白炽灯灯丝残骸微观形貌分析

本文模拟火灾中不同情况,制备普通白炽灯破坏的灯丝残骸,利用扫描电子显微镜（SEM）分析灯丝残骸的微观形貌,研究灯丝在不同情况下破坏的特征。发现通电状态下破坏的灯丝氧化严重,与未通电状态的灯丝具有明显的区别。即使经历了高温或火焰灼烧作用后,微观形貌特征仍具有明显的差别。根据这种微观特征可以判断火场中白炽灯的通电状态。     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.     

A level change in mutagenicity of Japanese tap water over the past 12 yr

A relative comparison study of mutagenicity in Japanese tap water was conducted for 1993 and 2005 surveys. It intended to assess the effects of advanced water treatment installations to water works, improvement of raw water quality and improvement of residual HOCl concentration controlling. Sampling points (taps) were the same in both surveys. The results of 245 samples obtained by the Ames Salmonella mutagenicity test (Ames test) were analyzed. The Ames tests were conducted by using Salmonella typhimurium TA98 and TA100 strains with and without exogenous activation (S9). With the exception of TA100-S9, the other conditions needed no discussion as a factor in the mutagenicity level change. The average mutagenicity in 1993 and 2005 under the conditions of TA100-S9 were 2600 and 1100 net revertant L⁻¹, respectively. This indicated that the mutagenicity level of Japanese tap water decreased during the 12-yr period. Particularly a remarkable decrease in mutagenicity was observed in the water works where the advanced water treatments were installed during the 12-yr period. The advanced water treatments were effective in decreasing the mutagenicity of tap water. Mutagenicity also decreased in the water works with conventional water treatments; the improvement of residual HOCl concentration controlling was also considered to be effective in decreasing the mutagenicity of tap water.     

The use of anthracene as a model compound in a comparative study of hydrous pyrolysis methods for industrial waste remediation

Polycyclic aromatic hydrocarbons are very stable compounds and tend to bioaccumulate in the environment due to their high degree of conjugation and aromaticity. Hydrous pyrolysis is explored as a technique for the treatment of industrial water containing PAH, using anthracene as a model compound. The reactivity of anthracene under a range of temperatures and durations are studied in this paper. Aliquots of 1.0-10.0 mg of anthracene in a range of 1.0-5.0 mL of H₂O are subjected to hydrous pyrolysis under varied conditions of temperature, reagents and duration. The conditions include oxidising systems comprising distilled water, hydrogen peroxide and Nafion-SiO₂ solid catalyst in water; and reducing systems of formic acid and formic acid/Nafion-SiO₂/Pd-C catalysts to assess a range of redox reaction conditions. Oxygen in air played a role in some of the reaction conditions. Pyrolysed products were identified and quantified by the use of Gas Chromatography-Mass Spectrometry (GC-MS). The major products were anthrone, anthraquinone, xanthone from oxidation; and multiple hydro-anthracene derivatives from reductive hydogenation. The nature of reaction conditions influenced the extent of anthracene degradation. The products formed are more reactive (less stable) as compared to anthracene the starting material and will therefore be less persistent in the environment.     

Elimination of diclofenac from water using irradiation technology

The effluents of wastewater treatment plants, usually directly emitted to the environment, often contain the anti-inflammatory drug diclofenac (DCF). The paper investigates DCF elimination using irradiation technology. Hydroxyl radical and hydrated electron reactive intermediates resulting from water radiolysis effectively degrade DCF and strongly reduce the toxicity of the solutions. OH attaches to one of the rings of DCF, and hydroxylated molecules, 2,6-dichloroaniline and quinoid type compounds are the products. Hydrated electron adds to the chlorine atom containing ring, in the reaction quinoid type compounds and 4-chloroacridine form. At a 0.1 mM DCF concentration, a ∼1 kGy absorbed dose is needed for the degradation of DCF molecules, but for mineralization of the products (in presence of O₂) an order of magnitude higher dose is required.For irradiation of wastewater after biological treatment a ∼1 kGy dose is suggested. At this dose DCF and other drugs or metabolites present at μg L⁻¹ level are eliminated together with microorganism deactivation.     

The effect of alkyl chain length on the degradation of alkylimidazolium- and pyridinium-type ionic liquids in a Fenton-like system

