7时,沸石对Zn2+去除率随pH值升高迅速提高。反应温度越高,沸石吸附Zn2+到达平衡时间越短。沸石对Zn2+吸附过程符合Langmuir吸附等温式,其吸附为单分子层吸附;准二级反应动力学方程能很好描述沸石对Zn2+的吸附行为。     

金属涂料生产中挥发性有机物(VOC)的污染及其防治

阐明了金属涂料生产中挥发性有机物（VOC）的危害性,介绍了一种工程造价低,处理效果较好的治理方法,供投资生产金属涂料的生产者参考。     

洗毛废水的不同处理方法对活性炭吸附的影响

通过活性炭吸附2种不同处理方法处理后的洗毛废水,研究了活性炭的吸附容量和吸附机理。结果表明：活性炭吸附无机酸酸化处理后废水和高分子絮凝剂处理后废水中COD的吸附容量分别为：70mg／g和43mg／g。进一步研究发现,2种废水中废水中小分子组分和疏水性组分的含量差异是造成活性炭吸附效果差异的主要原因。     

Simultaneous removal of Cu(II) and Cr(VI) by Mg–Al–Cl layered double hydroxide and mechanism insight

Mg–Al–Cl layered double hydroxide (Cl-LDH) was prepared to simultaneously remove Cu(II) and Cr(VI) from aqueous solution. The coexisting Cu(II) (20 mg/L) and Cr(VI) (40 mg/L) were completely removed within 30 min by Cl-LDH in a dosage of 2.0 g/L; the removal rate of Cu(II) was accelerated in the presence of Cr(VI). Moreover, compared with the adsorption of single Cu(II) or Cr(VI), the adsorption capacities of Cl-LDH for Cu(II) and Cr(VI) can be improved by 81.05% and 49.56%, respectively, in the case of coexisting Cu(II) (200 mg/L) and Cr(VI) (400 mg/L). The affecting factors (such as solution initial pH, adsorbent dosage, and contact time) have been systematically investigated. Besides, the changes of pH values and the concentrations of Mg²⁺ and Al³⁺ in relevant solutions were monitored. To get the underlying mechanism, the Cl-LDH samples before and after adsorption were thoroughly characterized by X-ray powder diffraction, transmission electron microscopy, Fourier transform infrared spectroscopy, and X-ray photoelectron spectroscopy. On the basis of these analyses, a possible mechanism was proposed. The coadsorption process involves anion exchange of Cr(VI) with Cl⁻ in Cl-LDH interlayer, isomorphic substitution of Mg²⁺ with Cu²⁺, formation of Cu₂Cl(OH)₃ precipitation, and the adsorption of Cr(VI) by Cu₂Cl(OH)₃. This work provides a new insight into simultaneous removal of heavy metal cations and anions from wastewater by Cl-LDH.     

Study of cyanide removal from contaminated water using zinc peroxide nanomaterial

The present study highlights the potential application of zinc peroxide(ZnO_2)nanomaterial as an efficient material for the decontamination of cyanide from contaminated water. A process patent for ZnO_2 synthesis has been granted in United States of America(US Patent number 8,715,612; May 2014),South Africa,Bangladesh,and India. The ZnO_2 nanomaterial was capped with polyvinylpyrrolidone(PVP)to control the particle size. The PVP capped ZnO_2nanomaterial(PVP-ZnO_2)before and after adsorption of cyanide was characterized by scanning electron microscope,transmission electron microscope,X-ray diffractometer,Fourier transform infrared spectroscopy and time of flight-secondary ion mass spectrometry. The remaining concentration of cyanide after adsorption by PVP-ZnO_2 was determined using ion chromatograph. The adsorption of cyanide over PVP-ZnO_2 was also studied as a function of p H,adsorbent dose,time and concentration of cyanide. The maximum removal of cyanide was observed in p H range 5.8–7.8 within 15 min. The adsorption data was fitted to Langmuir and Fruendlich isotherm and it has been observed that data follows both the isotherms and also follows second order kinetics.     

