菜地氨氧化微生物驱动的N2O和NO对有机无机肥配施的响应

氨氧化细菌（AOB）和氨氧化古菌（AOA）是驱动土壤氨氧化过程的"引擎".氨氧化过程在土壤氧化亚氮（N₂O）和一氧化氮（NO）排放过程中扮演着重要角色.有机无机肥配施是实现化肥零增长和作物稳产增产的重要途径，但在有机无机肥配施下，菜地土壤AOB和AOA对氨氧化过程的相对贡献仍不清楚.本研究采用选择性抑制的方法（辛炔和乙炔）区分有机肥添加近3年后（2016年10月—2019年5月）AOB和AOA在氨氧化过程中对碱性菜地土壤N₂O和NO产生的相对贡献.试验共设5种施肥处理：不施氮肥（CK）、单施尿素（N）、单施有机肥（M）、50%尿素+50%有机肥（M1N1）和80%尿素+20%有机肥（M1N4）.结果表明，有机无机肥配施（M1N1和M1N4）可显著增加土壤电导率、有机碳和全氮含量.培养试验发现，与N处理相比，M和M1N1处理分别使N₂O排放量增加100.7%和38.8%，NO排放量增加77.9%和42.8%，AOB基因丰度增加16.6%和10.2%，同时，AOB对N₂O排放的相对贡献增加6.5%.相反，M1N4处理分别使N₂O和NO排放量降低19.3%和4.8%，AOB基因丰度降低37.5%，同时，AOB对N₂O及NO排放的相对贡献分别降低7.8%和7.4%.相关分析表明，土壤N₂O和NO累积排放量与土壤AOB基因丰度呈显著正相关（p<0.05），与土壤AOA基因丰度无显著相关性.有机无机肥配施下AOB是氨氧化过程的主要驱动者，适当比例的有机无机肥配施（即M1N4）措施可在一定程度上减弱AOB对碱性菜地土壤N₂O及NO排放的相对贡献.     

Mn-Cu-O负载型催化剂上CO氧化性能的研究

研究了ＺｒＯ２或Ａｌ２Ｏ３负载Ｍｎ－Ｃｕ－Ｏ体系催化剂ＣＯ催化氧化活性，以及物相结构，表面氧性能与活性的关系。结果表明，锆基催化剂的氧化活性明显优于铝基催化剂，起燃温度Ｔ５０低达５０℃，ＺｒＯ２载 利于活性组份形成高活性物相，并促进表面吸附氧的脱附，表现出催化剂表面吸附氧的脱附温度高低次序与其氧化活性有一致的对应关系。     

Photocatalytic degradation of dye effluent by titanium dioxide pillar pellets in aqueous solution

Photocatalytic oxidation (PCO) process is an effective way to deal with organic pollutants in wastewater which could be difficult to be degraded by conventional biological treatment methods. Normally the TiO2 powder in nanometre size range was directly used as photocatalyst for dye degradation in wastewater. However the titanium dioxide powder was arduous to be recovered from the solution after treatment. In this application, a new form of TiO2(i. e. pillar pellets ranging from 2.5 to 5.3 mm long and with a diameter of 3.7 mm) was used and investigated for photocatalytic degradation of textile dye effluent. A test system was built with a flat plate reactor(FPR) and UV light source(blacklight and solar simulator as light source respectively) for investigating the effectiveness of the new form of TiO2. It was found that the photocatalytic process under this configuration could efficiently remove colours from textile dyeing effluent. Comparing with the TiO2 powder, the pellet was very easy to recovered from the treated solution and can be reused in multiple times without the significant change on the photocatalytic property. The results also showed that to achieve the same photocatalytic performance, the FPR area by pellets was about 91% smaller than required by TiO2 powder. At least TiO2 pellet could be used as an alternative form of photocatalyst in applications for textile effluent treatment process, also other wastewater treatment processes.     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

中国危险废物和医疗废物焚烧处置行业二（口恶）排放水平研究

通过调研全国危险废物和医疗废物焚烧处置设施,对包含二噁英排放水平的设施按处置对象、炉型和处理量分类,并作系统分析和研究.结果表明现有危险废物焚烧设施烟气中二噁英的浓度比医疗废物低,达标率为74.19%;危险废物选用回转窑处置效果较好,达标率为66.67%;而医疗废物选用回转窑或热解炉,要综合考虑处置规模、生产成本和二英排放总量等因素;危险废物介于10~30 t·d-1和医疗废物介于10~20 t·d-1的处置设施要尤其注意二噁英的排放问题;医疗废物焚烧飞灰中二噁英的均值浓度为危险废物6倍以上,仅有16.67%满足填埋要求.二者烟气中二英的浓度分布以1,2,3,4,6,7,8-HpCDF、2,3,7,8-TCDF和OCDD为主.     