Background, aim, and scope  Ionic liquids are regarded as essentially “green” chemicals because of their insignificant vapor pressure and, hence, are a good alternative to the emissions of toxic conventional volatile solvents. Not only because of their attractive industrial applications, but also due to their very high stability, ionic liquids could soon become persistent contaminants of technological wastewaters and, moreover, break through into natural waters following classical treatment systems. The removal of harmful organic pollutants has forced the development of new methodologies known as advanced oxidation processes (AOPs). Among them, the Fenton and Fenton-like reactions are usually modified by the use of a higher hydrogen peroxide concentration and through different catalysts. The aim of this study was to assess the effect of hydrogen peroxide concentration on degradation rates in a Fenton-like system of alkylimidazolium ionic liquids with alkyl chains of varying length and 3-methyl-N-butylpyridinium chloride. Materials and methods  The ionic liquids were oxidized in dilute aqueous solution in the presence of two different concentrations of hydrogen peroxide. All reactions were performed in the dark to prevent photoreduction of Fe(III). The concentrations of ionic liquids during the process were monitored with high-performance liquid chromatography. Preliminary degradation pathways were studied with the aid of ¹H NMR. Results  Degradation of ionic liquids in this system was quite effective. Increasing the H₂O₂ concentration from 100 to 400 mM improved ionic liquid degradation from 57–84% to 87–100% after 60 min reaction time. Resistance to degradation was weaker, the shorter the alkyl chain. Discussion  The compound omimCl was more resistant to oxidation then other compounds, which suggests that the oxidation rates of imidazolium ionic liquids by OH· are structure-dependent and are correlated with the n-alkyl chain length substituted at the N-1-position. The level of degradation was dependent on the type of head group. Replacing the imidazolium head group with pyridinium increased resistance to degradation. Nonetheless, lengthening the alkyl chain from four to eight carbons lowered the rate of ionic liquid degradation to a greater extent than changing the head group from imidazolium to pyridinium. 1H-NMR spectra show, in the first stage of degradation, that it is likely that radical attack is nonspecific, with any one of the carbon atoms in the ring and the n-alkyl chain being susceptible to attack. Conclusions  The proposed method has proven to be an efficient and reliable method for the degradation of imidazolium ionic liquids by a Fenton-like reagent deteriorated with lengthening n-alkyl substituents and by replacing the imidazolium head group with pyridinium. The enhanced resistance of 1-butyl-3-methylpyridinium chloride when the resistance of imidazolium ionic liquids decreases with increasing H₂O₂ concentration is probably indicative of a change in the degradation mechanism in a vigorous Fenton-like system. H-NMR spectra showed, in the first stage of degradation, that radical attack is nonspecific, with any one of the carbon atoms in the ring and the n-alkyl chain being susceptible to attack. Recommendations and perspectives  Since ionic liquids are now one of the most promising alternative chemicals of the future, the degradation and waste management studies should be integrated into a general development research of these chemicals. In the case of imidazolium and pyridinium ionic liquids that are known to be resistant to bio- or thermal degradation, studies in the field of AOPs should assist the future structural design as well as tailor the technological process of these chemicals     

Application of lime and calcium hypochlorite in the dephenolisation and discolouration of olive mill wastewater

The application of hypochlorite for the removal of soluble COD, phenolic and polyphenolic like compounds, and other organic compounds responsible for the olive mill wastewater (OOWW) colour has been experimentally studied. After the OOWW filtration on a sand column, the effluent was subjected to a fast liming under optimal conditions. Lime application reduced polyphenols, COD and SS contents to half of their initial values but an important blackening of the treated OOWW was observed, especially when adding high concentrations of lime (10% (W/V) and 15% (W/V)).A second stage of treatment was applied using calcium hypochlorite. In this stage, removal of the studied compounds reached as much as 95% at higher concentrations, and particularly the colouring of OOWW which is generally difficult to eliminate was greatly reduced. The OOWW hypochloration acted through coagulation–flocculation and a rapid oxidation of the organic matter proceeded from the first 5 min. The kinetic study of the degradation of the waste polluting compounds from liming showed that Ca(ClO)₂ reacts similarly in the elimination of organic compounds, polyphenols, SS and colouration. The analysis of the organochloride compounds generated by the reaction between hypochlorite and the organic compounds showed that DDD, DDT and the heptachlor contents exceeded the values recommended by the International and European drinking water standards.     

On-line production of ferrate with an electrochemical method and its potential application for wastewater treatment – A review

A number of studies on the oxidation of various organic/inorganic contaminants by ferrate(VI) were reported in the 1980s and 1990s. The exploration of the use of ferrate(VI) for water and wastewater treatment has been well addressed recently. However, challenges have existed for the implementation of ferrate(VI) technology in practice due to the instability of a ferrate solution or high production cost of solid ferrate products. The research has been carried out aiming at the generation and application of ferrate(VI) in situ. This paper thus reviews ferrate chemistry and its overall performance as a water treatment chemical, discusses the factors affecting the ferrate yield efficiency using the electrochemical method, and finally, summarises the work on the production and use of ferrate in situ which is currently under study.     

吨量煤体的自燃过程实验模拟研究

为更好地弄清矿井实际的煤自然发火规律,利用装煤量达5吨的大型实验台对两种烟煤分别进行了自燃模拟实验。大煤量的实验能够很好地模拟煤矿中煤低温氧化和传热传质共同作用导致的发火过程,实验得到的自然发火期与煤矿实际发火期也是一致的。实验中煤样从缓慢氧化变为快速氧化的临界温度为100～110℃。当煤温低于,临界温度时,煤样的升温受到空气流带走热量和向外界散热的影响很大,因此夹层水的保温作用就很关键。当煤温超过临界温度后,反应加快,温度急剧上升,散热的影响明显降低,反应主要受限于氧气的供应情况。     

Studies on the Coupling Product between Oxidation Products Derived from Pentachlorophenol and Cyclodextrins

The coupling products (CPs), which were formed via the peroxosulfate catalyzed oxidation of pentachlorophenol (PCP) with iron(III)-tetrakis(sulfonatophenyl)porphyrin (Fe(III)-TPPS) in the presence of hydroxypropyl-β -cyclodextrin (HP-β -CD) or HP-γ -CD, were separated by ultrafiltration from the reaction mixture. When the percentages of chlorine species in the reaction mixture were calculated from the concentrations of organic chlorine in the reaction mixture and CPs, 10–25% of chlorine species in the reaction mixture was organic chlorine that was incorporated into CDs. Analyses of the CPs by pyrolysis-GC/MS (Py-GC/MS) and ¹³C NMR showed that the PCP-derived products were covalently incorporated into the CDs. To evaluate the acute toxicity of the CPs, a Microtox® test was examined. Toxicities of the CPs were reduced slightly, compared to the controls (PCP alone and PCP + reaction blanks). In the reaction blanks, mesaconic acid (MA) moieties were detected as a result of the oxidation of CDs in the absence of PCP. Thus, factors in the toxicities, detected in the CPs, can be attributed to the oxidation products derived from CDs, such as MA, as well as the PCP-derived products incorporated into the CDs.