吸附法处理垃圾渗滤液的研究进展

综述了吸附法和吸附法耦合其他技术处理垃圾渗滤液的研究进展,针对渗滤液中有机物的去除,重点比较了各种吸附剂的吸附性能,并做了展望。     

Recent advances in antimony removal using carbon-based nanomaterials: A review

• The synthesis and physicochemical properties of various CNMs are reviewed. • Sb removal using carbon-based nano-adsorbents and membranes are summarized. • Details on adsorption behavior and mechanisms of Sb uptake by CNMs are discussed. • Challenges and future prospects for rational design of advanced CNMs are provided. Recently, special attention has been deserved to environmental risks of antimony (Sb) element that is of highly physiologic toxicity to human. Conventional coagulation and ion exchange methods for Sb removal are faced with challenges of low efficiency, high cost and secondary pollution. Adsorption based on carbon nanomaterials (CNMs; e.g., carbon nanotubes, graphene, graphene oxide, reduced graphene oxide and their derivatives) may provide effective alternative because the CNMs have high surface area, rich surface chemistry and high stability. In particular, good conductivity makes it possible to create linkage between adsorption and electrochemistry, thereby the synergistic interaction will be expected for enhanced Sb removal. This review article summarizes the state of art on Sb removal using CNMs with the form of nano-adsorbents and/or filtration membranes. In details, procedures of synthesis and functionalization of different forms of CNMs were reviewed. Next, adsorption behavior and the underlying mechanisms toward Sb removal using various CNMs were presented as resulting from a retrospective analysis of literatures. Last, we prospect the needs for mass production and regeneration of CNMs adsorbents using more affordable precursors and objective assessment of environmental impacts in future studies.     

苯酚的褐煤吸附过程及影响因素分析

以污染物苯酚为研究对象,褐煤作为吸附剂,通过批量实验研究了褐煤对废水中苯酚的吸附特性,考察了褐煤粒径、褐煤投加量、反应温度、反应p H、反应时间对吸附作用的影响,并对吸附过程进行了分析。采用Lagergren动力学方程和拟二级吸附动力学方程分析苯酚吸附过程,结果表明,褐煤对苯酚的吸附动力学曲线更符合拟二级吸附动力学方程,反应初始速率随着苯酚初始浓度的升高而增大,但随着煤粉粒径的增大而减小。颗粒内扩散模型对苯酚的吸附动力学曲线分析结果表明:苯酚在褐煤上的吸附首先经历了速率较快的膜扩散控制阶段,进而经历了吸附较缓慢的颗粒内扩散控制阶段,最后到达吸附平衡,褐煤对苯酚的吸附过程主要受到颗粒内扩散控制。     

Effects of chemical modification on physicochemical properties and adsorption behavior of sludge-based activated carbon

This study aimed to explore the adsorption performance of sludge-based activated carbon (SBC) towards dissolved organic matters (DOMs) removal from sewage, and investigated the modification effect of different types of chemicals on the structure of synthesized SBC. Waste activated sludge (WAS) was used as a carbon source, and HCl, HNO₃, and NaOH were used as different types of chemicals to modify the SBC. With the aid of chemical activation, the modified SBC showed higher adsorption performances on DOMs removal with maximum adsorption of 29.05 mg/g and second-order constant (k) of 0.1367 (L/mol/sec) due to the surface elution of ash and minerals by chemicals. The surface elemental composition of MSBC suggested that the content of C-C and C-O functional groups on the surface of modified sludge-based activated carbon (MSBC) played an important role on the adsorption capacities of MSBC towards DOMs removal in sewage. Additionally, the residual molecular weight of DOMs in sewage was investigated using a 3-dimension fluorescence excitation-emission matrix (3D-EEM) and high-performance size exclusion chromatography (HP-SEC). Results showed that the chemical modification significantly improved the adsorption capacity of MSBC on humic acids (HA) and aromatic proteins (APN), and both of NaOH-MSBC and HCl-MSBC were effective for a wide range of different AMW DOMs removal from sewage, while the HNO₃-MSBC exhibited poorly on AMW organics of 2,617 Da and 409 Da due to the reducing content of macropore. In brief, this study provides reference values for the impact of the chemicals of the activation stage before the SBCs application.