Low-carbon transition of iron and steel industry in China: Carbon intensity, economic growth and policy intervention

As the biggest iron and steel producer in the world and one of the highest CO₂ emission sectors, China's iron and steel industry is undergoing a low-carbon transition accompanied by remarkable technological progress and investment adjustment, in response to the macroeconomic climate and policy intervention. Many drivers of the CO₂ emissions of the iron and steel industry have been explored, but the relationships between CO₂ abatement, investment and technological expenditure, and their connections with the economic growth and governmental policies in China, have not been conjointly and empirically examined. We proposed a concise conceptual model and an econometric model to investigate this crucial question. The results of regression, Granger causality test and impulse response analysis indicated that technological expenditure can significantly reduce CO₂ emissions, and that investment expansion showed a negative impact on CO₂ emission reduction. It was also argued with empirical evidence that a good economic situation favored CO₂ abatement in China's iron and steel industry, while achieving CO₂ emission reduction in this industrial sector did not necessarily threaten economic growth. This shed light on the dispute over balancing emission cutting and economic growth. Regarding the policy aspects, the year 2000 was found to be an important turning point for policy evolution and the development of the iron and steel industry in China. The subsequent command and control policies had a significant, positive effect on CO₂ abatement.     

考虑松动圈影响的钻孔瓦斯抽放合理封孔长度确定研究

以王行庄矿11071工作面为工程试验地点,通过超声波和钻孔窥视现场测试,结合理论计算,开展了瓦斯抽采煤巷松动圈范围和瓦斯抽放钻孔合理封孔长度确定的研究。确定了王行庄11071工作面二1煤层围岩卸压区宽度为8.87 m,极限平衡区宽度为9.87 m,合理封孔深度为10 m;通过极限平衡法理论计算得到的结果与超声波法、钻孔窥视法的测试结果基本相符。     

煤矿火灾烟气流动传播过程仿真研究

煤矿发生火灾后会生成大量有毒气体并产生火风压,烟气在火灾动力的影响下出现状态紊乱,研究煤矿火灾烟气流动传播过程对控制火情有着重要意义。基于国内外研究现状,对燃烧及风流特点进行分析,建立了煤矿火灾烟气流动数学模型,并利用CFD软件进行仿真。研究表明:无通风工况下的烟气为对称流动;随着风速增加,出口处温度降低,烟气向风流入口处的流速减小。     

气相色谱法测定水中的三氯乙醛

建立了一种用气相色谱法测定水体中三氯乙醛的方法。水样先以石油醚萃取,除去高沸点化合物,加入氯化钠破乳,然后再用石油醚—乙醚混合溶剂(V/V=2:1)萃取3次,萃取液经色谱柱分离,用电子捕获检测器检测。最低检出浓度可达0.008 mg/L,线性关系良好(相关系数γ=0.992~0.998),一般共存物质不干扰测定。     

重金属阳离子荧光传感器合成及光谱性研究

通过亚胺缩合的反应制备出阳离子荧光传感器（Cation Fluorescent Sensors,CFSs）,并对其结构、光谱性能检测、荧光量子产率等进行了详细的研究.通过荧光化学传感器产生的荧光光谱一直是高效的分析方法,因此合成了新的基于席夫碱的荧光化学传感器,并研究了对各种金属离子的结合特性.在CH3CN溶液中测试了阳离子荧光传感器时不同阳离子的选择性响应,发现对Cu2＋有较好的选择性,可用于Cu2＋的检测.该类阳离子荧光传感器是基于2,2-联噻吩-5-乙醛的荧光发射基团和邻氨基苯甲醚为识别基团的一类阳离子荧光传感器.